溫標換算 的英文怎麼說

中文拼音 [wēnbiāohuànsuàn]
溫標換算 英文
temperature scale conversion
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 標 : Ⅰ名詞1 [書面語] （樹梢） treetop; the tip of a tree2 （枝節或表面） symptom; outside appearance; ...
  • 換 : 動詞1. （給人東西同時從他那裡取得別的東西） exchange; barter; trade 2. （變換; 更換） change 3. （兌換） exchange; cash
  • 算 : Ⅰ動詞1 （計算數目） calculate; reckon; compute; figure 2 （計算進去） include; count 3 （謀劃;計...
  • 溫標 : [物理學] thermometric scale
  • 換算 : [數學] matrixing; scaler; conversion; convert; translation換算表 conversion table; equivalent tab...
  1. In this thesis, used thermocouple to sense the temperature in the space of the hearth, attributed the thermocouple based on calorifics and scientific arithmetic, acquired data by data acquiring card, processed data according to the demand of setting up temperature model and drawing graphics and then caculated the coordinates of isothermal points and normals of isothermal facets, ascertained the order of connecting points and the model of construct, drawed the isothermal facet of temperature field with opengl at last

    通過數據採集板卡進行數據採集並與計算機介面進行數據處理。然後，將處理后特殊點的溫度數據依據marchingcubes演算法建立數學模型求取等溫面上的點的坐標及各點的法向量等。最後，確定計算的三維坐標點的連接順序和拓撲模型，利用opengl進行等溫面的繪制、消隱和模式變換等工作。
  2. By means of laboratory and field experimentation of typical semi - rigid base materials, the relationships among laboratory experimental values, field maintain values, field core values and construction criteria are put forward. and the relationships between different test methods are established. using time - temperature conversion principle, it processes the intensity assessment of field cores, then offers the method of determining the test deflection of pavement surface

    通過典型半剛性基層材料的室內外試驗，研究主要設計參數的室內試驗值、野外養生值、現場取芯值及施工指標間的關系，建立了不同試驗方法間的相關關系，運用時溫換演算法則，對現場芯樣進行強度評定，並提出了路表彎沉檢測標準的確定方法。
  3. Based the humidity theory, the paper adopts the relative humidity as the character value and puts forward using 30 % rh and below 0c dew - point as the on - line monitoring critical value. it gives the method of volume ratio convert at the different temperature. with the standard value, we can conclude the result of moisture content

    針對現有規程標準中控制水分的指標的缺點和局限，提出了採用相對濕度作為監測特徵量並轉換為露點以直觀表示設備絕緣狀況：採用30相對濕度及0以下露點作為監測的臨界值與允許值；同時推導出了體積比單位在不同溫度下的折算方法，以結合現有標準，綜合分析，做出判斷結論。
  4. This product is a full electron construction in which its front - end adopts pressure sensor with baffle filled oil chip. output signal is sent the data to microprocessor from high - precision, low temperature drift and high - reliability amplification circuit and a d convert circuit, after operating, to transform by high - precision d a convert circuit into standard signal output

    該產品為全電子結構，前端採用帶隔離膜充油芯體的壓力傳感器，輸出信號由高精度低溫漂和高可靠性的放大電路和模數轉換電路將數據送入微處理器，經運算後由高精度數模轉換電路變換為標準信號輸出。
  5. Through developing a 2 - dimensions heat transfer model of buried pipe - in - pipe heat exchanger and simulating the process by computer, the author figures out inter - relations of factors which influence characteristics of buried pipe - in - pipe heat exchanger, such as pipe diameter, pipe length, ratio of pipe diameters, flow rate, inlet water temperature, patterns of water inlet and outlet, and material features made of pipe, and proposes some optimizing indexes of buried pipe - in - pipe heat exchanger. the author studies the " heat - - short circuit " phenomenon as well and gives < wp = 5 > some important results

    本文通過建立地下套管式埋管換熱器傳熱過程的二維傳熱模型，並藉助計算機對分析結果進行解析，弄清了影響埋管換熱器性能的管徑、管長、管徑比、通過流量、進水溫度、進出水方式以及管材等參數的作用，並提出了相應的優化指標，對研究界懸而未決的「熱短路」問題也進行了細致分析，得出了有關結論。
  6. Plasma characteristics of a rf ion source are investigated by emission spectroscopy. the spatiotemporal spectral line intensities of the first three atomic lines in hydrogen bahner series ( = 656. 28, 486. 13, 434. 05nm ) of rf ion source plasma, are measured with calibrated optical multichannel analyzer ( oma ). some plasma parameters, including electron temperature, hydrogen atom density and hydrogen ion density, are calculated and analyzed using partial local thermodynamic equilibrium ( plte ) theory and abel transform

    實驗採用絕對定標后的光學多道分析系統（ oma ）測定了離子源等離子體不同時間和空間位置的氫原子巴耳末譜線系中前三條譜線（ = 656 . 28 ， 486 . 13 ， 434 . 05nm ）的強度，並採用plte的理論和abel變換方法，計算出了高頻離子源等離子體的電子溫度、氫原子濃度、氫離子濃度等參數在放電的不同階段和徑向分佈情況，並進行了簡要分析。
  7. The dissertation discusses some theories of computation including the unit stiff matrix of the spatial member in the local coordinates ， the coordinate transformation, the integration of the integer stiff matrix ， the equivalent joint load ， the introduction of the boundary condition ， the computation of the unit internal force and support reaction ， the stableness of the spatial stiff frame. the dissertation also discusses the methods of dealing with several unusual problems such as combined structure, temperature stress ， elastic bearing

    本文論述了空間桿件局部坐標單元剛度矩陣、坐標轉換、整體剛度矩陣的集成、等效結點荷載、邊界條件的引入、單元內力與支座反力計算、空間剛架穩定的計算理論，以及組合結構、溫度內力、彈性支承等幾個特殊問題的處理方法。
  8. In practical application, due to the parameter accuracy of two point temperature correction is limited by readout circuit noise 、 dynamic range 、 analogue to digital converter word length and calculating noise, the performance of focal plane array detector is not the performance it should be

    目前實用性較好的兩點溫度定標法的校準系數精度受讀出噪聲、信號動態范圍、模數轉換字長和運算噪聲的限制，很難使焦平面探測器的空間殘留噪聲達到應有的精度。
  9. There is no thoroughly rounded theory about displacement ventilation system in our country at present and our research begins recently. the study work of this paper will be useful for further optimization design of displacement ventilation system. this dissertation includes five parts. the first part introduces the development of the displacement ventilation and the background of research in domestic and oversea. in the second part, it gives working principle of displacement ventilation system and it ’ s advantages to the mixture ventilation. the study also gives a series of indexes to evaluate displacement ventilation system and specifies air supply terminal device and so on. it is needed to simulate and analyse the velocity field, temperature field and distribution of flow field. this is the third part. the forth part specifies the simulative method for thermal stratification of displacement ventilation system. it gives some factors affecting thermal stratification height such as inlet temperature, inlet velocity, heat transfer of wall body, distance of heat source and so on

    本文的研究工作主要包括以下幾個方面的內容: （ 1 ）綜述了國內外相關的研究現狀和研究背景; （ 2 ）簡介了置換通風的工作原理，並分析了它相對于混合通風的優良特性及評價指標、末端裝置等; （ 3 ）對採用置換通風方式房間的溫度場、速度場和氣流分佈進行了模擬計算與分析; （ 4 ）對採用置換通風方式房間的熱力分層高度進行了模擬計算，並分析其影響因素，如:送風溫度、送風速度、圍護結構傳熱和熱源分佈等; （ 5 ）擬合了無量綱熱力分層高度相應于送風溫度t 、送風速度v 、熱源間距離l和圍護結構傳熱q的經驗公式。
  10. After carrying out a period of testing in which gshp system operated for three months and then turned off for same period of time, that energy stored in soil and rocks around buried pipe - in - pipe heat exchanger can be used in anti - season manner, that is, winter cool could be used in summer and summer heat could be used in winter, has been proved by calculating temperature distribution in soil and rocks around buried pipe - in - pipe heat exchanger

    對換熱器周圍巖土溫度的計算結果證明，地源熱泵經歷三個月開機運行和三個月停機過渡季后，換熱器周圍巖土一定程度實現了冬冷夏用、夏熱冬用的目標。
  11. The standard k - e turbulence model was employed in the core region of the cavity. two low reynolds number turbulence models, single equation model and launder and sharma low - reynolds number k - e model, were used in the near wall regions

    在紊流核心區採用標準k -模型，近壁區分別採用單方程模型和launder ? sharma低雷諾數k -模型，採用simple演算法，求解並獲得了盤腔中的速度和壓力場、全域的溫度場以及流固界面上的換熱系數和努謝爾數分佈。
  12. This tester has functions of whole - procedure automatization, temperature compensation, automatic pressure value corrected to standard atmospheric condition, and so on

    該儀器測量全過程自動化，具有溫度補償功能，能自動換算到標準狀態下的壓力值。
分享友人
分享到 Line

分享到臉書