無機膜 的英文怎麼說

中文拼音 []
無機膜 英文
inorganic membrane
  • : 無Ⅰ動詞(沒有) not have; there is not; be without Ⅱ名詞1 (沒有) nothing; nil 2 (姓氏) a surn...
  • : machineengine
  • : 名詞1. [生物學] (像薄皮的組織) membrane 2. (像膜的薄皮) film; thin coating
  • 無機 : [化學] inorganic無機氮肥 inorganic nitrogenous fertilizer; 無機肥料 inorganic fertilizer; 無機化...
  1. ( 2 ) in ( no3 ) 3 was dissolved in acetylacetone in the mol ratio of l : 3. they were mixed for about 3 hours to obtain acetylacetone salts. then glycol methyl aether was added in the ratio of 1 : 40 to obtain indium oxide sol. sncl4 was dissolved in glycol methyl aether and then added into the indium oxide sol to prepare transparent and stable ito sol

    ( 2 )通過將銦的鹽硝酸銦與乙酰丙酮按摩爾比1 : 3 ,混合攪拌3h左右得到銦的乙酰丙酮鹽,然後按一定摩爾比加入乙二醇獨甲醚溶液,混合攪拌制得氧化銦溶膠,再將一定量的sncl _ 4溶入乙二醇獨甲醚,摻入氧化銦溶膠制得透明穩定的摻錫氧化銦溶膠( ito溶膠) ,該溶膠性能穩定,易於成
  2. The experiment proves that the 6 silver - loaded diatomite inorganic membranes prepared by the writers themselves give satisfactory separation results in the treatment of ammoniated effluent, all above 64 %

    試驗證明,自製的6種載銀矽藻土無機膜對含氨廢水有較好的分離效果,都達到了64 %以上。
  3. Effect of basicity of poly - aluminium inorganic macromolecule solution on preparation of - al203 membrane

    聚鋁高分子鹽基度對成的影響
  4. The present work indicates the organic nf membranes and the inorganic nf membranes all have shortages, so develop composite nf membranes that have low cost, mechanically strong and thermally / chemically - resistant, easy to cleanout and good performances is a very important task. in this paper, the preparation of inorganic - organic composite nf membranes were presented. this composite comprise a porous sio2 / al2o3 support substrate, the pore diameters of which ranging from 10 to 15 nm, this inorganic support substrate having a polymer membrane which comprises an polyvinyl alcohol ( pva ) or polyamide ( pa ) densely deposited on at least one of the face surfaces thereof, the structural porosity of such pva and pa membrane ranging from 3 to 5 nm

    本論文以開發?有復合納濾為出發點,首先在al _ 2o _ 3多孔微濾上利用溶膠?凝膠法制備sio _ 2 al _ 2o _ 3復合超濾作為?有復合納濾的基;選用聚乙烯醇和聚酰胺為表面功能層材料,分別探討了以羥基丁二酸和磺基水楊酸為混合交聯劑,採用浸塗法制備了聚乙烯醇sio _ 2 ? al _ 2o _ 3復合納濾;以均苯二甲酰氯、哌嗪和二胺為單體,採用界面聚合法制備了聚酰胺sio _ 2 ? al _ 2o _ 3復合納濾,並對影響性能的諸多因素進行系統研究。
  5. The slightly porous nature of the surface of the oxide film allows it to be coloured with either organic or inorganic dye.

    氧化表面具有輕微的滲透性,因而可以用有染料著色。
  6. The results are listed as follows : ( 1 ) the inorganic acetate of y, ba and cu were used as precursors, and diethylenetriaminejactic acid and a - methacrylic acid as complexing agents, respectively. the stable fluorine - free ybco sol can be obtained

    研究結果表明: ( 1 )採用y 、 ba和cu的鹽為出發原料,採用乳酸、 ?甲基丙烯酸及二乙烯三胺作絡合劑,可以制得易於成且穩定性良好的氟系ybco溶膠。
  7. By examining the new generation condutive polymer material 3 , 4 ? polyethylene dioxythiophene ( pedt ), this paper investigated the edt monomer synthetic path and the optimum filming conditions of the compound pedt. based on this research, i also discussed the manufacturing processes and the related principles of the solid tantalum capacitors, when replacing the conventional inorganic material mno2 with the pedt as the negative pole

    本文以新一代導電聚合物材料3 , 4 ?聚乙烯二氧噻吩( pedt )為研究對象,研究了edt單體合成路線及聚合物pedt的最佳成條件,並以此為基礎,討論了以導電聚合物有材料pedt取代傳統的材料mno2作陰極的固體鉭電解電容器的制備工藝及相關理。
  8. The main conclusions with innovative features acquired from the present work are as follows : ( 1 ) soft solution processing technique for preparing functional thin films was put forward and applied to preparing advanced inorganic functional thin films ; a series of molybdate and tungstate films with scheelite - type were prepared directly on metal substrates ( molybdenum and tungsten foils ) by using constant current electrochemical technique at room temperature ; a series of titanate thin films with perovskite - type were synthesized directly on titanium flakes by hydrothermal method in our country for the first time

    通過上述研究工作,得到了如下具有創新性研究成果: ( 1 )首次在國內提出和運用軟溶液制備工藝技術進行功能薄材料的制備研究;首次在國內採用室溫恆電流電化學技術直接在金屬基底(鉬片和鎢四川大學博士學位論文片)制備了白鎢礦結構的鋁酸鹽、鎢酸鹽薄;首次在國內採用水熱合成技術在欽金屬片上直接沛叮備了鈣欽礦結構的欽酸鹽薄
  9. For enhancing the soakage capability and the combine intension between inorganic films and stainless steel plate, and improving the reactivity of stainless steel, to enhance the combine intension between sca film and stainless steel plate, the stainless steel plates are oxidized. the experiment prepared two oxidized stainless steels in different oxidation degree, aa and ab, respectively used as experiment plates in silver doped tio2 or sio2 antibacterial stainless steel and silver doped sca antibacterial stainless steel

    為提高和不銹鋼基板之間的浸潤性和結合強度,以及為使不銹鋼基板具有更高反應活性,以提高有硅烷薄與不銹鋼基板間的結合能力,對不銹鋼基板進行氧化處理,制備兩種氧化程度不同的不銹鋼: aa和ab ,分別作為摻銀tio _ 2 、 sio _ 2抗菌不銹鋼和摻銀有硅烷抗菌不銹鋼的基板材料。
  10. The interactions between particles were discussed based on dlvo and edlvo theories. experiment results show the effect of the ph on the dispersion is due to the repulsion interactions of electrical double layer ; and addition suitable inorganic dispersant or organic macromolecule dispersant results in improvement the stabilization of the dispersion. the main action of the inorganic dispersants is to increase the repulsion interactions of electrical double layer and the main action of organic macromolecule dispersant is to increase hydration shell and steric hindrance

    研究表明: ph對顆粒分散的影響主要體現在對顆粒間雙電層靜電排斥力的改變;添加合適分散劑可以改變顆粒在水中的分散性;電解質的分散制主要是增加顆粒表面的雙電層靜電排斥作用能,而高分子分散劑的分散制主要是增加顆粒的水化排斥能和位阻排斥能;復合分散劑的分散效果要優于單一分散劑;提出了用經時損失性來評價分散穩定性。
  11. 2801 and lbg was used as polymer matrix because of their different hfp ratio, dbp was used as plasticizer. the films were made by bellcore method. structure, crystallinity, liquid uptake and conductivity of the films with different ratio of pvdf dbp sio2 was determined

    本文用hfp含量不同的2801和lbg為基體, dbp為增塑劑,採用bellcore方法制,得到了聚合物電解質的結構、結晶度、吸液量和電導率隨sio _ 2 、增塑劑含量、聚合物結晶度的變化規律,並對納米粒子改性聚合物電解質的理進行了一些探討。
  12. The microgels of close monodispersity with different volume and cross - linking density can be prepared by using an inverse emulsion polymerization method. both artificial and natural materials, including zeolites, membranes, vesicles, liquid crystal, microemulsion, micelles, biopolymers, etc., have been used as template. the three - dimentional network structure and spherical morphology of polymeric microgels may guarantee the homogeneous of the structure of the composite, the size and the morphology of the various organic - inorganic composites with unusual structures

    在反相乳液聚合條件下,通過控制反應條件可以得到體積不同、交聯度不同的近乎單分散的微凝膠,如同分子篩、單(多)分子、囊泡、液晶、微乳液、膠束、生物大分子等可作為微納米材料合成模板一樣,高分子微凝膠所特有的三維網路結構和球形形貌有可能對在其中進行的結晶或沉積反應施加限域和導向作用,從而控制所生成材料的形貌和大小,得到各種具有特異結構的-有復合材料。
  13. Research of organic - inorganic hybrid membranes become the most interesting focus because they poccess both properties of organic and inorganic membranes : good permeability, selectivity, mechanical strength, thermal and chemical stability, etc

    摘要有-雜化由於具備了無機膜和有各自的特點,具有良好的分離特性和物化穩定性,因而成為當前技術領域新型材料研究的熱點。
  14. Resistance analysis and experimental research on inorganic membranes cross - flow filtration

    無機膜動態過濾阻力分析與實驗研究
  15. To deal with gas separaion at high pressure and high temperature, inoghc membranes are used widely in the ligh of the production and the uitrahigh purity of hydrogen isotope requlred by some special professions and the defects of the current einpoyed membranes separation technology the preparation teehnology of high h - permselective membrane

    在涉及高溫、高壓環境下的氣體分離中,主要使用的是無機膜分離技術。針對特殊行業對氫同位素氣體處理量及超高純度的需求和現有分離技術存在的問題和不足,創新性地提出了利用耐熔金屬鋯等對氫的高滲透性,制備高選擇滲氫的分離技術。
  16. Study of inorganic membrane recovering metatitanatic acid in titanium dioxide production with sulfuric acid method

    無機膜回收硫酸法鈦白生產中偏鈦酸的研究
  17. Automatic control system design of abio - membrane filtration dust - cleaner

    無機膜分離除塵器自動控制系統設計
  18. A pilot study of treatment of emulsified wastewater with inorganic membrane

    無機膜處理乳化廢水實驗研究
  19. The study shows that when 1 % ~ 2 % of a binder is added and sintering is done at 900, macroporous inorganic membrane is obtained

    研究表明,當粘結劑加入量為1 % ~ 2 % 、燒結溫度在900時,可以獲得較大孔徑的無機膜
  20. Updated patented technology of nuclear industry : inorganic membrane preparing process is adopted together with double - face and micropore ceramic board sintered with silicon carbide or alumina, which has a good resisting performance against friction and corrosion

    核工業先進的專利技術:應用無機膜制備工藝,並採用耐磨耐腐性能良好的碳化硅或氧化鋁燒結成雙面微孔陶瓷板。
分享友人