漏驗率 的英文怎麼說

中文拼音 [lóuyànlǜ]
漏驗率 英文
percentage of omi on of examination
  • 漏 : Ⅰ動詞1 （從孔或縫中滴下、透出或掉出） leak; drip 2 （泄漏） divulge; disclose; leak 3 （遺漏） le...
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 率 : 率名詞（比值） rate; ratio; proportion
  1. Testing method of cryo - insulation pressure vessels leak and outgassing rate measurement

    低溫絕熱壓力容器試驗方法漏放氣速率測量
  2. Standard test method for determining air leakage rate by fan pressurization

    用風扇增壓法測定空氣泄漏率的標準試驗方法
  3. Energy consume, electric strength, insulation resistance, ground conductivity, leakage current, microwave leakage, power input, normal temperature, humidity treatment, glow wire, horizontal flame, vertical flame, tracking, ball pressure, rainproof, water splash, dustproof, salt fog, endurance, motor load test, cord flexing, cord pulling, pull & torque test, lamp replacement, construction check etc

    能耗、電氣強度、絕緣電阻、接地連續性、泄漏電流、微波泄漏、功率、溫升、濕熱試驗、灼熱絲、水平燃燒、垂直燃燒、漏電起痕、球壓試驗、防雨淋、防濺水、粉塵、鹽霧、耐久性（壽命）試驗、電機負載試驗、電源線彎折、電源線提拉、拉扭力測試、燈頭互換性、安全結構檢查等。
  4. The tests show the system levels the relevant standards set by atp and iso, which are proved to be a successful one. airtightness test shall be carried out when the temperatures inside and outside the refrigerated containers should be stabilized within 3k of each other and should both be within the range 288k to 298k

    進入實驗工況后，溫度調節精度為0 . 3 ，環境溫度場的梯度值不超過1k ，而箱內溫度場的梯度值一直維持在2k以內，該集裝箱的漏熱率u為43 .
  5. Research of thermal engineering performance test facilities for refrigerated containers - the test standards and methods are deeply analyzed. airtightness test, heat leakage test and performance test ( with refrigeration unit ) are done on the developed test facilities. the process of the experiment system, used hi measuring the thermal engineering properties of refrigerated containers, is thoroughly discussed

    氣密性實驗結果顯示，箱內、外的溫度波動范圍處於15 25之間，箱內、外的壓差處於250 10pa范圍內，平均漏氣率為2 . 38 （ m / h ） ，遠遠低於極限值10 （ m / h ） ，被測試的冷藏集裝箱的氣密性符合規范要求。
  6. With regard to its field drilling applications in the geologically loose sandy pebble layers, kl vegetable - gum drilling fluid showed itself with excellent rheological behaviours in its abilities of lubrication, lost circulation, suspension and removal of debris, anti - shear shinning, and high coring rates, which satisfactorily meet the demands of geological boring in the dam foundation of huangjin ping hydroelectrical power plant

    通過在黃金坪水電站壩基深厚砂卵石覆蓋層鉆探取芯的現場試驗，證明了kl植物膠沖洗液具有優良的流變特性，潤滑、堵漏、懸浮排除巖屑和抗剪切稀釋能力顯著，可實現高取芯率，能很好的滿足地質鉆探對取芯質量的要求。
  7. Test results indicated : with the hoist of altitude, the increase of ice amount and the rise of pollutant, the average flashover voltage reduced. the character exponent generally depends on the insulator profile, ice amount, ice state and pollution severity etc. by means of a high - speed camera, a data acquisition system and high voltage test facilities, a series of the flashover processes on ice surfaces were record. the experimental results form this study and the subsequent theoretical analyses suggested : the thermal ionization of the air in front of an arc root resulted in arc movement ; the electrostatic force had an auxiliary effect of impelling arc propagation ; the electrical

    通過對攝像機、數據採集系統及高壓試驗裝置記錄覆冰絕緣子表面閃絡電弧的發展過程的試驗結果進行理論分析得出：弧根周圍空氣的熱電離導致了電弧的發展，靜電場力對電弧的發展起到了加速作用，電擊穿僅發生在閃絡最終的跳躍階段；通過測量閃絡過程中的放電電壓、泄漏電流、閃絡時間、覆冰水電導率、電弧長度及電弧半徑等參數，得到了不同階段電弧（電弧起弧階段、電弧發展階段及完全閃絡）的發展速度、臨界電弧長度均隨覆冰水電導率的增加而減小。
  8. Finally, with regression analysis on the simulation results, a regression model is made and the optimal process parameters of laser bonding are found

    然後通過漏選試驗確定影響激光鍵合的主要工藝參數有激光功率、激光掃描速度及鍵合初始溫度。
  9. The etching reactor is developed to obtain reproducible tapers of desired diameter and length. an approach for on - line monitoring of etching using the power meter is demonstrated. based on the experimental data, the relationship between the leak - out optical power and change of time and also that between the leak - out power and width of the remaining width of cladding, and the fiber length exposed to hf acid are summarized

    本文對氫氟酸腐蝕法製作光纖耦合器的反應裝置和實驗系統進行了設計，介紹了具體的實驗過程及其注意事項，通過對實驗結果進行分析總結，得出泄漏光功率隨腐蝕時間的變化關系以及泄漏光功率與包層剩餘厚度和腐蝕長度的關系。
  10. Cylinder leak tester

    氣缸漏氣率檢驗儀
  11. Standard test method for volumetric flow rate of metal powders using arnold meter and hall funnel

    用阿諾德測量計和霍爾漏斗測定金屬粉末體流率的標準試驗方法
  12. Based on many references form civil and abroad, the author mainly studies the measurment theory and method for flux, raising height, axial power and rotational velocity. avoiding many complicated and intermediate courses for power wastage analysis, introduces the electric measurement and using efficiency curve of motor in measureing axial power, and satisfies the automatization of the device. the paper also provides a new method, inductive winding, in measuring rotational velocity of electromotor, supplys limitations of other method in measuring rotational velocity of electromotor in water, and meet practical needs in developing diving electric pump for corporation

    作者在參閱大量國內外有關文獻，著重探討了水泵流量、揚程、軸功率、轉速的測試原理和測試方法，提出了採用電測法並結合電機效率特性曲線測量水泵軸功率，從而避免了損耗分析法中大量復雜的中間過程，滿足了試驗裝置的自動化測量要求；採用漏磁感應線圈法測量電機轉速，彌補了其它轉速測量方法對水下電機測試的局限性，適應了萊恩公司開發潛水電泵的實際需要。
  13. The pin silicon photodiode made by alice - china group, which has a large area and high performances, is an important part of the photon spectrometer ( pros ) pbwo4 detector read - out system on the alice experiment. the pin diode has a sensitive area of 16x17 mm2. its leakage current is lower than 5na at room temperature

    本工作研製的pin硅光電二極體的靈敏區面積為16x17mm2 ，常溫漏電流小於5na ，紫光區量子效率約為83 % ，結電容為110 - 120pf ，以及由pin光電二極體與電荷靈敏前置放大器組成的讀出系統的噪聲水平在- 25下小於527個等效噪聲電荷，並經過了長期性能穩定性的考驗
  14. The prototype of the pnids shows that the pnids can make use of advantages of cluster computing to improve the capability of high performance computing of the nids and to decrease false alarm rate

    Pnids的實驗原型系統表明， pnids能利用機群計算優點，提高nids高性能『卜國科學院研究生院博士學位論文蔣建春:而向網路環坡的信息安全對抗理論及關鍵技術研究計算能力，降低漏警率。
  15. Based on the results and experience of twd s 2003 endeavors and incorporating advanced techniques and research data of advanced countries, twd drew up a 20 - year, long - term plan to proclaim the determination of twd in addressing leakage problems, to continue to improve leak detection and to meet the expectations of the public in this undertaking. we will actively and optimistically carry out the plan step - by - step, so that we can gradually reduce the leakage rate and leave a mark as witness to our efforts

    為延續漏水改善成效，符合民眾殷切期盼，本處參酌92年執行成果與經驗，並納入國外先進技術及研究資料，研擬20年長程計畫，宣示本處勇於面對問題的決心，未來更將以務實樂觀的態度，一步一腳印按照計畫執行，期能逐年降低漏水率，為歷史留下見證。
  16. Experiments show that he correct - localizations rate of this model applied in the dot - domain and wavelet - transformation - domain is higher

    實驗中正確檢測率達到93 . 7 ，較低的漏檢率6 . 3 ，錯誤檢測率百分之十幾。
  17. Glass in building - insulating glass units - long term test method and requirements for gas leakage rate and for gas concentration tolerances

    建築玻璃.絕緣玻璃組件.長期試驗法以及漏氣率和氣體濃度公差的要求
  18. Glass in building - insulating glass units - part 3 : long term test method and requirements for gas leakage rate and for gas concentration tolerances

    建築物玻璃.隔熱玻璃組件.第3部分:長期試驗法以及漏氣率和氣體濃度公差要求
  19. Standard test method for determining rate of air leakage through exterior windows, curtain walls, and doors under specified pressure differences across the specimen

    通過樣品的規定壓差測定外窗幕墻及門的漏氣率的標準試驗方法
  20. Test method for leak rates versus y stresses and m factors for gaskets

    襯墊的漏泄率與" y "應力和" m "因子關系曲線的試驗方法
分享友人
分享到 Line

分享到臉書