流體調節器 的英文怎麼說

中文拼音 [liútǐdiàojiéqì]
流體調節器 英文
fluid conditioner
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 體 : 體構詞成分。
  • 調 : Ⅰ動詞1 （配合得均勻合適） harmonize; suit well; fit in perfectly 2 （使配合得均勻合適） mix; adju...
  • 節 : 節構詞成分。
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 流體 : [物理學] fluid; fluor流體力學 fluid mechanics; hydromechanics; 流體生物學 hydrobiology; 流體運動學 hydrokinematics
  • 調節器 : regulator; adjuster; governor; controller; conditioner; actuator; phaser
  • 調節 : regulate; adjust; monitor; measure; take care of; condition; regulation; adjustment; conditioning...
  1. Pre - data gathering module achieves the collection and communication of sixteen - route temperature signal. speed measuring and controlling module realizes the control of refolw soldering transfer speed by manipulating transducer. on - off outputting module fulfills calefaction control of calefaction tube by solid state relay. above position operator software programs by delphi, and realizes pid parameter automatic timing and no - oversnooting temperature control. software has friendly interface, convenient operation, complete functions

    前置數據採集模塊完成16路溫度信號的採集和通訊；速度測量模塊與速度控制模塊通過控制變頻器來調節迴流焊的傳輸速度；開關量輸出模塊通過固態繼電器對加熱管進行控制；上位機軟體採用delphi編程，實現了pid參數自整定以及無超調的溫度控制。
  2. A white led driver circuit is presented in this paper. the circuit drives up to four white leds with regulated constant current for uniform intensity. by utilizing proprietary adaptive 1x / 1. 5x modes and ultra - low - dropout current regulators, it maintains the highest possible efficiency over the full 1 - cell li + battery input voltage range

    整體電路以恆定電流驅動4隻白光led ，利用1倍/ 1 . 5倍分數型電荷泵和低壓差電流調節器，在整個鋰電池供電電壓范圍內保持最高的效率，並使四個白光led獲得均勻的亮度。
  3. The load current is handled directly by the controller through semiconductor switching devices.

    負荷電流由調節器通過半導體開關元件直接控制。
  4. The principle of the hardware and software has been introd uced, with the circu it d i agram, the flow chart an d list of the program

    介紹本次課題所用的196單片機的原理，設計出數字勵磁調節器的電路，分析裝置的硬體電路工作原理，給出詳細的硬體原理圖，設計運行程序流程圖。
  5. The structure and operating principle of an air - charged split - type adjustable shock absorber was described, e non - linear parameterized mathematical model of this shock absorber ' s damping characteristics was established according to fluid mechanics theory and the main structural affection factors to shock absorber ' s damping performance, such as the diameter of piston valve orifice, the diameter of adjustable orifice, the initial volume of gas chamber, the diameter of piston rod, the inner diameter of oil pipe and so on, were analyzed by simulations

    摘要通過分析一種分體式充氣可調阻尼減振器的結構和工作原理，運用流體力學理論，建立了該減振器阻尼特性的非線性參數化模型，模擬分析了活塞阻尼閥孔徑、阻尼調節孔徑、氣室初始體積、活塞桿直徑、油管內徑等主要結構參數對減振器阻尼性能的影響，通過試驗測試，得到了減振器樣件的阻尼特性及其可調范圍。
  6. The gas feed automation system, which includes field instruments, gas feed controller, wireless remote supervising system, and so on, will realize following functions : gas flow measurement, gas pressure and temperature measurement, gas flow control, gas pressure regulation, intermittent gas lift, wireless remote monitoring, and etc. this paper will discuss the following content in detail : first part is introduction

    該自控系統包括現場變送儀表、氣舉配氣控制器和無線遠程監控等，主要完成天然氣流量計量、氣體壓力溫度檢測、天然氣流量控制、管道干壓調節、間歇氣舉以及遠程監控等功能。本文將會重點介紹以下內容：首先是概述部分，簡要介紹了氣舉採油技術和氣舉配氣系統的地位和現存問題，並介紹了配氣自控系統的主要性能和優點。
  7. A method of fuzzy optimization design based on genetic algorithm is presented as a new method of parameter optimization design for dc double closed loop speed adjusting system. the method covers three steps. firstly, speed overshoot rate and settling time are chosen as performance indice according to the demand of engineering. these indice are normalized by using fuzzy membership function and then weighted to form objective function of optimization model of the system. secondly, the dynamic response curve of the system with corresponding parameters and peoformance indice are obtained by computerized numerical calculation and simulation. finally, parameters of engineering design are expanded as searching space ; and parameters of speed regulator and current regulator are taken as genes in chromosome. these genes in searching space are optimized to get best solution by way of genetic algorithm. as shown by experimental results, the parameters designed by this method are capable of significantly improving performance indice of the system, which proves that it is a practical and effective method

    提出一種基於遺傳演算法的直流雙閉環調速系統參數優化設計方法.根據工程技術的要求，選用速度超調量和過渡時間作為參數優化性能指標.將該指標用模糊隸屬度函數歸一化，再加權平均形成系統優化模型的目標函數.採用計算機數值計算方法，通過模擬獲得系統對應參數的動態響應曲線及其性能指標.最後以工程設計的參數為搜索范圍，以速度調節器和電流調節器的參數為染色體中的基因，通過遺傳演算法在搜索范圍中優化這些基因，獲得優化解.實驗結果表明，所設計的參數能使系統性能指標有顯著提高
  8. The control method was introduced and the hardware of the controller was designed. the controller uses the 89c52 and 89c2051 as the main control unit and produces the on and off and angle signal of each phase. combined with protecting signal and current chopping signal, it can control the igbt on and off

    介紹了srd的控制方式和本系統所採用的控制策略，對控制器的硬體電路進行了設計，控制器以89c52和89c2051雙cpu為主控單元，採用模糊調節，發出相通斷信號和角度信號，並和電流、電壓等保護信號以及斬波信號相結合，實現對主功率元件的通斷控制。
  9. Specification for fluid conditioner fittings in piping applications above 0of

    0of以上的管道設備中流體調節器配件的規范
  10. Specification for electrically operated automatic gas shut - off valves fitted with throughput adjusters, proof of closure switches, closed position indicator switches or gas flow control

    裝有流量調節器閉路開關檢驗閉合位置指示開關或氣流量控制器電動式氣體自動關閉閥規范
  11. The main products of eaglepower are diodes, rectifiers, regulators, ignition modules, alternators, starters and column ecu ( or mcu ) switch control units also namd local interconnect network ( lin ) control units

    本公司的主要產品為二極體、整流橋、調節器、點火模塊、發電機、起動機和汽車內部電路本地網際網路等。
  12. The general transfer functions of pwm converter are developed and the small - signal transfer functions controlled by the duty cycle are given using matlab. the voltage adjuster and the current regulator of the control circuit are designed. the isolated cuk converter is analyzed and the features and the description of the uc3854 are presented in detail

    論文分析了帶隔離變壓器的cuk變換電路，介紹了平均電流型功率因數校正晶元uc3854的結構、功能；根據uc3854的具體特點與要求，以設計一個具體、實用的帶pfc功能的開關電源為例，設計、計算了主電路電感l1 、 l2 、 c1 、 c2 、隔離變壓器以及電壓、電流調節器電路的參數及要求。
  13. Three - phase full bridge controlled rectifier, filter circuit and the common loads " mathematics models are built and analyzed. according to the rate of the transition process, the controlled rectification power supply can be classified into fast response and slow response. based on identification of the transition processes using the slope method, the different fuzzy control strategy is adopted. the control method can meet the requirements of real time control and non - error regulation. the simulation results verify its practibility. after that. the design scheme based on dsp is introduced including the design of hardware and software flow chart. emc is an important aspect which can not neglected, so the designs of emc are summarized including hardware and software

    根據過渡過程的快慢將可控整流電源系統分為快響應過程和慢響應過程，本文在利用響應曲線斜率法辨以過渡過程的基礎上，分別針對快響應過程和慢響應過程採取了相應的模糊控制策略，以滿足快響應過程要求實時控制，快速跟蹤誤差變化，慢響應過程要求精確定位，無差調節的要求，模擬結果驗證了該方法的有效性，進而分析了用dsp實現該調節器的硬體電路和軟體流程的設計思路。
  14. Air conditioners, liquid chilling packages and heat pumps with electrically driven compressors for space heating and cooling - testing and rating at part load conditions

    對流式供暖和製冷用帶有電動壓縮機的空氣調節器液體製冷包和熱泵.部分負載條件下的檢驗和額定
  15. The object to measure and control is the mathematically simulated flux control valve system of underwater vehicles. the software simulated the dynamic change procedure of inner variables through changing control parameters in server port or client port

    測控對象是數學模擬的水下航行器中的流量調節閥系統，通過在測控軟體的服務端或客戶端改變系統的控制參數，模擬該系統的內部變量的動態變化過程。
  16. Based on the analysis and comparison of the peak current - injection mode and average current mode control strategies, the method of designing average current control mode pi regulator is obtained. the digital simulation of the converter has been done with the help of matlab software. the good transient and stable character of the converter is attained while rated load

    在分析與比較峰值電流模式與平均值電流模式控制策略的基礎上，給出平均值電流模式pi調節器的設計方法，利用matlab軟體對變換器進行了數字模擬，證實了變換器在額定功率范圍內動、靜態特性良好；過載情況下變換器具有自動限流、保護主功率器件的特性。
  17. Pneumatic fluid power - compressed air pressure regulators and filter - regulators - part 2 : test methods to determine the main characteristics to be included in literature from suppliers

    氣動流體動力.壓縮空氣壓力調節器和過濾調節器.第2部分:廠商資料應包含的主要特性測定的試驗方法
  18. Pneumatic fluid power - compressed air pressure regulators and filter - regulators - part 1 : main characteristics to be included in literature from suppliers and product - making requirements

    液壓流體動力.壓縮空氣壓力調節器和過濾調節器.第1部分:廠商資料和產品生產要求應包含的主要特性
  19. Standard specification for fluid conditioner fittings in piping applications above 0 f

    溫度大於零華氏度的管道用流體調節器配件
  20. The mixed control chip sg3525a combined with hardware pi controller generates the high - frequency pwm pulse for the first inverter. the digital control block tms320lf2407a mainly provides current preset for constant - current source through the outer filter, pwm pulse for the second inverter and drive signal for the high - frequency pulse power supply

    其中變極性電源的一次逆變pwm信號由pwm發生晶元sg3525a ，配以外部硬體電路pi調節器產生;一次逆變閉環控制迴路的電流給定（配以外部濾波） 、二次逆變pwm驅動以及高頻脈沖電源的控制則由tms320lf2407a數字控制器實現。
分享友人
分享到 Line

分享到臉書