激勵光 的英文怎麼說

中文拼音 [guāng]
激勵光 英文
activating light
  • : Ⅰ動詞1 (水因受到阻礙或震蕩而向上涌) swash; surge; dash 2 (冷水突然刺激身體使得病) fall ill fr...
  • : Ⅰ動 (勸勉) encourage; exert oneself Ⅱ名詞(姓氏) a surname
  • : Ⅰ名詞1 (照耀在物體上、使人能看見物體的一種物質) light; ray 2 (景物) scenery 3 (光彩; 榮譽) ...
  • 激勵 : 1 (激發鼓勵) encourage; impel; urge; inspire; excite; stimulate; put one on one s mettle 2 [電...
  1. It ' s impossible to grasp just how powerful love is, it can sustain us through trying times, or motivate us to make extraordinary sacrifices, it can force decent man to commit darkest deeds, or compel ordinary woman to search for hidden truths, and long after we are gone, love remains, burned into our memories, we all search for love, but some of us, after we ' ve found it, wish we hadn ' t

    我們不可能理解愛是如何的強大,它能支持我們度過困難時,或者我們走出非同尋常的犧牲,它能迫使正派的男人做出最黑暗的事,或者促使普通的女人尋找隱藏的真相,在我們過世很久之後,愛依然存在,深深刻在我們的記憶中,我們都在尋找愛,但我們中的一些人,在我們找到愛之後,寧願希望沒找到過。
  2. Technology about hydrophilous and hydrophobe film by light - excite reaction

    利用反應的親水及憎水膜技術
  3. Even if there is only a fantasy or an illusion, so long as it shows a ray of hope, it still urges you on in pursuit of the glimmer without letup

    不管是望梅止渴,還是畫餅充饑,它都會你不停手中的槳,去追逐哪怕是一星微小的火
  4. Lord, when i am confused, guide me. when i am weary, energize me. when i am burned out infuse me with the light of the holy spirt

    主!當我疑惑時,引導我。當我疲乏時,加添我力量。當我耗盡時,以聖靈之我。
  5. For the negative uniaxial crystal material, the principal mode is a hybrid guided mode, which can also be excited by the light at any frequency, but when the single mode propagation condition can not be satisfied, some of the higher order hybrid guided modes will exist in the waveguide

    對于負單軸晶體,波導的主模是混合模hgm _ 0模,該模式同樣可被任何頻率的波所;當波波長滿足一定條件時,波導內傳輸單模,否則,將起高階混合模。
  6. The most achievement is that we firstly obtain the analytic accurate solution of the modal fields of the waveguide structure and find some available character : ( 1 ) the different uniaxial crystal materials have the different propagation properties ; ( 2 ) when the optical axis of the crystal is on the plane that is made up of the normal direction of the waveguide plane and the propagation, there are te mode and tm mode in this special waveguide, but the principal mode is different of the character of the uniaxial crystal, the principal mode is the principal mode of te mode for the negative uniaxial crystal, but the one of tm mode for the positive uniaxial crystal ; ( 3 ) when the crystal optical - axis parallel to the waveguide plane, for the positive uniaxial crystal material, the principal mode of the waveguide is a te wave, which can be excited by the light at any frequency ; when the light frequency satisfies a single mode propagation condition, there will be only the principal mode propagating in the waveguide, otherwise some of the higher order modes can be excited, which are neither te modes, nor tm modes, but the hybrid guided modes

    本文就是在此背景下,利用金屬波導和單軸晶體的一些特性,結合麥克斯韋方程組和波導的邊界條件,從三種不同的情況研究了在對稱平面單軸晶體金屬波導(波導層是單軸晶體,兩個波導界面均為金屬)內的傳輸特性,其主要貢獻為,首次解析地得到了這種波導結構下模式場的精確解,並發現了一些有用的特性: ( 1 )模式場的性質因單軸晶體的性質不同而異; ( 2 )當單軸晶體軸位於波導界面法方向與傳輸方向構成的平面內時,波導中傳輸te波和tm波,只不過其主模因單軸晶體的性質不同而異,當波導層介質為負單軸晶體時,波導主模是te波主模,而波導層介質為正單軸晶體時波導主模是tm波主模。 ( 3 )當單軸晶體軸位於波導面內時,對于正單軸晶體,波導的主模是橫電波te _ 0模,任何頻率的波均可該模式;當波波長滿足一定條件時,波導內傳輸單模,否則,將起高階模式,高階模即匪te波,也匪tm波,而是兩者耦合而成的混合模。
  7. Rf over voltage protection, laser over heat protection, automatic power control and automatic temperature control to ensure the reliability and stability

    射頻過保護器過熱關斷保護,自動功率控制,自動溫度控制,確保發射機工作性
  8. No matter they are quenching your thirst by thinking of plums or are appeasing your hunger with depicted cakes, they will encourage you to keep up to purchase the brightness, even though it is tiny

    不管是望梅止渴,還是畫餅充饑,它都會你不停手中的槳,去追逐哪怕是一星微小的火
  9. For instance, the phosphor on a crt screen needs to be constantly reactivated by an electron beam in order to remain illuminated

    例如,陰極射線管熒屏上的磷體為了保持它狀態,需要用電子束不斷地再
  10. In this paper, the stl technique with cw modulated top - hat beam excitation is investigated theoretically and experimentally. 1. the theoretical model based on the fresnel diffraction integral is developed to describe the stl signal excited with the cw modulated top - hat beam for the first time to the best of our knowledge

    本論文提出採用連續調制的平頂束作為激勵光的表面熱透鏡技術測量薄膜吸收的方法,主要開展了如下工作: 1 .建立了連續調制的平頂束作用下樣品的表面熱透鏡信號模型。
  11. Xrd patterns, excitation spectra, emission spectra, photo - stimulated emission spectra, photo - stimulated emission decay curves and thermo - luminescence spectra have been measured on the samples

    對樣品進行了x射線衍射分析( xrd ) 、譜、發射譜、譜、衰減和熱釋譜測定。
  12. The rf discharge excited waveguide co2 laser has been the suitable light source of lidar, because of its low volume, high efficiency and the particular wavelength

    由於射頻波導co _ 2器體積小、效率高、調諧范圍寬、波長正處于大氣透射窗口等獨特優勢,它已成為雷達等應用的理想源。
  13. The conclusions are as follows : the ultrasonic intensity is proportion to the laser intensity ; the ultrasonic induced by a laser line source has much more advantages than by a laser point source, such as stronger energy, higher snr, more directivity and shape ; the intensity of cfpi ' s output signal is linear with ultrasonic vibration velocity, and is effected by incidence angle and scattered angle ; snr will increase by reducing cfpi ' s bandwidth, reducing incidence angle, increasing cavity ' s length and reflectivity

    在分析點聲表面波機理的基礎上,求出了線的超聲振動的位移表達式,發現線的近場區表面波具有波形好,信噪比高,指向性好,幅度強等特點。通過理論推導,得出共焦fabry - perot干涉儀的輸出強除了與樣品表面的振動速度成正比,並與入射角和散射角有關;適當減小cfpi的帶寬,增加腔長,增大鏡面反射率,或者減小檢測入射角都可以提高系統的信噪比。
  14. On the design of the system, the thickness measure system of mems chip is built based on lbu and pump - probe technology. on the analysis of data, the reflectivity curve is analyzed using the law of reflectivity change induced by ultrasound, and the thickness is calculated using the system designed by the article, to aluminum film the size of about 20nm can be measured, when the film be measured is single layer, the relative error of the system is less than 2 %, when the film be measured is double layer, the relative error of the system is less than 10 %

    在基礎理論方面研究了(特別是超短脈沖)超聲的機理,探討了調制技術以提高系統信噪比,闡述了泵束探針束技術及相關實驗設置;在系統設計上,以超聲為基本原理,以泵束探針束技術為系統設計方案完成了mems基片厚度測量系統的設計;在數據分析方法上,利用聲致反射率變化的一般規律對測得的反射率曲線進行分析,確定超聲回波在薄膜兩界面間來回傳播的時間,以計算薄膜的厚度。
  15. Hardware circuit includes the unit loop circuits such as main loop circuit, drive circuit, control circuit, protective circuit, the circuit of power source and displaying circuit etc. the function that the induction cooker can realizes are mainly as follows : heat function, warm function, time function, no pan detecting and alarm function, which includes overheat alarm, over voltage or under voltage alarm, fan failure alarm etc. the displaying interface has digital number display indicator and vacuum fluorescent display

    硬體電路主要包括主迴路、電路、控制電路、保護電路、電源電路和顯示電路等單元迴路,主要實現的功能如下:加熱功能、定溫功能、定時功能、無鍋檢測功能、報警功能,具體包括過熱報警、過壓或者欠壓報警、風扇失效報警等。顯示界面有數碼管顯示和真空熒屏顯示。
  16. In former stl instruments, a laser beam with a gaussian distributed intensity was commonly used as the excitation source. nevertheless, the output of a high power laser is usually a superposition of multi - modes rather than a gaussian distribution ( tem00 ). therefore, it is very convenient to add an aperture to get a top - hat beam

    以前的表面熱透鏡裝置中,多使用高斯束作為激勵光,但由於高功率器一般為多模輸出,要獲得嚴格的基模高斯束比較困難,而平頂束可以通過在器前加一定大小的闌實現,降低了對束質量的要求,更有利於實際的測量。
  17. Numerical results show that the top - hat beam stl instrument is more sensitive than the gaussian beam stl instrument, with a maximum sensitivity enhancement factor of approximately 2. 3

    測量了信號的衍射分佈,信號與激勵光功率、激勵光斑半徑、調制頻率、探測距離的關系,與理論吻合較好。
  18. Moreover, higher sensitivity can be achieved when a top - hat beam is used as the excitation source

    且使用平頂束作為激勵光可以提高學薄膜微弱吸收的測量精度。
  19. In part i the fluorescence photobleaching characteristics of oxygen sensitive membrane for fluorescence quenching based oxygen sensors are analyzed in details. using laser source and home made heater control circuit, we study the photobleaching model and investigate the characters of wavelength - dependance, intensity - dependance and temperature - dependance of ru ( dip ) 32 + based oxygen sensitive membrane

    文中重點研究了ru ( dip ) _ 3 ~ ( 2 + )絡合物氧敏感膜的降解模型、氧敏感膜降解速率與激勵光波長、強度及膜環境溫度的依賴關系。
  20. The system uses a new replaceable chip and has realized the chip separated from the flow injection pool. and according to the new chip, the system is designed to employ a new flow injection pool which has a compact structure. in addition, the new system strengthens the function of the control software and puts automatic data - treating into practice

    改進后的系統採用激勵光源正面照射的方式,增強了電流的響應;同時系統採用新型的可替換式laps晶元設計,實現了多個laps晶元共用一個流通測量池;系統還針對新的晶元設計了流通測量池,該測量池結構緊湊合理,真正實現流通檢測;另外系統還增強了主機控製程序的功能,實現了實驗數據自動化處理,並優化了系統參數設置。
分享友人