混凝土支架 的英文怎麼說

中文拼音 [húnníngzhījià]
混凝土支架 英文
concrete support
  • : 混形容詞1. (渾濁) muddy; turbid2. (糊塗; 不明事理) foolish; stupid
  • : 動詞1. (凝結) congeal; curdle; coagulate 2. (注意力集中) fix
  • : Ⅰ名詞1 (分支; 支派) branch; offshoot 2 (地支) the twelve earthly branches3 (姓氏) a surname...
  • : Ⅰ名詞1 (用來放置東西或支撐物體等的東西; 架子) frame; rack; shelf; stand 2 (毆打; 爭吵) fight;...
  • 混凝土 : concrete; beton; jetereting混凝土壩 concrete dam; 混凝土板 concrete slab; 混凝土標號 concrete gra...
  • 支架 : support; stand; trestle; holder; rack; tressel; spur; sting; husk (hoose); buck; undercarriage
  1. To study the flexural behavior, ultimate bearing state and laws of internal force redistribution of prestressed concrete continuous beams cast by different construction methods, the model tests for three pieces of the continuous beams were carride out, in which three kinds of the construction methods, such as those of lowering formwork supports at one time, transferring simply - supported structure into the continuous one and casting the beam by cantilever construction, were considered

    摘要為研究不同施工方法下預應力連續梁的彎曲性能、極限受力狀態及內力重分佈規律,進行了3根連續梁模型試驗,分別考慮一次落、簡變連續和懸臂施工3種施工方法。
  2. For reinforcement concrete corbel with the shear span to depth ratio ( a / ho ) less than 1, has its performance of mechanics that is close to cantilever deep beams, it is an important kind of components in architectural structure which sustains roof trusses, brackets, tray " beams, frame " beams, wall " beams and crane " beams

    剪跨比a h _ 0 1的短鋼筋牛腿,其受力性能接近於懸臂深梁,在建築結構中是承屋、屋面梁、托、托梁、框梁、墻梁和吊車梁等的重要構件。
  3. Corrosion may have played a role here as well : the minneapolis bridge ? what ' s known as a deck steel truss bridge ? was a concrete roadway supported by gridwork of steel

    金屬的銹蝕也許在這些事故中扮演者某種角色:明尼阿波利斯橋是一座鋼板桁橋,也就是有鋼格來橋面。
  4. Supports for overhead lines. reinforced concrete poles. specification

    空線.鋼筋電桿.規范
  5. Supports for overhead lines. prestressed concrete poles. specification

    空線用.預應力電桿.規范
  6. Fixed railway installations. equipment for overhead telecommunication and signalling lines. bracing collars for reinforced concrete posts

    鐵路固定裝置.通訊和信號裝置空線路用器材.鋼筋電桿撐卡箍
  7. Steel products. bars with improved bond for concrete poles, supports for over head lines

    鋼製品.空線路電桿用帶改進粘附性的棒材
  8. On the contents of two sides abovementined, this paper attempts to do some initial researches from three angles as follows : 1, the analyses of anti - seismic features on longitudinal direction of the aqueduct l ) the seismic longitudinal effects are small. the vibrant characters are decided from the structure integration and rigidness of piers and main arch - ring of the aqueduct, so the following measures should be taken in order to weaken and isolate seismic influence : properly broadening the section sizes and adopting the high class concrete, lowering the height and barycenter of building, setting hoop steel bars so as to increase the plasticity of the concrete which can absorb the seismic energy and prevent the damages due to stress centralization on the linkages and changing place

    本文試圖就上述的這兩大方面的內容,從以下三個角度進行了初步研究: 1 、縱槽向抗震性能分析1 )湯峪河吊桿拱承結構的縱槽向地震效應較小;吊桿式拱結構動力特性取決于槽墩和主拱圈的剛度,以及結構的整體性,故適當加大構件截面尺寸或提高砼標號,盡量降低結構的建築高度和重心,在構件連接和變截面處增設梗脅,按照約束的要求來加強箍筋的配置,增加砼的延性,以克服地震時構件連接和變截面處的應力集中造成的坡壞,並吸收大量的地震能量,從而起到隔震,減震的效果。
  9. The effect of pouring arch circle to support ' s deformation is studied. the pour sequence of main arch circle is laid down by the principle that support ' s deformation is minimal in the process of pouring concrete

    研究了拱圈澆注對變形的影響關系,遵循分段灌注順序應使灌注過程中變形幅度最小的原則,制定了主拱圈灌注順序。
  10. Products made of magnesium oxychloride concrete used in mines. technical condition of arch support

    礦用菱鎂製品.拱形技術條件
  11. The main suspension gallows consist of a steel box beam, sitting on hydraulic jacks that support all the structure during concreting

    主吊有一鋼箱梁組成,坐落在液壓千斤頂上,在澆注過程中撐所有結構。
  12. The whole system is supported by the main jack arrangement when concreting, placed at the front supporting bracket and the ( rear ) suspension gallows ? or on supporting brackets only at the start and expansion joint spans

    整個系統在澆注過程中由前牛腿及(后)吊上主千斤頂系統撐,在起始段和伸縮縫處則在前後牛腿處撐。
  13. Firstly, for the system of moulding board and support frame in construction the side pressure and screws are analyzed. the material and structure form of support frame are discussed. the design of support frame uses the method of limited state, and also it analyses the integer stability, part stability, and single stability, and then proposes the load analysis of multi - level support frame

    首先,針對轉換層梁模體系及施工,重點分析了轉換層結構現澆對模板側壓力值及模板對拉螺桿的計算;討論了轉換層撐體系的形式及構造,詳細論述了基於極限狀態設計的計算方法,包括縱橫向水平桿的強度驗算、立桿的整體穩定性、局部穩定性、單肢桿件穩定性等驗算,並提出了多層的施工荷載計算方法。
  14. Scaffolding construction of concrete filled steel tube arch bridge with no wind - support system

    無風撐鋼管拱肋的施工
  15. On the base of researching lots of information, the author particularly analyzes and compares the technique and economic index of steel residence and traditional structural system - rc structure to reflects the steel residence ' s good overall economic benefit by concrete datum from the material cost, effective service area and the construction ' s speed etc. discuss the optimum structural system of different scale of earthquake. the theory and example illustrate that when high steel residence has great horizontal load, the frame - prop structure is optimum

    在大量資料研究的基礎上,作者進行了一個六層住宅建築實例的技術性與經濟性分析比較,該建築分別採用鋼結構和傳統結構體系? ?鋼筋結構,通過具體數字,從結構主材造價、有效使用面積、施工速度等幾方面反映鋼結構住宅建築的綜合經濟效益好,討論了不同地震烈度下兩種結構的優化體系,理論、結構分析算例和此實例分析都說明了有較大水平荷載時,多、高層住宅鋼結構宜採用鋼框? ?撐結構體系。
  16. Under the supporting of the natural science foundation of china, " a study on the earthquake vulnerability and failure dependence of the building structures based on the push - over analysis ( 50178064 ) ", in this paper, it was studied the elastic - plasticity random response and the failure dependence of the rc structures, and some conclusions were obtained : 1

    在國家自然科學基金項目「基於靜力彈塑性分析的建築結構地震易損性及失效相關性研究」 (項目編號: 50178064 )的持下,本課題利用pushover方法對鋼筋結構進行了彈塑性隨機反應統計分析,研究了框結構在小震和大震作用下的失效相關性問題,並得出了以下幾點結論: 1
  17. Based upon the experimental research and nonlinear finite element calculation, and the analysis of joint failure modes, a set of formula was proposed to predict the ultimate bearing capacity of cfrst joints : 1 ) the ultimate bearing capacity of t -, y -, x - compression joints and k - compression branch joints can be predicted according to the failure model of transverse local compression

    基於試驗研究和非線性有限元數值計算,通過對矩形鋼管節點各種可能破壞模式的分析,提出了矩形鋼管節點承載力計算的破壞模式和相應計算公式: t 、 y 、 x型受壓節點和k型受壓管節點承載力按橫向局部承壓破壞模式進行計算。
  18. 4 ) the ultimate bending capacity of cfrst joints can be considered as branch tube flange effective width failure mode

    對于矩形鋼管受彎節點承載力可按管受拉翼緣有效寬度破壞模式計算。
  19. In this paper, two steel bracing - retrofitting methods are proposed for the rc frame structures, which are steel angels - at - four - corners method and embedded - steel framework method. two test models of one - story and two - bay reinforced concrete frame retrofitted with above two methods separately are designed and conducted low - cyclic reversed load tests, their aseismic behaviors such as strength, stiffness, ductility and energy - dissipating capability are studied

    本文提出了兩種撐抗震加固方法,即外包鋼撐加固法和鋼內框撐加固法;設計了兩榀單層兩跨鋼筋結構試驗模型,進行了水平低周反復荷載試驗,重點探討其強度、剛度、延性和耗能能力等抗震性能。
  20. The test results show that : the above two steel bracing - retrofitting methods can improve the lateral stiffness and energy - dissipating capacity of the existing frame structure effectively ; the adopted connection configuration can transfer the force of steel braces to existing frame effectively : retrofitting existing rc frame structures with steel braces while the members adjacent to the steel braces be retrofitted can meet the requirements of aseismic design code

    試驗表明,兩種撐加固方法都能顯著提高結構的抗側剛度,有效改善結構的耗能能力;所採用的撐連接構造可靠,能有效地傳遞撐的內力;採用鋼撐加固鋼筋結構時,可僅對與鋼撐相關的構件進行加固,整體結構能滿足《規范》要求。
分享友人