激磁電壓 的英文怎麼說

中文拼音 [diàn]
激磁電壓 英文
excitation voltage
  • : Ⅰ動詞1 (水因受到阻礙或震蕩而向上涌) swash; surge; dash 2 (冷水突然刺激身體使得病) fall ill fr...
  • : 名詞1. [物理學] (磁性; 能吸引鐵、鎳等的性質) magnetism 2. (瓷) porcelain; china
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : 壓構詞成分。
  • 電壓 : voltage; electric tension; electric voltage
  1. Finally, because high - speed power solenoid valve is one of the most important executive parts in the electronic control diesel engine and the performances of diesel engine are strongly related to the solenoid valve, the response performance of the solenoid valve is investigated. the response performance of the solenoid is influenced by many factors, such as driving voltage, electric driving unit etc. in order to have high excitation voltage and in low maintaining voltage, a high - low voltage electric driving unit is designed, and in order to make the solenoid valve close more rapidly, an active free - wheeling circuit and a bootstrapping circuit are designed in the electric driving unit, too. in the high - low electric driving unit, high voltage and low voltage are supplied by the dc - dc device and by the accumulator respectively

    高速強力閥的響應性能除了與閥本身的結構和材料有關外,與驅動、驅動路的設計密切相關,本文通過分析,首先開發出一種高低驅動路,高源是山升式dc - dc原理獲取的,低由蓄池本身提供,實現高和低維持的功能,路中採用有源續流柴汕機中卜軌知介系統的設訓及其七川j敝略的叭究路進行續流,加誣了閥的關閉速度;採用自舉吐路,降低了場效應管對驅動的要求。
  2. Based on the thorough investigation of the post - regulation and efficiency in multiple output switching - mode power supplies, an optimal combination topology for multiple output switching converter is presented in this thesis, which is consisted of forward converter with active clamp ( fac ), synchronous rectification ( sr ) techniques and magnetic amplifier technique ( magamp )

    本文通過研究分析近年來多路輸出開關源輔助輸出調節和提高效率的方案,面對開關源朝著輸出低流方向發展的趨勢,提出多路輸出開關源新的拓撲優化組合模式? ?有源鉗位正變換器、同步整流技術、放大器。
  3. The wave of magnetic induction density will bring distortion with the raising of excitating voltage while measuring the magnetization characteristic

    在進行化特性測量時,隨著激磁電壓的升高,感應強度波形將產生畸變。
  4. Applying the theory on hydrodynamics and combining the structure of the pump, the method of calculating the flux is found, using the simulating dual pump which mercury serve as the working medium, by the experiment on the electromagnet used in the dual pump, the optimum method of the coil connection is gained ; by the experiment on the relation the static pressure and the working parameter in different groove structure, a high - efficiency groove structure named as " + " shape are devised ; by comparing the static pressure and flux between single pump and dual pump, the conclusion that the flux of dual pump is about 1. 6 times as much as the flux of single pump is educed, and prove it practical that the dual pump is adopted to increase the flux

    利用水銀為工作介質的雙聯泵,通過對雙聯鐵不同接法的實驗研究,找到最佳線圈接線方法;通過對不同流槽結構的靜頭與工作參數關系實驗,研究得出一種高效率的新型流槽結構? ?十字型流槽結構;通過對單泵、雙泵的泵高和流量實驗,得山了在同等工作條件下,雙泵流量大約為單泵的1 . 6倍的結論,從而證明了採用雙聯泵的方法來提高直流泵的方法是切實可行的。
  5. Then a thorough analysis to the bias - magnetic of ppfc is made. the retraining effects of the main parameters ( include clamping capacitance c, output filter inductor lf, load r, the leakage inductor ls and source winding resistance r ) are studied under the conditions of different von, different ton and different winding parameters. then a conclusion can be drew, that the smaller lf and the bigger r are, the better the bias - magnetic is restrained and c has a best value to retrain the bias - magnetic

    分別對管降不同,導通時間不同以及兩原邊繞組參數不一致(包括漏感、阻、感三種情況)的情況下,主要參數(包括箝位容c 、輸出濾波感lf 、負載r 、原邊繞組漏感ls 、原邊繞組阻r )對偏的抑制作用進行了模擬分析研究,得出lf越小, r越大時勢偏移量ni越小, c在其他參數確定時對抑制偏有最優值等結論,為參數的優化設計提供了依據。
  6. In this paper, the working principle of the interleaving two - transistor forward converter is analyzed in detail, and the waveforms of the switch drain - to - source voltage and transformer magnetizing current are researched in different duty cycle conditions. the simulation model is constructed and the simulation results verify the analysis

    本文分析了交錯並聯雙管正變換器的工作原理,研究了在不同占空比條件下開關管的漏源和變器勵流波形,建立了模擬模型,模擬結果證明理論分析的正確性。
  7. Imported accessories are adopted. unique design of less noise with dc electromagnetic switch and hydraulic circle

    進口配件,採用直流閥及無沖之油迴路,機器運轉噪音低的獨特設計。
  8. This dissertation also presents the equivalent stiffness and damping models and the nonlinear hysteresis and saturation model of a kind of the mr damper developed by the experimental testing and modeling in order to describe accurately characteristics of the mr damper

    建立了流變阻尼器的等效剛度和等效粘性阻尼系數與施加振頻率和振幅的關系以及能精確表示流變阻尼器的力學特性的非線性滯回模型。
  9. According to the experience of under - excitation operati on of the same type units and the suggestion of manufacturers, the generator excitation system was improved to ensure stable function of auto voltage adjusting device during over - excitation and under - excitation operation

    根據同型機組進相經驗和廠家意見改進發機勵系統,保證過、欠狀態時自動調整裝置運行穩定。
  10. We took the high frequency flyback converter design as an example and made a calculation model of the total loss of the high frequency flyback transformer. on basis of the caculation model combined with the systemic method of designing dc - dc converter, and the method which is base on the current shape, is presented to achieve the appropriate parameters of the flyback transformer, an optimized approach to design high frequency dc - dc converter is given in this paper. the appropriate parameters were achieved by genetic algorithm. through this method, a practical high frequency flyback

    2 .在理論分析的基礎上,以優化高頻變器的芯損耗和繞組損耗為目標,以單端反式變器為例建立了高頻變器的總損耗計算模型,在該損耗計算模型的基礎上結合從系統角度設計dc - dc變換器的方法和考慮流波形對變換器設計的影響,採用一種基於遺傳演算法的高頻dc - dc變換器的優化設計方法,該優化方法實現是通過遺傳演算法計算得到設計參數的最優取值。
  11. The characteristic of those topologies are analyzed in detail. a novel isolated interleaving two - transistor forward boost converter is proposed in this paper. this converter has less voltage stress of power switches, and no transformer magnetic deviation

    研究一種新穎的隔離boost變換器,它具有開關管應力低,沒有變器單向飽和問題,可以實現交錯並聯雙管正路所有開關管零開關。
  12. The mathematical model of non - linear transient magnetic field excited by voltage source is established in this paper. it coupled with electric circuit equation and mechanical motion equation, could solve the transient problem excited by voltage source, and the effect of the eddy currents, non - linearity in magnetic materials and mechanical motion of medium is taken into account

    文中建立了下的非線性瞬態場的數學模型,通過把瞬態場方程、路方程及機械運動方程耦合在一起,得出求解下,考慮鐵材料的非線性、導媒質的渦流及媒質機械運動等條件下的瞬態過程問題。
  13. We adopted excitating voltage that its frequency is 0. 5hz to replace dc excitating voltage when measured the dc magnetization characteristic

    對于直流化特性的測量,本文採用了用0 . 5hz的激磁電壓宋代替直流進行測量從而使測量方法更加簡單。
  14. Because the excitating voltage ' s frequency is 0. 5hz, the signal of induced voltage is very small, even though smaller than noise. so how to accurate pick the weak signal is the key of measuring dc magnetization characteristic

    由於激磁電壓為0 . 5hz ,因此其感應非常小,甚至小於干擾信號,如何準確的採集到該弱信號是進行直流化特性測量的關鍵。
  15. In order to measure magnetization characteristic with high accuracy we must keep the wave of magnetic induction is sine, so we must control the excitating voltage

    為了能夠精確的測量化特性必須保證感應強度波形為正弦,因此必須對激磁電壓波形進行控制。
  16. On the basic of completed the wave control, we studied the accelerated arithmetic. the speed of measurement has widely improved by using the accelerated arithmetic

    我們在完成了對激磁電壓控制的基礎上並研究了波形控制的加速演算法,從而使化特性的測量速度有了很大提高。
  17. Firstly, the controllable reactor is connected directly with power network, so it is a electromagnetic field inspired by both voltage source and current source

    首先,鑒于可控抗器是一個既有源又有流源勵的非線性準靜態的場問題。
分享友人