浮力修正 的英文怎麼說

中文拼音 [fúlìxiūzhēng]
浮力修正 英文
buoyancy correction
  • 浮 : Ⅰ動詞1 （漂在液體表面） float; drift 2 [方言] （在水裡游） swim Ⅱ形容詞1 （在表面上的） superfici...
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 修 : Ⅰ動詞1 （修飾） embellish; decorate 2 （修理; 整治） repair; mend; overhaul 3 （寫; 編寫） write;...
  • 正 : 正名詞（正月） the first month of the lunar year; the first moon
  • 浮力 : [流] buoyancy; buoyant force; buoyance; floatage; rising force; buoyancy force浮力參數 [流] buoya...
  1. The instability in the natural convection boundary layer initiates with the buoyancy eigenmode and develops into non - linear stage with the turbulization of the buoyancy eigenmode. in the mean time, the invisid eigenmode at the inflexion point appears and begins to increase at the outer layer. experimental results show that the turbulent layer near the maximum velocity point can be detected while the reformed grashof number

    自然對流邊界層的穩定性由浮力振型失穩開始，並隨著浮力振型的湍流化進入非線性階段，與此同時，無粘性振型在外層開始失穩。實驗結果表明，修正格拉斯霍夫數grashof
  2. In this paper, the standard three - dimensional k - two - equation turbulence model which modifies the item of buoyant effect and simple algorithm are adopted, wall functions are used to deal with the boundary condition and a simplified method - box method is used to model the supply air boundary condition

    本文數值計算採用經過浮升力項修正的k -兩方程模型和simple演算法，壁面邊界條件採用標準壁面函數，風口邊界條件採用盒子方法。廠房內的氣流運動主要受風口出流動量的制約，因此選擇合理描述入流邊界條件的風口模型對數值模擬至關重要。
  3. In this article, simulations of air distribution in the vav air - conditioned office are carried out in the cases of different air - supplying diffusers including slot diffuser, sqaure grille, bar grille and square diffuser to supply air, the standard three - dimensional k - ? two - equation turbulence model with correctional item of buoyancy effect and simple algorithm are adopted, and wall function method is used to handle boundary conditions

    本文採用經過浮升力項修正的-兩方程模型和simple演算法，應用壁面函數法處理邊界條件，對利用包括條縫風口、方型百葉風口、長條型百葉風口和方型散流器不同型式送風口送風的變風量空調房間內的氣流組織進行了模擬。
  4. From the measured mass, the volume can be determined with a knowledge of water density and corrections for air buoyancy and thermal expansion of the vessel. the volumetric method requires a standard ( calibrated ) volumetric measure

    重量分析測定法測定一個測試量器所載或所出的水的質量。從量得的質量，加上水的密度，空氣浮力及容器的熱力膨脹修正，便可測定容量。
  5. Author considers that munk - anderson ' s modification is not suitable to simulate the buoyant flow in reservoir, and suggests the turbulent prandtl number as the constant of 0. 85 in the water temperature model of reservoir

    本文認為該修正模型並不適用於水庫浮力流的模擬，建議在大型深水庫水溫模型中溫度普朗特數採用常值0 . 85 。
  6. And flux distributions and radial force of an induction type bearingless motor is analyzed employing the finite element method. relationships between the radial force and radial force winding currents are influenced by magnetic saturation. it was shown that the generated radial force reaches its maximum value due to magnetic saturation

    首次運用有限元方法對該電機進行了深入的研究，充分展現了無軸承異步電機特有的氣隙磁場分佈、驗證了穩定磁懸浮力產生的條件、指出了磁飽和對磁懸浮力的影響、利用有限元方法修正了磁懸浮力數學模型。
分享友人
分享到 Line

分享到臉書