溫度力峰 的英文怎麼說

中文拼音 [wēndùlìfēng]
溫度力峰 英文
temperature stress peak
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 峰 : Ⅰ名詞1. （山的突出的尖頂） peak; summit 2. （形狀像山峰的事物） peak-like thing Ⅱ量詞（用於駱駝）
  • 溫度 : [物理學] temperature
  1. The welding technology of francis turbine runners is optimized from the view of subsection welding and local heating by numerical simulation. the result shows that welding residual tensile stress appears in the weld and its area nearby, and peak stress appears in the dangerous area of blades after practising quondam welding technology ; welding residual tensile peak stress in the dangerous area of blades can be decreased by welding both ends earlier and then welding middle section later during subsection welding, and decreasing effect on welding residual stress of the subsection welding is related to the weld length of blade outlets and welding direction of each subsection ; decreasing effect on residual stress of the local heating is direct proportional to heating time, heating temperature, heating area, and inversely proportional to cooling area, and welding residual tensile peak stress in the dangerous area is decreasing trend earlier, and then increasing trend later with heated location increased

    本文利用數值模擬手段對轉輪的焊接工藝從分段焊和局部加熱兩個方面進行了優化，結果表明:採用普通工藝焊接時，葉片焊后殘余拉應力出現在焊縫及其附近區域，並且在葉片出水邊的熔合線附近（危險區域）出現了峰值;在採用優化的分段焊時，先焊兩端后焊中間的方法可以降低葉片危險區域的焊接殘余拉應力峰值，降低效果與葉片出水邊焊段長度、焊縫各段的焊接方向有關;局部加熱法降低轉輪危險區域殘余應力的效果主要與加熱時間、加熱溫度以及加熱面積成正比，與冷卻面積成反比，並且危險區域的殘余應力隨加熱區域的增大呈先降低后升高的趨勢。
  2. Principal conclusions were drawn as the following : the non compatibility of pressure or velocity of the gas on both sides of the contact surface is the cause of the formation of shock wave ; the heating effect of reflective shock wave to driving gas during charging or exhausting process is the internal mechanism of peak oscillating effect, and all the factors that influence the formation and the running of the shock wave will influence the peak oscillating frequency, cooling effect

    主要結論如下：熱分離機內激波形成的原因是射氣瞬間接觸面兩側壓力和速度不相容；峰值振蕩效應的內在機制為反射激波對充氣階段的驅動氣或低溫排氣的加熱，凡是影響激波形成及運動的因素都將對峰值振蕩頻率、冷效應及熱效應產生影響；當充、排氣時間比為0 . 1763時，最佳射流激勵頻率出現在高階峰值振蕩頻率上。
  3. In the summer stratified water column, the deeper the maximum depth of food distribution is, the stronger the dvm is performed ; the increase of the gradient of temperature in the thermocline layer can decrease the magnitude of the dvm and form the thermal barricade to the copepod ; the effects of the predation pressure on dvm is complex. on the one hand, the variations in the distribution depth of the predation pressure vs. the thermocline layer or the depth of the maximum food can modify the dvm patterns of the copepod. on the other hand, different predation pressure induces different dvm patterns

    在夏季分層水體中，食物的最大分佈深度越大，動物向下遷移的幅度也越大；溫躍層的溫度梯度增大可以減小動物遷移的幅度，成為橈足類垂直遷移的溫度屏障；捕食壓力對垂直遷移的影響較復雜，一方面，捕食壓力的分佈深度與溫躍層或食物峰值的相對位置的變化能夠改變橈足類垂直遷移的模式，另一方面，捕食壓力強度不同，橈足類垂直遷移的幅度也不同，捕食壓力越大，遷移的幅度越大，當捕食壓力增加到一定程度，橈足類停止向上的遷移，大部分時間呆在水體深層，可能進入捕食壓力引起的「滯育」狀態。
  4. The results show that the dynamic elastic modulus, loss modulus and complex viscosity of the nanocomposite are higher than those of pp, while the loss factor is lower, that the complex viscosity of the nanocomposites is more sensitive to temperature, and that the flow activation energy and the crystallization temperature increase respectively by 15 % and 10k as compared with pp, which may contribute to the enhanced interfacial interaction between pp and ommt resulting from the addition of tmpp

    結果表明：與純聚丙烯相比，納米復合材料具有較高的動態彈性模量、損耗模量和復合粘度，力學損耗因子則降低，納米復合材料的復合粘度對溫度的敏感性略高於聚丙烯；界面改性劑的加入增強了有機蒙脫土與聚丙烯的界面作用，與聚丙烯相比，納米復合材料的流動活化能提高約15 % ，結晶峰溫度提高10k左右。
  5. Determined by dsc. whereafter, the surface micro - morphology of both sides of tini sma thin film deposited on glass was investigated by atomic force microscope ( afm ), and the difference of morphology between the two sides is observed. it has been shown that, in the growing surface of sputtered tini film, the trend of grain to accumulating along the normal direction like a column is clearly observed, and the grain is very loose which resulted in more microcavities, but in the surface facing to glass substrate, grain is so compact that there are hardly microcavities

    通過濺射法，在玻璃襯底上淀積了tini薄膜，並在600進行了真空退火， dsc法測得其馬氏體逆相變峰值溫度為75 ，利用原子力顯微鏡，對玻璃基tini形狀記憶合金薄膜的襯底面與生長面進行了表面微觀形貌分析，發現：生長面晶粒呈現出沿薄膜法線方向柱狀堆積的趨勢，晶粒緻密性差，微孔洞多；而襯底面晶粒緻密，幾乎沒有微孔洞存在。
  6. The results indicated : the mechanical properties of pu prepared by added eg in a two - step process in prepolymerization technology were better than that of one - step process, its tg shifted 6 towards high temperatures ; the tan peak of pu material at low temperature disappeared through decompress boiling distilling technology

    結果表明，採用預聚體工藝並且分步加入eg所制備的聚氨酯彈性體具有較好的力學性能，玻璃化溫度向高溫方向偏移了6 ；採用減壓共沸蒸餾工藝制備的聚氨酯材料在低溫區的tan峰消失。
  7. The effect of deposited condition, include substrate temperatures, different substrates and annealing on the structural properties of zno films has been studied in considerable detail. it is found that the optimal conditions to deposit zno are below : the substrate temperature of 450c, the substrate of sapphire. the sample on this condition is 0. 3491

    通過分析襯底溫度、不同襯底和退火對樣品結構的影響，得到了樣品的最佳制備條件：襯底溫度450 、藍寶石襯底，此條件下制備的樣品具有高度（ 002 ）取向性， （ 002 ）衍射峰半高寬僅僅0 . 3491 ，原子力顯微鏡（ afm ）分析表明zno薄膜具有密集堆積的均勻柱狀晶粒。
  8. The formation process of w - type ferrite underwent from oxide of metal, the m - type transition phase to final w - phase. when the heating rate was 5 / min, at 900 for 3 hrs and 1200 for 4 hrs, pure m - type and w - type ferrites were formed in air respectively. with heat treatment temperature increasing, crystal structure was more intact, the saturation magnetization increased and the coercive force decreased

    熱處理過程表明， m型鐵氧體直接由金屬氧化物反應形成，未經歷尖晶石中間相； w型鐵氧體形成由金屬氧化物到m相過渡相最終向w相的轉變；當升溫速率為5 min ，溫度在900 ，保溫3小時和1200保溫4小時，就分別形成單相m相和w相鐵氧體；隨著熱處理溫度的升高和保溫時間的延長，衍射峰變尖銳，結晶更完整，空心微球的飽和磁化強度增大，矯頑力減小。
  9. The size of the zno nanocrystal grain was so little that the quantum confinement effect should be considered. that makes the band gap wide. atom transfer rate is affected by the substrate temperature, and the average size of the zno nano crystal grain increases with the increasing substrate temperature resulting in the red shift of pl emission position and the narrowness of pl fwhm

    低溫生長的氧化鋅晶粒小，考慮到量子限制效應，禁帶寬較大；襯底溫度影響吸附原子遷移能力，隨著溫度升高，晶粒的尺寸增大，分佈變的均勻，因而發光峰位隨著襯底溫度的升高而紅移，發光的半高寬變小。
  10. To analyze the severe power supply shortage of zhejiang electric power grid during summer peaks in recent years, the data of power consumption and temperatures of zhejiang from 1999 to 2002 are studied, from which the electricity consumed that is sensitive to temperatures is separated

    摘要針對近年來浙江電網迎峰度夏期間電力供應短缺較嚴重的嚴峻情況，以浙江省1999 ~ 2002年的用電量和氣溫數據為基礎，從中分離出與氣溫敏感的氣溫電量，分析了電量與氣溫的相關關系，重點研究了氣溫電量隨氣溫變化的規律，最後提出了完善與改進相關模型的幾點建議。
  11. The tunable optical characteristics of the novel lpfgs are recognized during the study of their optical characteristics : ( 1 ). the relationship between the resonant amplitude and the applied curvature radius in the bend - sensitive orientation of the novel lpfgs is linear, ( 2 ). the relationship between the resonant amplitude and the applied transverse load in the wavelength - insensitive orientation of the novel lpfgs is linear, ( 3 ). the relationship between the resonant wavelength shift of the novel lpfgs and the applied temperature is linear

    在對新型長周期光纖光柵光學特性的研究中，我們發現了新型長周期光纖光柵的一些獨特的可調諧性：新型長周期光纖光柵的諧振峰幅度和彎曲敏感方向所受的彎曲率呈線性關系；新型長周期光纖光柵在波長不敏感方向其諧振峰幅度和它所受的橫向壓力呈線性關系；長周期光纖光柵的諧振峰中心波長隨溫度的變化呈線性關系。
分享友人
分享到 Line

分享到臉書