激波曲率 的英文怎麼說
中文拼音 [jībōqūlǜ]
激波曲率
英文
shock curvature-
If the velocity of atoms is near to zero, the light for ces will tend to confine the atoms near to nodes and antinodes. the stability depends on the magnitude of the negative slope of the light force, the depth of the potential well and the momentum diffusion coefficient. it is important to select the parameters, e. g
如果通過激光冷卻能使原子速度降至很小甚至為零，光壓力的作用將使原子被較穩定地囚禁于激光駐波場的節點和反節點處，其穩定程度取決于該處光壓力曲線負斜率的大小、對應勢能的勢阱深度以及動量擴散系數的大小，因此，如何在實驗中合理選擇激光強度、失諧量等顯得尤為關鍵。This paper analyses the coupling wastage in columniform wave guide gas laser, and gives the function between the coupling wastage of laser guide modulo eh11 and the position and radius of reflector
摘要分析了圓柱形波導氣體激光器中的耦合損耗，給出了最低階波導模eh11的耦合損耗與反射鏡位置、曲率半徑的函數關系。The relation between area of ccd saturation and 0. 632 m 、 1. 06 m laser power / energy was measured. the ccd camera was disturbed by strong radiation from laser outside the field of view in experiment. the relation between the area of ccd saturation and off - axis angle was measured
通過實驗，得到激光干擾ka - 320型面陣ccd光電探測器的像元飽和閾值、探測器靶面飽和閾值、局域損傷閾值，並得到了0 . 632 m與1 . 06 m波段入射激光功率與ccd靶面飽和程度的對應關系曲線，了解了面陣ccd探測器受激光干擾的各個階段。The components of the tangential stretch mode of swtns are assigned, the variational curve of the value of ig / id changed with laser power is obtained at 632. 8nm excitation, the vibration of d mode is assigned renewedly
對單壁碳納米管的正切拉伸模的成分進行了歸屬，在632 . 8nm激發波長下得到了ig / io值的隨激光功率變化曲線。重新對d模的振動進行了歸屬。Fluorescence power transfer function, three - dimensional point spread function ( 3d - psf ) and three - dimensional optical transfer function ( sd - otf ) for the various fluorescent wavelength of the two kinds of fluorescence confocal scanning microscopy are calculated in this paper by using fourier imaging theory. the results show that the fluorescent wavelength has influence on imaging property of confocal microscopy such as spatial cut - off frequency, resolution and 3d - otf. there is a different missing - cone in the 3 - d space of otf when the ratio of excitation wavelength to fluorescent wavelength decreases
本文在sheppard和gumin等人的理論基礎上，利用fourier光學成像理論，討論了不同熒光波長對單光子和雙光子共焦顯微鏡成像特性的影響，導出了單光子和雙光子共焦顯微鏡的熒光功率傳輸函數、三維脈沖響應函數和三維光學傳遞函數，得到了它們在不同激發波長與熒光波長比值時具體的表達式，並且通過數值計算，得到了它們的曲線圖，結果表明：隨著激發波長與熒光波長比值的增加，焦斑的橫向分佈和縱向分佈變窄，橫向解析度和縱向解析度提高，系統的成像效果變好，當激發波長與熒光波長的比值下降到一定程度時，可以看到不同程度的失錐現象。Secondly, the third order nonlinear optical properties of these compounds are studied under the excitation of ps pulsed laser with the wavelength of 1064nm using z - scan technique, nonlinear refractive indices and nonlinear absorption coefficients are calculated according to the z - scan experiment curves of the compounds. all the three compounds have self defocusing characters and two photon absorptions. lastly, nonlinear refraction and absorption properties of these compounds are studied by z - scan technique under the excitation of ps pulsed laser with the wavelength of 532nm the self defocusing and reverse saturation absorption are found in these compounds
根據實驗曲線計算了它們在1064nm下的三階非線性折射率和非線性吸收系數，三種化合物都具有自聚焦特性，並且在該波長下，三種化合物均具有雙光子吸收，最後，以皮秒脈沖的532nm為激發波長，採用z掃描方法，研究了三種金屬有機化合物的非線性折射和非線性吸收性質，在該波長下三種化合物仍然表現為自聚焦特性，且其吸收為反飽和吸收。Shock wave curvature
激波波前曲率On the design of the system, the thickness measure system of mems chip is built based on lbu and pump - probe technology. on the analysis of data, the reflectivity curve is analyzed using the law of reflectivity change induced by ultrasound, and the thickness is calculated using the system designed by the article, to aluminum film the size of about 20nm can be measured, when the film be measured is single layer, the relative error of the system is less than 2 %, when the film be measured is double layer, the relative error of the system is less than 10 %
在基礎理論方面研究了激光（特別是超短脈沖激光）超聲的激勵機理，探討了激光調制技術以提高系統信噪比，闡述了泵束探針束技術及相關實驗設置；在系統設計上，以激光超聲為基本原理，以泵束探針束技術為系統設計方案完成了mems基片厚度測量系統的設計；在數據分析方法上，利用聲致光反射率變化的一般規律對測得的光反射率曲線進行分析，確定超聲回波在薄膜兩界面間來回傳播的時間，以計算薄膜的厚度。Based on these foundations, we give a perfect scheme of the bbo opos : single pass amplification coefficient of the opg under different pump intensity is calculated ; collinear type - i and type - ii phase matching tuning curve pumped by the q switch nd : yag various harmonics as well as noncollinear type - i tuning curve are calculated in details ; the effect of the walkoff for the nonlinear effect coefficient and the group velocity matching are analyzed ; the acceptance angle in parametric process is calculated ; the numerical threshold of the bbo opo is calculated ; the process of the saturation and depletion of the pump beam are analyzed ; the relationship of the conversion efficiency and reflectance of output mirror are discussed ; various linewidth controlling methods are discussed ; the improvement of the beam quality applying the unstable cavity is discussed ; and the crystal bbo design is considered
在此基礎上，給出了一整套bbo - opo激光參數設計方案：計算了不同泵浦強度下的參量放大倍數；詳細計算了在nd : yag調q激光器各次諧波泵浦條件下的共線類和類相位匹配的調諧曲線，以及非共線類相位匹配調諧曲線；分析了走離角對非線性系數和群速匹配的影響；計算了參量過程的允許角；計算了bbo - opo的理論閾值條件；分析了飽和與泵浦光束的消耗過程；給出了轉換效率與超過泵浦閾值的倍數的關系；討論了轉換效率與輸出鏡反射率的關系；討論了線寬控制的各種方法；研究了利用非穩腔改善光束質量的方法；考慮了bbo晶體的設計。This paper begins with the calculation of the stator ' s resonance frequency, deals with the design and manufacture of motor, and puts forward dual nut structure of traveling wave revolving ultrasonic motor, and presents the analysis of the contract between rotor and stator in the manufacturing process, relation between the amplitude of voltage - ceremic chip and drive sources. the conclusion is that amplitude is affected by deviation of resonance frequency
同時分析了電動機的加工工藝，對超聲波電動機製造過程中功率與接觸角和振幅與驅動電源的關系進行了討論，得到了接觸角與輸出功率的關系曲線，以及超聲波電動機的振幅主要受電壓和激振頻率偏離定子環第2n階諧振頻率的偏離量確定。On the basis of this, the effective reflective index with the variation of the carrier density is discussed. this paper also analyzed the random facet phase and the length of the cavity ' s influence on threshold characteristic. especially, the wavelength tuning characteristics have been investigated in detail when one segment works as absorbed region
在此基礎上，研究了每一段等效反射率譜曲線隨載流子濃度變化的情況；分析了邊界相位的不確定性以及激光器腔長對閾值特性的影響；重點討論了其中一段工作在吸收狀態下的波長調諧性質。5. based on the solutions developed herein, the main features of the interaction between visco - elastic layered soil and an integral pile or a multi - defective pile are systematically analyzed. the influence on the vibration properties caused by soil modulus, the degree of pile defects, and the length and location of the defects are discussed, and many important conclusions are drawn
5 、利用所得解，對成層土中完整樁、變截面、變模量樁的振動特性進行了較系統的分析，並重點討論了土層模量、樁身缺陷程度、埋身、缺陷段長度、激振頻率等對樁項復剛度、樁頂反射波曲線、導納曲線的影響，得到了許多重要結論。Second, the mode fields of a strip waveguide and some slab waveguides have been simulated by applying finite - difference time - domain ( fdtd ) method. the curvature radius ; vicinity coupling ; transition loss and power attenuation of a s - shape bend waveguide have been analysed numerically by employing wide angle finite - difference beam propagation method ( fd - bpm ), as well as the coupling loss of optical fiber and waveguide. in addition, the framework of the s - shape waveguide laser has been
其次，應用時域有限差分法，結合波導模式理論對條形與平面波導進行了模場模擬;應用廣角有限差分光束傳播法，對s形彎曲波導的曲率半徑、鄰近耦合、過渡損耗、功率衰減以及波導與光纖的各種耦合損耗進行了數值分析，並在此基礎上，對s形波導激光器的結構作了初步設計。Wave - front curvature relation of exciting media affected by external field
外界場作用下激發介質的波前曲率關系分享友人