焊接性能 的英文怎麼說

中文拼音 [hànjiēxìngnéng]
焊接性能 英文
welding characteristic
  • 焊 : 動詞（用熔化的金屬修補金屬器物或使金屬工件連接起來） weld; solder
  • 接 : Ⅰ動詞1 （靠近;接觸） come into contact with; come close to 2 （連接; 使連接） connect; join; put ...
  • 性 : Ⅰ名詞1 （性格） nature; character; disposition 2 （性能; 性質） property; quality 3 （性別） sex ...
  • 能 : 能名詞（姓氏） a surname
  • 焊接 : weld; welding; soldering; seal; sealing; sealing-in; shutting together
  1. The welding performance of homemade wear - resistant cast steel has been studied base on the weldability tests, the repair welding procedures of wean - resistant cast steel ( abrasion - plates ) have been made up, the results show that satisfying repair welding quality can be attained with such welding conditions as the low hydrogenous alkalescent welding rod, preheating and slow cooling, strictly maintaining the interbedded temperature of 250 ~ 300 and controlling welding technique

    通過對其焊接性能的試驗研究，制定了該類鑄鋼件（磨耗板）的補焊工藝：低氫型堿性焊條，預熱與緩冷相結合的工藝措施，嚴格控制層間溫度（ 250 ~ 300 ）及焊接工藝規范，可獲得滿意的修復質量。
  2. Study of welding properties of alloy tig welding of cuznal

    合金氬弧焊焊接性能研究
  3. Designed for automatic spray application. contains retile titanium dioxide to improve weld ability

    是專為自動噴塗施工而設計的。含有可改進焊接性能的金紅石鈦白粉。
  4. However the welding property of al mmcs is poor, it ' s difficult to obtain high joint strength. the application of al mmcs has been restricted by the low joint strength

    但是鋁基復合材料的焊接性能差，很難形成高強度的接頭，成為該種材料走向實用化的嚴重障礙。
  5. Welding - test for shop primers in relation to welding and allied processes - part 2 : welding properties of shop primers

    焊接.與焊接和相關工藝有關的預塗底漆的試驗.第2部分:預塗底漆的焊接性能
  6. Zirconium tungsten electrode has good performance in ac welding

    鋯鎢電極在交流條件下，焊接性能良好。
  7. Zirconiated tungsten electrodes have good performance in ac welding. especially under high load current its excellent performance can not be replaced by any other products

    鋯鎢電極在交流條件下，焊接性能良好；尤其在高負載電流的情況下，鋯鎢電極表現出良好的優越性能。
  8. " the contactors feature silver cadmium oxide, double break contacts to assure a long electrical life, high weld resistance and excellent interrupting capacity.

    這種接觸器採用銀氧化鎘材料，雙斷接點，有利於保證較長的電氣壽命、較高的抗焊接性能和傑出的斷開容量。
  9. General hot dip galvanized steel sheet is worse workability than cold rolled steel sheet, but recently it has the same and more than workability with cold rolled steel sheet as advanced facilities and technology

    通常鍍鋅鋼板的焊接性能不如冷軋鋼板，隨著工藝和設備的改進鍍鋅板的焊接性能已經趕上甚至超過冷軋板。
  10. The effect of electrode metal microscopic structure change on welding performance

    電極合金顯微組織結構變化對焊接性能的影響
  11. Good corrosion resistant, heat - resistant, high - temperature resistant and antioxidizing in high - temperature, very good mal lea bil i ty and weldability

    具有良好的耐蝕性、耐熱性，高溫強度及高溫抗氧性能良好，加工性、焊接性能良好。
  12. Excellent gas cutting property and weld ability

    具有優異的焊接性能和切割性能。
  13. The jointing capability of acid - resistant stainless steel 1cr17ni2 and jointing measures

    2耐酸不銹鋼的焊接性能分析
  14. Weldability of hg70 steel

    70鋼的焊接性能
  15. Satisfactory welding properties will only be obtained by strict control of application to the recommended film thickness

    只有嚴格控制膜厚，不超過推薦的范圍，才能獲得滿意的焊接性能。
  16. Atmospheric corrosion resisting steel plates with a high weldability, used for bridges, buildings and other structures

    焊接結構用耐大氣腐蝕鋼板，用於要求優良焊接性能的橋梁，建築和其他結構件。
  17. This paper introduces the wonderful cutting and welding properties of lpg （ liquefied petroleum gas ） and its lower cost. thus, the application of lpg is an effctive methods that can improve product quality and reduce cost and benefit the enterprises

    介紹了液化石油氣良好的切割和焊接性能以及燃氣成本顯著降低的特點，從而液化石油氣的應用成為企業提高產品質量，降低成本、增加效益的有效途徑之一。
  18. Abstract : this paper introduces the wonderful cutting and welding properties of lpg （ liquefied petroleum gas ） and its lower cost. thus, the application of lpg is an effctive methods that can improve product quality and reduce cost and benefit the enterprises

    文摘:介紹了液化石油氣良好的切割和焊接性能以及燃氣成本顯著降低的特點，從而液化石油氣的應用成為企業提高產品質量，降低成本、增加效益的有效途徑之一。
  19. Lanthanated tungsten electrodes attract close attention and become popular in international welding area for its unique welding performance. it is easy to use under ac or dc conditions

    鑭鎢電極因其具有良好的焊接性能而在國際焊接界倍受關注，鑭鎢電極不管在交流還是直流條件下使用都能輕松自如。
  20. This project use high voltage ignitor to solve the problem of interrupt. proved by experience, the output characteristic of this welding can be suitable to tech - guideline, and the inverter can work normally during arc welding process. the success ratio of ignition is also good enough

    經實驗結果證明，該焊機輸出特性滿足技術指標的要求，焊接過程中不出現誤動作，引弧成功率較高，焊接性能穩定，對周圍環境有一定的抗干擾能力。
分享友人
分享到 Line

分享到臉書