焙燒料 的英文怎麼說

中文拼音 [bèishāoliào]
焙燒料 英文
calcines
  • 焙 : 動詞（用微火烘） bake; torrefy; heat over a slow fire
  • 燒 : Ⅰ動詞1 （使東西著火） burn 2 （加熱或接觸某些化學藥品、放射性物質等使物體起變化） cook; bake; hea...
  • 料 : 名詞1 （材料; 原料） material; stuff 2 （喂牲口用的穀物） feed; fodder 3 （料器） glassware 4 （...
  1. Standard specification for raw and burnt sienna pigments

    未加工黃土和焙燒黃土顏料的標準規范
  2. Raw and burnt umber pigments

    未加工棕土和焙燒棕土顏料
  3. Improving oven drying technology of the roaster and lower fuel consumption

    改進焙燒爐烘爐工藝降低燃料消耗
  4. Carbonaceous materials used in the production of aluminium - cold and tepid ramming pastes - preparation of baked test pieces and determination of loss on baking

    鋁生產用含碳材料.冷和微熱搗實糊料.焙燒試樣的制備和焙烤時損失的測定
  5. The graphitized cathode block samples have been trial - produced using high quality eca ( electrically calcined anthracite ) rationed petroleum coke and pitch coke and quantitative pitch used as raw materials by the conventional carbon technics concluding moulding, baking, high pressure impregmating, after - baking and graphitization

    摘要選取優質電煅無煙煤，分別配以一定比例的石油焦和瀝青焦作為骨料，與煤瀝青混合后按照模壓成型、焙燒、高壓浸漬、二次焙燒和石墨化等常規炭素製品生產工藝流程制備石墨化陰極材料試樣。
  6. The characteristic of different products at different calcinating temperatures and time, ph value of solution, raw materials were investigated. the results show that perfect spinel li4mn5o12 crystals whose size belongs to nanometer can be obtained from the precursor of lithium manganese oxides after being calcinated. it is founded that calcinating temperature has great influence on the crystal structure of li4mn5o12 and the optimized temperature is 500

    結果表明焙燒溫度是影響產物結構性能的最重要的因素，最佳焙燒溫度為500 ，溫度小於200不能形成完整的尖晶石結構，而焙燒溫度超過500產物會發生分解；綜合考慮焙燒時間最佳為8小時；溶液ph值也是影響產物性能的因素之一，實驗證明前驅體合成ph = 9 . 0最佳；另外不同的原料也會影響產物的結構，考察了不同鋰源的影響，選擇li _ 2co _ 3為最佳鋰源。
  7. The results showed that sequence and way of feeding, reaction temperature, time of aging, stirring speed and drying and calcinations had remarkable influence on the pore structure

    結果表明，加料順序、加料方式、成膠溫度、老化時間、攪拌速率以及乾燥焙燒等因素對孔結構均有明顯影響。
  8. In this paper, concentrated sulfuric acid and titanium dioxide are used to prepare the tios04 solution that test later required under long time heat. the influences of reaction time and reaction temperature to yield of tioso4 are discussed. in the experiment of preparing tio2 powder, reaction temperature, ph values, material ratio, operation way, velocity of feed, calcining heat and time are researched by the principle of nucleation and growth in thermodynamics and kinetics

    在制備tio _ 2粉體實驗中，根據成核生長的熱力學和動力學原理，深入分析了沉澱反應時環境的溫度、 ph值、反應物配比、操作方式、加料速度等因素對ti （ oh ） _ 4粒度的影響，以及焙燒溫度和保溫時間等因素對制得的納米tio _ 2粉體性能的影響，得出了制備銳鈦型納米tio _ 2粉體的優化工藝條件。
  9. The results showed that the precursor played an important role on the products and the calcination process had directly influenced on the quality and the shape of the products. the middle infrared, ultraviolet - visible light absorption behaviors of nano - zno were investigated and compared with commercial zno powder

    結果表明：前驅物在均勻沉澱法制備納米材料的過程中起到了重要的關聯作用，通過調控沉澱反應的工藝參數就可以控制前驅物的形貌和尺寸，從而經焙燒反應控制了納米氧化鋅的形狀和尺寸。
  10. A. the ct permanent canister magnetic dressing machine produced by us can be used for the dry magnetic dressing of magnetite, magnetism pyrite, calcines etc under 3mm. it can also be used for the iron dividing operation for coal, nonmetal mine and building material. magnetic separator

    磁選機適用於不同粒度及粉狀物料的磁鐵礦磁黃鐵礦焙燒礦鈦鐵礦耐火材料高鋁礬土硅礦玻璃原料石英鉀長石等180餘種物料的干濕式磁選，磁選機也用於煤非金屬礦建材等物料的除鐵作業。
  11. Carbonaceous materials used in the production of aluminium - baked anodes - determination of the reactivity to carbon dioxide - thermogravimetric method

    鋁生產用含碳材料.焙燒陽極.對二氧化碳反應性的測定.熱解重量分析法
  12. Carbonaceous materials used in the production of aluminium - baked anodes and sidewall blocks - determination of the reactivity to air - thermogravimetric method

    鋁生產用碳素材料.焙燒陽極和側壁塊.空氣反應性的測定.熱重分析法
  13. Abstract : abstract according to the testing results in the shaft furnace, the problems of pellets roasting and heat transferring in the furnace caused by using bf gas were analyzed, and some countermeasures for reformation were proposed

    文摘:根據球團豎爐工業測試結果，從焙燒制度和熱工制度等方面分析了用高爐煤氣作燃料的豎爐存在的問題，提出了球團豎爐強化焙燒的方向。
  14. Standard test method for compressive crushing strength of fired whiteware materials

    焙燒的白色陶瓷材料抗壓
  15. Standard test method for drying and firing linear change of refractory plastic and ramming mix specimens

    耐火塑料和沖擊混合樣品的乾燥和焙燒線性改變的標準試驗方法
  16. In this paper, the necessary and sufficient conditions such as the diameter and some physical properties of the baked electrodes in the lengthwise graphitization furnace are highlighted and discussed in terms of single series or in multi - series packing types of the electrodes in the furnace

    摘要討論了串接石墨化爐內焙燒坯料單串裝爐和多串並聯裝爐時，坯料的直徑和一些物理性質必須滿足的充要條件。
  17. Foam glass is a new kind of inorganic heat insulating material with a structure of equally closed cells. it is mainly made of glass added with adequate foaming agents after heating and baking in high - temperature tunnel furnace, then annealing and cooling

    泡沫玻璃是一種以玻璃為主要原料，摻入適量發泡劑，通過高溫遂道窯爐加熱焙燒和退火冷卻加工處理后制得，具有均勻的獨立密閉氣隙結構的新型無機絕熱材料。
  18. Applied researches and new developments of magnetizing roasting on iron materials

    難選鐵物料磁化焙燒技術的研究與發展
  19. In order to overcome the disadvantages of traditional solid brick, to protect environment and to economize resources, the author first recommended the experimental study of drying and firing of coalstore - shale fired perforated brick. the result assumed the effect of percentage of water content, raw material fineness, temperature and insulation time on property of coalstore - shale perforated or hollow brick

    論文首先針對傳統實心磚存在的問題，從環境保護和資源綜合利用出發，以頁巖、煤矸石為原料制磚，通過頁巖、煤矸石制磚中乾燥、焙燒試驗研究，總結了原料化學成份、顆粒粗細程度、乾燥速度、含水率以及焙燒溫度等因素對煤矸石多孔磚、空心磚性能的影響。
  20. Methods of sampling and test for carbonaceous materials used in aluminium manufacture - electrode coke - determination of tapped bulk density of green and calcined coke

    制鋁工業用炭素材料取樣與試驗方法.第2部分:電極用焦炭.第13節:未焙燒焦炭和焙燒焦炭散裝密度測定
分享友人
分享到 Line

分享到臉書