溫差法 的英文怎麼說

中文拼音 [wēnchā]
溫差法 英文
temperature difference method
  • : Ⅰ形容詞(不冷不熱) warm; lukewarm; hot; gentle; mild Ⅱ名詞1 (溫度) temperature 2 (瘟) acute ...
  • : 差Ⅰ名詞1 (不相同; 不相合) difference; dissimilarity 2 (差錯) mistake 3 [數學] (差數) differ...
  • : Ⅰ名詞1 (由國家制定或認可的行為規則的總稱) law 2 (方法; 方式) way; method; mode; means 3 (標...
  • 溫差 : [物理學] difference in temperature; range of temperature
  1. The article mainly studied and analyzed the chemical structure and conponents of yeast, pointed out that the way that yeast autolysis combined together with both breaking - wall in temperature difference and high - pressure homogenization can be used to promot the inside things from waste yeast cell and enhance the extract rate, thus searched for the technology in higher extraction rate

    摘要主要研究分析了酵母化學結構與組成,提出了酵母自溶、破壁、高壓均漿三者相結合的方來促進酵母內容物溶出提高抽提率,探索抽提率比較高的工藝流程。
  2. This evidence supported the hypothesis that contrails reduce the temperature range by cooling the atmosphere during the day and heating it at night

    這個證據支持凝結尾會縮小日夜的說,白天會使度下降,夜間則使度上升。
  3. The box beam ' s temperature stress of longitudinal direction and transverse direction with different conformation are analyzed, it finds that there is largish temperature tensile stress in the bottom of top deck and the haunch of box beam increase temperature tensile stress in the bottom of top deck. the paper makes a study of different thermal effects resulted from several kinds of closed rigid frame

    根據大量實測度場結果建議採用一個有利於理論推導的指數函數的公式來擬和箱梁體內的分佈,既貼近實測數值,計算又比較簡單;通過對空腹式剛架拱橋尤溪洲大橋所在地夏季、秋季、冬季的度場及度應力的實測,以及與本文所提出計算方的理論解進行的分析比較,證實了本文計算方的正確,同時改進了已往混凝土箱梁度自應力的計算方
  4. Abstract : the paper established the idea of passive solar houses with zero - auxiliary heating source as well as the calculating method for the design and passive solar house. based on the ratio of radiant temperature difference i. e. thermal design and calculation method for passive solar houses with zero - auxiliary heating source

    文摘:著重介紹零輔助熱源被動式太陽房的概念及以輻射比為設計依據的被動式太陽房熱工設計計算方零輔助熱源被動式太陽房熱工設計計算方
  5. Based on the refrigerant state, divides a heat exchanger into three zones with zoned lump method, i. e. superheat, two - phase and subcooling zones, works out the temperature difference and heat transfer coefficients of the three zones

    採用分區參數將換熱器按製冷劑狀態分為過熱、兩相、過冷三區,分別計算了各區的換熱、傳熱系數等。
  6. Since the temperature difference was most important parameters in thermal effects calculation, a combined temperature difference method considered year temperature difference and day temperature difference was put forward. with the combined temperature difference obtained from field tests, a lot of calculations have been done by finite element method ( fem ), considering of different structural measures. the law of displacement and stress in cshbb was presented and a relative displacement formula was deduced

    在介紹小砌塊建築的度作用分析方的基礎上對度作用計算中最重要的參數? ?取值進行了探討,提出了同時考慮年和日影響的組合取值方;根據各種不同的組合取值方,結合現場實測數據給出了試點建築的組合取值,並考慮了不同構造措施的影響,對試點建築進行了有限元的度效應計算;給出了小砌塊建築的位移變化規律和應力變化規律以及層間相對位移的計算表達式。
  7. As the microbolometer which is voltage biased express some characters different from other infrared detectors under the effect of electric heat and infrared radiation together, the computing method of parameters, such as responsivity, noise, noise equivalent temperature different ( netd ), noise equivalent power ( nep ), optical gain, detectivity and so on is given in this paper. some of these parameters are particular compared with other detectors, and some have difference between microbolometer and other detectors

    由於微測輻射熱計在施加偏置電壓的情況下,電熱效應與紅外輻射的共同作用使它表現出與其他紅外探測器完全不同的一些特徵,文中給出了響應率、噪聲、噪聲等效功率、噪聲等效、光學增益、探測率等參數的計算方,這些參數中的部分是微測輻射熱計獨有的,或者與其他的紅外探測器的同一參數有所區別。
  8. The system follows carnot cycle principle. driven by electricity, its working substance absorbs the latent heat in the air or other low - temperature heat source, and waste heat let out of living or industry, compresses it to heat by compressor, exchange, exchange heat with water to higher the water temperature ( 55 warm ). it a new water heating apparatus, used in home heating, and influenced by environment runoff and the heat exchang of working substance. this system is more used in southem china

    根據逆卡諾循環原理,採用電能驅動,通過工質吸收空氣中或其他低熱源中無被利用的太陽能潛熱、生活及工業排放的廢熱,通過壓縮機壓縮升,再與水換熱,使水升高,獲得( 55 )熱水,是一種新型的熱水製造設備,應用於家庭和熱水系統,受到環境和工質換熱的影響,熱泵熱水器/熱水系統更多適合南方地區應用。
  9. The contents include : based on the previous research and the data of experimentations, the author researches and develops a kind of satisfactory semi - empirical formula of nonlinear temperature distribution, and calculates the temperature stress of rigid - framed arch bridge by the fem. the temperature effects of bridge structure by annual and sunlight temperature difference are discussed, it indicates that the temperature effect of annual temperature difference is small but the temperature effect of sunlight temperature difference is great and the temperature stress along beam depth resulted from sunlight temperature difference is nonlinear. with the comparison between the temperature effects of different position of bridge, the results show that where the section of bridge is small, the temperature stress of it is large

    本文主要包括以下內容:從理論上研究並結合實測資料發展了一種比較理想的半經驗度場非線性分佈公式,並將有限元方應用於剛架拱橋結構度應力的計算中,對橋梁結構進行整體度應力分析;討論了年和日照引起的橋梁結構的度效應,表明年引起的度效應較小,而日照引起的度應力較大且沿梁高呈非線性分佈;分析比較了橋梁結構各個部位的度效應的大小,可知截面越小度拉應力越大,受力越不利;並對箱梁結構由於構造不同引起的縱向與橫向的度效應大小進行了探討,發現在頂板下緣也會出現相當大的度拉應力,並且梗腋的存在反而增加了頂板底部的度拉應力;還對幾種相近的剛構式橋型的度效應進行了分析對比,總結了這些橋型針對度效應的優劣,並提出相應的針對性措施。
  10. During the discussion of the coefficient which signifies the degree of fouling and slagging, traditional coefficient is abandoned. to the heat surfaces of convection, the coefficient of enthalpy difference is advanced, and to the water - cooled walls, the coefficient of temperature difference is adopted

    對于對流受熱面,本文摒棄了傳統的灰污特徵參數,提出了用焓灰污系數來反映積灰、結渣程度;而對於水冷壁,在背面溫差法的基礎上又引進了灰污系數。
  11. 3 the design theories of cooling pipe of play down internal temperature of mass concrete about diameter, length, arrange method, rate of flow, current velocity, reduce heat time, temperature disparity to in and out, reduce heating result etc. 4 the theory of influence about concrete internal temperature and concrete crack because of transform of mixture ratio and pulverized fuel ash sophisticate quantity

    西安建築科技大學博士生論文一;一;一一『一一一3降低大體積混凝土內部度常用的冷卻水管的管徑、長度、布置方、水流量、流速、降時間、進出水口的、降效果等的設計計算理論。 4配合比及摻加料對混凝土內部度和混凝土開裂的影響理論。
  12. Test method for density or relative density of light hydrocarbons by pressure thermohydrometer

    用壓力比重計測定輕質烴密度或相對密度的試驗方
  13. Test method for density, relative density and api gravity of crude petroleum and liquid petroleum products by thermohydrometer method

    比重計測定原有和液化石油產品的密度相對密度和api重量的試驗方
  14. Standard test method for density, relative density, and api gravity of crude petroleum and liquid petroleum products by thermohydrometer method

    比重計測量原油和液態石油產品的密度相對密度和api重量的標準試驗方
  15. Testing method for fine ceramics thermoelectric materials part 1 : thermoelectric power

    細陶瓷熱電材料的試驗方.第1部分:電勢率
  16. Therefore well controlling of difference in temperature and temperature strain are important measures on concrete cracking control

    因此,控制好內外度變形是防止大體積混凝土出現裂縫的重要方
  17. According to the laplace transformation method and superimposition principle, theoretical solutions of the effect of three typical bin ' s surface protecting methods of thermal insulation were given. based on the solutions, the characteristics and rules of three insulation procedures were analyzed in numerical calculation. the research results of this paper are valuable for engineers to design economical and viable bin ' s surface insulation way

    利用拉氏變換方及疊加原理,求解出保板保、倉面噴霧、流水養護這三種常用倉面保護方式降效果理論解答;並基於此理論解答,對三種倉面保護方式的特點及規律進行了研究,從數值上分析了幾個影響度變化的主要因素:保板厚度、內外梯度,距表面不同深度等對每種保護方式降效果的影響。
  18. Mean temperature difference for countercurrent flow and cocurrent flow in steady continuous heat transfer has been deduced uniformly

    摘要採用統一的方對定態傳熱逆流和併流的平均進行了推導。
  19. Test method for determining the rate of air leakage through exterior windows, curtain walls, and doors under specified pressure and temperature differences across the specimen

    在試驗樣件規定壓力和下測定通過外窗幕墻和門空氣泄漏率的試驗方
  20. In addition, describes the trouble diagnosis of catalytic converter by using the comparing method of double waste - gases, the comparing method of cold and heat idle speed, the temperature differential method in idle speed, the vacuum measuring method and etc

    另外,闡述了利用兩次廢氣對比、冷熱怠速對比、怠速溫差法及真空測量等方對催化轉化器的故障診斷。
分享友人