浸析 的英文怎麼說

中文拼音 [jìnxī]
浸析 英文
leaching
  • 浸 : Ⅰ動詞1 （泡在液體里） soak; steep; immerse 2 （液體滲入） soak; saturate; steep Ⅱ副詞[書面語] （...
  • 析 : Ⅰ動詞1. （分開; 散開） divide; separate 2. （分析） analyse; dissect; resolve Ⅱ名詞（姓氏） a surname
  1. The analysis results show that the technical code for sanitary landfill in china would satisfy the antipollution request of surrounding site and groundwater, on condition that the water level in landfills is limited to a small value

    分析結果表明，我國的衛生填埋技術規范對填埋場襯墊的要求是可行的，但還需限制填埋場內的滲濾液浸潤線水頭高度。
  2. First, a simple discussion for the mechanism about electrostatic atomization of the liquids has been given ; then the paper theoretically analyzed waving course, liquid drop producing course, and the liquid drop diffusing course in electrostatics atomization process., gave an analysis about the methods about carrying charges to the liquid drop, and analyzed that liquid with high electrical conductivity can be carried charges and atomized by electric field, while the isolated liquid with low electrical conductivity can be charged fully with the soakage electrode and inducing charge methods. at last the paper designed and configured the experimental equipment, conducted the atomization experiment to the three liquid medium - kerosene, emulsifier and alcohol under the same environment, handled the experimental results, then summarized the relationship between liquid electrostatic atomization effect and liquid surface tension, electronic conductivity and viscosity, along with the influence of voltage to electrostatic atomization and so on, found out the liquid atomization rule in high voltage electrostatic field

    首先，對液體介質的靜電霧化機理作了初步的探討，理論上分析了液體霧化過程中射流區、波紋區、霧滴區和霧滴擴散區;然後對液體荷電方法進行了研究分析，對于高電導率的液體，場致荷電和接觸荷電可以使其霧化，而對于電導率較低的絕緣液體，需用浸潤電極荷電和感應荷電方法使其充分帶電;最後，根據前面的研究分析，設計和組裝試驗裝置，在同一環境下對煤油、乳化劑、酒精三種不同液體介質進行高壓靜電霧化試驗，並對試驗結果進行分析處理，總結出液體靜電霧化與液體表面張力、電導率和粘度的關系及電壓對液體靜電霧化的影響等，得出高壓靜電場中液體霧化的一般規律。
  3. Measurement and analysis of multi - frequency electrical impedance in crus after long time seawater immersion

    長時間海水浸泡下小腿多頻電阻抗測量與分析
  4. The genomic dna are extracted from alcohol steep sample of tachinidae ( diptera ), by the analysis of experimental results, show that the method is feasible

    目的提出了一種有效的酒精浸泡的雙翅目寄蠅科昆蟲基因組dna的提取方法，通過對實驗結果的分析，表明該方法可行。
  5. The chemical analysis of the soil extracted solution has shown that the soluble salt in the soil is predominated by the divalent ions ca2 + and mg2 + which mean that the soil aggregates have been chemically stable during the field experiment

    同時，對土壤浸劑液的化學成分的分析結果表明，浸提液中二價的鈣、鎂離子占優勢，這使土壤微團聚體處於一種化學穩定的狀態。
  6. Analysis on the epigenetic reducing conditions of neogene in - situ leachable sandstone uranium deposits in baicheng - kailu area of songliao basin

    開魯地區新近系地浸砂巖鈾成礦後生還原條件分析
  7. Some main results of testing research were as fellows : i. in the course of testing of leaching zinc dross, leaching zinc dross by sulfuric acid was researched and the effects on the leaching rate of the zinc dross were analyzed by author, the optimum conditions of leaching testing of zinc dross were determined as fellows : liquid - solid ratio 6 : 1, stirring ratio 250r / min, granularity 120 mesh, the soaking time 5h, the concentration of sulfuric acid of 30 %, and under these conditions, the rate of leaching zinc is above 92. 0 %. ii. in the course of testing of purification, on the basis of comprehending and comparing all present methods of the manganese - removal and iron - removal, the oxidizing method of manganese - removal in zinc sulfate solution using ammonium persulfate was put forward and the oxidizing method of iron - removal in zinc sulfate solution using the goethite process and oxidation - hydrolysis process was adopted

    研究的主要結果具體如下： 1 、研究了硫酸浸出鋅浮渣並分析了影響浸出率的各種因素，確定了浸出鋅浮渣的最佳條件為：液固比為6 ： 1 ，攪拌速度為250r min ，粒度為- 120目，酸浸時間為5 . 0h ，硫酸濃度30 ，鋅浮渣的浸出率大於92 . 0 ； 2 、在綜合和比較了目前除錳和除鐵的各種方法基礎上，提出了過硫酸銨氧化除錳方法和選擇了針鐵礦-氧化水解聯合法除鐵方法，並分析和討論了影響除錳率和除鐵率等各種因素，確定了除錳的條件為：溫度90 ， ph值5 . 4 ，反應時間3h ，過硫酸銨達到理論值的1 . 2倍，除錳率超過99 . 86 ；聯合法除鐵的條件為：氧化反應時間1 . 5小時、溫度控制在90 92 、 ph值5 . 2 5
  8. Virtual machining is a very important part in systematized techniques about virtual manufacturing. it requests an immersible 3d virtual machining environment which supplies panoramic, integrated simulation and analysis for the processing of product so as to evaluate the rationality of machining process parameters and the machining quality of product

    虛擬加工是虛擬製造技術體系的重要組成部分，它要求有一個具有一定沉浸感的三維可視化虛擬加工環境，並能對產品加工提供全方位的、集成的模擬分析，以對工藝參數的合理性、產品的加工質量等做出評價。
  9. Meanwhile, solid immersion lens is also applied to focus femtosecond laser pulse in three - dimensional optical data storage

    分析和闡述了固體浸沒透鏡應用於飛秒脈沖激光三維光存儲系統中的可行性及優點。
  10. The optical near - field distribution and propagation properties of solid immersion lens system are analyzed in detail when illuminated by linearly polarized focusing gauss beam. the change of the optical intensity and beam dimension at the bottom of solid immersion lens with different refractive index and different distance are discussed. the simulated results reveal that the higher the refractive index is, the stronger the optical intensity and the smaller the beam dimension at the bottom of the solid immersion lens will be

    編制了對固體浸沒透鏡近場超高密度光存儲系統進行模擬的二維時域有限差分程序，實現了對固體浸沒透鏡光存儲系統的數值模擬；著重研究了線偏振的高斯光束通過固體浸沒透鏡的光傳輸和近場光場分佈特性；分析了固體浸沒透鏡底面出射光強、光斑直徑隨固體浸沒透鏡折射率的變化、光透過固體浸沒透鏡后的強度、光斑直徑隨離開固體浸沒透鏡底面距離的變化。
  11. The control system of furnace " s temperature has been widely used in every walk of life, as an important link of repair and manufacture of the electrical equipment such as electromotor transformer etc., soaking lacquer drying craft has some especial requests on drying crafto this article starts with the analysis of drying chamber " s configuration, analyzed its configuration limitation and control function limitation according to the factory " s situation and advances the conception of heated air drying circulation, in addition, this article adopts an intellectualize a / d module, a development sampling tuning - voltage circuit, and presents the method to measure online the insulation resistance of products in order to improve constantly products quality

    而浸漆乾燥工藝作為電機、變壓器等電氣設備的修理、製造中的重要環節之一，對乾燥過程的質量要求有一定的特殊性。該文從乾燥爐的結構分析入手，聯繫到工廠的實際情況分析了結構功能缺陷和控制功能缺陷，提出了熱風循環乾燥的概念，同時，選擇了較為先進的a d板卡、熱電阻信號調理板等專業化智能卡，運用數字pid控制技術，構成了一個較有特色的計算機控制系統。此外，該文還從保證乾燥品質量的角度，採用智能化交流模塊和自製采樣調壓電路的方法，提出了在線檢測產修品的絕緣電阻的方法和手段，以確保企業產品質量不斷提高。
  12. Carbon absorption system, coagulation flocculation system, maceration, filter - cartridge, filter - packed bed, floatation unit, grease trap, grit removal, mixer, oil interceptor, oil water separator, screen intake, sedimentation system, uv steriliser

    絮凝系統、浸析、過濾筒、過濾填充床、浮起設置、隔油池、除砂器、混合器、截油器、油
  13. Carbon absorption system, coagulation flocculation system, maceration, filter - - cartridge, filter - - packed bed, floatation unit, grease trap, grit removal, mixer, oil interceptor, oil water separator, screen intake, sedimentation system, uv steriliser

    絮凝系統、浸析、過濾筒、過濾填充床、浮起設置、隔油池、除砂器、混合器、截油器、油
  14. Productive exploration of ion - type rare earth ore by in - situ leach mining

    離子型稀土礦原地浸析采礦的生產勘探
  15. Wood preservatives - accelerated ageing of treated wood prior to biological testing - leaching procedure

    木材防腐劑.進行生物試驗之前處理木材的加速老化.浸析程序
  16. Phenomena of stope slide in in - situ leaching of ionic type rare - earth ore are described, their causes analyzed and several measures for slide prevention suggested, which are of practical guiding significance to the mining by in - situ leaching of ionic type rare - earth ore

    介紹了離子型稀土礦原地浸析采礦時采場滑坡的幾種現象，分析了各種滑坡現象產生的原因，並提出了預防滑坡的多項對策，對實施離子型稀土礦原地浸析采礦具有實際指導意義。
  17. Characterisation of waste - leaching - compliance test for leaching of granular waste materials and sludges - one stage batch test at a liquid to solid ratio of 10 l kg for materials with particle size below 10 mm without or with size reduction

    廢棄物的特性.浸析.顆粒廢棄物和污泥浸析的一致性試驗.粒徑小於10mm材料在液體固體比為10 l kg時的一級分批試驗
  18. Characterisation of waste - leaching - compliance test for leaching of granular waste materials and sludges - one stage batch test at a liquid to solid ratio of 10 l kg for materials with particle size below 4 mm without or with size reduction

    廢棄物的特性.浸析.顆粒廢棄物和污泥浸析的一致性試驗.高固體含量和粒徑小於4mm的材料在液體固體比為10 l kg時的一級分批試驗
  19. Characterisation of waste - leaching - compliance test for leaching of granular waste materials and sludges - one stage batch test at a liquid to solid ratio of 2 l kg for materials with high solid content and with particle size below 4 mm without or with size reduction

    廢棄物的特性.浸析.顆粒廢棄物和污泥浸析的一致性試驗.高固體含量和粒徑小於4mm的材料在液體固體比為2 l kg時的一級分批試驗
  20. Characterisation of waste - leaching - compliance test for leaching of granular waste materials and sludges - two stage batch test at a liquid to solid ratio of 2 l kg and 8 l kg for materials with a high solid content and with a particle size below 4 mm without or with size reduction

    廢棄物的特性.浸析.顆粒廢棄物和污泥浸析的一致性試驗.高固體含量和粒徑小於4mm的材料在液體固體比為2 l kg和8 l kg時的二級分批試驗
分享友人
分享到 Line

分享到臉書