測溫試探器 的英文怎麼說

中文拼音 [cèwēnshìtànqì]
測溫試探器 英文
pyrometer probe
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 探 : Ⅰ動詞1 （試圖發現） try to find out; explore; sound 2 （看望） call on; visit; see 3 （向前伸出）...
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 試探 : sound out; feel out; probe; explore
  1. In my present study, changes in structure and function of all parts of non - leaf organs ( culms, paleae, lemmas, awns, and glumes ) were investigated during a series of developmental stages and in various cultivars. characterization of the culms of lodging - resistant wheat varieties lodging is a potential cause of yield reduction in cereal crops ( crook et al, 1994 )

    其中，比較分析了非葉器官葉綠體超微結構的差異，測量了非葉器官的放氧和低溫熒光等生理指標，嘗試從結構與功能相結合的角度，探討非葉器官在提高作物產量中所起的重要作用。
  2. Auxiliary pressure and temperature measurements make the multifrequency phase fluorometer an ideal choice for luminescence sensor design, testing and calibration

    輔助壓力和溫度測量讓多頻相位熒光計是發光探測傳感器設計、測試和校準的理想選擇。
  3. We select ni / cr alloy resistor as element together with ceramic embedding hearth ; select small flat - and - disc heat - even hubby ceramic sample holder, select ni / cr & ni / si thermoelectric couple ( type k ) as thermoscope with threads 0. 5 mm in diameter which is installed in the middle of the holders symmetrically ; select aluminum silicate fire - retardant fiber as materials for heat preservation ; design some hardware, for example temperature controller & transporter, signal amplifier etc ; design controlling curve to heat stove ; and introduce the method of least squares nonlinear regression and subsection function to deal with data. in order to obtain the reasonable operation conditions and operation curve, we have also done many theory analysis and experiment discussions

    通過理論和試驗探討，選用鎳鉻合金電阻絲作為加熱元件，配以陶瓷質埋入式爐膛；選用陶瓷質小尺寸扁平?圓盤均熱塊體型樣品支持器；選用0 . 5mm絲徑鎳鉻?鎳硅熱電偶（ k ）作為測溫元件；熱電偶對稱安置在樣品支持器容器的中部；選用硅酸鋁耐火纖維作保溫材料；合理選用和設計了溫度控制器、溫度變送器、信號放大電路等硬體；採用升溫曲線來控制爐膛供熱過程；採用最小二乘法非線性回歸與分段函數相結合的曲線模擬方法，進行圖形處理。
  4. In order to eliminate the influences caused by temperature, electrode - polarization and autoeciousness - capacitance, the traditional instrument has added complicated circuits so that it cause such shortcomings as big error, time - retardation and a relatively small scope. through the problems caused by 2 - probe electrode and ac current source, a new measuring circuit based on the excitation of bi - directional voltage pulse and the sensor of 4 - probe electrode is proposed, using single - chip to achieve auto - temperature compensation

    作者在參閱國內外大量相關參考文獻的基礎上，從電導測試技術的原理性研究出發，分析了採用交流激勵源、兩電導電極為傳感器的傳統電導測試系統所面臨的種種問題，提出並研製了一種基於雙極性脈沖電壓激勵、以四電導電極為探頭、運用單片機進行溫度自動補償的新型電導率測量系統。
  5. Compressor panel testing mainly includes acculator axle temperature monitor, plc group. after connection of local cable and testing of detector charactertistic contour, testing vibration and site ? change monitor

    對其中的壓縮機盤主要是調速器、軸瓦溫度監視器、機組plc調試。至於振動、位移監視器調試，需待現場電纜連接後作探頭特性曲線測試后進行。
  6. Through analysis and discussion on experiment theory and structure of calorimeter, the precision and veracity of apparatus can be efficiently enhanced with improvement on cooling emendation which is very important to calorific value measurement

    本文通過對恆溫式氧彈儀試驗原理和結構的分析和探討，對測定發熱量過程中至關重要的冷卻校正計算進行改進，有效的提高了儀器測量的精確度和準確度。
  7. The traditional level measuring methods can n ' t meet our demand because the subjective investigated is in such a poor systemic condition that the temperature is a little high and there ' s so many mill dust and steam there. in this article we perform systemic discuss and research against the dynamic level measuring method under special working condition on the basis of analyzing kinds of level measuring technique in and abroad. first we establish the pressure distribution mathematic model in storage bin and then deduce the mathematic relation between level height and the uniform stress on the bottom of the bin and designed a resistance compressive stress sensor used for the special condition and put forward a resoivement according to its zero excursion existing in practical use

    由於本研究系統被測對象環境溫度較高且潮濕，同時料倉中有大量粉塵及蒸汽，因此傳統的料位檢測方法不能滿足本測試要求。本文在分析國內外各種物位檢測技術的基礎上，針對特殊工況下動態物料高度的檢測進行了系統的探討與研究。首先建立了料倉中的壓力分佈數學模型，推導出料位高度與倉底均布壓力間的數學關系式，並據此設計了中溫電阻應變式壓力傳感器，同時對它在實際應用中存在的零點漂移等問題提出了改進措施，提高了傳感器性能，解決了上述特殊工況下動態物料檢測的技術難題。
  8. Cd1 - xznxte single crystal with good crystallinity has been grown by the descending ampoule with rotation method - before this, high - purity cd1 - xznxte polycrystal materials have been synthesized from 6n gd zn te in the same ampoule. on the basis of this, we deeply explore method of detector fabrication. and we also studied the level and density of traps in detector. gold, indium and c have been deposited as electrodes on polished and chemically etched surfaces of samples with the sizes from 5 5 1 to 10 10 1. 5mm to compare different contact technologies. the behavior of detector ' s leakage current with temperature and leakage current with time were studied as well as th current - voltage characteristics to deduce the level and density of trap in detectors

    我們利用熔體溫度振蕩法在石英安瓿中將6n的單質cd 、 zn 、 te合成多晶原料，用坩鍋旋轉下降法在同一安瓿中生長出尺寸為20 40mm的cd _ （ 1 - x ） zn _ xte晶體。在此基礎上對碲鋅鎘探測器的工藝進行了較深入的研究，製作了厚1 ? 1 . 5mm的探測器，測試了c 、 in 、 au等不同金屬的電極接觸性能，並在國內首次通過測試器件的i ? v 、 i ? t曲線、弛豫特性和電容特性對電阻率、陷阱能級、陷阱濃度進行了分析，同時測得的~ （ 241 ） am源的能譜。
  9. " we will deploy 60 more health surveillance assistants to station at the border and 28 more scanners at immigration counters to meet the increased passenger load for health screening, " he added. endtuesday, september 23, 2003

    他續說：我們將于關口增多六十位健康監察助理，亦於出入境櫃位增設二十八個體溫探測器，以應付因多增旅客而增加的體溫測試工作。
  10. Technical requirements and test methods for heat sensitive point type fire detectors

    點型感溫火災探測器技術要求及試驗方法
分享友人
分享到 Line

分享到臉書