滲透壓力測定 的英文怎麼說

中文拼音 [shèntòuyālìcèdìng]
滲透壓力測定 英文
osmometry
  • 滲 : 動詞（液體慢慢地透過或漏出） ooze; seep
  • 透 : Ⅰ動詞1 （滲透; 穿透） penetrate; pass [seep] through 2 （暗地裡告訴） tell secretly; let out; lea...
  • 壓 : 壓構詞成分。
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 定 : Ⅰ形容詞1 （平靜; 穩定） calm; stable 2 （已經確定的; 不改變的） fixed; settled; established Ⅱ動詞...
  • 滲透 : 1 [物理學] [生理學] osmosis2 （液體從細小空隙中透過） permeate; seep; permeation; seepage; inflow...
  • 測定 : determine; determination; setting-out; admeasurement; assignment; assay; finding
  1. The investigation of a lot of parameters about treated sandstone, brick materials and earthen materials with fluorited polymers has been carried out, such as the formation of polymer, the penetration depth, porosity, capillary absorption and penetration coefficient, water uptake, compressive strength, drilling resistance, absorption isotherms of water vapor, water vapor diffusion, color changes as well as resistance to desegregation of water, frizzing - throwing cycles, worming - cooling cycles, and so on. in addition, the influence of salt crystallization, acid and base, and uv aging have also been assessed in order to better understand the protection effects and utilization possibility of two fluorinated polymers, mainly according to astm standard and the combination of international methods together with general technological

    分別以國家級文物保護單位的土質、砂巖和磚材文物樣品為對象，依據astm標準及國際通用文物保護研究方法與評估準則相結合，通過膠化物形成周期、滲透深度、孔隙度、毛細吸水和滲透系數、持水量、抗壓強度、抗鉆強度、吸附水蒸氣的能力、透氣性、外觀顏色等系列參數的測定，及凍融、冷熱循環、酸堿腐蝕后抗壓強度的衰減、可溶鹽對保護效果的影響、酸堿及光照對表面保護效果的影響，對兩種含氟聚合物及其與有機硅的共混物在文物加固保護和表面防護中的可行性和保護效果給予了系統研究。
  2. Effects of diverse environmental factors on the growth rate ( od4oo ) and nitrogenase activity ( ara ) of the strain w12 hi nitrogen - free culture were investigated in our experiments. the results implied that the strain w12 could easily adapt to different cultural conditions : it could use various carbon sources ( especially glucose, sucrose, malic acid, mannitol ), propagate quickly and fix nitrogen at a temperature range of 15 ? to 40 ? and at 25 - 35 ? for optimum, at a ph range of 4 to 8. 5, at a saline concentration range of 0. 01 % to 1. 5 % ; low nlv " concentration had little effect on its nitrogenase activity. ara could also be detected when it grow in the culture media with 5mmol / l ntv "

    W12菌株對環境因子的適應性研究：無氮培養條件下，測定溫度、碳源、酸堿度、滲透壓對w12生長及固氮能力的影響，結果表明，在15 - 40下均能生長並表達固氮酶活性，其最適生長及固氮的溫度為25 - 35 ；能利用葡萄糖、蔗糖、蘋果酸、甘露醇等多種碳源生長並固氮，當培養基中同時存在蔗糖和蘋果酸時，細菌生長和固氮活性最強；在偏酸和偏堿的條件下（ ph4 . 5 - 8 . 5 ）均能保持較強的生長勢和較高的固氮酶活性，並能通過調節自身代謝平衡並適應環境的酸、堿性變化，使培養液趨于中性：能耐受較高的滲透壓，培養液中卜、 5 naci濃度對其生長和固氮酶活性影響不大，當naci濃度升至2時，菌株的生長勢及固氮酶活性才有所下降：低濃度的鉸對其固氮酶活性影響不大，在0
  3. Abstract : a formula for calculating the minimum underbalance in lower permeability reservoir is obtained by applying a drag force function to testing data

    文摘:通過將拖曳力函數用於油田測試數據，提出了確定低滲透地層最小測試壓差的公式和方法。
  4. Leather - physical and mechanical tests - determination of water penetration pressure

    皮革.物理和機械試驗.水滲透壓力測定
  5. ( 2 ) in order to validate the rightness of the parameters, hydrogeology parameters is measured, such as discharge, percolation coefficient and hydraulic pressure using the precise instruments and existing formula and arithmetic

    （二）利用各種精密測量儀器進行滲流量、滲透系數、水壓力等水文地質參數的測定，結合已有的公式和演算法，驗證各種數據的取值合理性。
  6. Leather - physical and mechanical tests - determination of water penetration pressure ; german version en 14289 : 2003

    皮革.物理和機械試驗.水滲透壓力的測定
  7. In order to make clear the effects of fe3o4 on composite film structure, the thickness, porosity, average and maximum pore size, pore size distribution of different films are measured. surface morphology is studied by scan electronics microscope ( sem ). the characterizing results of film micro - morphology showed that pore structure of fe3o4 / pvdf composite film were better than those of pvdf host film

    為進一步分析fe3o4的原位生成對復合膜結構的影響，測定了pvdf基膜和復合膜的膜厚；採用干濕膜重法測試了膜樣品的孔隙率；採用泡點壓力法流體滲透法相結合，對比測試了膜樣品的最大孔徑、孔徑分佈及平均孔徑；通過掃描電子顯微鏡（ sem ）照片分析，對比研究了pvdf基體膜和fe3o4 / pvdf復合膜的表面形貌。
  8. ( 2 ) used the predecessors " research achievements for reference, an experimental provision by which relationship between capillaiy pressure and saturation and relationship between unsaturated permeability and capillary pressure of fracture can be determined simultaneously is developed for the first time. experiment of simplified fracture model on the provision is done

    借鑒前人的研究成果，基於動力法原理（即逐次建立水相和氣相之間的穩定流動狀態） ，首次研製出了一套可同時測定單裂隙毛細壓力飽和度以及非飽和滲透系數毛細壓力關系的實驗裝置。
  9. Textiles - determination of resistance to water penetration - hydrostatic pressure test

    紡織品.耐水滲透性的測定.靜水壓力試驗
  10. Regarding the lcm filling process as the newton fluid through fibrous reinforcements, the permeability of preform determines the saturating of resin in fiber, and has effects on the curing process and the quality of products. based on the darcy ' s law, the theoretical model of permeability measurement was established. and the influence of different testing methods and major process parameters such as fabric structure, fiber volume fraction, injection pressure, flow rate and resin viscosity on preform permeability were investigated in details

    文中首先根據達西定律建立了滲透率測量的理論模型，深入研究了不同的測試方法及主要工藝參數（纖維織物織構、纖維體積含量、充模壓力、流動速度、樹脂粘度）對滲透特性的影響規律，發現多孔介質增強材料的滲透率主要取決于纖維織物的結構形式，預成型體孔隙分佈及其體積分數、壓實性對滲透率有較大的影響，提高充模壓力和流動速度可以縮短充模時間，在一定程度上可以提高滲透率。
  11. The changes of leaf water potential, water deficiency, water - holding ability under drought stress conditions were measured. the water parameters were calculated by using pressure - volume technique, also the abilities of maintaining turgor and adjusting osmotic potential of the four species were comprehensively evaluated. the effects of drought stress on photosynthesis, transpiration and water use efficiency were studied

    研究乾旱脅迫下葉水勢、葉水分飽和虧缺及葉保水力的變化；應用壓力室和pv技術測定四個樹種多項水分參數，並對四樹種滲透調節和維持膨壓能力進行綜合評定；研究乾旱脅迫對光合作用、蒸騰作用及水分利用效率的影響；測定生長指標及水分脅迫下苗木的生物量分配。
  12. Carbonaceous materials for the production of aluminium - cathode block materials - determination of the expansion due to sodium penetration with application of pressure

    鋁生產用含碳材料.陰極塊材料.壓力作用下由於鈉滲透引起的膨脹的測定
  13. Carbonaceous materials for the production of aluminium - cathode block materials - determination of the expansion due to sodium penetration without application of pressure

    鋁生產用碳質材料.陰極塊材料.無壓力作用下由於鈉滲透引起的膨脹的測定
分享友人
分享到 Line

分享到臉書