潤滑油泵 的英文怎麼說

中文拼音 [rùngǔyóubèng]
潤滑油泵 英文
grease pump
  • 潤 : Ⅰ形容詞（細膩光滑; 滋潤） moist; smooth; sleek Ⅱ動詞1 （加油或水 使不幹枯） moisten; lubricate 2 ...
  • 滑 : Ⅰ形容詞1 （光滑; 滑溜） slippery; smooth 2 （油滑; 狡詐） cunning; crafty; slippery Ⅱ動詞（貼著物...
  • 油 : Ⅰ名詞1 （脂肪; 油脂） oil; fat; grease 2 （姓氏） a surname Ⅱ動詞1 （用桐油、油漆等塗抹） apply t...
  • 泵 : 名詞（吸入和排出流體的機械） pump
  • 潤滑油 : lube; lubricating oil; lubricant oil; lubrication oil; lube oil
  • 潤滑 : [機械工程] lubricating; lubrication; lubricate
  1. They are f. o. pumps ， l. o. pumps, ballast pumps, fresh water pumps, sea water pumps, and bilge pumps

    它們是燃油泵，潤滑油泵，壓載水泵，淡水泵，海水泵，和舭部液艙泵等。
  2. Test method for evaluating diesel fuel lubricity by an injection pump rig

    用噴油泵裝置評價柴油潤滑性的試驗方法
  3. Standard test method for evaluating diesel fuel lubricity by an injection pump rig

    用噴油泵裝置評價柴油潤滑性的標準試驗方法
  4. Turbine driven cargo oil pump lubricating oil tank

    汽輪貨汪泵潤滑油櫃
  5. 3. based jellification dynamics theory that the larger the jellification activation energy, the greater the lubricant ' s jelling tendency, it is advisable to analysis the whole jellification process in attempt to find out maximum jellification activation energy emax and its ambient temperature tmax, as a ground for judging the lubricant ' s pumpability

    根據凝膠動力學理論，凝膠活化能越大，潤滑油的凝固趨勢越大，因此對潤滑油應分析其凝膠全過程，從中找出最大凝膠活化能emax以及開始出現最大活化能的溫度tmax ，作為潤滑油低溫可泵性判據。
  6. Lqry series hot oil pump is supported by the ball bearings at the both ends, front end lubricated by lubricating oil, while back end lubricated by grease, with an oil conduit in the middle used to observe the conditions of sealing and recovery of heat conduction oil

    Lqry系列熱油泵的支撐採用了雙端球軸承支撐的結構形式，前端採用潤滑油潤滑，後端採用潤滑脂潤滑，中間有一導油管，用以隨時觀察密封情況和回收導熱油。
  7. Transmission gear for lubricating pump

    潤滑油泵驅動齒輪
  8. Through the statistic analysis on the change of the melt gear pump working condition pre - and post - pet plant capacity increasing and concatenate direct spinning process, the reasons for the unsteady running were studied, the modification measures such as lubricating the oil groove with sliding bearing, mechanical sealing of the gear pump, decreasing the gear pump outlet pressure, changing the automatic speed increasing to hand speed increasing were put forward

    摘要通過對聚酯裝置增容和後接直紡長絲前後熔體齒輪泵工況變化的統計分析，研究其運行不穩定的原因，提出改造措施，包括滑動軸承潤滑油槽，齒輪泵的機械密封，降低齒輪泵出口壓力，改自動提速為手動提速等等。
  9. The mainly works had been done as follows : 1. in order to keep commonality, the modules who have similar thermodynamic process had been classed. such as evaporating module ( including furnace, drum, system of boiler recycled water ), single - phase heat exchange module ( including superheater, reheater, ecomomizer ), lubricating oil system module ( can be used for any lubricating oil system of rotation mechanical impedance ), pump and fan module, ect

    本文所作的主要工作如下: 1 、為保證模塊的通用性，對鍋爐有相似熱力環節的模塊進行分類，建立模塊庫，便於模塊調用，如蒸發區模塊（包括爐膛、汽包和爐水循環系統） ，單相換熱模塊（包括過熱器，再熱器，省煤器等） ，潤滑油系統模塊（可用於各種轉機軸承潤滑油的動態特性的計算） ，泵與風機的動態計算模塊等。
  10. Firstly it spares a large amount of lubricants and reduces the expenses of 1, 000 yuan for a single pump per year. indiect economic loss of unplaned shutdown caused by nonclearence between bearings and the shafts are accoridingly reduced

    首先是節約了大量潤滑油，單臺泵潤滑油損耗每年可減少1000元左右，同時也減少了抱軸次數和影響整個裝置循環或非計劃停車所造成的間接經濟損失。
  11. We have planed to innovate the structure of 1, 685 sets of pumps of the whole company. it is estimated the annual oil consumption of rmb 1, 685, 000 yuan will be economized after completion of the innovation

    計劃逐步對錦西石化分公司1685臺泵密封結構進行改造，全部完成後預計每年減少潤滑油損耗摺合人民幣達1 ， 685 ， 000元。
  12. Products made are enhanced, and to promote industrial safety. we supply lubricants for various industries. products include high temperature lubricating oils, vacuum

    本公司提供不同工業界之生產和保養各方面之特殊潤滑劑、高溫潤滑油、真空泵油、防燃
  13. Airox zs is a premium vacuum pump oil manufactured from high vi base stocks after special water removed treatment combined with oxidation, rust inhibitors and other additives

    雅士zs系列為優質高性能真空泵潤滑油，由經過特別脫水處理的高粘度指數基礎油和精選添加劑調配而成。
  14. Turbo - charger lubricating oil pump

    渦輪增壓器潤滑油泵
  15. Machine tools ; multi - spindle heads ; building blocks lubrication pumps form a

    機床.多軸頭.組合式a型潤滑油泵
  16. Auxiliary lubrication pump

    輔助潤滑油泵
  17. Bearing oil pump

    軸承潤滑油泵
  18. Cause analysis and improvement for deterioration of lubricant in liquid short pump

    貧液泵潤滑油變質原因分析及改進
  19. The lubrication oil in the pump housing must be changed every 2500 working hours or every six months, whichever occurs earlier

    每工作2500個小時或者六個月，以先到期的時間為準，必須將泵殼內的潤滑油更換一次。
  20. The products add the screw pump and the gear pump skillfully and realizes the shaft lubrication forcedly in order to made the lubrication more credibility, which has reduced the lubricating oil level and has solved the contradiction between the lubricating oil capacity and transmission efficiency

    本產品巧妙增加了螺紋泵、齒輪泵實現強制軸心潤滑更充分，且大大降低了潤滑油麵，解決了潤滑油麵和傳動效率之間的矛盾。
分享友人
分享到 Line

分享到臉書