測隙片 的英文怎麼說

中文拼音 [cèxìpiān]
測隙片 英文
feeler blade
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 隙 : 名詞1 （縫隙; 裂縫） crack; chink; crevice 2 （空閑） gap; interval 3 （漏洞; 機會） loophole; op...
  • 片 : 片構詞成分。
  1. The system measures photosynthesis rate by using infrared co2 gas analyze method. it has two work modes : open route and close route. it can measure the leaf photosynthesis rate, transpiration rate, stomata conductance and co2 thickness in cell clearance etc parameters about plant physiology

    本文研究設計了測定光合、蒸騰速率的主從式虛擬儀器系統，系統採用紅外線分析法測定光合速率，設置有開路和閉路兩種測定方式，可以測量植物葉片的光合速率、蒸騰速率、氣孔導度和細胞間隙co _ 2濃度等與植物光合作用相關的參數。
  2. By using a counter and an operation microprocessor, this paper analyses the measuring method and designs an instrument of edm sinking process in discharge state. this instrument takes samples of voltage, current signal and strong and weak of high frequency signals of detecting voltage amplitude, translates them into various time pulses in discharging state. and a counting unit turns these pulses into digital signals, then send them to a microprocessor. finally various discharge time percentages are sent to the control tache

    通過采樣電火花加工放電間隙的電壓、電流信號和檢測電壓幅值上的高頻信號的強弱，得出反映間隙放電狀態的各種時間脈沖，利用計數器分別對其計數，再送給單片機運算處理，輸出控制環節所需的各種放電狀態時間百分數。
  3. Abstract : by using a counter and an operation microprocessor, this paper analyses the measuring method and designs an instrument of edm sinking process in discharge state. this instrument takes samples of voltage, current signal and strong and weak of high frequency signals of detecting voltage amplitude, translates them into various time pulses in discharging state. and a counting unit turns these pulses into digital signals, then send them to a microprocessor. finally various discharge time percentages are sent to the control tache

    文摘:通過采樣電火花加工放電間隙的電壓、電流信號和檢測電壓幅值上的高頻信號的強弱，得出反映間隙放電狀態的各種時間脈沖，利用計數器分別對其計數，再送給單片機運算處理，輸出控制環節所需的各種放電狀態時間百分數。
  4. Based on the analysis of thin sections by microscope, measurement of porosity and density, and geological setting, we tested the rock physical parameters of sandstone, siltstone, carbonate and other transitional sedimentary rocks by the mts system under formation conditions ( temperatures, pressures and pore fluid properties ). the rocks we tested are from tertiary ( including zhujiang formation, zhuhai formation, enping formation, hanjiang formation ) of zhujiangkou basin in southern china sea. according to the analysis results, we studied the main ultrasonic wave velocity characters of rocks, which are compressive and shear wave velocity and poisson ' s ratio under different formation conditions

    在對珠江口盆地第三系儲集巖進行顯微鏡薄片分析、孔隙度和密度分析，以及地質背景分析的基礎上，利用巖石物理參數測試系統（ mts ）模擬地層條件（溫度、壓力和孔隙流體狀況）測試了珠江口盆地第三系（包括珠江組、珠海組、恩平組、韓江組，以下有關討論同）砂巖、粉砂巖、碳酸鹽巖及其過渡性巖石物理性質，重點研究了不同地層條件下巖石的聲學特徵（巖石的縱橫波速度和泊松比） 。
  5. Either the boron nitride ( bn ) thin films with different cubic phase content were deposited on n - type si ( 111 ) and fused silica substrates by radio frequency ( rf ) sputtering using two - stage deposition process. the films were characterized by fourier transform infrared ( ftir ) spectroscopy. the transmittance te ( ) and reflectance re ( ) were obtained as a function of incident photo wavelengths and the thickness of films was measured by alpha - step. the absorption coefficient was calculated from te ( ) and re ( ). the optical band gap ( eg ) of the films was determined by effective medium form of formula containing eg

    本文還研究了立方相含量與光學帶隙的關系，在n型si （ 111 ）片和熔融石英片上沉積出不同體積分數的立方氮化硼薄膜，薄膜的成分由傅立葉紅外吸收譜標識；用紫外-可見分光光度計測量了沉積在石英片上的bn薄膜的透射光譜te （ ）和反射光譜re （ ） ，薄膜的厚度用臺階儀測得。
  6. On the basis of the study of high resolution sequence stratigraphy, this paper discusses the reservoir petrology ' s diagenesis and secondary pore of the chang 4 + 52 ~ chang 62 pay zones in detail by using the methods of analysis of mercury injection, cast section, popular section, scanning electron microscope, x - ray diffraction and etc. the reservoir rock is mainly composed of feldspar fine sandstone, which is characterized by low compositional maturity and relatively high textural mature

    本文在高解析度層序地層學研究的基礎上，通過15口井的常規物性、壓汞、鑄體分析、薄片鑒定、掃描電鏡、 x光衍射、陰極發光、粒度分析等多項測試手段，對坪北油田延長組長4 + 52長62儲層巖石學、成巖作用及次生孔隙進行了詳細研究。
  7. In this paper, the definitions of soil macropore and macropore flow, their types, characteristics, generation mechanisms, and experimental methods in laboratory and field were introduced, and the research progress in their determination techniques, including dye tracing, slice up penetration curve, tension infiltration apparatus, x - ray ct scanning, and radar exploration were summarized

    摘要介紹了大孔隙及大孔隙流的定義、多種表現形式及其重要特徵、產生機理和室內外實驗研究概況，以及染色示蹤、切片、穿透曲線、張力入滲儀、 x射線ct掃描攝像和雷達探測等方法的研究進展，揭示這些實驗方法的優點與存在的問題。
  8. In order to make clear the effects of fe3o4 on composite film structure, the thickness, porosity, average and maximum pore size, pore size distribution of different films are measured. surface morphology is studied by scan electronics microscope ( sem ). the characterizing results of film micro - morphology showed that pore structure of fe3o4 / pvdf composite film were better than those of pvdf host film

    為進一步分析fe3o4的原位生成對復合膜結構的影響，測定了pvdf基膜和復合膜的膜厚；採用干濕膜重法測試了膜樣品的孔隙率；採用泡點壓力法流體滲透法相結合，對比測試了膜樣品的最大孔徑、孔徑分佈及平均孔徑；通過掃描電子顯微鏡（ sem ）照片分析，對比研究了pvdf基體膜和fe3o4 / pvdf復合膜的表面形貌。
  9. Through the statistic and analysis of rock core crack, sonic wave velocity test, microcosmic structure of core slice observation by electron microscope, core strength test to the sampled damaged slope rock mass, it indicates that the damage degree of smooth blasting to slope rock mass has no obvious relation with blasting scale but with the line density of explosive filling and the strength of the rock in damaged area decreases evidently

    通過受損邊坡巖體取樣巖芯裂隙的統計分析、聲波速度測試、巖芯切片微觀結構的電鏡觀察及巖芯的強度試驗，發現光面爆破對邊坡巖體的損傷程度與爆破規模無明顯關系，而與光爆孔的線裝藥密度有關，損傷區巖石的強度明顯降低。
  10. This machine is controlled by the industry control computer, which can measure the clearance along the driving taper gear axes and select the suitable sleeves so that the clearance can be eliminated and the set tightening of the bearing can be achieved

    選墊機採用工業控制機控制、自動化檢測驅動橋主錐齒輪軸軸向間隙，並優化選擇合適的墊片，通過墊片來消除軸向間隙並調整軸承達到設定的預緊力矩。
  11. The feeler material must be harder than the material that is checked ( hardened pins )

    測隙片的材料必須比被檢查的材料更堅硬（被硬化的針） 。
  12. Advanced technical ceramics. monolithic ceramics. general and textural properties. part 2 : determination of density and porosity

    高技術陶瓷.單片陶瓷.一般和結構特性.第2部分:密度及孔隙度的測定
  13. Leaf type head on the probe allows it to fit through small openings, so it is ideal measuring for the small opening temperature of dies, bearings, machinerys, etc

    薄片型探頭的端部適合通過狹小縫隙，所以它是測量模具、軸承以及機械設備狹縫溫度的理想工具。
  14. Firstly, waveguide - slot - microstrip patch coupling structure is studied and designed. secondly, series - fed array is studied and designed. lastly, the array is made and measured

    首先對波導-縫隙-微帶貼片耦合饋電結構進行研究和設計;然後對微帶串饋陣進行研究和設計;最後設計和製作出面陣，並對它進行調試和測量。
  15. Oxygen precipitation characterization of silicon wafers by measurement of interstitial oxygen reduction

    矽片氧沉澱特性的測定-間隙氧含量減少法
  16. Test methods for oxygen precipitation characterization of silicon wafers by measurement of interstitial oxygen reduction

    通過測量間隙氧含量的減少表徵矽片氧沉澱特性的方法
分享友人
分享到 Line

分享到臉書