濕潤試驗 的英文怎麼說

中文拼音 [shīrùnshìyàn]
濕潤試驗 英文
spread test
  • : Ⅰ形容詞(沾了水的或顯出含水分多的) wet; damp; humid Ⅱ名詞(姓氏) a surname
  • : Ⅰ形容詞(細膩光滑; 滋潤) moist; smooth; sleek Ⅱ動詞1 (加油或水 使不幹枯) moisten; lubricate 2 ...
  • : 名詞(古代占卜用的器具) astrolabe
  • : 動詞1. (察看; 查考) examine; check; test 2. (產生預期的效果) prove effective; produce the expected result
  • 濕潤 : moist; humectation; humidification
  • 試驗 : trial; experiment; test
  1. The measurement of spontaneous surface wetting is one of the few experimental tools available for the study of solid-surface energetics.

    對自發性表面的測量,確實是研究固體表面力能學的少數幾項方法之一。
  2. Test mothod for effective bentonite and effective seacoal content in green molding sand

    鑄造用型砂有效膨土及有效煤粉。方法
  3. Standard test method for evaluation of wetting agents by the skein test

    用絞紗評定劑的標準方法
  4. Testing of solderability for soft soldering ; wetting tests

    軟釬焊可軟釬性的檢.濕潤試驗
  5. The research and development and industrial test of aluminium electrolysis wetness cathode

    鋁電解可性陰極的研究開發與工業
  6. Testing method of wettability of glass substrate

    玻璃襯底材料度的方法
  7. Test method for surface wettability of paper angle - of - contact method

    紙表面性的方法
  8. Laboratory experiment study on the effects of water quality and emitter discharge on wetted soil geometry and volume

    水質及流量對鹽堿土滴灌鋒運移影響的室內研究
  9. Standard test method for wetting tension of polyethylene and polypropylene films

    聚乙烯和聚丙烯薄膜張力的標準方法
  10. Through 3 - year field experiment, mathematical models were established for yields of spring and winter wheat, soil wetness, designed irrigation depth and fertilization rate. 8

    6 .通過三年田間,建立了噴灌條件下冬小麥、春小麥產量與土壤度、計劃層深度和追肥量三因素間的數學模型。
  11. The test research continuous two years, carry out land membrane cover, the ambient conditions that can improve garlic growth growth, raises winter spring soil temperature, maintenance has moist soil, loose, reduce moisture to evaporate run off, it is good to promote garlic to make sprout early, growth better, and take out moss early, raise output and quality, promote garlic to increase production and receipt

    摘要經過連續兩年的研究,實行地膜覆蓋,可以改善大蒜生長發育的環境條件,提高冬春季土壤溫度,保持土壤、疏鬆,減少水分蒸發流失,可以促進大蒜早出苗、齊苗、長勢好、早抽苔,提高產量和質量,促進大蒜增產增收。
  12. According to the basic equation for water flow in subgrade soil, based on the basic soil properties of compacted loess, the redistribution of soil moisture and the soil water - migrate parameters are studied

    摘要基於黃土路基壓實後土體的基本性質,根據路基土中水分運動的基本方程,通過室內一維土柱入滲,得到不同壓實度的黃土度與平均度、水分入滲速率的關系曲線。
  13. Standard test method for surface wettability and absorbency of sheeted materials using an automated contact angle tester

    使用自動接觸角測儀測定覆蓋材料表面度和吸收性的標準方法
  14. This research was conducted to : ( 1 ) understand the characteristic and pattern of trickle source infiltration, ( 2 ) study mulched crop evapotraspiration for cotton and corn in a arid climate sandy loam soils. according to the researches of the dissertation, the main results are as follows : ( 1 ) the shape of wetted soil volume is influenced by soil texture, discharge rate and the total volume of applied water in case of trickle source infiltration

    本文以粘壤土為研究對象,對微源入滲特性規律進行了系統的室內研究,並且對膜下滴灌大田作物棉花和玉米的需水規律進行了野外,得到了以下幾點結論: ( 1 )地表微源入滲土壤體的形狀受到土壤質地、供水強度和灌水時間的影響,一般為半個橢球體。
  15. Test method for surface wettability and absorbency of sheeted materials using an automated contact angle tester

    利用自動接觸角測儀測定薄板材料的表面性和吸水性的方法
  16. However, the movement and transformation of n in soil under fertigation remains unclear. the methods of simulation experiment and culture experiment were used to study the movement and transformation of n in soil under fertigation by drip irrigation. the main experimental results were shown as folio wings : ( 1 ) the water infiltration under drop irrigation is a point infiltration ; and the soil moisture in vertical and horizontal directions was increased with the irrigation time, and the movement rate were decreased with the irrigation time

    本研究採用室內模擬和生物培養相結合的方法,研究了在滴灌施肥條件下,化學氮肥施入土壤后的遷移、轉化規律以及對作物生長的效應,獲得了以下主要結論: ( 1 )滴灌條件下水分以點源入滲土壤,水平和垂向的鋒均隨入滲時間的增加而逐漸變大,在入滲開始階段鋒的推進速率較大,隨入滲時間的延長,鋒的推進速率逐漸變慢。
  17. Test method for properties of investment casting pattern materials - part 6 : determination of wetting angle between pattern an binder

    熔模鑄造模料性能方法第7部分:熔模-粘結劑角的測定
  18. The results showed that the lower initial soil moisture content was, the less infiltration occurred and wetting front moved slowly, and soil salt were leached more efficiently. at the same time, salt reduced in the top soil and salt accumulated at the wetting front

    通過對土壤初始含水量下土壤水鹽運移規律室內模擬研究,發現隨著土壤初始含水量的增加,相同入滲歷時內的累積入滲量和鋒都在增加。
  19. The experimental device of soil moisture movement of multi water storage pit is developed, which can measure the infiltration of moisture and the movement of moisture frontal directly. distribution of soil water content in all soil section are measured with y ray apparatus. 3

    利用該裝置進行室內的蓄水多坑灌水,直接對水分的入滲過程和鋒變化進行觀測,並通過y射線儀裝置測量整個土體剖面上含水率的分佈狀況。
  20. The reasons why surface of workpiece is moistened from bottom to top in quenching and axial hardness gradient is generated after quenching are also given in this paper

    中所觀察到的工件表面由底部向頂部逐漸的現象,以及淬火后工件產生軸向硬度梯度的原因進行了解釋。
分享友人