焙燒程度 的英文怎麼說

中文拼音 [bèishāochéngdù]
焙燒程度 英文
degree of roasting
  • 焙 : 動詞（用微火烘） bake; torrefy; heat over a slow fire
  • 燒 : Ⅰ動詞1 （使東西著火） burn 2 （加熱或接觸某些化學藥品、放射性物質等使物體起變化） cook; bake; hea...
  • 程 : 名詞1 （規章; 法式） rule; regulation 2 （進度; 程序） order; procedure 3 （路途; 一段路） journe...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 程度 : 1. （知識、能力的水平） level; degree 2. （事物變化達到的狀況） extent; degree
  1. Techniques, and their physico - chemical parameters such as specific areas, particle size distributions and diffusion coefficients are measured by the bet method, laser scattering technique and galvanostatic intermittent titration technique ( gitt ), respectively. sem photographs show that these samples are made up of the irregular porous granules, which are conglobated by many small spherical crystals

    溫度助p 』 c賊品中有明顯的尖晶石相雜質，充放電曲線表現出3v和4vmglz臺，而焙燒溫度在sic 』 c以下的樣品充放電曲mn有一個3v平臺，充放電循環過程中沒出現明顯的3v平臺向4v平臺轉化的現象，表明該樣品在循環過程中結構是愧箍淀的。
  2. After a program memory is selected, the firing chamber temperature is automatically set to the starting temperature, so that the austromat

    選擇了程序儲存器之後，焙燒室溫度自動調整到開始溫度值-所以austromat
  3. The reaction activity of the catalyst can be adjusted by changing the preparing condition, which including the calcination temperature, the metal load and the carrier

    制備過程中焙燒溫度、負載量以及不同催化劑載體的選用都會影響所得催化劑的性能。
  4. In this paper, the optimum conditions of catalyst preparation were found by studying the influences of the sol - gel process parameters on the crystal structure of the nanometer la1 - xsrxmno3, such as the value of original solution ph, the temperature of water bath, the baking temperature of sol

    本文研究了採用溶膠-凝膠法制備納米鈣鈦石型氧化物催化劑過程中，初始溶液ph值、水浴溫度、焙燒溫度對納米la1 - xsrxmno3晶體結構影響。
  5. In order to overcome the disadvantages of traditional solid brick, to protect environment and to economize resources, the author first recommended the experimental study of drying and firing of coalstore - shale fired perforated brick. the result assumed the effect of percentage of water content, raw material fineness, temperature and insulation time on property of coalstore - shale perforated or hollow brick

    論文首先針對傳統實心磚存在的問題，從環境保護和資源綜合利用出發，以頁巖、煤矸石為原料制磚，通過頁巖、煤矸石制磚中乾燥、焙燒試驗研究，總結了原料化學成份、顆粒粗細程度、乾燥速度、含水率以及焙燒溫度等因素對煤矸石多孔磚、空心磚性能的影響。
  6. Simulates object temperature measurement and automatically regulates the distance from the firing chamber with the stepless, vibration - free lift for precise drying and cooling phases

    模擬物體上的溫度測量，通過無級無振動的升降機構自動調節與焙燒室的間距，保證精確的乾燥和冷卻過程。
  7. The results show that the a - phase - transformation of pure aach can be completed by heating at 1200 ? for two hours. but under this temperature, the alumina particles will be sintered together, which can lead to the formation of bough - like structures. and these bough - like structure will make the powder difficult to be dispersed

    接著對碳酸鋁銨進行了焙燒實驗，研究了其在升溫過程中的相變行為，結果表明：純aach在1200保溫1 . 5h的情況下才能100轉變為氧化鋁，而在這樣高的溫度下，粒子之間會形成燒結頸，從而使粉體產物在形貌上出現所謂「樹枝狀」結構，給粉體使用時的分散帶來了困難。
  8. ( 2 ) the affecting factors such as components in precipitation process, the add - on, add on of precipitator, calination temperature and calination time were studied in the preparation process of ceo2 nanoparticles. the tg was used to analyze the processor, the xrd, sem and tem were used to characterize the size of crystal type of products. by a series of designed experiments the interaction between different factors and impacts on the preparation of ceo2 nanoparticles were probed, and the optimum preparation condition was gotten

    （ 2 ）對納米二氧化鈰制備過程中可能的一些影響因素（反應組分的濃度，沉澱劑的加入量，焙燒溫度，焙燒時間等）進行了研究，並通過tg ? dta分析手段對前驅物進行熱重分析；用xrd 、 sem及tem等測試手段對產物的粒度和晶型進行分析；探索了各個因素對納米二氧化鈰制備的影響及各因素間的交互作用；確定了在該試驗條件下制備納米二氧化鈰比較優化的制備條件。
  9. If the necessary roast temperature is lower than it, the roasting in shaft is feasible

    球團礦在焙燒過程中有一個強度大幅下降的特定溫度。
  10. The change of hot strength of iron ore pellets during oxidizing roasting and reduction was researched

    摘要研究了球團礦在氧化焙燒和還原過程中抗壓強度的變化規律。
  11. Through experiments, we conclude that the new method is not only easy to handle and improve the evenness of current distribution, but also extend the service life of aluminum reduction cells to a certain extent

    研究表明，採用軟聯接方法可簡化操作，提高焙燒時電流分佈的均勻性，從而可在一定程度上延長電解槽壽命。
  12. A critical temperature was found, at which the strength of pellets is severely dropped during the oxidizing roasting

    使用可調氣氛高溫抗壓試驗機研究了相應球團礦在氧化焙燒過程中的強度變化規律。
分享友人
分享到 Line

分享到臉書