滑移向量 的英文怎麼說

中文拼音 [gǔyíxiàngliáng]
滑移向量 英文
slivectors
  • 滑 : Ⅰ形容詞1 （光滑; 滑溜） slippery; smooth 2 （油滑; 狡詐） cunning; crafty; slippery Ⅱ動詞（貼著物...
  • 移 : Ⅰ動詞1. （移動） move; remove; shift 2. （改變; 變動） change; alter Ⅱ名詞（姓氏） a surname
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  1. Variation ratio of dimensional after water rinse, ultimate strength, neps and pile, tearing resistance, bursting strength, joint strength, commissure ' s swerve strength, fabric shift ( slip ), ventilate degree, elasticity ( resilient rate / deformation rate ), anti - water permeability ( hydrostatic pressure ), extension and resilience, abrasive resistance, gets wet the nature, hydroscopicity, stock ' s transverse ductility, fire resistance, antistatic

    水洗尺寸變化率（縮水） ，斷裂強力，起毛起球，撕破強力，彈子頂破強力，脹破強度接縫強力，縫口脫開程度，紗線滑移性能（滑脫） ，透氣量，彈性（回復率/變形率） ，抗滲水性（靜水壓） ，延伸及回復性，耐磨性，沾水性，吸水性，襪子橫向延伸，阻燃性能，抗靜電。
  2. In theoretical analysis, the motion of radially - emitted electron beam in diode region and drift region has been analyzed, and the relation between radial momentum or current of electron beam and the guiding magnetic field has also been studied, then the possibility to optimize the guiding magnetic field has been derived. the motion of radially - emitted beam electrons in smooth bore magnetron and smooth bore milo has also been studied theoretically. at last, the motion of radially - emitted beam electrons in compound axial and azimuthal magnetic field has been studied

    在理論分析中，初步分析了軸向發射條件下電子在二極體區域和漂移區的運動規律，電子徑向動量隨著外加磁場變化的規律，以及電子束電流隨著外加磁場的變化規律，還有二極體區域磁場優化的可能性;分別研究了有軸向磁場時以及有角向磁場時徑向發射的電子在光滑陽極結構中的運動規律，最後分析了在軸向和角向復合磁場中電子的運動規律。
  3. According to the spread of nappe and relation between the nappe and depression, oblique - thrust fault zone was divided into three parts in this paper : sertengshan, lvliangshan and xitieshan. ( 3 ) according to macroscopic characteristics of fault zone, cleavage characters of fault zone, drag folds, the reverse " s " fold in the footwall, positive flower structures and small left strike - slip fault, the kinematics characters of fault zone of sertengshan - xitieshan are concluded : thrusting in section, left - slip fault in plane and the strike - slip displacement increasing from the west to the east

    （ 3 ）根據斷裂斷裂帶的宏觀特徵、斷層帶劈理特徵、斷裂帶附近的牽引褶皺和斷層下盤的平面反「 s 」型褶皺以及斷層上盤剖面正花狀構造和平面左行小型平移斷層，認為賽什騰-錫鐵山斷裂帶運動學主要表現為剖面上的逆沖、平面上的左行走滑特點，並且走滑量具有自西向東增大之勢。
  4. The result of md simulation means that : ( 1 ) the microstructure in the amorphous carbon has no obvious change, the slippage which is parallel to the fiber axes in the graphite slices of the pyc interphase was found ; ( 2 ) bulk moduli of every part of interphase diminished, young ' s moduli in all three direction of amorphous carbon diminished, young ' s moduli of the graphite slices in the direction of parallel to the fiber radial decreased, and ones in the direction of parallel to the fiber axes increased

    分子動力學模擬結果表明， （ 1 ）界面相內部無定形碳部分微結構無明顯變化，石墨片層部分沿纖維軸向滑移； （ 2 ）界面相模量發生變化，界面相區域各部分的體積彈性模量降低，無定形碳部分及石墨片層部分垂直於纖維軸向的楊氏模量降低，平行於纖維軸向的楊氏模量升高。
  5. Change direction by moving body weight from uphill ski to downhill ske, adjusting weight from uphill edge to downhill edge on both skis

    犁式轉彎：依靠身體重心向一側板移動或加大一側雪板的蹬雪力量來改變滑行方向。
  6. The kinematic performance of the macpherson suspension on a real vehicle is studied, and the changes of the front wheel alignment and the motion of the front wheel in the longitudinal and the transversal directions are figured. based on the requirements of general layout, a constrained optimization design model is set up with the steering cross rod ball joint position as the optimization variables ( design parameters ), and the sum of steering cross rod length interference while the left front wheel turning and bouncing as the objective function. and the optimization results are worked out by programming on computer

    針對一種實際車型上的麥弗遜式懸架，計算分析了轉向輪跳動時前輪定位角和車輪橫向、縱向滑移量的變化情況，並根據實際車型上麥弗遜式懸架的空間布置要求，建立了以轉向橫拉桿斷開點空間位置坐標為優化變量，轉向橫拉桿斷開點空間布置坐標可變化范圍為約束條件，車輪轉向和跳動時轉向橫拉桿長度干涉量為目標函數的約束優化設計模型。
  7. The main achievements are as follows : the theory models of defect mfl field are set up ; based on the magnetic dipole model and finite element model, the distribution of defect mfl field is simulated in the dissertation ; the component of flux density ( magnetic filed ) parallel to the surface of pipe is detected by a circumferential array of hall probes ; the factors including defect geometry parameters, defect surface angle and shape, pipe material, field intensity, vehicle velocity, background magnetization, operating pressure and remanent magnetization and so on influence the mfl signal characteristics

    採用霍爾元件作為缺陷漏磁檢測傳感器，獲得管道軸截面漏磁場切向分量的漏磁信號；研究了缺陷外形尺寸、缺陷傾角和形狀、管道材質和磁化強度、檢測儀移動速度、管道背底磁場、管內壓力和剩磁對漏磁信號的影響。提出了各通道增益放大、各路漏磁信號偏離調整、波形微分、數字濾波和平滑等漏磁信號預處理方法；分析了等空間采樣的漏磁信號轉換為等時間采樣信號的必要性，研究了漏磁信號的小波去噪方法。
  8. From extension degree, differential lifting, sliding surface depth and modern seismic data analysis, it is concluded that the structural activity of liaohe basin moves from west to east, i, e., the rifting happens in the western depression first, it moves to the eastern depression and now it locates in bohai area

    從伸展量、差異升降、滑脫面深度及現代地震資料分析認為，遼河盆地構造運動從西向東運移，即裂谷作用最先在西部凹陷，后移至東部凹陷，現在位於渤海海域。
  9. In all these 20 specimens, the embedded electronic steel - concrete slip transfer were respectively embedded on the steel shape webs and inside and outside of the flanges at certain intervals along the embedment length to measure the distributions of the interior slip, and the electronic strain gauges were also installed on the shallow grooves of each steel shape web and flanges at close intervals along the length to measure the distributions of the steel shape web and flanges strain, from which the distributions of bond stress were obtained. with these methods of measuring the distributions of slip and bond stresses, the establishment of the bond - slip constitutive relations were ensured

    用力的平衡方程，得到推出試驗中型鋼混凝土粘結應力的大小及其分佈規律;根據鋼一混凝土電子滑移傳感器的滑移量測結果，分析了沿型鋼埋置長度的內部滑移分佈規律，並對試驗量測的特徵滑移值進行了統計回歸;根據粘結應力和內部滑移測量結果，得出沿型鋼埋置長度方向上各截面的局部粘結應力一滑移關系曲線，建立了局部粘結滑移本構模型嘆x ）一s仁， ， … ， c ， … c 。
  10. Through imitated to experiment to the physics of the typical model slopes, it can be found that the k23 + 850 ' s dip slope is belong to creep - sliding and fracturing, that the k47 + 750 ' s scarp slope is belong to bending and fracturing, ( 3 ) it is a effective method by establishing the reasonable geology model, and proceed to study with evaluation of determine the nature and fix quantifying

    通過對典型邊坡的物理模擬試驗，研究發現k23 + 850處中傾順向巖質邊坡變形破壞形式為滑移?拉裂型，而k47 + 750處的陡傾內反向巖質邊坡的變形破壞形式為彎曲?拉裂型。其次是建立合理的地質模型，對邊坡進行定性及定量評價。
  11. That shear stress, resolved within a slip plane and direction, which is required to initiate slip

    使得晶體開始滑移所需要的純剪切應力，在某一特定滑移面和滑移方向上的分量。
  12. Based on the assumed vertical displacement of the unit cell and the assumed distribution on the pile - soil interface of the pure friction pile, and using the boundary conditions that there was no relative slipping between pile and soil, the pile decrement was equal to that of soil on the pile - soil interface and that the vertical sheer stress of the unit cell ' s outer edge was equal to zero, the formula for the frictional distribution of the pure friction pile and the formulas for the displacement of pile and soil in the treated area were deduced

    通過假定的單元體豎向位移模式和純摩擦樁樁側摩阻力分佈模式，利用樁土間無相對滑移、樁土界面處樁土壓縮量相等和單元體邊界處豎向切應力為零等邊界條件，推導出復合地基純摩擦樁樁側摩阻力分佈的具體表達式，以及加固區樁土壓縮量的計算公式。
  13. A certain thickness of sand cushion of a certain size or gradation is paved between the foundation and ground in this new method. when earthquake happens the sand cushion will have plastic shearing strain, reducing the input of high frequency volume, thus consume the earthquake energy form substrate. it is showed in shaking table experiments that there is relevant slippage between foundation and sand cushion, which can prevent the seismic energy from being passed to the above structure and thus reduced the seismic role for the above structure

    在建築物的基礎與地基之間鋪設一定厚度、某種單一粒徑或級配砂墊層，在地震作用時砂墊層發生的塑性剪切變形，減少地震波高頻分量的輸入，從而消耗了下層傳來的地震能量；振動臺試驗表明，當振動發生時，基礎與砂墊層之間有明顯的滑移產生，這就對地震能量向上部結構的傳遞起到了隔斷作用，因而對上部結構起到了減震作用。
  14. Based on the improved codog power plant experiment rig of harbin engineering university, the thesis has set up the displacement measurement system of the middle slippage of the synchronous self shifting ( s. s. s. ) clutch at the first time, and obtained the curve which follows the time variability of the axial displacement when engaging or disengaging and reflects the dynamic change of the s. s. s. clutch for the main engine changeover of codog power plant experiment rig

    本文的研究是建立在對我校原有codog物理模擬實驗臺改進的基礎上進行的，首次建立了三s離合器中間滑移件位移測量系統，獲得了三s離合器中間滑移件在嚙合及脫開過程中的軸向位移隨時間的動態變化曲線，該曲線從一個側面反映了切換過程中三s離合器的動態變化。
  15. A usually high - speed ski turn used for changing the direction of descent or stopping, performed by shifting the weight forward and turning with the skis kept parallel

    作制動轉彎在轉變下滑方向或停止時的高速滑雪旋轉，通過向前轉移重量並平行地旋轉滑雪板來完成
分享友人
分享到 Line

分享到臉書