渦流粘度模型 的英文怎麼說

中文拼音 [guōliúniándùmóxíng]
渦流粘度模型 英文
eddy-viscosity model
  • 渦 : 渦名詞1. （漩渦） eddy; whirlpool; vortex 2. （酒窩） dimple
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 粘 : 粘動詞（粘附） glue; stick; paste; adhere to; bond
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 模 : 模名詞1. （模子） mould; pattern; matrix 2. （姓氏） a surname
  • 模型 : 1 （仿製實物） model; pattern 2 （制砂型的工具） mould; pattern3 （模子） model set; mould patter...
  1. For the present two les models, adopting the subgrid eddy viscosity concept and introducing the transport equation of turbulence energy k, the subgrid scale turbulence is parameterized by the turbulence energy k and the length scale of turbulence / ( k - 1 model ). in addition, vegetation is considered as an internal source of resistant force and turbulence energy

    在應用大渦模擬方法求解數值計算模型控制方程時，亞網格雷諾應力項沿用了亞網格渦粘性系數思路，引入亞網格紊流脈動動能k的輸運方程，建立了關于亞網格紊流脈動動能k和紊流特徵長度l的k - l模型求解。
  2. Based on prandtl ' s momentum transportation, this paper calculates in detail the physical quantities such as eddy viscosities, and ratio of eddy viscosity to motion viscosity, total stresses with respect to relative position in three regions of viscous sub - layer, buffer layer, and main turbulent stream for non - newtonian fluid flowing turbulently in ducts, which according to karman ' s three layer models and measurement of fluid parameters in evaluation apparatus, discusses the influence of polymer drag reduction on flowing properties of non - newton fluid, analyzes quantitatively principle of turbulent reduction phenomenon and condition of increasing reduction rate

    摘要以普蘭德動量傳遞理論為基礎，按照卡門的三層模型，通過室內模擬環道用0號柴油及加入減阻劑在圓管內的流動參數的測定，計算了非牛頓型流體管內湍流邊界層的層流內層、過渡層、湍流中心的渦流粘度，渦流粘度與運動粘度比、總應力隨相對位置的變化等定量參數，探討了高分子減阻劑對非牛頓流體流動特性的影響，對湍流減阻現象的機理與增大減阻率的條件進行了定量分析。
  3. The computations are shown to agree well with available experimental and numerical data and the physics of 3d large - scale flow separations and vortex shedding are confirmed. the simulation of the flow around a maneuvering wigley hull is a demonstration of capability for calculations of sway forces and yaw moments acting on a hull moving obliquely at a large range of yaw angles. the focus of study is large - scale cross - section separation flows, bilge - vortex development along the hull in the longitudinal direction and their effects on hydrodynamic forces

    應用所開發的求解器，以wigley船型為算例計算了大角度斜航船體粘性流場和水動力，分析了漂角的變化對船體所受到的粘性水動力的影響，相當精確地預報了以橫流分離和般渦生成與泄出為特徵的操縱運動船體特有流動形態及橫向水動力和轉脂力矩，經與現有試驗和計算數據比較，檢驗和驗證了該求解器精確模擬繞斜航運動船體的大尺度分離流動和計算非線性水動力的能力。
  4. If the two - equation turbulence models employ a linear relationship between the reynolds stress and the mean strain - rate tensors, this relationship is known as the generalized boussinesq model, the two - equation models can be extended for a wider range of applicability by developing more advanced nonlinear algebraic relations between the stress tensor and the mean - velocity gradient and the turbulent scales, this is known as explicit algebraic stress models ( easm )

    另一個是構成模型，即決定應力張量、應變率張量和兩個湍流尺度因子之間的函數關系式，它決定了雷諾應力。如果構成模型是線性的，則為boussinesq渦粘模型（ evm ） ，如果構成模型是非線性的代數關系式，則為顯式代數應力模型（ easm ） 。
分享友人
分享到 Line

分享到臉書