無定型結晶 的英文怎麼說

中文拼音 [wúdìngxíngjiējīng]
無定型結晶 英文
imperfect crystal formation
  • 無 : 無Ⅰ動詞（沒有） not have; there is not; be without Ⅱ名詞1 （沒有） nothing; nil 2 （姓氏） a surn...
  • 定 : Ⅰ形容詞1 （平靜; 穩定） calm; stable 2 （已經確定的; 不改變的） fixed; settled; established Ⅱ動詞...
  • 結 : 結動詞（長出果實或種子） bear （fruit）; form （seed）
  • 晶 : Ⅰ形容詞（光亮） brilliant; glittering Ⅱ名詞1. （水晶） quartz; （rock） crystal 2. （晶體） any crystalline substance
  • 結晶 : 1 （析出晶體） crystallize2 （晶體） crystal 3 （成果） crystallization; fruit; product; quintess...
  1. Znf16pc molecules grow on quartz substrate in a stransky - krastanov model ; a fundamental layer is laid by strong interactions between quartz and f - atoms on znf16pc, on which an amorphous transition layer develops, finally an well ordered film is obtained, " card - packing ", " amorphous accumulation " and " brick - stacking " are adopted hi three different layers

    Znf _ （ 16 ） pc分子在石英襯底上的生長基本符合stransky - krastanov模型：通過f -原子與石英襯底的強相互作用形成奠基層，發展成無定型的過渡層，最後形成有序的結晶層。在這三個區域內分子分別採取「 card - packing 」 、 「 amorphousaccumulation 」和「 brick - stacking 」排列方式。
  2. Electro - optical curves for lc cells have been analyzed and it has been shown mat a large attenuation range and a shallow attenuation slope can be achieved simultaneously for a variable optical attenuator based on a parallel - aligned lc cell with an appropriate surface anchoring strength. as compared with the existing liquid crystal - based voa structure ( using two cascaded lc cells with a particular material ), the present structure is simple and has no special requirement for the lc materials

    提出了基於弱錨定平行排列液晶盒的可變光衰減器（衰減范圍大、衰減曲線下降平緩以保證調節精度） ，與己有液晶型可變光衰減器結構（選用特定液晶材料、兩個液晶盒級聯結構）相比較，本論文提出的基於弱錨定平行排列液晶盒的可變光衰減器結構簡單，同時對于液晶材料無特殊要求。
  3. The one deposited at 300 substrate temperature owns denser crystallites. during the annealing process, with the increasing of annealing temperature, the crystallites become bigger, and crystalline phase begins to transfer. when the annealing temperature gets to 800, tio2 transfers to rutile structure completely

    （ 2 ）常溫下制備的tio _ 2薄膜是無定型的， 300濺射薄膜表面有緻密的晶粒，熱處理溫度升高，晶粒變大，晶相開始轉化， 800退火tio _ 2完全轉化為金紅石結構。
  4. The result indicated that the crystlal type of film convert to anatase after 500 c treatment for 1 hour, the particles size on the film surface and film ' s thickness can be adjust in some extent by properly control the technics conditions

    結果表明，在500熱處理后， tio _ 2晶型從無定性態轉變為銳鈦礦結構，且通過適當控制工藝條件，可在一定范圍內調控tio _ 2薄膜表面粒徑大小和薄膜厚度。
  5. First, the solid ice on the surface could have been annealed, meaning that its temperature could have been raised above the 78 kelvin mark to allow the amorphous ice to recrystallize

    首先，表面的固體冰曾經退火過，也就是說其溫度曾升高至78k以上使無定型冰重新結晶。
  6. The xrd showed that the crystalline of samples prepared in various o _ ( 2 ) partial pressure and various sputtering power was amorphous, the anatase crystalline formed when heat treatment temperature was above 450, and heat treatment temperature was higher, the crystalline was better. sem showed that the crystal grams formed on the surface of films when the o _ ( 2 ) partial pressure was high ; the obvious and big grains appeared hi the surface with improvement of heat treatment temperature

    Xrd分析表明，不同氧氣分壓下制備的樣品基本是無定型結構，不同濺射功率下制備的樣品基本也是無定型結構，當熱處理溫度高於450時，試樣出現了晶面趨向為（ 101 ）的銳鈦礦相，隨著熱處理溫度的升高，結晶程度增大； sem分析表明：隨著氧氣分壓的升高，試樣表面出現微小結晶顆粒；隨著熱處理溫度的升高，試樣表面出現了相當明顯的結晶顆粒，試樣的比表面積增大。
  7. The structural characterization of v _ 2o _ 5 compounds were measured bymeans of differential thermoanalysis ( dta ) and thermogravimetry ( tg ), scanning electron microscopy ( sem ), and x - ray diffraction ( xrd ). the testsreveale that materials which were prepared by sol - gel ( inorganic sol gel andmelting - coling ) showed that the amorphous structure, and the interlayer spacingenlarge a lot than that of crystalline v _ 2o _ 5

    採用熱重與差熱（ tg - dta ） ，掃描電子顯微鏡（ sem ） ， x射線衍射（ xrd ）等測試手段對材料的結構性能進行表徵，結果顯示兩種溶膠-凝膠法（無機溶膠凝膠法和熔融淬冷法）制備的v _ 2o _ 5材料均為無定型結構，其層面間距均比晶體v _ 2o _ 5成倍增大。
  8. The catena product wholly design for transporting definite corrosive medium have granule or crystal, adopt steel pad uhmw - pe to made it. owned excellent resist causticity and reputably resist attrition, structure and design is model of hang arm front - karat, impeller is half karat model no front cover, boost up transit capability of passage. let the granule and impurity of medium pass pump - cavity quickly not to jam

    本系列產品專為輸送具有一定腐蝕性且含有細顆粒或有結晶的介質而設計，採用鋼襯超高分子量聚乙稀模壓成型工藝製造，具有優異的耐腐蝕性和卓越的耐磨性能，結構設計為懸臂前開式，葉輪為半開式無前蓋板，增強了流道內的通過性，使介質中的顆粒及雜質很快通過泵腔而不會堵塞，軸封為k型氟橡膠密封環外帶冷卻水套，兼顧了耐腐與耐磨的雙重要求。
分享友人
分享到 Line

分享到臉書