流體應力 的英文怎麼說

中文拼音 [liútǐyīnglì]
流體應力 英文
fluid stress
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 體 : 體構詞成分。
  • 應 : 應動詞1 （回答） answer; respond to; echo 2 （滿足要求） comply with; grant 3 （順應; 適應） suit...
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 流體 : [物理學] fluid; fluor流體力學 fluid mechanics; hydromechanics; 流體生物學 hydrobiology; 流體運動學 hydrokinematics
  1. Hydrodynamics in an air - lift loop reactor

    氣升式環流反應器的流體動力學模型
  2. The hydrodynamic parameters and mass transfer coefficient are studied in the internal loop airlift bioreactor used in treating wastewater. the hydrodynamic parameters consist of gas holdup, liquid velocity and axial dispersion coefficient

    本文從流體動力學和傳質動力學兩個方面考察了用氣升式內環流生物反應器應用於廢水處理的性能。
  3. Centered on the investigation on the evolvement of permeability as well as the coupling action between seepage and stress, the following work is carried out : 1. a further examination is given to classical biot seepage theory to discover the basic assumption to form the coupling seepage equation, and discuss the variety of coupling equations between seepage and stress and their adaptabilities. the physical meanings, adaptability, testing method of seepage parameters used in equation of continuum are analyzed based on the experimental investigations on complete relationship between stress, strain and permeability of rock and engineering test on permeability of rock at different depth

    本文圍繞巖石破裂過程中滲透性的演化規律及其滲流-應力耦合作用機理這一課題，開展以下方面的研究工作: 1 .對經典biot滲流力學做了進一步的考察，揭示建立耦合滲流方程的主要假設，討論了各種滲流與應力耦合方程及數學模型的適用條件，通過巖石應力應變-滲透率全過程實驗研究和不同深度巖體滲透率工程試驗研究，分析了連續介質模型耦合滲流方程參數的物理意義、適用性、測試方法。
  4. Kerosene testing ? when specified for special service valves, pacific valves can perform hydrostatic shell and seat closure testing using kerosene in lieu of water

    煤油檢測?對于特殊應用的閥門，如果用戶指定，美國太平洋閥門可以採用煤油代替水對閥門進行流體靜力學殼體和閥座壓縮檢測。
  5. In chapter 4, the influences of the earth ' s models on the elastic green ' s function, as well as on the atmospheric loading effects, are discussed using the numerical techniques. the attraction green ' s function is solved out based on the state equations of the ideal gas and the hydrostatic equilibrium equation. the influences of various factors upon the gravity and tilt green ' s functions, as well as upon the gravity and tilt, are considered in detail

    第四章：採用數值計算方法，研究了地球模型對彈性項格林函數及其對大氣負荷響應的影響；利用理想氣體方程和流體靜力學平衡方程解算了吸引項格林函數，討論各種因素對大氣重力和傾斜格林函數及其對重力和傾斜的影響；基於球對稱地球模型，給出了武昌站臺站依賴的大氣重力、傾斜格林函數
  6. The three - dimensional primitive equations were derived for ocean in the condition of turbulence, by using the reynods time average method

    首先在流體動力學和熱動力學的基礎上，應用雷諾時均方程法，詳細推導得到海水在湍流狀態下的三維原始方程。
  7. 3 ) based on the analysis result of equal contact stress curve and the theory of elasto - hydrodynamic lubrication, the expression of the oil film thickness between roller ( or ball ) and orbit are calculated. the simulation result proved that the thickness of oil film is enough for bearing and lubricating

    （ 3 ）基於等接觸應力曲線的求解結果和彈性流體動力潤滑理論，求得滾動體和軌道曲線間的油膜厚度表達式，並通過模擬分析論證了馬達正常工作時這種油膜能滿足承載能力和潤滑的需要。
  8. ( 5 ) conclusion was obtained by the analyzing and studying the mechanics environment of the rock mass and the landslide on right bank : according to the analysis, the present direction of the maximal principle stress was consistent with the present tectonic stress field, the value of the principle stress increased or reduced in special place, and there was tensile stress region at the 2000m or above it on the left bank, the accumulate and adjustment was very limited in 200 years, the calculated result of the landslide indicated that the landslide on the right bank was stable under the various conditions

    （ 5 ）壩址區河谷巖體力學環境及右岸古滑坡體的穩定問題分析得出：河谷巖體應力場的分析顯示，河谷巖體中主應力的方向基本上與現今區域構造應力場的方向一致，在一些特殊地帶巖體的主應力值有所降低或增高，特別是在左岸的2000m高程附近及以上，存在有明顯張應力區。在未來200年流變計算時步范圍內，河谷巖體應力的積累與調整較為有限。同時對滑坡體各種工況條件下的穩定性計算結果表明，右岸古滑坡體在各種工況條件下是處于穩定狀態的。
  9. In this paper, the theory of slender bodies was used to calculate hydrodynamic forces and to numerically simulate the underwater trajectory of supercaviting bodies, the motion stability of supercaviting bodies was analyzed, too

    本文應用細長體理論計算航行體在超空泡狀態下的流體動力，成功類比了超空泡狀態下的航行體水下彈道。
  10. With the increase of volume fraction of sic particles, the flow stress of composites increases. from the compare of the experiment result and the analysis result, the constitute equation of mmcs is given. the penetration experimental equipments and technologies are also introduced

    隨著sic顆粒的體積分數的增加，復合材料流動應力相應增加，並將實驗結果與理論計算結果進行了比較分析，得到反映顆粒增強金屬基復合材料性能的本構方程。
  11. The hydrodynamic and the drift - diffusion models are the most widely used models to describe semiconductor devices today

    在所有描述半導體的數學模型中，流體動力學模型和漂移擴散模型是應用最廣泛的模型。
  12. As one of the several models to improve the drift - diffusion model, the hydrodynamic model plays an increasingly important role in simulating the behavior of the charge carrier in sub - micron semiconductor devices because it can exhibit velocity overshoot and ballistic effects for which are not accounted the classical drift - diffusion model

    漂移擴散模型自上世紀五十年代初一出現，就得到了人們的廣泛關注。但隨著微電子技術的發展，它不能很好的解釋半導體中的有些現象，流體動力學模型就應運而生了。
  13. Based on the hydrodynamic, by using momentum theory to the liquid in the flow channel, the computational formula of the air exciting - vibration force is acquired. by using four - step runge - kutta method, the periodic response results of the elastic rotor system with one single - disc are gained. then the dynamic characteristics of the rotor system at the certain rotate speed and the certain physic parameter of system are analyzed by using the phase spaces and poincare maps of this system

    基於流體動力學，通過對葉片流道內的流體模型應用動量定理，得到此汽流激振力模型，並採用四階龍格庫塔法，得出了單盤彈性轉子系統的周期響應規律，然後根據系統的相軌跡及poincare映射圖，分析了系統在特定轉速及特定的轉子系統參數下的運動特徵。
  14. Three models are proposed as follows by applying the model of " mixed flow " : the stress of increasing fluid on fouling, collision between solid particles and fouling, and solid particles movement velocity ; the effects of operating parameters, properties of particles, and the volume fraction of particles on stress in solid - liquid two phase flow, collision stress between solid particles and fouling, maximal contacting area between solid particles and fouling and maximal contacting time between solid particles and fouling are investigated systematically by calculating and theoretical analysis

    利用「混流」模型，建立了兩相流體的剪應力模型、固體顆粒與垢層的碰撞模型和固體顆粒的運動速度模型；通過計算和理論分析，系統地考察了操作參數、顆粒物性、顆粒體積分率等對固液兩相流剪應力、顆粒對垢層的碰撞力、顆粒與垢層的最大接觸時間和最大接觸面積的影響。
  15. In the thesis the low drag - low noise optimization of the vehicle main form design is realized, main accomplishments are as follows. researched the knowledge of drag and flow noise, the parameters of the boundary layer are calculated by the hess - smith method and boundary layer momentum integral method. the calculation of the length of transition zone and change in boundary layer displacement thickness between laminar and turbulent states in the transition is improved, then the drag coefficient and self - noise from the transition zone are calculated as the objective functions of the optimization

    主要研究內容和成果如下：對航行器繞流流場進行分析，深入研究了阻力和流噪聲產生機理，建立了阻力系數和自噪聲的評估數值計算模型；採用物面分佈源匯法和邊界層動量積分法對繞流流場的流體動力參數進行計算，改進了轉捩區長度和邊界層位移厚度的計算，應用於航行器頭部駐點自噪聲的計算；最後設計了阻力系數和自噪聲數值計算程序模塊。
  16. Based on creep constitutive model of power function, numerical simulation and detailed algorithm applied to the analysis of general fem is presented for the stress and deformation analysis of shuibuya concrete faced rockfill dam

    摘要採用高圍壓下的冪函數流變本構模型進行堆石體應力變形計算，推導該本構模型在三維有限元分析中的具體演算法和實現步驟，對水布埡面板堆石壩進行了考慮堆石流變性的應力應變分析。
  17. Development and application for hydro - lubricating non - contacting spiral groove mechanical seals

    流體動力潤滑螺旋槽非接觸機械密封的發展及應用
  18. But the detail explanation for experiment results requires 2d hydrodynamic and pic simulation with the experiment condition

    要詳細解釋實驗結果，還應該作2d的流體動力學和pic的混合數值模擬。
  19. The analysis and calculations of fluid stresses in a bending pipe

    彎管內的流體應力分析與計算
  20. Based on the review of coupling theory of porous media, a nonlinear mathematics mechanical model and the governing differential equation of the coupled problem of thermal - gas fluid - mechanical are derived from the theory of continuum mechanics and mixture theory. a constitutive equation of the porous media is obtained in the coupling processes

    在全面系統的回顧與總結多孔介質多物理場耦合分析與模擬的研究成果的基礎上，以混合物理論以及流體、應力、溫度相互作用的機理為基礎，建立溫度場、滲流場、應力場三場耦合分析的非線性數學模型。
分享友人
分享到 Line

分享到臉書