測量用變量器 的英文怎麼說

中文拼音 [cèliángyòngbiànliángqì]
測量用變量器 英文
measuring transformer
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 用 : Ⅰ動詞1 （使用） use; employ; apply 2 （多用於否定: 需要） need 3 （敬辭: 吃; 喝） eat; drink Ⅱ名...
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 測量 : measure; survey; gauge; meter; measurement; measuring; surveying; mensuration; metering; gauging;...
  1. When measuring the magneto performance parameter ， we find that the instrument which use to measure voltage and current is still the simple voltmeter and amperemeter in the national standard ， and the form of wave that we observed is anomaly. based on the measure principles, it obviously ca n ' t be used to do quantitative analysis ； because the discharge process of ignition system is quite complex, accompanies with very strong electromagnetism interference, and the ignition current and voltage are variable ， it make the measure of ignition energy become a difficult thing of ignition system performance detection

    在磁電機常規測量時，發現在國家標準中用於測量電壓、電流的儀器仍然是普通的電壓、電流表，而觀測到的波形多為不規則的形狀，根據測量原理，顯然不能用其來做定量的分析；由於點火系統的放電過程比較復雜，伴隨著很強的電磁干擾，點火電流、點火電壓都是變量，使得點火能量的測量成為點火系統性能測試的一個難點。
  2. The autogeny target neutron and pipeline neutron are monitored with associated particle method and long counter through changing different target foil. the effect of the autogeny target neutron is over ten times than that of the pipeline neutron

    對加速器d - t中子源自生靶中子和管道中子，通過改變不同靶片，用伴隨粒子法和長計數器進行測量，評估了自生靶中子和管道中子的影響。
  3. Changes in soybean water status have also been measured by beta ray gauging.

    大豆水分狀況的變化也已用射線計量器測出。
  4. Pre - data gathering module achieves the collection and communication of sixteen - route temperature signal. speed measuring and controlling module realizes the control of refolw soldering transfer speed by manipulating transducer. on - off outputting module fulfills calefaction control of calefaction tube by solid state relay. above position operator software programs by delphi, and realizes pid parameter automatic timing and no - oversnooting temperature control. software has friendly interface, convenient operation, complete functions

    前置數據採集模塊完成16路溫度信號的採集和通訊；速度測量模塊與速度控制模塊通過控制變頻器來調節迴流焊的傳輸速度；開關量輸出模塊通過固態繼電器對加熱管進行控制；上位機軟體採用delphi編程，實現了pid參數自整定以及無超調的溫度控制。
  5. Ch400 transformer coulometer can be widely applied in test on production line of small manufacturer of transformer or rectifier power or in labs

    Ch400變壓器電量測量儀系列可廣泛用於各種小型變壓器或整流器電源等廠家的生產流水線測試，實驗室試品試驗等場合。
  6. Optical 3 - d profilometry has been widely used for 3 - d sensing, machine vision, intelligent robots control, industry monitoring, biomedicine, dressmaking, etc. several 3 - d object profilometry methods, including moire technique ( mt ), phase - measuring profilometry ( pmp ), fourier transformation profilometry ( ftp ), modulation measurement profilometry ( mmp ) have been exhaustively studied

    光學三維傳感已廣泛應用於機器視覺，實物仿形，工業檢測，生物醫學等方面，在三維面形測量中，對莫爾輪廓術，位相測量輪廓術，付里葉變換輪廓術，調制度測量輪廓術這些方法已經進行了大量深入的研究。
  7. Secondly, the steel balls millstone is used to grind steel ball in ones steel ball factory, and process flocculus the steel balls that possess reticulate veins surface. measure the result as follows : ra ( surface roughness of steel ball ) = 0. 015 u m, wavmess = 0. 06 um, sph ( deviation from spherical form ) = 0. 010 u m, vdwl ( variation of ball lot diameter ) = 0. 015 u m

    然後利用製成的鋼球研磨板對鋼球進行超精磨削加工，加工出了表面具有網狀紋理形貌的「絨面」鋼球，利用儀器測量鋼球表面的粗糙度值達到了0 . 015 m ，表面波紋度值達到了0 . 006 m ，圓度達到了0 . 010 m ，球批直徑變動量小於0 . 015 m 。
  8. With the deveiopment of hydraulic technology, hydraulic system and hydraulicequipment are more complicated, hydraulic technology is more widely and morecomp1icatedly used in agricultural machine and their malfunction is more difficu1t to bedetected. fault diagnosis of hydraulic system is not as apt to be observed as that of themechanical equipmeflt or is not as easy to be detected as that of electric equipmeflt bymu1tipurpose meter or other meters. flux meter gage and pressure gage ca n ' t meet the needof fault diagnosis for hydraulic system because its working medium and workingcomponents are hiding inside the sealed vessel

    隨著液壓技術的發展，液壓系統及液壓設備越來越復雜，液壓技術在農機上的應用也變得廣泛而復雜，農機液壓系統的故障診斷也越來越困難，液壓系統的故障診斷不象機械設備那樣直觀，也不象電氣設備那樣通過萬用表等儀器測得，液壓系統的工作介質和工作部件都在密閉的容腔內，流量計、壓力表等測量儀器遠遠不能滿足故障診斷的需求。
  9. And the interfaces have analog input, analog output and digital input / output. we have used differently cards, such as pc - 6330d a / d card, pcl - 728 d / a card based isa bus, ipc - 5375 i / o card and so on. in addition, we select micro - stir switches and pressure sensors as sensor elements to inspect the system and choose relays and induction valves to control the bicycle pump and the motor

    總線採用isa內部總線；介面主要有模擬量輸入介面、模擬量輸出介面、開關量輸入輸出介面等，課題分別選用pc - 6330d型a d板卡、基於isa總線的型號為pcl - 728的d a板卡、型號為ipc - 5375的i o板卡；另外，課題選用了微動式行程開關、壓力變送器作為傳感元件檢測系統，選用繼電器、電磁控制換向閥實現對氣缸、電機的控制；採用vc + + 6 . 0編制控制軟體，實現了纖維鋪放技術的計算機控制。
  10. Whole scheme of frame design of test - bed is proposed as : the host fanner supply the firebox the once and twice air required by diesel oil ' s burning and the cooling air ; the export parameter of the test - bed is varied by the adjust of the flux of air and diesel oil. and the air flux is varied by adjusting the rev of the fanner adjusted by transducer and the corner of the fan inlet adjusted by step motor. the quantity of oil is varied by adjusting the oil valve adjusted by step motor ; the measurement of the air flux in the test - bed adopts the method of fanner dynamics performance test in the nation criterion

    確立了實驗臺結構設計方案：主風機為燃燒器提供燃燒所需的一次、二次進風量及冷卻風量；利用變頻器調節主風機轉速、用步進電機調節風門開度來調節風量，用步進電機調節回油閥開度來調節供油量，從而實現對模擬實驗臺出口煙氣熱流量的調節；實驗臺的流量測量採用風機動力性能測試標準中測流量方法等。
  11. Based on the theory that the optical properties of zncdse / znse qd structure at different formation and ripening stage are different from each other, by investigating the variation in emission peak energy and integrated intensity, the formation and ripening information of the dots was obtained, which overcomes the disadvantage of atomic force microscopy ( afm ) in that it can not be applied to the measurement of the initial formation stage of the qd. furthermore, it is of great help to clarify the controversies in the ripening process of se - compound qd

    利用量子點在不同形成和熟化階段具有不同的光學性質這一思想，通過測量zncdse znse量子結構的發光峰的位置與相對強度的變化，獲得了量子點的形成和熟化信息，從而既解決了一般金屬有機物化學氣相沉積（ mocvd ）設備由於沒有原位監測儀器而無法對量子點的形成過程進行監測的不足，又澄清了原子力顯微鏡表徵的量子點熟化過程的爭議。
  12. A novel fault diagnostic strategy based on time - varying dynamic pca model has been presented, which makes use of continuous updating time - lagged data matrix to construct a changeable pca model to fulfill the task of fault detection and identification

    摘要提出利用不斷更新的時滯數據矩陣建立變化的動態主元模型對某些動態系統內的傳感器故障進行檢測，利用變量貢獻圖的樣本平均對故障進行識別的方法。
  13. Aerospace series - elements of electrical and optical connection - test methods - part 704 : electrical elements - measurement of turns ratio on a transformer used in a coupler

    航空航天系列.電氣及光學連接元件.試驗方法.第704部分:電氣元件.耦合器用變壓器的匝數比測量
  14. Current transformers are widely used for changing the magnitude of ac current. high currents can be stepped down to facilitate measurement by precision ammeters

    使用變流器能把高值電流變為低值電流，以便使用精密電流表進行量測。
  15. Blood essels causing edema of the lower legs were measured using a strain gauge plethysmography ( a general instrument for determining and registering ariations in the size of an organ or limb )

    利用應變容積描記術（用於測量並記錄器官或四肢的尺寸一種通用方法）測量低位腿部水腫患者的血管直徑。
  16. But in the paper, there are two directly inputting variables that they are ed and fd, and the ed is calculated by ld and rd, where the ld, rd and fd denote the distance that are measured by range sensors on a car between the left, right, front obstacle and the car, then they will be translated into controlling variable u by the function of fuzzy controller, and then the car will move basing on the controlling variable u

    在常規的模糊控制中採用變量和變量變化以及變化率作為輸入的多維模型。本文採用所檢測到的三個距離即ld 、 rd 、 fd經過簡單變換為ed 、 fd ，再以這兩個變量直接作為輸入，經模糊控制器的作用，輸出控制量u ，小車就按照該控制量的控制來實現運動。
  17. After comparing many methods of capacitor measurement, the method of stray - immune microcapacitor measurement based on charge - discharge method is used, so the theory and advantage of this method are especially analyzed

    其中微小電容測量是變送器部分的關鍵技術，在比較了多種電容測量方法后，採用了基於充放電法的抗寄生干擾的微小電容測量方法，因此重點在理論上分析了這種測量方法的原理和優點。
  18. The interferometric strain gage offers a method for measuring strain without actual use of a gage.

    干涉應變計提供了一種實際上不用儀器測量應變的方法。
  19. Resonant devices are used to measure strain, stress, acceleration, pressure, mass, flow, etc. by detecting the change of the resonant frequency or amplitude of the resonant components

    諧振器件通過檢測振動元件的諧振頻率或振幅的變化來測量應變、應力、加速度、壓力、質量變化以及流量等，廣泛應用於力學量傳感器中。
  20. By using single - chip microcomputer c8051f060 and dds ad9852, the instrument is easy to measure the transport characteristic of the high frequency tuner. by using c8051f060 to control dds chip ad9852, a signal with high resolution, high transferring speed and pure spectrum is obtained. the output frequency range is up to 1000mhz. the system can give the frequency characteristic drawing of the high frequency tuner by connecting pc with usb

    採用cygnal公司的專利cip51微處理器內核的c8051f060單片機作為控制器，使用鎖相環+直接數字合成+下變頻的方法構成掃頻信號源，用直接數字頻率合成（ dds ）晶元ad9852實現掃頻信號的控制，產生測量用的掃頻信號的范圍為1 ~ 1000mhz 。
分享友人
分享到 Line

分享到臉書