無應變 的英文怎麼說

中文拼音 [wúyīngbiàn]
無應變 英文
strain-free
  • 無 : 無Ⅰ動詞（沒有） not have; there is not; be without Ⅱ名詞1 （沒有） nothing; nil 2 （姓氏） a surn...
  • 應 : 應動詞1 （回答） answer; respond to; echo 2 （滿足要求） comply with; grant 3 （順應; 適應） suit...
  1. By itself, on demand business is an apolitical model : it looks at what s needed to ensure that all resources are used to the best benefit of the enterprise

    就其本身而言，隨需應變業務是一種與策略無關的模型：它只是檢查自己需要哪些資源，從而確保能夠最有效地使用企業的所有資源。
  2. Since these two models - the apolitical on demand business environment and the political enterprise - are diametrically opposed, we need technology that encourages enterprise " kingdoms " to share their resources

    由於這兩種模型恰好截然相反：一個是與策略無關的隨需應變業務環境，另外一個卻是具有嚴格策略的企業，因此我們需要採用一些技術來鼓勵這些企業「王國」進行資源共享。
  3. Ke : the argute reaction is needed. for example, when you face the interviewee, you can ' t anticipate what he or ahe will say during the interviewing

    科:臨場應變很重要。像是面對被采訪者時，你無法預期他會說出什麼，所以機警的反應是必須的。
  4. The first invariant of strain is independent of the coordinate system being used.

    第一應變不變量與所用的坐標系無關。
  5. Because of the extraneous and uncontrolled factors, those may affect the dependent variable.

    由於許多外來的無法控制的因素，這些因素可能影響應變因素。
  6. Although there is only a very tiny chance of y2k - related problems occurring at east rail, in order to ensure our passengers enjoy a reliable and safe journey, kcrc has been proactively tackling the millennium bug since 1997. a special y2k team was established to monitor the situation and take contingency measures when required

    盡管東鐵服務因千年蟲問題而受影響的機會微乎其微，九廣東鐵為確保乘客在二千年過渡時都享有一個可靠、舒適的東鐵服務，早已進行了一系列的防蟲措施，並且成立了一隊監察隊伍，確保所有系統正常運作及制定適當的應變措施，有備無患。
  7. A two - dimensional plain strain finite element model of infinite plate is developed to investigate the ultrasonic wave propagation and scattering on three kinds of cracks : parallel to the surface, 450 oblique angle to the surface, and quarter - circle

    摘要建立了無限長板的具有吸收邊界的二維平面應變有限元模型，在研究了脈沖超聲波在無限長板中傳播的基礎上，對板中平行於表面的裂紋、與表面成45的斜裂紋和四分之一圓周弧形裂紋三種情況的脈沖超聲波散射進行了重點研究。
  8. In making the radio waves correspond to each sound in turn, messages are carried from a broadcasting station to a receiving set

    使無線電波依次對每一個聲音作出相應變化時，信息就由廣播電臺傳遞到接收機。
  9. Range represents the maximum strain which can be recorded without resetting or replacing the strain gage.

    量程表示無需重調或重裝應變計就能記錄到的最大應變。
  10. Application on brushless rheostat starter in the preparation plant of bailong coal mine

    無刷變阻起動器在白龍礦洗煤廠的應用
  11. She looked bold and resourceful and unscrupulous and she was all of these.

    她看上去很大膽，善於隨機應變而且肆無忌憚，她正是這樣一個人。
  12. A kind of mechanical patterned step - less variator with specified range of application has been introduced. the composition, working principle of this mechanism and its designing calculation were expounded

    摘要介紹了一種具有一定應用范圍的機械式無級變速器。闡述了該機構的組成、工作原理及其設計計算。
  13. While cyclic deformation experiment under constant strain control is performed in 400, the material shows the continuous hardening until cyclic invalidation. ( 3 ) back stress attained by kwl " s method is used to analyse the bauschinger effect during an incremental step cyclic test and cyclic deformation test under constant strain control, it is shown that back stress increases with increasing plastic strain and the numbers of cycle, and the back stress is uniform, regardless of tension or compression conditions. ( 4 ) as far as recrystallized zircaloy - 4 plate is concerned, the back stress in transverse direction is higher than that in rolling direction due to the higher schmid factor in rolling direction

    對于再結晶狀態的zr一4合金板材試樣來說， t方向（橫向）試樣的背應力要高於r方向（軋制方向）的背應力，原因在於r方向的schmid因子高於t方向的schmid因子; 400下， zr一4合金的背應力要明顯低於室溫下的背應力;含氫200pg / g的zr一4合金的背應力大小與無滲氫的zr一4合金背應力相比，無明顯區別;固溶處理后， zr一4合金的背應力大小發生了變化，在較高塑性應變下，背應力均高於固溶處理前的背應力。
  14. 3. passive and active time - domain demodulation schemes were demonstrated based on a fiber bragg grating used as a tunable filter controlled by a piezoelectric stack, which was driven by an electrical sine wave signal. the measured strain applied on the sensor axially could be judged by observing the interval of the output between notches within a driving period in time - domain

    利用匹配濾波技術，分別採用無源和有源方式，藉助受pzt驅動的解調光柵，將待測應變信息變為時序負脈沖間隔的變化，利用常規的示波器觀測同一掃描周期中兩負脈沖在時域中間隔的變化來確定待測應變的變化。
  15. The first stage is primary slip then followed by secondary slip ; the last stage is due to dislocation passing the slips. the cyclic stress strain ( css ) curve exhibits a stronger hardening occurred in cyclic plastic deformation than that in tensile test

    建立了拉伸和應變疲勞的有限元模型，使用基於晶體滑移模型的數值方法，對晶體內部滑移系的啟動以及滑移繫上的分解切應變、切應力這些無法試驗觀測的變量進行計算，分析它們對晶體塑性變形的不同影響。
  16. The theoretical research, computer simulation and experimental results analysis show that maskless laser interferometric lithography and holographic lithography have the characteristics of large field of view, high resolution, distortionless, relatively simple system structure, low costs and convenient realization way. they have a broad application prospect

    激光干涉光刻技術研究四川大學博士學位論文理論研究、計算模擬和實驗結果分析表明，無掩模激光干涉光刻和全息光刻具有大視場、高解析度、無畸變、系統相對簡單、成本較低，實現方便等特點，具有廣闊的應用前景。
  17. Ratio control of cvt is the key for engine running according to ideal curve, and controlling thrust of driving and driven pulley reasonably can improve efficiency and extend life - span of metal belt, and it is coupling relation between control of ratio and thrust

    無級變速傳動系統的速比控制是實現發動機按理想工作線運行的關鍵，合理控制主、從動帶輪的夾緊力能提高傳動效率和金屬帶的壽命，而夾緊力和速比控制存在耦合效應。
  18. Besides, the gauss interpolation function and the domain of support which includes much more nodal information than finite element method does is used to make meshless method much more earlier solve the large deformation and distortion and describe the local characteristic ( such as stress locality et al. ) more facilely

    並由於在無網格法中採用了高次插值函數和包含有較多節點的支持域（在有限元法中的支持域只包含單元節點） ，從而使得無網格法能方便地處理變形畸變和應力應變局部化等問題。
  19. The existed material fatigue performance test curves are dealt with and analyzed, and the non - dimensional stress - strain curve, tangent modulus factor curve and fatigue life curve are drawn based on the experiment data, and these three non - dimensional parameter curves are used to find the inherent rules that the test curves can be replaced each other to some extent. it can be concluded that if the common character and system error of these materials are found, the test curve of a certain material can be used for reference by another material. this is a simple approach about fatigue life estimate and is engineering practical

    對已有的材料力學疲勞性能試驗曲線進行分析整理，利用試驗數據繪制了相對應力應變曲線、切線模量因子曲線和疲勞壽命曲線，利用這三種無量綱參數曲線發現了其中存在的規律性，即在某種程度上實驗曲線可以互相取代，並用試驗數據對此進行了討論，並由此推斷，如果找出材料彼此的共性或彼此之間的系統誤差就可以將一種材料的試驗曲線供其它材料參考使用，這是一種估算材料的疲勞壽命的簡便方法，對工程而言具有實用性。
  20. Strain free lattice

    無應變點陣
分享友人
分享到 Line

分享到臉書