測溫孔 的英文怎麼說

中文拼音 [cèwēnkǒng]
測溫孔 英文
temperature hole
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 溫孔 : vincon
  1. This paper elementarily collects the anomalies of coseismic and post - seismic effect such as seismic activity, crustal deformation and underground liquid and so on observed in china ' s mainland, which include the evident seismic activity ( especially in yunnan ) increase, obvious crustal deformation, such as the abnormal variation of crustal stress and strain in bore volumetric deformeter and the remarkable change of underground temperature, the chemical component, especially the underground water level

    初步匯集了在中國陸區觀測到的地震活動、地殼形變、地下流體等多學科震時和震後效應的異常變化，包括地震活動性（特別是雲南地區）的顯著增強；地殼形變觀測，尤其是鉆孔應變觀測記錄到地殼應力應變的震時和震后顯著變化，以及地下水溫度、化學成分、特別是水位的突出變化。
  2. Standard practice for determining the effects of temperature cycling on fenestration products

    測定穿孔產品溫度循環效果的標準實施規程
  3. Benthic foraminifer fauna, ams14c dating and acoustic sub - bottom profile was analyzed in the core ey02 - 2 and ey02 - 1 drilled from the muddy deposit in the middle southern yellow sea and the mid - shelf of north east china sea. considering the results of core qc2 ? dz4 and the standard oxygen isotope curves, we discussed the late - quaterenary paleo - environment evolution, benthic foraminifer fauna, paleo - climate, the climate events and water mass in postglacial period, average sedimentation rates, paleo - water depth, origin of sediments, average sea level rise rate in the shelf of south yellow sea and east china sea. at last we discussed the condition of sea level rise in the east china, green house effect and the protection of coastal zone

    本文根據南黃海中部泥質區和東海中陸架的兩個鉆孔巖芯的古生物、 ams ~ （ 14 ） c測年、淺地層剖面等，參考qc _ 2 、 dz _ 4成果及標準氧同位素曲線探討了黃東海陸架晚第四紀古環境演化、底棲動物群特徵、古氣候、冰後期以來氣候事件、古水團、沉積速率、古水深、沉積物源、海平面平均上升率，討論目前中國東部海平面上升的狀況、溫室效應及海岸帶保護。
  4. Using the rock resistivity meter with simulating in - situ conditions, the relations between rock resistivity and temperature were observed from 6 sandstone samples with different porosity and permeability, while samples were brine water - saturated and subjected to certain confining pressure. it is found that the resistivities of water - saturated rock samples decrease in the form of power expression with the temperature increase. although the resistivity of brine water decreases with temperature in the same rule, it can not entirely account for the decreasing of rock resistivity. the cementation factor

    利用模擬地層條件巖芯電阻率測量儀，對6塊孔隙度滲透率各不相同的砂巖巖芯，在一定圍壓條件下，巖芯完全飽和鹽水時，考察了巖芯電阻率隨溫度的變化。發現飽和鹽水巖芯的電阻率隨溫度升高，以冪函數形式下降。雖然巖芯中飽和鹽水的電阻率同樣隨溫度以冪函數形式下降，但巖芯電阻率的下降不能完全用巖芯飽和鹽水的下降表徵。
  5. Standard test method for microcellular urethanes - high temperature sag

    測試微孔氨基甲酸乙酯高溫垂弛度的標準試驗方法
  6. If anomalously high temperatures are recorded the next step consists of taking temperature logs in existing bore holes.

    如果測到反常性高溫，下一步就要收集現有鉆孔的溫度記錄。
  7. The dual - bath coagulation method suggested by j. a. va n ' t hof could be used in membranes with high selectivity clearance rate of low - molecular weight substances and moderate water flux theoretically. therefore it may be applied in the field of hemofiltration. to improve and optimize the performance of the pes ultrafiltration membrane applied in the hf, here the flat membranes and hollow fiber ( hf ) membranes are made in certain conditions based on the dual - bath coagulation method where pes is used as the membrane material, dmso as solvent and pvp & peg as additives this paper includes five parts as follow : 1

    為了改善和優化聚醚碸超濾膜（單浴法）在血液過濾實際應用中的性能，本論文以j . a . van ' thof等提出的雙凝固浴法為基礎，以聚醚碸（ pes ）為主要成膜材料，以二甲基亞碸為溶劑，並添加一定分子量的致孔劑（ pvp ，聚乙烯吡咯烷酮）以及一定分子量的添加劑（ peg ，聚乙二醇）按照一定配比在一定溫度下製成透明均一的鑄膜液，靜置脫泡后在一定的工藝條件下製成聚醚碸平板膜和中空纖維膜，然後通過測試膜的結構和性能來評估其用於血液過濾中的前景。
  8. The diageneses which are destructive to the reservoirs are mainly the filling of minerals in secondary pores, the fissures and the dissolved caverns

    對儲層起到破壞作用的主要是充填作用，表現為次生溶蝕孔隙、裂縫、溶洞中充填自生礦物，它們的包裹體測溫數據證明充填作用發生在埋藏時期。
  9. Based on the analysis of thin sections by microscope, measurement of porosity and density, and geological setting, we tested the rock physical parameters of sandstone, siltstone, carbonate and other transitional sedimentary rocks by the mts system under formation conditions ( temperatures, pressures and pore fluid properties ). the rocks we tested are from tertiary ( including zhujiang formation, zhuhai formation, enping formation, hanjiang formation ) of zhujiangkou basin in southern china sea. according to the analysis results, we studied the main ultrasonic wave velocity characters of rocks, which are compressive and shear wave velocity and poisson ' s ratio under different formation conditions

    在對珠江口盆地第三系儲集巖進行顯微鏡薄片分析、孔隙度和密度分析，以及地質背景分析的基礎上，利用巖石物理參數測試系統（ mts ）模擬地層條件（溫度、壓力和孔隙流體狀況）測試了珠江口盆地第三系（包括珠江組、珠海組、恩平組、韓江組，以下有關討論同）砂巖、粉砂巖、碳酸鹽巖及其過渡性巖石物理性質，重點研究了不同地層條件下巖石的聲學特徵（巖石的縱橫波速度和泊松比） 。
  10. Gauge hatch series, which are pedal type and set on the tank roof for measuring the oil lever & temperature and also for sampling of the oil in the tank

    量油孔為腳踏式，安裝于油罐頂部，用於測量罐內油品的標高和溫度及取樣等。
  11. The results shows that temperature in the porous dried layer varies - as a exponential discipline whose changing scope is determined by the mass flux and a linear distribution in temperature exists across the frozen layer

    結果表明，多孔乾燥層溫度按指數規律變化，變化幅度取決於水汽流率，凍結層溫度按線性分佈，預測凍干時間與實際結果相符。
  12. Independent air hating system, oven with sealed round hole array with hot air curtain, automatic oven temperature detector and control, dro, application of second time reflex of heat energy and centralize waste discharge result in energy and cost saving

    獨立的熱風加熱系統，密閉式圓孔陣列風幕式熱風乾燥烘箱，烘箱溫度自動檢測控制、數字顯示，熱能二次迴流利用，集中排廢裝置，有效地降低能耗、節約成本。
  13. Temperature logs in bore holes down to several thousand metres are made by cable probes.

    幾千米鉆孔用的溫度測井裝置是用電覽探頭做的。
  14. But there are some technical difficults for the welding of aluminium alloy such as some broken bits being easily found, a large welding distortion can happen easily, hard to distinguish the difference between the solid metal and liquid metal colour, hard to control the temperature, a lot of air holes can be seen in the welding line and so on

    但是鋁合金熔化焊時的技術難點在於：焊接時易引起夾渣，焊接變形大，金屬的固態和液態的色澤不容易區別，焊接操作時控制溫度困難，容易產生氣孔等等。如果焊前清理工作不是很好，檢測氣孔往往超標。
  15. The key to prediction of casting shrinkage / porosity lies in ascertaining the critical value of temperature gradient and niyama criterion. the thesis put forward two methods to ascertain the value, one is which is positive - direction and the other is negative - direction. we verify the realistic arithmetic of temperature gradient method and niyama criterion method by experiment, and we can draw a conclusion that the arithmetic is correct and reasonable in most cases and choice of developing tool is sound

    臨界梯度值和新山判據臨界值的確定是實現縮孔縮松預測的關鍵，本文提出了確定臨界值的正向法和反向法，並以高鉻鑄鐵件縮孔縮松預測和鑄造工藝改進為研究對象，應用正向法，確定了溫度梯度法的臨界值為180 m 。
  16. On the basic of the detailed analysis on main causes and main prediction methods of casting shrinkage / porosity, we put forward two methods to describe the solid phase rate of materials solidification. one is liner - distributing method, and the other is parabola - distributing method. and then, we apply the former to the system

    本文在充分分析鑄件縮孔縮松產生機理與主要預測方法的基礎上，提出了材料凝固固相率的線性分佈法和拋物線分佈法，並將前者應用於系統中；同時提出了溫度梯度法和新山判據法的實現演算法，此演算法具有一定的靈活性。
  17. 4 ) effect on photosynthesis : the important parameters of photosynthesis such as net photosynthetic rate, transpiration rate, stomatal conductance and substomatal co2 concentration were measured and the results was that the first three parameters of the transgenic tomato were highter than that of the control plants, and the last one was lower than the control tomato, which indicated that the photosynthesis of transgenic tomato were stronger than control clearly. all the results sugges

    4 ） ） t hs用：低溫al ： pll6周，測定植物光合作用的重要指標凈光合速率、蒸騰速率、氣孔導度、胞間隙cqz鵬，結果顯示賂因番茄的即雛率、蒸騰速率、氣孔導度均明顯高於對照，而胞間隙coz氏于對照。
  18. Thermocouple and thermal resistance in power station suit to measure temperature of electric generator groups and auxiliary machine correspond to 300000 and 600000 kilowatt, which can substitute one from import with many advantages as shock - proof, pressure - resistant, long in service, and convenience in maintain etc. the protective tube is processed in a special construction by deep - blind hole technology whose end not be welded to enhance the strength and prolong service life. thermocouple or thermal resistance

    本公司生產的電站專用熱電偶阻，適用於我國30萬60萬千瓦等發電機組及輔機的測溫需要，產品安全可替代進口，具有防震耐壓使用壽命長，維修方便，保護管是採用深盲孔技術加工而成，端部不用焊接，提高了保護管的強度和使用壽命，鎧裝熱電偶熱電阻採用彈簧壓著式結構，在運行中保護管與鎧裝熱電偶熱電阻測量端始終保持著良好的接觸，抗震動，減少熱響應時間，鎧裝熱電偶測量端採用絕緣形式，能防止電磁干憂。
  19. Cut out insulation around pressure taps so that when diagnostic checks are required, plugs are visible when outside shell is removed as shown in fig. 3

    當需要進行診斷檢測時，切開環繞測壓孔周圍的保溫材料，使得外殼拆卸后能夠看到塞子，如圖3所示。
  20. The performance of flat surface film cooling with 30 film cooling holes along streamwise was experimentally investigated using thermal liquid crystal

    摘要採用熱色液晶測溫法，對沿流向傾角30的圓孔排平板氣膜冷卻進行了實驗研究。
分享友人
分享到 Line

分享到臉書