渦流磁場 的英文怎麼說

中文拼音 [guōliúchǎng]
渦流磁場 英文
eddy current magnetic field
  • : 渦名詞1. (漩渦) eddy; whirlpool; vortex 2. (酒窩) dimple
  • : Ⅰ動1 (液體移動; 流動) flow 2 (移動不定) drift; move; wander 3 (流傳; 傳播) spread 4 (向壞...
  • : 名詞1. [物理學] (磁性; 能吸引鐵、鎳等的性質) magnetism 2. (瓷) porcelain; china
  • : 場Ⅰ名詞1 (平坦的空地 多用來翻曬糧食 碾軋穀物) a level open space; threshing ground 2 [方言] (...
  • 磁場 : [物理學] (傳遞運動電荷或電流之間相互作用的物理場) magnetic field
  1. As a result, the electromagnetic field intensity is changed accordingly and fluctuating current in the damper coil is created. damping force is mostly produced because of the phase difference between fluctuating current and displacement of rotor. the formulas of fluctuating current and damping coefficient are deduced theoretically, and the calculated results are consistent with the experimental results

    通過分析發現電阻尼器線圈內由於轉子動時變化的而產生的波動電與轉子位移間的相位差是產生阻尼的主要原因,推導了波動電、阻尼系數的計算公式,並通過實驗展示了被動式電阻尼器的阻尼效應。
  2. Fem analysis of the internal magnetic field and inductance of cylindrical conductor by accounting for the skin effect and eddy currents

    考慮趨膚效應和效應的柱形導體內部和內部電感的有限元分析
  3. The flow visualization indicates the primary cause of the phenomena to be a combination of mass transport and vortical structures induced by strong paraelectric and peristaltic electrohydrodynamic ( ehd ) body forces on the flow. the main jobs of this paper can be generalized as follow : 1

    動顯示結果表明了該實驗現象的初步原因,由於在自洽電中等離子體的電體( ehd )順電力與蠕動力誘導了和能量輸運所致。
  4. Based on researching the shaft bearing replacer, this paper built the models of electromagnetic field and vortex density in bearing race snap being induction heating

    摘要在研究軸承內環感應拆裝的基礎上,建立了感應加熱過程中工件內電分佈的基本方程。
  5. The regularities distribution of the electromagnetic field and vortex density had been simulated by the software matlab, the results of simulation not only proved the existence skin effect but also provided theory evidence for designing and researching of the shaft bearing replacer

    通過matlab軟體對被加熱工件進行了電分佈的計算機模擬,形象描述了工件內電的分佈規律,證明了集膚效應的存在,為軸承感應拆卸裝置的設計研究提供了理論依據。
  6. In order to improve the efficiency of the permanent canned - motor pump, and decrease electromagnetics effect of the liners in designing the permanent magnet canned - motor pump. the main parameters of the permanent canned motor pump have been calculated with the finited element method, the eddy - current of the liners also have been studied deep and systematically in this dissertation

    為提高永屏蔽電泵的效率,減少永屏蔽電泵設計中屏蔽套電影響問題,本文對永電泵電進行了有限元分析,計算了主要參數,對屏蔽套的問題進行了分析研究。
  7. Numerical analysis of the electromagnetic field caused by the eddy - current transducer the dissertation calculates the field caused by the solenoid coil with a finite - length ferrite core carrying time - harmonic current by the finite element method

    二、傳感器電數值分析本文採用有限元數值分析方法計算了含有有限長芯的放置式線圈的屯
  8. Based on the magnetic field data, this paper presents a double - frequency method to separate eddy current lossand hysteresis loss from iron loss, then different methods are used to calculate the two losses separately

    計算所得數據的基礎上,本文提出了採用雙頻法分離出sr電機鐵損中的損耗與滯損耗,並分別採用不同的方法計算出這兩種損耗。
  9. The primary of linear induction motor which drives the metro is installed on the chassis bogie, and because it is quite strict with laying down railway rail to use flat linear induction motor to drive metro, its secondary - - - - reaction board ( called induction board ), which is a kind of compound board of aluminum and steel, is fixed on the rail sleeper between the track. it is the airgap which is a gap between the primary and secondary of lim. the electromagnetic airgap is a very important parameter of lim

    利用有限元法對直線感應電動機二維非線性進行了數值計算,並在此基礎上,運用電有限元分析的專用軟體ansoftmaxwell2d對單邊型直線感應電動機的瞬態特性進行了模擬分析,得到電機運行過程中的電推力、法向力、初級電、氣隙密等曲線,通過改變直線電機參數,分析了電機氣隙對其瞬態性能的影響。
  10. The interaction between the eddy currents and the field therefore will brake the action on the disk.

    於是,之間的相互作用對圓盤產生一種制動作用。
  11. This paper, firstly, introduces some basic nondestructive tests, shows the background of the subject about the test for the defect of sucker rod, by comparing with the other nondestructive tests, proves the advantage of eddy - current test, then beginning with maxwell equation in electromagnetic field theory and combining with the idea model of defect, this paper proves that the feasibility of eddy - current test technology in multi - parameter and multi - frequency which applied in the test for for the defect of sucker rod

    本文首先介紹了無損檢測技術的幾種典型方法,並給出了抽油桿裂紋檢測這個課題的背景,通過同其它幾種無損檢測技術的比較,給出了電技術的優越性。然後從電理論中的麥克斯韋方程出發,結合裂紋的理想模型,從理論上證明了電多頻率多參數檢測技術在抽油桿裂紋檢測中的可行性。
  12. Because the field caused by the eddy - current transducer in the dissertation is not only axially symmetrical, but also plane symmetrical, there is no normal component of the electrical field strength and we cannot apply the condition en = 0 to solve such a problem

    由於本文中的傳感器模型,其電不僅是軸對稱,而且還是平面對稱,不含有電強度的法向分量,所以無法利用邊界條件e _ n = 0來求解。
  13. Through the analyzes of electromagnetic system of a axial symmetry by the method of electromagnetic vector potential, an eddy current field math model is build by triangle cell, this article has researched the effect of power frequency to eddy current density, penetration depth and the skin effect

    本文以電矢量位有限元法為基礎對二維軸對稱強度、密度進行了計算求解,採用三角形單元和六面體單元建立了數學模型,研究了電源頻率對密度、透入深度及集膚效應等量的作用影響。
  14. Performance improvement of remote field eddy current detection for ferromagnetic tubes corrosion

    性管道腐蝕遠檢測性能的改進
  15. Based on the electromagnetic theories, this dissertation presents an analytical method to analyze the el ectromagnetic field caused by the solenoid coil with ferrite core that is popularly used in eddy - current non - destructing test ( not )

    本論文從電理論出發,應用解析方法分析了無損檢測用帶芯的放置式線圈的阻抗,並利用數值方法和實驗驗證了分析結果。
  16. Below are the work and results of the dissertation : 1. analytical solution to the eddy - current transducer with ferrite core according to the practical eddy - current transducer used in eddy - current not, the analytical model described by a solenoid coil with a coaxial cylindrical ferrite core of finite length " is established

    論文的主要工作和結論概括如下:一、傳感器電解析解根據無損檢測中實際使用的放置式線圈傳感器,建立了含有共軸有限長芯的通電圓柱線圈電分析模型。
  17. Before giving the numerical solution, the finite element method and how to make the finite element analysis for 3d time - harmonic electromagnetic fields and 3d eddy - current fields are introduced in detail

    在此之前,詳細介紹了有限元方法以及三維時諧電的有限元分析方法和三維有限元分析的a - , a法。
  18. In this paper , the design characteristics and development situatution of powerformer are introduced ; the structure of prototype is studied , and three dimension end region entity model of powerformer stator is established ; the theory of analyzing end region eddy magnetic field of stator by finite element method is studied ; end region magnetic field of stator is analyzed and the numerical value of end region leakage reactance of stator is calculated

    本文介紹了powerformer的設計特點和發展現狀;研究了其樣機本體結構,並建立了定子端部三維實體模型;研究了用有限元法分析定子端部渦流磁場的理論基礎;用有限元法分析了定子端部並計算出了定子端部漏抗值。
  19. In this paper, the electromagnetic problems of the passive feedback coils that restrain the vertical displacement of plasma in fusion device is discussed and the induced currents on the passive feedback coils, the eddy currents magnetic field and the electrical parameters of coils are also analyzed

    本文研究了聚變裝置中用於抑制等離子體垂直位移的被動反饋線圈電問題,分析了被動反饋線圈感應電分佈、渦流磁場及線圈電氣參數等問題。
  20. On the basis of producing the mathematical model of calculating the induced currents on the passive feedback coils, the distribution and variation of the induced currents and the eddy currents magnetic field are given by numerical calculation. these conclusions are necessary to study the vertical unstability of plasma and design the coils

    在建立求解被動導電板感應電數學模型的基礎上,通過數值計算,給出了感應電的分佈和變化情況,同時對渦流磁場的分佈和變化也給出詳細的計算結果,這些結論對研究等離子體垂直不穩定性和線圈的設計是必需的。
分享友人