測斜機構 的英文怎麼說

中文拼音 [cèxiéjīgòu]
測斜機構 英文
tilt check mechanism
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 斜 : 形容詞（跟平面或直線既不平行也不垂直的） oblique; slanting; skew; bevel; diagonal; askew; inclined; tilted
  • 機 : machineengine
  • 構 : Ⅰ動詞1 （構造; 組合） construct; form; compose 2 （結成） fabricate; make up 3 （建造; 架屋） bui...
  • 機構 : 1 [機械工程] （機械的內部構造或一個單元） mechanism 2 （機關; 團體） organ; organization; institu...
  1. The thesis has summarized the development of the oblique - pull bridge, its construction technology and the importance of bridge construction control, then has introduced project general situation, and has narrated detailed regulation, organization construction, the major work and difficult part of this bridge construction control. the following is the key part of this thesis, firstly, it has introduced the experiment work of early stage, structural calculation and its theoretical result : the absolute altitude of each operating mode, the absolute altitude of building mould in each section and the absolute altitude after pouring concrete ; then, it has discussed the method and content of the line shape control of the main beam, actual absolute altitude of building mould is put forward, and it has described the method of structural stress monitoring, how to arrange measure point and collect data, and how to analyze data. it has also narrated the method of rope force detection and structural temperature inspection

    本論文在總結了斜拉橋的發展及其施工工藝，並指出了橋梁施工控制的重要性之後，簡要的介紹了工程概況，敘述了炳草崗金沙江大橋監控細則、組織機構及監控的主要工作和難點部分；論文的核心部分，在介紹了炳草崗金沙江大橋施工控制與監測工作的前期實驗工作和施工各工況標高、各節段支模標高、澆注混凝土后的標高的結構計算和其理論計算結果之後，詳細論述了主梁的標高線形控制方法和內容，實際支模標高的提出，結構應力監控的方法、布點、測讀及其對測讀數據的合理分析方法，索力檢測和結構溫度監測的方法。
  2. This paper focuses on the subject of high precision vertical pendulum tiltmeter, and studies deeply a series of problems that involve in high precision capacity micrometry sensor, the mechanical structure of the tiltmeter and its parts, adjusting pendulum and calibration of tiltmeter, and practical application of the vertical pendulum tiltmeter

    本文圍繞高精度垂直擺傾斜儀這一主題，對高精度電容測微傳感器，傾斜儀機械本體的結構及其零部件，傾斜儀的調擺和標定，以及垂直擺傾斜儀的實際應用等一系列問題進行了較為深入的研究。
  3. Domestic furniture - seating - test method for the determination of the durability of reclining and or tilting mechanisms and operating mechanisms for convertible sofa beds

    傢具.座椅.活動沙發床斜靠和或微傾機構以及操作機構的耐用性能測定的試驗方法
  4. With the development of the network and the multi - processor system, the research, simulation and the impemeni of the system - level fault diagnosis which is the very important means to increase the reliability of the system, are becoming more and more important. on the system - leve1 fault diagnosis, based on the group theory of system - level fault diagnosis that has been put forward by pro f zhang, the paper constructs newly the theory bases, improves on the matrix method, reinforces and consummates group arithmetic of all kinds of test mode, for the first time, analyses and discusses the equation solution of all kinds of models, so al1 the consistent fault patterns ( cfp ) could be found, straightly and high efficiently, even if the sufficient and necessary condition of t - diagnosable is dissatisfied and the complexity of system - level fault diagnosis is greatly decreased, especialy in strong t - diagnosabl6 system. last the simulation system ' s function has been extended and the application hotspot and the development trend have been disscussed

    本人在張大方教授等人提出的基於集團的系統級故障診斷的理論基礎上，重新構建了系統級故障診斷的理論基礎，定義了系統級故障診斷測試模型的三值表示；改進了系統級故障診斷的矩陣方法，重新定義了測試矩陣、鄰接矩陣、結點對、結點對的相連運算、極大準集團和斜加矩陣，由此能直觀、簡便地生成集團和極大獨立點集；補充和完善了各類測試模型的系統級故障診斷的集團演算法，通過定義集團測試邊和絕對故障集，簡化了集團診斷圖，由此能較易地找到所有的相容故障模式，即使不滿足t -可診斷性，大大減少了系統級故障診斷的復雜度，尤其是對強t -可診斷系統；首次分析探討了各類測試模型的方程解決，由此從另一角度能系統地、高效率地求出所有的相容故障模式（ cfp ） ：擴充了系統級故障診斷模擬系統的功能，快速、直觀和隨機地模擬實驗運行環境，進行清晰和正確的診斷，同時提供大量的實驗數據用於理論研究，優化演算法和設計。
  5. By the study of the whole decay curves of 10 hours, the influence of each step is summarized, and the best stoichiometry and preparation techniques are acquired. the crystal structure of sral2o4 eu2 +, dy3 + is monoclinic system, which is a high efficiency luminescence crystal structure. the emission spectrum and the excitation spectrum of sral2o4 eu2 +, dy3 + powder are measured

    此外，通過x射線衍射譜確定了所制備的sral _ 2o _ 4 ： eu ， dy長余輝材料晶體為單斜晶系結構，並測量其發射光譜，激發光譜，初步討論了sral _ 2o _ 4 ： eu ， dy長余輝蓄能材料可能的發光機理。
  6. Therefore, according to the mobility of the aircraft, the present study builts a multi - static location system, which uses the measurements detected by active or passive airborne sensors, when the aircraft is at the different positions. this study proposes two methods for locating sonobuoys. the first one is using aircraft - to - buoy slant range information

    根據飛機的機動性，本文構造了使飛機到達不同點獲取相同的測量信息而實現定位的多基地定位系統；依據機載有源無源探測器所能獲得的測量量，提出了兩種定位方法：斜距離測量定位法和基於卡爾曼濾波的方位測量定位法。
  7. Abstract : taking the 1 500 auxiliary concrete structures roadway which has just a few multiple diploid strata as a research object, by terms of utilizing the 3d fem model, integrating the observation result and resemble simulacrum ending, comprehensive research on the inside of stress distortion and its mechanism are developed, an extraordinary fairly visual result is gained which has an important support in practical supporting design, reinforcement, enhancing the strata cohesion and intensity

    文摘:以窯街三礦1500混凝土結構副大巷多層急傾斜煤巖層中復雜結構為研究對象，應用三維有限元模型，結合現場礦壓觀測結果和相似材料模擬試驗結果，對該巷道內部應力破壞敏感部位的內力和變形機理進行了系統的研究，得到了非常直觀的可視化計算結果，這對現場支護設計、維護加固和提高巖層的「凝聚力」具有重要的意義
  8. Based on the discussion the peculiarity of computer identification of tectonic soft coal seam, implemented the computer automatically identification of tectonic soft coal seam with well log of coal seam using the method of stratifying with slope - variance and probability statistics

    摘要在對構造軟煤分層計算機識別的特殊性進行探討的基礎上，應用斜率方差分層、概率統計計算的方法，實現了煤層段的測井曲我對構造軟煤分層的計算機「自動」識別。
  9. Abstract : in this paper, a new simple method is put forward to on - line survey and analyse the real - time response of bridges loaded under random vehicles and people. based on linear elastic hypothesis and finite element method, the dynamic whole displacement state and load of the bridge can be obtained through surveying partial displacements, so the problem that load is unknown and difficult to determine when calculating is solved in a sense. this method is adap ted to girder bridge, arch bridge, cable - stayed bridge and suspension bridge. through the instrumentality of ways and means in this treatise, a real - time system to survey and analyse a working bridge can be established

    文摘:在線彈性假設基礎上，根據有限元理論和橋梁隨機車輛（行人）荷載的特點，討論並提出了一種通過監測部分位移，計算橋梁其餘位移和橋面荷載的簡化分析方法，解決了橋梁在隨機車輛（行人）荷載作用下的荷載確定問題，建立了動位移和等效節點荷載的有限元列式.該方法為橋梁結構的在線監測和實時分析提供了理論基礎，適用於連續梁橋、拱橋、斜拉橋和懸索橋等橋梁結構形式，具有實際應用價值
  10. This paper has studied and set up a supervision and control system based on the backing item of jinzhou yangtze river bridge with main span of 500m, by analyzing the development of construction control of cable - stayed bridges in china and abroad, foreword calculation of 250 work cases of plane bar fem, adoption of advanced equipment and devices, quick analysis of gathered data research of karemen filtering method, least square and gray model gm ( 1, 1 ) into the identification of the real state and precuts and effective manage mechanism

    本文以荊州長江公路大橋主跨500米的混凝土斜拉橋施工為應用背景，通過分析目前國內外大跨度混凝土斜拉橋施工控制現狀，結合該橋施工實踐，運用平面桿系有限元計算理論對大橋250個工藝進行正裝計算，採用先進測試設備和儀器，利用計算機快速分析處理技術對現場監測系統收集的數據進行誤差分析，系用卡爾曼濾波法、最小二乘法和灰色理論gm （ 1 ， 1 ）進行結構真實狀態的識別和後期預測，通過科學高效的監控管理機制的運行和監控實踐，探索並建立了一套適合於大跨度混凝土斜拉橋的施工監測監控體系。
分享友人
分享到 Line

分享到臉書