溫度位 的英文怎麼說

中文拼音 [wēndùwèi]
溫度位 英文
temperature level
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 位 : Ⅰ名詞1 （所在或所佔的地方） place; location 2 （職位; 地位） position; post; status 3 （特指皇帝...
  • 溫度 : [物理學] temperature
  1. Kelvin is the unit for the absolute temperature scale. one kelvin is equal to one degree celsius. however, the absolute temperature scale is shifted by 273

    絕對溫度是科學界最通用的溫度單位，只要將它減去273 ，便可轉化為攝氏度，例如絕對溫度300度，相等於攝氏27度。
  2. Through preparative experiments and optimized experiments on cu ~ zn ultrafine powders that are prepared by the method of thermal spray and ball milling, the author finds that dispersants concentration, dispersing time, ph, temperature and adscititious ions have significant influences on dispersing effects

    西安理工大學碩士學位論文通過對熱噴塗球磨法制備的超細銅鋅粉的分散性進行預試驗和優化試驗，發現分散劑濃度、分散時間、 ph值、溫度和外加離子濃度對分散作用效果有重要影響。
  3. The press is ingenious in design, hign quality in materials, with features as fine workmanship, handsome appearance, compact structure, higher work pressure, lower work noise, and equipped with single skip. controlled temperature, electric autotimer, so that it will be reliable is operation and easy to repair

    本機設計精巧，用材講究、製造精良、造型美觀、結構緊湊，傳動部分採用大功率雙向電磁離合器，可連續工作，也可單獨工作，且有壓力大、噪音小、單級跳位、溫度自控、電子式時間繼電器延時，操作安全可靠、維護保養方便等優點。
  4. E ) with the help of pecvd, we found that high substrate temperature is advantage to the basal plane orientation. higher temperature helps the particles absorbed on the substrate moved to the location of two - dimension nucleation rapidly

    E ）高溫有利於基面平行於襯底的取向，在高的生長溫度下吸附於襯底表面的沉積粒子能夠迅速遷移到二維核的位置，並使粒子有足夠能量調整位置。
  5. Burble out of the ground at many different temperatures and with many different types of mineral content

    位於火山地帶的陽明山擁有多種不同泉質不同溫度的溫泉。
  6. Pre - data gathering module achieves the collection and communication of sixteen - route temperature signal. speed measuring and controlling module realizes the control of refolw soldering transfer speed by manipulating transducer. on - off outputting module fulfills calefaction control of calefaction tube by solid state relay. above position operator software programs by delphi, and realizes pid parameter automatic timing and no - oversnooting temperature control. software has friendly interface, convenient operation, complete functions

    前置數據採集模塊完成16路溫度信號的採集和通訊；速度測量模塊與速度控制模塊通過控制變頻器來調節迴流焊的傳輸速度；開關量輸出模塊通過固態繼電器對加熱管進行控制；上位機軟體採用delphi編程，實現了pid參數自整定以及無超調的溫度控制。
  7. Heat convected, a mode of motion developed by such combustion, was constantly and increasingly conveyed from the source of calorification to the liquid contained in the vessel, being radiated through the uneven unpolished dark surface of the metal iron, in part reflected, in part absorbed, in part transmitted, gradually raising the temperature of the water from normal to boiling point, a rise in temperature expressible as the result of an expenditure of 72 thermal units needed to raise i pound of water from 50 to 212 fahrenheit

    燃燒所引起的運動形式之一-熱對流傳熱，不斷地加速度地從熱源體傳導給容器中的液體，由那凹凸不平未經打磨的黑色鑄鐵面把熱向周圍發散出去一部分反射回來，一部分被吸收，另一部分被傳導，使水的溫度從常溫逐漸升到沸點。這種溫度的上升可作為消費結果標志如下：將一磅水從華氏五十度加熱到二百十二度，需耗七十二熱量單位。
  8. In trpsin tolerance assay. this virus could resist to 1 % trpsis at 37 in an hour. in acid tolerance assay, this virus was resistant to ph3. 0 and ph5. 0 at 37 in 2 hours, and the average infection litre of the virus decreased little. in heat assay, at 50, the virus was processed from 5 minutes to 150 minutes and at each condition the viral virulence reduced to some certain degree. among these conditions, when at 50 in 30 minutes. the average infection litre of this virus decreased over 2 tilre. and when al 50 in an hour, cpe of ihis virus disappeared. when time was set for an hour. but with processed in different temperature as 50 60 70, 80, the virus losl the multiplication capacity complelely. in biological assay, we selected different cell lines to cultivate this virus by laking advantage of possesional cells at that time in our laboratory. then we found that fcwf cell line was the most sensitive to dxmv and mdck was the second. with f81 cell line, after passaged for 12 times continuously with low concentration of fcs. the virus could produce cpe. however, with vero cell line. the virus could not procuce any cpe after many passages. the hemagglutination and lumadsorption reaction test proved that this virus had no any reaction to erythrocyte of pig, fowl and cavy. by neutrolizaion assay, dxmv could be identified as a kind of ccv

    理化學研究表明，該病毒為rna病毒，對氯仿、乙醚敏感；胰酶試驗中，經37 、 1小時處理的病毒，仍然能夠在貓源細胞fcwf細胞上生長，並且毒力基本保持不變；耐酸性試驗中，病毒分別在ph5 . 0和ph3 . 0經37作用2小時，毒力僅下降一個滴度；耐熱性試驗中，該病毒在恆定溫度50 ，設定不同時間，從5分鐘到150分鐘，毒力均有不同程度下降，其中， 50作用30分鐘，病毒平均滴度下降2個單位； 50 ， 60分鐘， cpe消失；恆定時間1小時，設定不同溫度（ 50 - 60 - 70 - 80 ） ，病毒在細胞上完全喪失增殖能力， cpe消失。生物學試驗，利用實驗室現有條件，選擇不同的細胞系對該病毒進行培養，發現該病毒對貓源細胞fcwf最敏感； mdck細胞次之； f81細胞經多次傳代，亦可出現cpe ；而vero細胞則不敏感。血凝試驗表明，該病毒對豬、雞、人及豚鼠的紅細胞均無血凝性。
  9. Abstract : the formation technologies, the structure and properties of tcs microporous man - made yarn - kind new polyester fibre which was spinned in tcs with some micrometallic - oxide have been studied. the results indicate that the rheological behaviour and spinnability of commixed polyester melt, and the structure and properties of the fibre, are relative to the spinning temperature, melt pressure, microporpus size for spinning, formation conditions, thermo - vascellum temperature, thermo - vascellum position and rolling speed, besides the viscosity of polyester cuts, coacervation particles, adding amount and size of micrometallic - oxide

    研究表明， tcs微孔化共混聚酯熔體在成型加工中的流變行為和可紡性，及其纖維的結構性能除了與原料切片的特性粘度、凝聚粒子和共混聚酯中超細金屬氧化物微粒的添加量、粒徑等因素的影響有關外，還與紡絲溫度、紡絲熔體壓力、噴絲板微孔尺寸、冷卻成形條件、熱管溫度、熱管安裝位置以及卷繞速度等因素的影響密切有關。
  10. The mechanical environment is described in the paper and then the environments in three different orbits are proposed, called leo ( low earth orbits ), meo ( medium earth orbit ) and geo ( geosynchronous earth orbits ). the influence produced by the atomic oxygen, micrometeorites and debris, ionizing radiation and cold welding under vacuum is presented in the paper. some principles are proposed, which can be as the method to choose materials of the mechanism in space environment

    空間環境中力學環境對可動結構的影響直接關繫到機構的設計問題，所以本文第四章中嶽建如：中文摘要浙江大學博士學位論文20024首先詳細論述了空間環境中的力學環境，然後給出了空間環境的三種軌道環境劃分，及每一種環境影響因素對空間可動結構設計的影響，包括原子氧、離子射線、溫度、微隕石和碎片以及真空冷焊現象等環境因素，提出了材料選擇的原則，為可動結構材料選擇提供了一定的依據。
  11. It was indicated that the temperature of growth period of grape is between that of the world famous grape production regions through the analysis of ecological condition in mancheng longju base

    通過分析滿城縣龍居基地的生態條件，發現葡萄生長期的溫度位於世界各名產區的溫度范圍之內，土壤、水分等條件適宜發展綠色食品。
  12. At the temperature level of - 60 ?, verious experiments are conducted on the cycles of lhr, acr _ i, acr _ r, with two component mixed refrigerants. the results are consistent with that of the numerical optimization

    在即溫度位，對利用二元混合工質組元的mr 、 「凡i和北lr循環分別進行了實驗優化研究。
  13. The structure and price of analog storage temperature compensated crystal oscillator are similar to that of tcxo, and its temperature stability is close to that of mcxo

    它是以一個線性的溫度? ?位移傳感器和一個可變電容器構成的存儲載體來存儲兩個模擬信號之間的函數關系。
  14. Based on the steel - concrete coordinating relations, element stiffness matrix of geometrically nonlinear analysis, formulas for self - stresses by temperatures and displacements, stresses of corresponding superfluous structures are further studied. furthermore, a new theory and method for structural geometrical nonlinearity and buckling analysis is put forward

    根據鋼混協作關系進一步推導出鋼混組合構件幾何非線性分析單元剛度矩陣、溫度自應力及鋼混超靜定結構溫度位移和應力的計算公式，建立了一種新的基於鋼混協作關系的異種材料組合構件的幾何非線性和結構穩定性分析方法。
  15. At this level, the cop of the cycle reaches 7. 4 %

    在100oc溫度位，循環cop達到了7
  16. This study puts emphasis on the optimization of composition in the experiments at the temperature level of - 100 ?

    本文重點在100oc溫度位進行了多元混合工質精餾循環成分的實驗優化。
  17. The numerical optimization and the detailed exergy analysis of the cycles approved the conclusions rendered in the analysis of the cycle ' s features. we also obtained the optimum compositions of the mixture refrigerant for the rectification cycle under the pressure ratio of 8, at the temperature levels of - 60 ?, - 80 ?, - 100 * c, and - 120 ? respectively. the method of equivalent entropy generation is initially used in this study

    通過對混合工質節流製冷機諸循環進行的數值優化和較為詳盡的循環粗（火用）分析，驗證了循環的特性分析中所得到的主要結論，同時得到了壓比為8 ，溫度為- 60 、 - 80 、 - 100和- 120等四個溫度位的混合工質精餾循環最優混合工質成浙江人學博十學位論文摘要分。
  18. The measurement system of optical fiber temperature and displacement includes the measurement of temperature and displacement

    光纖溫度位移測量系統包括溫度測量和位移測量兩大部分。
  19. The experiments on optical fiber temperature and displacement measurement system include the measuring experiments of temperature and displacement. the paper presents the results of the experiments and the pointed model and results, and analyzes them in theory

    光纖溫度位移測量系統的實驗，包括溫度測量和位移測量兩部分的實驗，給出了實驗過程及其標定的模型和結果，並對其進行了理論分析。
  20. The paper researches a kind of system measuring the temperature and displacement of the optical fiber that can monitor and control simultaneously the temperature and displacement of the blades two - way signals of the turbine, and alert when the emergencies happen

    本課題研究的光纖溫度位移測量系統能在惡劣的環境下，同時實時監測渦輪機軸溫及其軸向位移兩路信號，保證其正常工作，並在發生異常情況時，能立刻報警。
分享友人
分享到 Line

分享到臉書