渦流溫度計 的英文怎麼說

中文拼音 [guōliúwēndùjì]
渦流溫度計 英文
vortex thermometer
  • 渦 : 渦名詞1. （漩渦） eddy; whirlpool; vortex 2. （酒窩） dimple
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 計 : Ⅰ動詞1 （計算） count; compute; calculate; number 2 （設想; 打算） plan; plot Ⅱ名詞1 （測量或計算...
  • 溫度計 : [物理學] thermometer; thermograph
  • 溫度 : [物理學] temperature
  1. Haibo huang ( mechanical engineering ) directed by jianzhong xu cooling techniques in turbine have become more important since the extra high inlet temperature in turbine

    隨著渦輪前溫度的提高，渦輪葉片的冷卻技術變得十分重要。渦輪葉片中流/熱耦合計算成為必不可少的熱環境分析手段。
  2. There are five parameters need to be measured. there are five channels for input : the displacement of casting - roller, the rotate speed of casting - roller, the pressure of casting and rolling, the casting temperature and the water - speed of cooling water. they are measured by raster, photoelectric coder, strain pressure sensor, thermocouple and turboflowmeter

    系統需要進行監測的參數有五個，即有五路輸入信號：鑄輥位移、鑄輥轉速、鑄軋壓力、澆鑄溫度、冷卻水流速，分別採用光柵、光電編碼器、應變式壓力傳感器、熱電偶和渦輪流量計作為檢測元件。
  3. The paper establishes mathematics model of electromagnetic heating system of eddy current field and temperature field, and gives corresponding discrete format with elements as eight nodes, hexahedron equal cell, through calculating eddy - current field to gain the internal heat source that the temperature field needed, to use discrete method to solve the problem of induction - heating part ' s temperature field by axial symmetrical electromagnetic, and then to analyze the characteristic of instantaneous temperature field

    本文建立了電磁加熱系統的渦流場和溫度場間接耦合的數學模型，分析了不同頻率下渦流和溫度的分佈情況，並以八節點六面體等參元為例給出了渦流場對應的離散格式，通過計算渦流場獲得溫度場所需要的內熱源強度，加熱部件的溫度場以軸對稱格式進行離散求解，並對瞬態溫度場有限單元法的求解特點進行了分析。
  4. The intelligence vortex flowmeter system is consisted of vortex sensor, temperature sensor, pressure sensor, lcd module and master controller, etc. the master controller uses a single - chip computer to collect, analyze, compute and compensate the signals of all sensors, and gets the needed data, then displays all data via the lcd

    智能渦街流量計系統由渦街傳感器、溫度傳感器、壓力傳感器、液晶顯示模塊、主控制器等幾個部分組成。主控制器使用單片機對各個傳感器的信號進行採集、分析、計算，並進行補償，得到所需數據，再將各種數據送到液晶顯示器顯示。
  5. The simulations results show that the spoiler is available to make the fuel and the oxidizer coming from the former to stay in the cavity for a long time, to let the fuel and oxidizer mix and burn completely. since there is a high temperature zone forming by vortex in the middle of the motor, it required a restricted thermal protection. the plate with holes decreased the vortex function in the cavity, which could not promote the combustion efficiency, but to decrease temperature in the cavity and be benefit to thermal protection of the wall

    計算結果分析表明:擾流板可以使燃料和氧化劑在擾流腔內的滯留時間加長，促進燃料與氧化劑的摻混燃燒，提高燃燒效率，但由於渦流在發動機的中間部位形成了高溫燃燒區域，致使局部燃料和絕熱層燒蝕速率增大，加大了熱防護的難度;孔板結構減弱了擾流腔內迴流區的漩流作用，不能增加推進劑燃燒效率，但可以使擾流腔內的溫度降低，給壁面熱防護帶來好處。
  6. In chapter 3, the mathematical modal of electromagnetic and temperature fields is presented by a complex magnetic vector potential, which is also applied to solve eddy current field in ansys software. then, the electromagnetic field analysis, thermal analysis and coupled - field analysis in ansys are introduced

    第三章：介紹了ansys中引入復矢量磁位計算電磁場、渦流場的方法以及溫度場求解的數學模型，簡述了ansys軟體中的電磁場、溫度場以及耦合場分析。
  7. Refined grids were utilized in a large - eddy simulation model for obtaining high - resolution planetary boundary data and analyzing surface layer turbulence. simulation results showed that refined meshes reduced turbulent contributions of subgrid scales, sensitivity of simulation results to sgs parameters decreased, and features of the whole boundary layer were explicitly resolved better. results also revealed flux - profile relationship correctly in surface layer and a good agreement of turbulent velocity characters with observation. therefore, it concluded that the les method was able for simulation of surface layer flow and turbulence, and might be used for further applications

    採用加密網格的大渦模式獲取邊界層風溫場的高解析度模擬結果，並據以分析近地面層大氣的湍流特性。結果表明，較小的網格尺度使次網格湍流貢獻率大為降低，模式計算結果對次網格參數的依賴性減小，邊界層整體特徵得到更好的反映。同時，模擬出的近地面層通量廓線關系及湍流速度特徵與實際觀測結果吻合甚好，表明模式具有反映近地面層平均運動和湍流特性的能力。
  8. In order to get the temperature distribution of the turbine blades, the usually method was to simulate flow fields and temperature fields for solid area and liquid area respectively, then coupled on the interface of the solid and liquid. this was mainly because the control equations were different between liquid and solid

    為了獲得渦輪葉片的溫度分佈，通常的做法是將計算域分為固體區域和流體區域，對這兩個區域分別進行計算，然後在固體和流體的交界面上進行耦合，這主要是因為流體和固體的控制方程是不同的。
  9. I setted up the physical modele and calculation - domain for the conviction heat transfer enchancement by the longitudinal vortex, and did the numerical value simulation for the chang of the velocity filed and temperature filed which influnced by lvg. at the same time, i studied the generation develepment of the longitudinal and its mechanism for the heat transfer enchancement. by the analycise of the result, i got the pricipium rule of how the size, ratio corner and distence of the lvg have influence on the generation and develepment of longitudinal vortex, and gave out the relative construct parameter scope

    通過對phoenics軟體進行應用開發，本文建立了渦旋強化換熱的物理模型和計算域，對擾流元作用下的流動速度場和溫度場的變化進行了數值模擬，研究了縱向渦旋發生發展及其強化對流換熱的機理。初步得出了擾流元的有關結構參數如總體尺寸、寬高比、攻角、間距等因素對渦流發生發展的影響規律，並給出了有關結構參數的取值范圍。
  10. Calculating the distribution of losses in stator strands based on the eddy current distribution coefficient method. it shows that results from this method and the traditional method are nearly same. so, the average method can be applied to calculate the temperature field

    研究結果表明，採用渦流分佈系數法和傳統所採用平均法計算損耗進而得到的溫度場真實分佈基本相同，可在工程中採用更為簡便的渦流平均法計算損耗和溫度場。
  11. Based on the exhaust heat data of the iurbine ( 6160a - 12 ) and the micro gas turbine produced in japan, parameters of test - bed such as deferent thermal flow temperature and pressure are defined by the calculation of design parameter in method of combined theory and experience data

    以柴油機（ 6160a - 12 ）和日本的微型燃氣渦輪機尾氣參數為設計基礎，通過理論和經驗數據相結合的方法進行設計參數計算，確定了模擬實驗臺熱流量、出口溫度及壓力等參數。
  12. After analyzing the present situations of flowmeters, applications of single - chip computers in flow measurement meters, and the development trends of flowmeters, we ' ve designed an advanced intelligence vortex flowmeter, which can display the results on - the - spot ( includes instantaneous flow, total flow, temperature, pressure, and surplus capacity of the cell ), communicate with the upper computers through the serial port and realize automatic copying meters

    本論文通過對現有流量計及單片機在流量檢測儀表中的應用現狀的分析，結合流量計的發展趨勢，設計了一種先進的智能渦街流量計，它能現場顯示測試結果（包括瞬時流量、累計流量、溫度、壓力、電池剩餘容量） ，並且通過串口可與上位機通訊，實現自動抄表功能。
  13. To analysis the heat environment in the turbine, it ' s required to couple a flow solver with a conduction heat transfer solver

    本文從實驗和計算的角度對渦輪葉片中的流場、溫度場耦合進行了研究。
  14. Use electromagnetic finite element method to analyze the distribution of eddy current field with different power supply, then to research that the temperature and distribution of ferromagnetic material can improve the control of electromagnetic and electrothermal field greatly. there into the research of the theory and computation of electromagnetic field act on other physical field is the foundation of the application of magnetic technology, and it is also one of the hot - spot topics in circles researching electromagnetic field

    利用電磁場有限元法分析渦流場在不同電源激勵下的分佈，進而研究鐵磁材料中的溫度及其分佈可以大大提高對電磁場和對電熱場的控制，其中電磁場和其它物理場綜合作用理論和計算的研究是相關磁技術應用的理論基礎，也是近年來電磁場計算應用的難點課題。
  15. Calculation of stator temperature field of generator based on

    基於渦流分佈系數法的發電機定子溫度場計算
分享友人
分享到 Line

分享到臉書