激光接收 的英文怎麼說

中文拼音 [jīguāngjiēshōu]
激光接收 英文
laser pick-off
  • 激 : Ⅰ動詞1 （水因受到阻礙或震蕩而向上涌） swash; surge; dash 2 （冷水突然刺激身體使得病） fall ill fr...
  • 光 : Ⅰ名詞1 （照耀在物體上、使人能看見物體的一種物質） light; ray 2 （景物） scenery 3 （光彩; 榮譽） ...
  • 接 : Ⅰ動詞1 （靠近;接觸） come into contact with; come close to 2 （連接; 使連接） connect; join; put ...
  • 收 : Ⅰ動詞1 （把攤開的或分散的事物聚集、合攏） put away; take in 2 （收取） collect 3 （收割） harvest...
  • 激光 : [物理學] laser 激光靶 laser target; 激光報警器 laser avoidance device; 激光玻璃纖維 laser fibre; ...
  • 接收 : 1 （收受） receive; reception; accept; [電學] receipt; receiving 2 （接管） take over; expropriat...
  1. In the system, the collimation semiconductor laser - scanned beam scanning two perpendiculars direct of one plane of the measured workpiece at the same time is made. the beams with the dimension information of two perpendiculars direct are processed by the scanning receive system, the high - speed photoelectric transition and electronic data process. two measured results of the diametric directs and ellipse tolerance, etc, parameter, of the turning workpiece on the same plane are obtained by non - contact automatic measurement

    在單向激光掃描檢測技術的基礎之上，提出了一種雙向激光掃描檢測系統，其採用激光掃描檢測技術與特殊光學系統相結合，用準直半導體激光掃描光束對被測工件徑向某一截面的兩個相互垂直方向同時掃描，經掃描接收光學系統、高速光電變換、電子學系統和微機數據處理系統，對將攜帶有垂直方向被測量信息的光束進行處理，實現了回轉體工件同一截面兩個垂直方向的徑向尺寸和橢圓度等參數的非接觸自動測量，解決了同時非接觸測量回轉體零件同一截面兩個徑向尺寸的難題，它具有高速，高精度和非接觸自動測量等特點。
  2. Some by - products of this work can be used as routine tools in the uv laser laboratory. commercial video ccd cameras are used to image uv laser and soft x rays, window glass as a fluorescer is used to indirectly measure the uv laser beam profile with high energy density, and a special glass which permits uv light to pass through while absorbs the visible, is introduced into the uv beam profiling in strong visible stray light environment

    實驗中發展了一些測量技術，例如用可見光視頻ccd直接測量紫外激光的光束分佈和激光等離子體產生的x光二維圖象，利用窗玻璃作為熒光體測量能量密度較高的紫外光束分佈，利用可見吸收紫外透射玻璃製成的衰減器測量有嚴重背景光的紫外光束分佈，可以作為實驗室的常規測量工具，並有一定的推廣價值。
  3. Compared with current instruments, the setup can decrease disturbance of disorder radiation by using double layer refractive index sample matching vessel, and it can increase collecting and transmitting efficiency of radiation by adopting single mode fiber with gradient refractive index lens. with a low power laser, the sample has a low scathe, and the laser and the measurement system can be integrated conveniently

    與現有的同類型儀器相比，該儀器採用雙層折射率樣品匹配池減少了雜散光的干擾；採用帶梯度折射率透鏡的單模光纖接收、傳輸散射光信號提高了散射光的收集傳輸效率；用低強度的激光避免了對樣品的輻射損傷，同時可以使激光器和系統集成在一起，整個系統小型實用。
  4. To investigate the practicability of a solar - direct - pumped fiber laser by using a parabolic dish concentrator, the solar power absorbed by the fiber laser and its absorption efficiency were calculated with numerical method based on the characteristics of solar spectrum in outer space

    摘要為了研究拋物面碟形聚光器實現太陽能直接抽運光纖激光器，根據空間太陽光譜分佈特點，採用數值方法，計算了用該聚光器聚集太陽能量抽運雙包層光纖激光器時光纖吸收的太陽能量及其吸收效率。
  5. A simulative algorithm of laser beam scattering by an object in near field is given. based on the algorithm, a simulative software is worked. and by using geometrical modeling and hiding, the received power of remote system for f16 airplane, as an example, is computed

    4 、提出激光引信目標近場散射特性模擬演算法，編制了模擬軟體，並以f16飛機為例，通過幾何建模和消隱處理，計算了目標不同姿態、不同脫靶量和不同脫靶方位角時，彈目交會過程激光引信接收系統的接收功率。
  6. In this thesis, wide - fov ( field - of - view ) optical systems with optical gain based on fov and optical gain of laser detection and warning optical system are studied. it can solve the problem of wide fov matching with small photosensitive surface, enhance the power received, increase detecting sensitivity, reduce the power of laser and decrease the cost of laser accordingly

    本文正是針對上述問題，從激光輻射探測光學系統的視場和光學增益出發，研究寬視場有增益光學系統，解決大視場和小光敏面匹配的矛盾，增強接收到的光功率，提高探測靈敏度，降低對激光輻射源功率的要求，從而降低相應激光器的成本。
  7. Fourthly, a wideband and low noise ladar receiver is manufactured

    研製了一種寬帶低噪聲激光雷達接收機。
  8. The use of interferometer to detect and analyze laser radiation is well known, but when the intense ratio of the laser radiation to the background natural light radiation is too small, the laser radiation cannot be detected. a novel more sensitive method for detect of wideband weak incident laser in strong background noise is introduced in this paper. the optical unit uses two wedge interferometers and two line array detectors. the incoming light radiation is divided into two beams and through the interferometers

    在被動激光偵察告警中，對微弱脈沖激光信號的探測是一個難點。當探測距離相當遠或視場內接收的背景光輻射很強時，脈沖激光信號到達探測器的能量很小，會淹沒在強大的背景光信號中而探測不到。本論文提出了一種探測微弱脈沖激光信號的方法，可對強烈背景光中的激光威脅信號進行探測和告警，並給出其波長參數。
  9. A type of receiver circuit and timing circuit which can be applied in high - speed laser range - finder is discussed in this paper

    本論文詳細討論了一種可實現高速激光測距的接收電路和計時電路。
  10. The hardware mainly included the emitting circuit of the laser light, receiving circuit and high speed data acquisition circuit

    硬體部分包括激光發射電路、回波接收電路，高速數據採集電路等。
  11. For these reasons, our vision naturally adjusts as clearly as possible to separate colors

    最終，散射強度大的藍色光波附近的色彩刺激人眼的藍色接收器。
  12. The thesis analyses the problems on the noise of apd photoelectric receiving system. author designs apd laser signal receiving system circuits, front amplify circuit, controlling time - series logic circuits, dc / dc transform circuits. and takes apd bias voltage fuzzy control

    分析了apd光電接收系統的噪聲問題，並對apd激光信號接收系統電路、前置放大電路、控制時序邏輯電路、 dc / dc變換電路進行了設計，採取了apd偏壓模糊控制。
  13. On the base of studying imaging theory of lens, the imaging theory of laser confocal scanning microscopy was analyzed in detail in this paper, and the advancement of that the optical fiber was applied to the system was described ; on the base of completed the demonstration for whole project, the experiment scheme was designed ; the relationship between the main parameters of key devices and the resolution was deduced, and the requirements of coupling efficiency and vignetting effects to optical system was analyzed ; the design of optical system and the planar scanning controlling circuit was completed ; a new method was put forward to resolved the inherent non - liner scanning problem of the galvanometer scanner by using software liner controlling in circuit design, and the perfect planar scanning was realized ; at last the low noise, high multiple and non - distortion amplify circuit of photoelectric detector was completed

    本文在透鏡成像理論的基礎上，系統、深入地分析了共焦掃描顯微成像的機理，論述了應用單模光纖的激光共焦掃描顯微成像系統的優點；進行了總體方案的論證，並設計確定了單模光纖激光共焦掃描顯微成像系統的總體方案；從理論上推導分析了解析度要求與試驗系統中相關器件主要參數之間的關系，分析了系統耦合效率和漸暈現象對光學系統的設計要求；完成了方案中光學系統和二維掃描控制電路的設計，並在電路設計中採用了用軟體解決檢流計式光學掃描器（振鏡）非線性問題的新方法，能夠實現較為理想的二維模擬掃描；完成了高增益、低噪聲和低失真的探測接收系統的設計和調試。
  14. Traditional laser iff has poor security because of low frequency of laser beam coded pulse. this can be greatly improved when the pulses are modulated by continuous wave laser, but the power of this laser beam output is so low that it ’ s difficult to be detected and received by laser warning subsystem

    傳統的激光敵我識別器激光編碼脈沖頻率低，通信保密性差，使用連續波激光器經調制后激光編碼脈沖頻率高，保密性好，但輸出激光功率較低，難以達到激光告警分機探測接收的要求。
  15. The five lingnan undergraduates were : au yeung wing kit, third - year bachelor of business administration honours ; ho kin shing, ho kin suen and ngai tsz yiu, all second - year students in the same programme ; and lam kwan yat, a third - year student from the department of philosophy. noting that consumers were becoming immune to conventional advertising channels, the five students came up with an idea of establishing a zero ad enterprise using laser - printed eggs as their medium. the eye - catching end result was an innovative new low - cost advertising channel that would get clients messages into almost every home in hong kong

    五位嶺大同學有見于雞蛋是一般家庭經常購買的基本食糧之一，而消費者對於一般的推廣渠道如電視報章及電臺廣告已漸見生膩，因此他們想到透過成立思路廣告zero ad的創新企業，利用激光技術將廣告印在雞蛋殼上，以為客戶帶來低成本直接而又高效益的市場推廣服務此外，廣告更可同時印于以可循環再做的有機物料製成的包裝膠盒上，在既能收到宣傳效用之餘，也合符環保原則。
  16. The article analyses wide angle laser signal receiving system and the receive sensitivity of system, and studies the problems on circuits designing of laser receiving system

    對廣角激光信號接收系統和系統的探測靈敏度進行了分析，研究了激光接收系統電路設計問題。
  17. A new technique for expanding the upper limit of the receivable angle of scattered light in laser particle sizers

    擴展激光粒度儀散射光接收角上限的新方法
  18. As the 4v4h1d laser striping instrument can also offer such a laser modulation ( detector ) function, it can be operated under strong light or outdoor light, if it is fitted together with a laser receiver

    4v4h1d激光標線儀還具有「激光調制（ detector ） 」功能，配合激光接收器，可以在光線較強的環境或室外使用。
  19. Normally the laser - controlled ground leveling systern contains four units, laser emitter, lasef receiver, controller and leveling shovel. this paper researches the following subject theoretically

    激光控制平地成套設備一般由四個基本部分構成，即激光發射裝置、激光接收裝置、控制器、平地鏟運設備。
  20. Second, the whole process of developing the test system is introduced. the design of optical structure, mechanical structure, laser, fiber, monitor software and database software are all presented in detail. third, the process of debugging and test is introduced

    其次，對pin光接收器測試系統研製的全過程進行介紹；重點論述了光學、機械結構的設計、激光光源、光纖的選擇和應用以及自動測試和集中監控應用軟體的集成和數據庫軟體的編制。
分享友人
分享到 Line

分享到臉書