溫度區 的英文怎麼說

中文拼音 [wēndùqū]
溫度區 英文
temperature province
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 區 : 區名詞（姓氏） a surname
  • 溫度 : [物理學] temperature
  1. Self - fluxing alloy powders - determination of solidus - liquidus temperature range

    液相線溫度區間的測定方法
  2. The experimental results show that water jet impingement induces higher heat flux, higher critical temperature and narrower transition temperature range

    水冷實驗數據分析結果表明：射流能提高熱流密度和臨界溫度，縮小過渡區溫度區間。
  3. At higher temperatures the equation of state becomes better and better approximated by the "perfect gas" law.

    在更高的溫度區內，狀態方程越來越接近於「理想氣體」定律。
  4. The properties of lacamno3 films were enhanced dramatically with a post annealing treatment in high temperature and high oxygen pressure. the films show the highest so far tmi, which reaches the 300k, the transition of resistivity is kept in a narrow temperature range and the temperature coefficient of resistance ( tcr ) is about 5 - 8 %

    以高溫、高氧壓的條件對薄膜進行後退火處理，薄膜性質得到極大改善，轉變溫度點提高到了300k ，電阻?溫度系數也達到了5 - 8 ，不僅提高了轉變溫度點，而且使轉變保持在一個較窄的溫度區間內。
  5. At the same time, water quenching at 190 aging exhibit the highest damping capacities. compared with furnace cooling which show the highest damping capacities in five heat treatments, it show higher damping capacities when tempera ture is under 120 and above 290. further more, it show constantly damping value ( tan above 0. 004 ), but the damping value of furnace cooling is just 0. 0015 under 75

    水淬試樣在190的時效溫度下有最高的阻尼性能，通過與爐冷試樣的阻尼性能（五種熱處理制度爐冷試樣的阻尼性能較高）對比發現，在溫度低於120 、高於290范圍，水淬試樣在190時效溫度下的阻尼性能均高於爐冷試樣的阻尼性能，在120 290之間，它的阻尼性能低於爐冷試樣的阻尼性能，而此溫度區間正好是位錯內耗峰出現的溫度范圍。
  6. By using the multinomial curve fitting, the expression which have 0. 01 accuracy between - 200 ~ 0 can be got and then be applied in measure meter

    應用擬合方法獲得了- 200 ~ 0溫度區段的直接表達式，並在智能儀表中得到了應用。
  7. While the temperature increases the flow curves move down, and it is showed that between 180 and 190 the influence of temperature on the flow behavior is smaller, and the influence of shear rate is smaller

    而溫度的上升導致流變曲線下移，可以認為，在180和190溫度區間內的流動性能相對溫度的影響較為穩定。剪切速率對流動性能的影響變小。
  8. Results show that the levitation force is generated between the high temperature superconductor and the magnetic field under the critical temperature. the value of the levitation force is determined by the temperature and the gradient of magnetic field. that is the smaller of the gap, the larger of the levitation force when the temperature is fixed, and the value of the levitation force is an exponential function of the gap

    研究表明，當高溫超導體的溫度低於其臨界溫度時，在磁場中開始受到力的作用；受到的懸浮力大小由溫度和磁場梯度共同決定；即溫度一定時，懸浮間距越小，對應的磁場梯度越大，懸浮力就越大，力的大小與懸浮間距成指數關系；而當懸浮間距一定時，溫度越低，對應的懸浮力也越大，且超導體剛進入超導態的一段溫度區間懸浮力增大最快。
  9. Decreasing cell thickness will increase the influence of surface interaction to mid - cell phase transition, and increase the temperature, anchoring field strengths region for biaxial phase. at very high value of hc, phase symmetry in mid - cell lags behind that in surface. keywords : liquid crystal, phase transition, surface energy

    對有限厚度液晶盒，減少盒厚可增加表面相互作用對系統的影響，使雙軸相所在溫度區域增加，表面與盒中心液晶的對稱性並非總是同步，當| h _ b |較大時，盒中心液晶雙軸相的對稱性明顯滯後於表面。
  10. Using the microwave selective heating property for materials, by setup equivalent equation, and first time inducing the electromagnetic field perturbation theory to the design of heating materials for substrate in mpcvd, three temperature distribution modes were established, including temperature distribution comprehensive mode of inhomogeneous plasma, temperature distribution composite mode of composite substrate materials, temperature distribution perturbation mode of composite materials, which ii provided an whole new technology route to the design of substrate heating system in mpcvd and guided the preparation of heating materials for substrate. and then the heating materials for substrate were designed and optimized to obtain large area homogeneous temperature distribution even larger than substrate holder ' s diameter. as an important part, this thesis researched the nucleation and growth of diamond films in mpcvd, systematically researched the effects of substrate pretreatment, methane concentration, deposition pressure and substrate temperature etc experimental technologic parameters on diamond films " quality on ( 100 ) single crystal silicon substrate in the process of mpcvd, characterized the films qualities in laser raman spectra ( raman ), x - ray diffraction ( xrd ), scanning electron microscopy ( sem ), infrared transmission spectra ( ir ), atomic force microscopy ( afm ), determined the optimum parameters for mpcvd high quality diamond in the mpcvd - 4 mode system

    該系統可通過沉積參數的精確控制，以控制沉積過程，減少金剛石膜生長過程中的缺陷，並採用光纖光譜儀檢測分析等離子體的可見光光譜以監測微波等離體化學氣相沉積過程；利用微波對材料的選擇加熱特性，通過構造等效方程，並首次將電磁場攝動理論引入到mpcvd的基片加熱材料的設計中，建立了非均勻等離子體溫度場綜合模型、復合介質基片材料的復合溫度場模型及復合介質材料溫度場攝動模型，為mpcvd的基片加熱系統設計提供了一條全新的技術路線以指導基片加熱材料的制備，並對基片加熱材料進行了設計和優選，以獲取大面積均勻的溫度場區，甚至獲得大於基片臺尺寸的均勻溫度區；作為研究重點之一，開展了微波等離體化學氣相沉積金剛石的成核與生長研究，系統地研究了在（ 100 ）單晶硅基片上mpcvd沉積金剛石膜的實驗過程中，基片預處理、甲烷濃度、沉積氣壓、基體溫度等不同實驗工藝參數對金剛石薄膜質量的影響，分別用raman光譜、 x射線衍射（ xrd ） 、掃描電鏡（ sem ） 、紅外透射光譜（ ir ） 、原子力顯微鏡（ afm ）對薄膜進行了表徵，確立了該系統上mpcvd金剛石膜的最佳的實驗工藝參數。
  11. Through basal theory and experiment discussions, the following are obtained : there is a distinct difference more than 150 between the combustion exothermic reaction of coal and the decompounding endothermic reaction of caco3, which is the main component of crm, while few thermal reactions happen during the area of such difference in the crm without coal ; there is a one - to - one relationship between dta curve acreage and crm heat

    論文通過基礎理論和試驗探討，得出煤燃燒放熱效應與生料主體成分caco _ 3分解吸熱效應之間有150以上的溫度差，對應白生料在差熱儀特徵峰溫度區間基本沒有熱效應， dta曲線峰面積與生料熱之間存在明顯的單一對應關系，從而提出用差熱法測定生料熱的設備開發思想。
  12. The temperature range analysis for the injection of finely divided limestone powder and the experiment on hydration activity of the calcinated product

    噴鈣脫硫溫度區間分析及煅燒產物水合活性實驗
  13. The a phase can change to b phase by stretching. in the range of low temperature the higher content of b crystalline was achieved during the higher drawing ratio and the higher drawing temperature

    拉伸有利於pvdf纖維的相結晶向相結晶轉變，且拉伸倍數越高相含量越高；較低溫度區域內（ 100 ） ，溫度提高有利於相結晶向相轉變，較高溫度區域內（ 100 ） ，溫度提高對相向相轉變作用不大。
  14. In the third ductility region, the reduction in area of the sn - undoped steel is larger than that of the sn - doped steel. this means that the hot ductility of the sn - undoped steel is better than that of the sn - doped steel

    在第類脆性溫度區內，不含sn鋼的斷面收縮率大於含sn鋼的斷面收縮率，即不含sn鋼的熱塑性要比含sn鋼的熱塑性好。
  15. In the experiments we found some methods to filtrate the components, and found the phenomenon that the fiber optic gyroscope ' s performance is better at low temperature ( eg. between 0 c to 20 c ) than at high temperature ( 40 c )

    在溫度實驗中，總結出了光纖陀螺儀元器件篩選方法，並得出了光纖陀螺儀在較低溫度區（ 0 20 ）時的性能優于較高溫度區（ 40 ）的結果。
  16. The periodicity fluctuating has been produced by pulse magnetic field so that there are periodic high temperature region exists in sintered body, it results in the symmetrical crack in sintered body of zro2

    感生磁場的存在引起電場周期性的波動，在燒結體內產生不同的溫度區域，是造成燒結體內產生分佈均勻裂紋的主要原因。
  17. The experiments show that the reaction temperature significantly influenced the alignment of the mwnts, and an appropriate reaction temperature for growth was 800c ~ 900c. the diameter of the carbon nanotube increased a little with the growth temperature

    試驗表明，反應溫度對定向碳納米管的形成具有決定性的影響，較適合定向碳納米管生長的溫度區域為800 900 ，隨反應溫度的升高，碳納米管的直徑略有加大。
  18. So that film ybig / ggg was grown in proper temperature, then film ybilg was grown onto ybig / ggg. to improve the magneto - optical properties of films, film ybig was grown onto substrate ybilg which was sliced from garnet ybilg and polished. the tests of magneto - optical properties of the grown thin films showed that through combining two types of rare - earth ion garnet films with opposite signs of farady rotation temperature coefficients, high faraday temperature stability was reached due to temperature compensation effect, which indicated of great potential for application

    反復實驗結果表明， ybiig薄膜的最佳外延溫度區間比ybig薄膜的低約10以上，因此，根據實驗結果選擇合適的溫度，我們先在ggg上外延生長ybig薄膜，然後在ybig上再外延ybiig薄膜，成功製成了ybiig ybig ggg復合膜結構；為了進一步提高性能，我們還將以前生長的ybiig單晶定向切割制為基底，在其上進行復合外延。
  19. 3 ) some low graphitization degree samples " magnetoresistance is 0 when measure temperature is enough high. 3 ) in low intensity of magnetic field, the curve of / 0 - b is parabola

    建議對碳/碳復合材料磁電阻的測量參數是：溫度區間為70 100k ；磁場強度選擇區間為1 1 . 2t 。
  20. It seemed that the fiber and the matrix did not creep themselves in the range of the testing stress and temperature, so the matrix microcracking and interfacial sliding will be the main contributer to the macroscopic deformation of the three - dimensional c / sic composite

    由於在所測定的溫度區間和應力范圍內，碳纖維和基體本身都不大可能發生蠕變。因此，基體開裂和界面的滑動是3d - c sic復合材料宏觀變形的主要貢獻者。
分享友人
分享到 Line

分享到臉書