滑滾系數 的英文怎麼說
中文拼音 [gǔgǔnxìshǔ]
滑滾系數
英文
slide-roll ratio- 滑 : Ⅰ形容詞1 (光滑; 滑溜) slippery; smooth 2 (油滑; 狡詐) cunning; crafty; slippery Ⅱ動詞(貼著物...
- 滾 : Ⅰ動詞1 (翻轉; 滾動) roll; turn round; trundle 2 (走開; 離開) get away; beat it 3 (液體沸騰)...
- 系 : 系動詞(打結; 扣) tie; fasten; do up; button up
- 數 : 數副詞(屢次) frequently; repeatedly
- 系數 : [數學] coefficient; ratio; modulus; quotient; factor
-
After designing oil ditches on the surface of its arc - block, increase friction factor and make sure self - lock which solves above problem. do qualitative analysis to lower pair and one - way overrunning clutch and inner star - wheel - roller overrunning clutch by using self - made lever loader. the experiment shows : on the same condition, the deformation of new overrunning clutch ’ s surface contact with lower pair is smaller than the deformation of roller overrunning clutch ’ s line contact with higher pair and new overrunning clutch ’ s skid angle is smaller
對低副單向超越離合器的部件進行了加工製造,在超越離合器弧塊表面創新設計加工排油溝,增大摩擦系數,保證實現自鎖,解決了很多離合器工作過程中容易出現無法自鎖的問題;對低副單向超越離合器和內星輪滾柱超越離合器用自製杠桿加載器做了定性分析,實驗表明:相同條件下,新型離合器低副面接觸比滾柱離合器高副線接觸變形小、溜滑角小。3, during the process of the gear teeth meshing, the film shape and pressure distribution have little difference. but, the temperatures have the distinctive changes as the engaged position is varied, which means that the temperatures as the increase in the rate of slide to roll
3 、在齒輪傳動嚙合過程中,壓力分佈和油膜形狀無明顯變化,但溫升隨嚙合位置的不同呈顯著變化,即溫升隨著滑滾比增大而增大;在單、雙齒嚙合交替處,摩擦系數達到極值,可達0 . 08 。Based on the analysis and discussion of characteristics and law of gear engagement under condition of elasto - hydrodynamic, a calculation method on sliding and rolling work loss of standard spur gear transmission had been put forward, and the relationship of geometric parameters and overlapping coefficients of gear with sliding work loss was revealed
摘要基於彈流潤滑狀態下的齒輪嚙合特性及規律分析和討論,提出了標準直齒傳動的滑動功損及滾動功損的計算方法,揭示了齒輪的幾何參數和重迭系數與滑動功損的關系。
分享友人