測流垂線 的英文怎麼說

中文拼音 [liúchuíxiàn]
測流垂線 英文
velocity measuring vertical
  • : 動詞1. (測量) survey; fathom; measure 2. (測度; 推測) conjecture; infer
  • : Ⅰ動1 (液體移動; 流動) flow 2 (移動不定) drift; move; wander 3 (流傳; 傳播) spread 4 (向壞...
  • : Ⅰ動詞1 (東西的一頭向下) hang down; droop; let fall 2 [書面語] (敬辭 多用於長輩、上級對自己的行...
  • : 名詞1 (用絲、棉、金屬等製成的細長的東西) thread; string; wire 2 [數學] (一個點任意移動所構成的...
  1. We can use the mm5 model in definite time, definite area weather forecasting. we conclude that : : the moving route of this necw in its developing progress was direct - south along latitude, the cold air is rough, and just this made the rough vertical velocity ; the necw southern moving and conflicting with the west pacification sub - tropical high makes rough jet steam. the plenty south - west warm and wet air made by the jet stream gave the rainstorm demanded vapor ;. the rough vertical velocity by jet stream is a main reason in this rainstorm ; the mm5 model uses four - direction analysis data as its input, this avoids some errors occurred in observe and transfer, thus made the result more useful

    綜合分析認為: ( 1 ) 、這次冷渦在其發生發展過程中,其移動路徑是沿經圈直南壓,攜帶的冷空氣勢力較強,形成槽后較強的直運動; ( 2 ) 、西太平洋副熱帶高壓偏北位置與東北冷渦南壓形成的急軸,把源源不斷的西南暖濕氣輸送到遼西地區,也就是急軸的左前方位置,為這次暴雨的產生提供了充足的水汽來源; ( 3 ) 、低空急不但為暴雨輸送水汽,其造成的較強的直環也是產生強降水的一個主要原因; ( 4 ) 、 mm5模式以四維同化資料作為初始場,最大限度地避免了觀誤差可能造成的積分不穩定,提高了模擬結果的參考價值。
  2. Energy consume, electric strength, insulation resistance, ground conductivity, leakage current, microwave leakage, power input, normal temperature, humidity treatment, glow wire, horizontal flame, vertical flame, tracking, ball pressure, rainproof, water splash, dustproof, salt fog, endurance, motor load test, cord flexing, cord pulling, pull & torque test, lamp replacement, construction check etc

    能耗、電氣強度、絕緣電阻、接地連續性、泄漏電、微波泄漏、功率、溫升、濕熱試驗、灼熱絲、水平燃燒、直燃燒、漏電起痕、球壓試驗、防雨淋、防濺水、粉塵、鹽霧、耐久性(壽命)試驗、電機負載試驗、電源彎折、電源提拉、拉扭力試、燈頭互換性、安全結構檢查等。
  3. 3. a three - dimensional - acoustic doppler velocimeter has been used to measure the velocity and turbulence in a compound channel with vegetated and unvegetated flood - plains. particulary in the interface region between main channel and floodplain. the distribution in three coordinate directions of velocity and turbulence intensities and the renolds stresses are presented. the momentum transfer at the main channel flood - plain interface can be described as an apparent shear stress which can be quantified as a function of the local turbulence at the interface

    採用adv對灘地種樹前後灘槽交界區域的速場進行了量。分析了灘槽交界區域的速、紊動強度和雷諾應力的變化。將灘槽交界的動量傳遞描述為一表觀應力,這個表觀應力可以看作是交界面處的脈動函數並將其定量化。
  4. In this paper, some characteristics of flow movement and sediment transport are analyzed by using the flume experiment data. the cross section of compound channel can be divided into four regions : the undisturbed region in main channel, the interactive region between channel and plain, the undisturbed region in flood plain and the boundary region. in the undisturbed regions, the distribution of longitudinal velocity along the depth has the feature of lograithmic. whereas, in the interactive region, the longitudinal velocity does not obey the logarithmic distribution law, but it can expressed as a revised logarithmic function by using a wake function. on the basis of the kinematic equation the velocity distribution of transverse velocity is obtained. in the boundary region, the longitudinal velocity obeys the law of parabolic distribution. furthermore, according to the simplified diffusion equation, the transverse distribution of sediment concentration in the interactive region is deduced. the analysis is in good agreement with the measured data

    本文根據漫灘水的運動特點,將漫灘水的復式斷面分為主槽平衡區、灘槽交互區、灘地平衡區及邊壁區等4個區,並給出了各區寬度的經驗公式.根據灘槽交互區速分佈的變化特點,提出了附加尾函數的對數速分佈公式.在簡化水運動方程和泥沙擴散方程的基礎上,對灘槽交互區內平均速及含沙量沿橫向分佈進行了理論分析,提出了反映灘槽水動量交換強度的橫向渦量粘性系數及橫向擴散系數的表達式,得到了漫灘水平均速及含沙量沿橫向分佈的解析解,並與實資料吻合較好
  5. According to more effect, when the hore component is placed in a gradient field, at the same time the direction of the current is perpendicular to the direction of the voltage, then between the two parallel side face come out the hore voltage. when hore component is set in this kind of uni - gradient magnetic field and the electric current is unchanged, the voltage output of hore component will be proportional to the position of the hore component in the magnetic field. so we can use the hore component to measure the movement of hore component against magnetic field

    根據霍爾效應可知,置於磁場中的霍爾元件若電方向與磁場方向直,則在霍爾元件直於磁場和電方向的兩個側面將產生電勢,將霍爾元件置於強度隨空間位置性變化的磁場中,且控制電恆定,輸出就正比于霍爾元件處于磁場中的位置,因此可以用霍爾元件來量磁場與霍爾元件間的相對位移量。
  6. However, df pre - processing is not required in a interferometer direction finder. it only makes use of the phase relations or differences of sensors disposed at different position. azimuth and elevation are caculated from the phase differences or displayed directly on a crt drived by the voltage or current from the phase differences

    干涉儀向不必進行向信號預處理而是直接或間接求取在空間上分開的傳感器上感應電勢之間的相位關系,即干涉相位差,方位角或仰角是直接由干涉相位差計算得到,或將兩基正交的天陣的干涉相位差轉化為驅動電壓(電)分別加到crt陰極顯示器的直偏轉圈和水平偏轉圈,模擬顯示出來波方位,干涉儀向為典型的相位向方法。
  7. We can provide customers with automatic / half - automatic dustless coating production line for plastic parts, whole - range liquid / powder electrostatic coating production line, automatic coating machine for small pieces, whole - range stand coating equipment, electrostatic eliminating equipment, dust removing equipment and various uv light curing equipment ; and we provide supporting logistic equipment including whole - range horizontal conveyor, bevel conveyor, overhead suspension conveyor, vertical conveyor and transfer machine ; and we also provide various production line equipment for assembly line, screen printing line, aging line, inspection line and packing line

    可為客戶提供全自動及半自動塑膠件無塵塗裝生產、全系列液、粉體靜電塗裝生產、小件全自動塗裝機、全系列臺式塗裝設備、除靜電除塵設備及各類uv光固化設備;配套提供全系列平面輸送機、斜面輸送機、懸掛式吊空輸送直輸送機和移載機等物設備;提供各類組裝生產、絲印生產、老化、檢和包裝水生產設備。
  8. A three - dimensional - acoustic doppler velocimeter is used to measure the velocity components of the flow field in all three coordinate directions for different discharge and measurement site. the influence of measurement site and the depth / vegetation height ratio on the measured velocity profile and turbulence intensity and the renolds stress is analyzed. the characteristics of the measured velocity distributions and the results of the previous investigators are used to select an analytical expression for the shape of the velocity profile

    利用三維超聲波多普勒速儀( adv )量不同位置、不同量下的瞬時場。分析了點位置和水深與植被高度比對時均速分佈的影響。本文還給出了種樹段紊動強度及雷諾應力的分佈。
  9. The method is better than others. firstly, the system sets up several models to assist detection work, such as road model, illumination model, shadow model and relationship model among them ; secondly, it introduces hue. saturation degree information to distinguish vehicles from shadow ; thirdly, it makes use of binary decision tree to analyze pressing line of vehicles to improve the reliability of the system ; fourthly, it puts forward a way of one dimension video tracing to resolve the problem of vehicle velocity detection

    該方法通過設置在每條車道中的兩條相互直的虛擬檢來檢交通信息(如車量、車速等) ;設計一種彩色分段檢技術來提取運動車輛的尺寸信息和色彩信息,再利用分類決策樹和濾波演算法確定運動車輛存在與否,增強了車輛、陰影、噪聲和背景之間的區分能力;設計了一種車速視頻檢方法。
  10. Aiming at the change of the traditional sediment measurement method, a new equipment, called infrared back - scattering sediment instrument, is introduced, it can measure the real - time sediment content continuously

    為改進環形水槽的傳統沙技術,自主研發完全開放式的實時在沙儀器,力求在水槽中實驗水樣的自然態下實時懸浮泥沙含量。
  11. A new high - speed ert experiment system based on the bi - directional current pulse technique is designed and developed. on - line observation is realized for simulating gas / liquid two - phase flow using this experiment system

    提出並研製成功了一種新型的基於雙極性脈沖電激勵的高速電阻層析成像系統並實現了直管道的氣液兩相的在
  12. ( 2 ) before and after the frames are placed the velocity vertical distribution in the same cross - section are measured by adv. the results indicate that after the frames are placed the mean velocity and turbulent intensity near bed are reduced, and vertical distribution of turbulent intensity is more uniform

    ( 2 )採用adv超聲速儀對投放框架群前後同一斷面的速分佈量表明:水槽投放四面體后,不但可以降低近底區的時均速、紊動強度,而且均化了紊動強度的分佈。
  13. The streamline model is used for optimizing the parameters of fractures and flow conductivity within the fractures and predicting the production performance in vertical fracturing wells of daqing oilfield and better result is achieved

    並運用模型方法對大慶外圍某油田直裂縫壓裂井進行了縫長和縫內導能力等參數的優化和生產動態預,取得了較好的效果。
分享友人