測站控制 的英文怎麼說

中文拼音 [cèzhànkòngzhì]
測站控制 英文
station control
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 站 : Ⅰ動詞1 （站立） stand; be on one s feet 2 （停下來; 停留） stop; halt; pause Ⅱ名詞1 （停車點） st...
  • 控 : 動詞1 （告發;控告） accuse; charge 2 （控制） control; dominate 3 （使容器口兒朝下 讓裏面的液體慢...
  • 制 : Ⅰ動詞1 （製造） make; manufacture 2 （擬訂; 規定） draw up; establish 3 （用強力約束; 限定; 管束...
  • 控制 : control; dominate; regulate; govern; manage; check; cybernate; manipulate; encraty; rule; rein; c...
  1. The functions of this automation system focus on five aspects : data acquisition 、 supervision and control 、 fault isolate and recovery 、 gis 、 data statistic and report. the design project takes the rcs - 9000 series 、 sd ? 9520 and sd - 9630, which is a new installation that can detect the operation state of the low - voltage current breaker, and send the state to the control room. the other new installation is sd - 9860, which is the monitor of the cable fault

    設計方案中，在採用南瑞rcs - 9000系列、雙電公司sd - 9520裝置的同時，採用了新開發的sd - 9630塑殼開關運行狀態採集裝置，檢測塑殼開關的運行狀態，並將運行狀態傳回到集控中心（中間站） ；採用了新開發的sd - 9860電纜故障指示器，完成電纜故障的識別；集控中心的設計實現了整個小區配電自動化系統的集中通訊、實時監控、統計與管理功能；高、低壓開關實現了自動控制、狀態檢測和無功補償等。
  2. Fourth, the paper treats two kinds of hoisting projects of high alititude construction in bulk and member assembly, hositing machine and plan layout, setting up scaffold and joints, and installing trunks, branches and joints etc. then in detail discusses the method which applys total station to measure three - dimensional coordinate of dendriform structure, including selecting survey sign points, creating survey system and converting survey coordinate system etc. the paper also deep research on the welding performance, welding method, welding process, welding stress and control, welding strain and rectification, weld defects analysis and weld quality inspection, and so on complicated heterogeneity steel weld proplems

    接著系統的論述了高空散裝法和分單元安裝法兩種樹狀結構吊裝方案，樹狀結構吊裝機械及平面布置，樹狀結構胎架及節點的搭設，以及樹狀結構樹干、樹枝和節點的吊裝工藝等諸多工藝問題。詳細的論述了採用全站儀對樹狀結構進行空間三維坐標測量的方法，包括測量標志點的選取、測量系統的建立及測量坐標的轉換等問題。深入地研究了樹狀結構可焊性、焊接方法、焊接工藝、焊接應力及控制、焊接變形及矯正、焊接缺陷分析及焊接質量檢查等復雜的異種鋼焊接問題。
  3. This software can not only measure the real time data of hydroelectric plant, but also carry out the auto generate electricity on the hydroelectric plan t and ordinal startup - stop of the dynamotor. the software also carrys out the functions of alarm disposal, report forms, print and load curve

    該軟體不僅實現了對水電站內各種模擬參數和數字信號的實時監測功能，還實現了對水電站的自動發電、機組順序啟停的控制，以及報警處理、報表列印、負荷曲線等功能。
  4. Nilometer is widely used in the system of automatic detection and automation in many water supply such as oil industry, chemical industry, metallurgy industry, electric power, irrigation works, reservoir, bulk plant, pumping station, towns water and so on. and it is a important tool in these fields

    水位、閘位計廣泛應用於石油、化工、冶金、電力、水利、水庫、油庫、泵站、城市供水等領域的自動檢測和控制系統中，是這些領域不可缺少的一種重要工具。
  5. Inferential measurement technique application in urban drain pump station control systems

    推斷測量技術在城市排水泵站控制系統中的應用
  6. Guide for the application of human factors engineering in the design of computer - based monitoring and control displays for nuclear power generating stations

    核電站用基於計算機的監測和控制顯示器的設計中的人因工程的應用指南
  7. Next, we will apply this new versioned clm to a river basin at xixian station in the huaihe river basin. xixian station is a hydrological observation station, which covers 10190 km2. we use 11 - year from janu - ary 1980 to december 1990 observed meteorological data and runoff data including surface runoff and subsurface runoff to validate the reliability of this new subsurface model, and furthermore a quasi - steady subsurface runoff model 13, 31 bqas and dsitqsdt is also applied to this region to perform a comparison simulation

    利用包含上述地下徑流機制的clm應用到實際的流域中，選取淮河流域的息縣站所控制的流域作為實驗區域圖4 .息縣站是淮河流域的一個水文觀測站，控制面積為10190 km2 ，利用該區域11年1980年1月到1990年12月的降水氣溫等氣象資料以及徑流包括地表徑流和地下徑流資料來驗證所建立的模型的可靠性
  8. This paper describes a series of preliminary results in combination with actual situations of hydropower development in dadu river by means of establishing river basin water rainfall regime monitoring network, carrying out multi - link large system comprehensive dispatching study of water, electricity and network in group reservoirs, conducting the control mode study of cascade hydropower stations, power supply range and development lime sequence, planning environmental impact assessment in a river basin, as well as the dispatching patching of gongzui, tongjiezi cascade hydropower stations

    大渡河流域水電開發有限公司結合流域水電開發實際，通過建立流域水雨情監測網，開展群庫水、電、網多環節的大系統綜合調度研究，流域梯級電站控制模式研究、流域供電范圍及開發時序研究，流域規劃環境影響評價研究，以及龔嘴、銅街子電站梯級調度實踐，在流域梯級電站統一調度研究方面已取得了初步的成果。
  9. Abstract : this paper studied the characteristics of phased array technology and principle of multi - targets tracking, measuring and controlling, analyzed the implementation technology of “ one station controls several vehicles ” based on phased array technology. an implementation scheme was given, feasibility of the scheme was discussed

    文摘:研究了相控陣技術的基本特點及其實現多目標跟蹤與測控的基本原理，分析了基於相控陣技術的「一站控制多機」的實現技術，給出了一種實現方案，並探討了其可行性。
  10. Vacuum breaker with adequate quality and long maintenance intervals are selected. further more, integrative automation of substation is the key factor in substation without watch - keeper. in the secondary design, we adopt layered and distributed configuration, install relay equipment with microcomputer, df1700 intelligent remote control equipment and other automatic equipment, and realize integrative automation of substation

    本變電所的二次系統設計中採用分層分散式系統結構，利用南瑞繼保電氣公司的微機型繼電保護裝置及df1700分散式電站自動化系統，經過功能組合和優化設計，對變電所執行自動監視、測量、控制和協調。
  11. The inter - link of tdrss contained forward link and return link. the forward link is the signal retransmitted from earth station to relay satellite, then transmitted the tt & c to the user aircraft

    前向鏈路指地面站經數據中繼衛星轉發信號，向用戶航天器（包括成像偵察衛星、航天飛機與載人飛船等）發送跟蹤、遙測與控制指令。
  12. Using distributed architecture, this controller integrates functions of protection, metering, signaling, communication and new kind of distribution automation. it combines the function for integrated automation and feeder automation. so this product can be used not only in the reforming of substation, realizing the protection of equipments and power lines, but also in ring power network, through repetitious reclose, eliminating instantaneous faults and isolating permanent faults

    本文所研究的智能重合控制器採取戶外分散式結構，將保護和測量、控制、信號、通訊以及新型配電自動化等功能集成一體；與斷路器配合，將綜合自動化系統中的測量、保護功能與饋線自動化系統中的重合功能相結合，不僅可以運用於變電站的改造，實現站內設備、線路的保護；還可以運用於城鄉環網中，通過多次重合，消除暫時性故障，隔離永久性故障。
  13. This paper sums up the recent development of the domestic substation automation technology, and the design principle and working mode of substation automation system as well, then proposes the development strategies of substation automation technology and operation mode

    認為全分散式變電站自動化系統是今後發展趨勢，這對我國一、二次設備設計、製造、運行管理部門都是一個全新的課題；要積極而慎重地推行保護、測量、控制一體化設計，且隨著各專業的相互滲透，原有的專業分工將會重新調整、組合。
  14. Computer testing control in transformer substation

    變電站的微機檢測與控制
  15. Computer testing control in transformer substatio

    變電站的微機檢測與控制
  16. Slave computers have data detection and control function with the help of the data capture and control interfaces which are composed of all kinds of position switches, sensors and execution units

    以各種位置開關、傳感器和執行元件為電站的數據採集和控制的介面，下位機具有數據檢測和控制功能。
  17. The system controlling automobile ' s test line will be designed by the developer who knows the whole test line and can describe it with one of program languages

    機動車安全檢測線控制系統軟體的實現，在於各檢測站對檢測線的理解和開發商的軟體解釋。
  18. Fundamentals of compiling

    變電站的微機檢測與控制
  19. Icsps integrate relaying protection, measuring, control and tekecommunications functions, and power station can be controlled and managed in all aspect by icsps

    它集微機繼電保護、測量、控制、遠程通信於一體，對變電站進行全方位的控制和管理。
  20. In the substation integrated automation system, the monitoring and control system is the interface of protection, monitoring, communication settings and substation operator. it also must send data between substation and distant dispatchers office

    變電站綜合自動化系統中，監控軟體充當站內保護、測量、控制以及通信裝置與變電站運行人員之間的介面，在變電站綜合自動化系統乃至電網自動化系統都起到重要的作用。
分享友人
分享到 Line

分享到臉書