測距誤差 的英文怎麼說

中文拼音 [cèjùwùchā]
測距誤差 英文
range error
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 距 : Ⅰ名詞1 （距離） distance 2 （雄雞、雉等的腿的後面突出像腳趾的部分） spur （of a cock etc ）Ⅱ動詞...
  • 誤 : Ⅰ名詞（錯誤） mistake; error Ⅱ動詞1 （弄錯） mistake; misunderstand 2 （耽誤） miss 3 （使受損害...
  • 差 : 差Ⅰ名詞1 （不相同; 不相合） difference; dissimilarity 2 （差錯） mistake 3 [數學] （差數） differ...
  • 測距 : range [distance] finding; distance measurement; ranging; stadiometry
  • 誤差 : error
  1. The model of the itr between a1n and cu is built by using the acoustic mismatch model, amm and diffuse mismatch model, dmm. because there is a limit of roughness and temperature in amm and dmm, the data of the theory model that is directly built by amm and dmm is far from the experimental data. accordingly, with dmm and traditionary methods, the mathematics model is posed by contrast and analyses of the experiment data

    由於聲失配理論和散聲失配理論對溫度和粗糙度有很嚴格的要求，所以直接建模所得的理論數據與實驗數據有很大的差距，本文採用聲失配理論與傳統研究方法相結合，通過與實驗數據的分析擬合，提出了修正的數學模型，預測誤差有了大幅度的提高。
  2. Due to the image exists the instances of spin and distortion, in order adopting part small template proceed matching in order to reduce thereof impacts by as possible, besides small template matching may decrease calculation quantity, and it is propitious to real time of matching. looking into be on the impact of illumination, chromatism, under cloak circumstance template size and quantity select versus matching rate. matching primitive chooses gray, gray information measure large and most easy to obtain, but it is rather effected by illumination condition and chromatism, maximum matching rate restricted to 70 %

    瓷磚缺陷檢測採用待測圖像與標準圖像作差法，作差法對匹配精度要求較高，因此在匹配誤差存在的點進一步做了亞像素級的匹配;導彈目標識別，採用背景匹配的方法，統計背景移動距離指導目標的識別;叢林中移動目標識別，採用作差法找到目標區和背景區，分別採用不同的模板和閾值匹配，統計目標區匹配結果。
  3. The main work of the first part includes : introducing some methods of underwater sound positioning and analyzing their performance, analyzing the theory of measuring direction and distance of the target by three elements symmetrical and dissymmetrical array, comparing the measuring error of two kinds of array, and giving the theory of the generic arrays and discussing the phase wrapping and the distance wrapping in passive ranging

    對被動測距技術的研究工作主要包括：簡單介紹了水聲定位的幾種方法，並對其性能進行了分析對比，分析了三元對稱陣和非對稱陣測向測距的原理，對兩種陣型的測向測距誤差進行了對比分析，還給出了一般陣型測向測距原理，最後還對被動測向測距中存在的相位模糊和距離模糊問題進行了探討。
  4. On the determination of errors in thin lens ' focal distance

    對測定薄透鏡焦距誤差的探討
  5. Using ansys as analysis tool, and the influence of river water fluctuating on geoelectric observation data in different distance from riverway to geoelectric monitoring observe station is numerically simulated, and the relationship between error of observation data and distance from riverway to the stations is summarized

    摘要利用ansys作為分析平臺數值模擬了觀測系統距河道不同距離情況下，由河水漲落引起的淺層局部電性非均勻性對地電觀測數據的影響，總結了觀測系統距河道遠近與觀測數據誤差大小的關系。
  6. Thirdly, an ideal satellite orbit is simulated, and on this foundation, we establish some typical simulation and testing circumstances. lastly, after simulation in the simulation and testing circumstances, we compare the performance of ukf and ekf. and then, based on the outdoor experiment of the vehicle, an analysis and contrast between our simulation results and commercial data process software is carried out, and the conclusion is obtained

    首先在第三章提出的目標運動模型的基礎上建立了系統狀態方程;其次簡要分析了衛星導航系統中的各類誤差，建立了基於偽距觀測量的系統觀測模型;第四節利用yuma格式歷書數據模擬了未受攝動影響的衛星軌道，並在此基礎上建立了幾種典型的動態模擬測試環境;第五節為模擬分析和比較，先對ukf演算法和ekf演算法在動態模擬測試環境中進行了模擬比較，然後針對外場試驗，對非線性濾波獲得的定位結果與商業軟體進行了分析比較，並得出結論。
  7. The influence of surveying distance error on the boundary point ' s accuracy

    測距誤差對界址點精度的影響
  8. First, the error transfer characteristic among subsystems at different space locations is analyzed, and the direct transfer characteristic from discrete standard measure space to the workpiece measure space under measured in measure system is proven. second, the error reconstruction condition and method of mapping from discrete standard measurement system to continuous standard measure space are analyzed. based on the measurement sample stationarity in limited distance, the prediction model ' s limited astringency and mensurability to the dynamic measuring error and the prediction error respectively are proven

    分析了不同空間位置子系統間的誤差傳遞特性，證明了在測量系統中離散標準量值空間向被測量工件量值空間的直接傳遞性；分析了離散標準量系統向連續量值空間映射的誤差重構條件和方法；基於測量樣本的有限距離的平穩性，證明了預報模型對動態測量誤差的有限收斂性和預報誤差的可測度性，進而證明了以離散標準量值系統對被測工件預報修正的可行性和合理性。
  9. In this thesis, the fault location algorithms of hv transmission line are evaluated at first, then the factors that affect the accuracy of the fault location are analyzed, and the proper solutions are presented

    本文首先對現有高壓輸電線路故障定位方法進行了綜合評述，在此基礎上對造成穩態故障測距誤差的一些尚未獲得滿意消除的因素進行了深入的探討，並提出了相應的解決方法。
  10. The sensitivity analysis and discussion of pose measurement error caused by the measurement errors of coordinate measuring machine and by the coordinate errors of three standard spheres on the base platform has been done in detail. the pose measurement error formulas as function of the measurement errors of coordinate measuring machine and the coordinate errors of three standard spheres have been deduced and it has been discovered that larger relative diatances among the three standard shpheres will efficiently minimize the influence of the measurement error of coordinate measuring

    推導出了三坐標測量機的測量誤差、固定平臺上三個標準球的位置誤差對位姿測量誤差的函數，發現只要適當地增大固定平臺上三個標準球之間的相對距離，就能夠有效地降低三坐標測量機的測量誤差和固定平臺上三個標準球的位置誤差對位姿測量的影響，從而提高了位姿測量的準確性。
  11. In order to reduce measure error causing by nlos, it adopt and regard intensity of the signal as right value, construct some tdoa measurement value again with the priori information

    為了減少非視距傳播nlos引起定位參數測量誤差，採用以信號強度為權值，用先驗信息重構部分tdoa測量值。
  12. This thesis analyzes the influence of line length and parameters changing on fault location results. lots of simulation results show the error of line length and parameters can cause the great locating error

    本文分析了輸電線路長度和參數的不準確對故障定位結果的影響，由大量模擬分析發現，線路長度和參數誤差會導致極大的測距誤差。
  13. But the phase changes many times of in while the range changes within a range - bin, thus ambiguity will occur in the phase measurement. to avoid the ambiguity in measuring the phase of the fft, the sampled data are divided into two segments, then apply fft on each segment of data separately

    ，因此可以用來估計距離（頻率x但是由於兩個fft的相位差隨距離的變化比fft的相位本身隨距離的變化慢很多，因此利用分段fft相位差估計距離要求fft相位測量誤差很小，為此本文又提出了利用分段fft的相位差消除相位測量模糊而用其中一段fft的相位估計距離的方法。
  14. Error analysis and correction for the coordinate measuring machine

    基於坐標測量機的雙目視覺測距誤差分析
  15. This algorithm can be executed independently of the source impedance and fault resistance with an error less than 0. 5 percent

    該演算法原理簡單，求解方便，模擬結果表明，演算法具有較高的精度，最大測距誤差小於0 . 5 % ，能夠滿足工程要求。
  16. The main work of the first part includes : analyzing the theory of measuring direction and distance of the target by three elements symmetrical and dissymmetrical array, comparing the measuring error of two kinds of array, discussing the characteristics of time delay in passive distance measurement, giving valid method of time delay estimation, and discussing the restriction of this method and the distance wrapping in passive ranging

    對三元非對稱陣被動測距技術的主要研究工作包括：分析了三元對稱陣和非對稱陣測向測距的原理，對兩種陣型的測向、測距誤差進行了對比分析，探討了三元陣被動測距中時延差的特點，提出了有效的時延差估計方法，並對該方法的局限性以及被動測距中存在的距離模糊問題進行了探討研究。
  17. ( 2 ) the measurement error using the 0. 618 method to measure grounding resistance with short electrode wire is discussed. the analysis results show that the measurement results must be modified, or change the placement of voltage - electrode

    通過對模型的計算和討論，發現在短距測量時，傳統的0 . 618法將導致較大的測量誤差，必須對測量結果進行修正，或者對測量位置進行調整。
  18. At the same time, being aware of the error due to the variation of the overhead line parameters with the environment, which is a common problem, the technique of on - line estimation for the parameters of the transmission line is put forward

    針對由於輸電線路參數隨外界條件變化而帶來的雙端測距誤差，本文利用現有的雙端（或多端）測距所提供的硬體設備，提出了基於兩端數據同步的線路參數在線估計技術和演算法。
  19. The tactical missile seeker handover accuracy from midcourse to terminal guidance is researched. the small perturbation method is proposed to analyse error sensitivity of the seeker presetting parameters from error sources. firstly, the terminal guidance seeker presetting parameters are computed, based on the equations of a surface - to - air missile movement and a target movement. then the seeker presetting unaccuracy due to the command guidance radar measurement errors is also computed. it can be seen that the seeker presetting errors increase rapidly when the missile is close to the target, which leads to an important conclusion that the late seeker handover from midcourse to teminal guidance should be avoided

    研究復合制導的戰術導彈中末制導交班的導引頭預定精度問題.提出用小擾動法分析導引頭預定參數對誤差源的誤差敏感性關系.以中遠程防空導彈為例，結合導彈運動方程組和目標運動模型，計算了中末制導交班的導引頭預定參數，並計算了在制導站雷達測量誤差下的末制導導引頭預定參數的計算精度.可知，導引頭定位參數的計算誤差隨著彈目距離的接近而顯著增大，得到中末制導交班不能太晚的重要結論
  20. Abstract : the tactical missile seeker handover accuracy from midcourse to terminal guidance is researched. the small perturbation method is proposed to analyse error sensitivity of the seeker presetting parameters from error sources. firstly, the terminal guidance seeker presetting parameters are computed, based on the equations of a surface - to - air missile movement and a target movement. then the seeker presetting unaccuracy due to the command guidance radar measurement errors is also computed. it can be seen that the seeker presetting errors increase rapidly when the missile is close to the target, which leads to an important conclusion that the late seeker handover from midcourse to teminal guidance should be avoided

    文摘:研究復合制導的戰術導彈中末制導交班的導引頭預定精度問題.提出用小擾動法分析導引頭預定參數對誤差源的誤差敏感性關系.以中遠程防空導彈為例，結合導彈運動方程組和目標運動模型，計算了中末制導交班的導引頭預定參數，並計算了在制導站雷達測量誤差下的末制導導引頭預定參數的計算精度.可知，導引頭定位參數的計算誤差隨著彈目距離的接近而顯著增大，得到中末制導交班不能太晚的重要結論
分享友人
分享到 Line

分享到臉書