焙燒條件 的英文怎麼說

中文拼音 [bèishāotiáojiàn]
焙燒條件 英文
firing condition
  • 焙 : 動詞（用微火烘） bake; torrefy; heat over a slow fire
  • 燒 : Ⅰ動詞1 （使東西著火） burn 2 （加熱或接觸某些化學藥品、放射性物質等使物體起變化） cook; bake; hea...
  • 條 : Ⅰ名詞1 （細長的樹枝） twig 2 （條子） slip; strip 3 （分項目的） item; article 4 （層次; 秩序; 條...
  • 件 : Ⅰ量詞（用於個體事物） piece; article; item Ⅱ名詞1. （指可以一一計算的事物） 2. （文件） letter; correspondence; paper; document
  • 條件 : 1. （客觀的因素） condition; term; factor 2. （提出的要求） requirement; prerequisite; qualification
  1. Technical specifications for the model of boiling - roaster

    沸騰焙燒爐模型技術條件
  2. Study on acidulation process of spent alkaline zinc manganese battery

    廢堿錳電池焙燒乾粉酸解條件的研究
  3. It ' s obtained that ph = 6. 5 is a suited ph value for getting ideal product with good properties. the calcinate temperature is the key factors to transform the precursor to a pure product with spinel structure

    研究了不同的工藝條件如溶液ph值、焙燒溫度、焙燒時間、焙燒方式、 li / mn的比值對產物結構的影響。
  4. A pressing sequence can be started with or without a vacuum, and the firing chamber can be optionally flooded with protective gas

    在真空或沒有真空的條件下也可以啟動壓制過程，作為選項，焙燒室還可以使用保護氣體吹掃。
  5. Effect of calcination conditions on the properties of a new tungsten phosphide catalyst for hydroprocessing

    焙燒條件對新型磷化鎢催化劑加氫活性的影響
  6. And the electrochemical properties of products were studied and the materials show good electrochemical properties

    以溶膠-凝膠化產物為前驅體，研究了不同焙燒條件對產物結構性能的影響。
  7. In this paper, concentrated sulfuric acid and titanium dioxide are used to prepare the tios04 solution that test later required under long time heat. the influences of reaction time and reaction temperature to yield of tioso4 are discussed. in the experiment of preparing tio2 powder, reaction temperature, ph values, material ratio, operation way, velocity of feed, calcining heat and time are researched by the principle of nucleation and growth in thermodynamics and kinetics

    在制備tio _ 2粉體實驗中，根據成核生長的熱力學和動力學原理，深入分析了沉澱反應時環境的溫度、 ph值、反應物配比、操作方式、加料速度等因素對ti （ oh ） _ 4粒度的影響，以及焙燒溫度和保溫時間等因素對制得的納米tio _ 2粉體性能的影響，得出了制備銳鈦型納米tio _ 2粉體的優化工藝條件。
  8. Effects of roasting conditions on desilication rate of coal - series kaolin

    焙燒條件對煤系高嶺土脫硅率的影響
  9. It is found that we can more easily obtain the good behavior material under the conditions of 600 sintering temperature 、 ar / h2 inertia atmosphere, after testing the influence of the different sintering temperature and inertia atmosphere during the reactions to the performance of lifepo4

    通過測試不同合成溫度和不同的焙燒氣氛條件對磷酸亞鐵鋰性能的影響，得出結論:採用600合成溫度、在ar / h2混合氣體保護下更有利於合成性能良好的磷酸亞鐵鋰。
  10. In this paper, the necessary and sufficient conditions such as the diameter and some physical properties of the baked electrodes in the lengthwise graphitization furnace are highlighted and discussed in terms of single series or in multi - series packing types of the electrodes in the furnace

    摘要討論了串接石墨化爐內焙燒坯料單串裝爐和多串並聯裝爐時，坯料的直徑和一些物理性質必須滿足的充要條件。
  11. Influence of roasting factors on discharge capacity and tap density

    焙燒條件對放電性能及視比重的影響
  12. In this work, layered lini1 - xalxo2 ( 0 < x 1 / 2 ) solid solution materials were successfully synthesized by current co - precipitation method in the air, and their preparation and properties were deeply and systematically explored. influences of different factors on the structure and properities of samples were studied, including li resources, different performs, li / m ( oh ) 2 molar ratio, calcining heat condition, the best synthesis technics were concluded : sintered for 16h at 700 from li source ( lithium nitrate ) : m ( oh ) 2 = 1. 05 : 1, ultrasonic vibration for dispersing and catalysing are best. lini0. 8al0. 2o2 exhibited a discharge capacity of 130. 7 mah ? g - 1 in the voltage range of 2. 8 ~ 4. 40v and at a specific current of 0. 2 c. a new co - precipitation method was proposed, it included ultrasonic for dispersing and catalysing, by dropping lioh to the aqueous solution of metal nitrates, hydroxides of metals were precipitated and the resulting solution was evaporated as received

    採用傳統共沉澱工藝在空氣氣氛中成功地合成出了二元lini1 - xalxo2 （ 0 < x 1 / 2 ）層狀固溶體系列，綜合考察了不同鋰源、預處理方式、鋰的配比量、焙燒溫度等條件對合成產物的結構和性能的影響，確定出了最佳合成工藝:以硝酸鋰為鋰源，超聲波作為分散動力源，鋰源與鎳鋁金屬鹽摩爾比為1 . 05 : 1 ， 700下焙燒16h的lini0 . 8al0 . 2o2樣品電化學性能最佳，在2 . 8 ~ 4 . 40v之間， 0 . 2c的倍率放電可逆容量達130 . 7mah ? g - 1 。
  13. Through the synthesis of licoo2 by using non - water dispersant and two - step roasting, influences of microstructures of precursor, the roasting temperature and the reaction time on the electrochemical properties of licoo2 were studied. it indicated that co3o4 with nano - crystalline have very good electrochemical property, and can shorten solid reaction time

    02的制備工藝，考察了不同微結構的co30 ;先驅物，焙燒溫度和焙燒時間等工藝條件對licoo ，電化學性能的影響，其中以納米晶co3o ;制備出的licooz表現出優良電化學性能，且大大縮短了反應時間。
  14. ( 2 ) the affecting factors such as components in precipitation process, the add - on, add on of precipitator, calination temperature and calination time were studied in the preparation process of ceo2 nanoparticles. the tg was used to analyze the processor, the xrd, sem and tem were used to characterize the size of crystal type of products. by a series of designed experiments the interaction between different factors and impacts on the preparation of ceo2 nanoparticles were probed, and the optimum preparation condition was gotten

    （ 2 ）對納米二氧化鈰制備過程中可能的一些影響因素（反應組分的濃度，沉澱劑的加入量，焙燒溫度，焙燒時間等）進行了研究，並通過tg ? dta分析手段對前驅物進行熱重分析；用xrd 、 sem及tem等測試手段對產物的粒度和晶型進行分析；探索了各個因素對納米二氧化鈰制備的影響及各因素間的交互作用；確定了在該試驗條件下制備納米二氧化鈰比較優化的制備條件。
  15. After prep - baking and making - granule, under different temperature we baking on the preceding powder, and it proof the most proper baking temperature is 1440. under 1440, we do the excessive zinc oxide experiment, and find when zinc oxide excessiving3 %, we can get the best production which i is 5962

    將制備得到的前驅粉在850 2 . 5h條件進行預燒、制粒后，在不同焙燒溫度下進行了鐵氧體焙燒試驗，並對最優配方下zno過量條件進行試驗研究。結果表明，在焙燒溫度1440 ， zno過量3 %的條件下，可制得i為5962的高磁導率鐵氧體。
  16. From the experiment, the optimum preparation condition is as follows : ce3 ~ vcitric = 1 : 3, reaction temperature is 65 ?, ph is 2 - 3, drying temperature of gel is 80 ?, sintering temperature is 500 ? and sintering time is 2h. crystal grows up in two steps

    通過實驗得出最佳實驗條件，硝酸鈰與檸檬酸的摩爾比為1 ： 3 ，在65水浴中反應成膠， 100下烘乾， 500焙燒，可得到平均晶粒尺寸為7nm的ceo _ 2納米晶。
分享友人
分享到 Line

分享到臉書