無機膠凝材料 的英文怎麼說

中文拼音 [wújījiāoníngcáiliào]
無機膠凝材料 英文
inorganic cement
  • 無 : 無Ⅰ動詞（沒有） not have; there is not; be without Ⅱ名詞1 （沒有） nothing; nil 2 （姓氏） a surn...
  • 機 : machineengine
  • 膠 : Ⅰ名詞1 （某些具有黏性的物質） glue; gum 2 （橡膠） rubber 3 （姓氏） a surname Ⅱ動詞（用膠粘） st...
  • 凝 : 動詞1. （凝結） congeal; curdle; coagulate 2. （注意力集中） fix
  • 材 : 名詞1 （木料） timber 2 （泛指可以直接製成成品的東西; 材料） material 3 （供寫作或參考的資料） ma...
  • 料 : 名詞1 （材料; 原料） material; stuff 2 （喂牲口用的穀物） feed; fodder 3 （料器） glassware 4 （...
  • 無機 : [化學] inorganic無機氮肥 inorganic nitrogenous fertilizer; 無機肥料 inorganic fertilizer; 無機化...
  • 材料 : 1. （原料） material 2. （資料） data; material 3. （適于做某種事的人才） makings; stuff
  1. The present work indicates the organic nf membranes and the inorganic nf membranes all have shortages, so develop composite nf membranes that have low cost, mechanically strong and thermally / chemically - resistant, easy to cleanout and good performances is a very important task. in this paper, the preparation of inorganic - organic composite nf membranes were presented. this composite comprise a porous sio2 / al2o3 support substrate, the pore diameters of which ranging from 10 to 15 nm, this inorganic support substrate having a polymer membrane which comprises an polyvinyl alcohol ( pva ) or polyamide ( pa ) densely deposited on at least one of the face surfaces thereof, the structural porosity of such pva and pa membrane ranging from 3 to 5 nm

    本論文以開發無機?有機復合納濾膜為出發點，首先在al _ 2o _ 3多孔微濾膜上利用溶膠?凝膠法制備sio _ 2 al _ 2o _ 3無機復合超濾膜作為無機?有機復合納濾膜的基膜；選用聚乙烯醇和聚酰胺為表面功能層材料，分別探討了以羥基丁二酸和磺基水楊酸為混合交聯劑，採用浸塗法制備了聚乙烯醇sio _ 2 ? al _ 2o _ 3復合納濾膜；以均苯二甲酰氯、哌嗪和二胺為單體，採用界面聚合法制備了聚酰胺sio _ 2 ? al _ 2o _ 3復合納濾膜，並對影響膜性能的諸多因素進行系統研究。
  2. Firstly, the surface characteristic of polystyrene particle is changed from water detesting to water intimity by using special techniques and admixtures so mat the compound quality with inorganic materials is insured. secondly, the contradiction between the weight and strength is solved through optimizing the particle size and using composite fiber and the best heat conductivity is achieved under the condition that the necessary strength is met. in the research process, the author solved the problem of fiber dispersing in insulating materials so that the contraction of the material is controlled

    課題研究中，首先採用特殊的改性工藝及外加劑實現對聚苯乙烯顆粒表面的成功改性，使其表面由憎水轉化為完全親水，確保與無機材料的復合質量；其次，通過採用優化骨料級配及使用復合纖維等措施解決了保溫材料的輕質與強度的矛盾，使保溫材料在滿足必要的強度的前提下，導熱系數降至最小；並且，課題研究中成功解決了纖維在保溫材料中均勻分散的問題，達到了抑制保溫材料收縮的目的；最後，通過採用復合外加劑、合適的膠凝材料及合理的配比等措施確保該保溫材料具有良好的和易性，滿足施工的要求。
  3. Inorganic anti - cracking reinforced chemical additive, called wj, generates some tittle expansive crystals in hydration process in concrete to reduce the porosity and improve the distribution of pore size. the expansive power is process in common to tumefaction that petty crystalloid aft suck water and pressure to concrete pores that aft crystal gather volume. its adding weight was 8 % - - 12 % in cement, its restrained expansive ratio was about 0. 02 % - - 0. 06 %, and relevantil brought self - stress 0. 2mpa ?. 6mpa

    無機增強抗裂材料wj摻入普通混凝土中，在水化硬化過程中生成一定量的微膨脹結晶體，降低空隙率，改善混凝土中孔結構分佈。其膨脹驅動力是凝膠尺寸的晶體鈣礬石吸水腫脹和結晶狀鈣礬石對孔隙產生膨脹壓的共同作用。當wj摻量為8一12兒在鋼筋和鄰位的限制下，使混凝土產生0
  4. The microgels of close monodispersity with different volume and cross - linking density can be prepared by using an inverse emulsion polymerization method. both artificial and natural materials, including zeolites, membranes, vesicles, liquid crystal, microemulsion, micelles, biopolymers, etc., have been used as template. the three - dimentional network structure and spherical morphology of polymeric microgels may guarantee the homogeneous of the structure of the composite, the size and the morphology of the various organic - inorganic composites with unusual structures

    在反相乳液聚合條件下，通過控制反應條件可以得到體積不同、交聯度不同的近乎單分散的微凝膠，如同分子篩、單（多）分子膜、囊泡、液晶、微乳液、膠束、生物大分子等可作為微納米無機材料合成模板一樣，高分子微凝膠所特有的三維網路結構和球形形貌有可能對在其中進行的無機結晶或沉積反應施加限域和導向作用，從而控制所生成無機材料的形貌和大小，得到各種具有特異結構的無機-有機復合材料。
  5. The structural characterization of v _ 2o _ 5 compounds were measured bymeans of differential thermoanalysis ( dta ) and thermogravimetry ( tg ), scanning electron microscopy ( sem ), and x - ray diffraction ( xrd ). the testsreveale that materials which were prepared by sol - gel ( inorganic sol gel andmelting - coling ) showed that the amorphous structure, and the interlayer spacingenlarge a lot than that of crystalline v _ 2o _ 5

    採用熱重與差熱（ tg - dta ） ，掃描電子顯微鏡（ sem ） ， x射線衍射（ xrd ）等測試手段對材料的結構性能進行表徵，結果顯示兩種溶膠-凝膠法（無機溶膠凝膠法和熔融淬冷法）制備的v _ 2o _ 5材料均為無定型結構，其層面間距均比晶體v _ 2o _ 5成倍增大。
  6. Nevertheless, new modified polymers have been obtained recently with thresholds of damage by laser radiation as high as those of the inorganic materials, and with higher stabilities than those of the silica gels under the same experimental conditions

    近來研究較多的是玻璃基質無機有機復合激光染料，通過溶膠?凝膠法，將有機激光染料均勻地摻入固態基質中，再利用適當的有機改性，就能有效提高材料各方面的性能。
  7. It has been demonstrated that it is the microgel that guaranteed the homogeneous of the structure of the composite, the size and the morphology of the composite particles. the surface structure of the micro - particles can be adjusted by changing the preparing conditions. the composites may adopt hollow sphere structure, and the inner may lack of cds due to precipitation was started from the outer part of the microgels

    實驗結果表明：高分子微凝膠的三維網路結構和所採用的制備方法確保了有機-無機復合材料復合的均勻性；微凝膠的模板作用使得復合材料呈球狀結構，微球的大小決定於模板的尺寸；微球的微納米結構可因微球的制備條件的不同（例如，改變連續相類型）而不同。
  8. Fireproof board of magnesium oxychloride with good properties of high strength and water resistance was prepared by analysis of the compression strength and resisting the intensity of rolling over. the proper composition of magnesium oxychloride cement, stuffing, resin and assistant additions is 100 : 35 : 5 : 4

    論文實驗獲得了強度高、耐水性好的氯氧鎂無機防火板材料，其優化配比為:膠凝料:填料:樹脂:各種助劑= 100 : 35 : 5 : 4 。
  9. They are poly ( sodium methacrylate ) / cds ( pmaana / cds ), pmaana / pbs, poly ( sodium acrylate ) / la ( oh ) 3 ( paana / la ( oh ) 3 ) and paana / pbs, respectively. ( 1 ) preparation and properties of pmaana / cds composite particles pmaana microgels containing cd2 + were prepared by inverse emulsion polymerization method. then, h2s gas was introduced slowly into the system, and the metal ions were deposited within the microgels as cds

    （ 1 ） pmaana cds復合微球的制備與性能研究首先，利用反相乳液聚合的方法，制備得到了包埋cd ~ （ 2 + ）的pmaana微凝膠，然後通過外源沉積（即向反應體系中緩慢通人硫化氫氣體） ，得到了pmaana cds有機-無機復合材料。
  10. The application of nano powder in conductive antistatic materials is introduced, including nano conductive powder, nano conductive vapor gel, nano conductive wave absorbent, carbon nanotube, nano conductive fiber, nano superconductor and nano inorganic / organic composite conductive materials

    介紹了納米粉體在導電抗靜電材料中的應用，包括納米導電粉體、納米導電氣凝膠、納米吸波導電材料、碳納米管、納米導電纖維材料、納米超導材料，以及納米無機有機復合導電材料等。
  11. The sol - gel process was an effective and feasible method in the preparation of organic dyes doped the inorganic matrix, which promoted the research of organic - inorganic optical composite system

    溶膠-凝膠濕化學方法在制備無機基質材料中的應用為有機染料的摻入提供了一種可行和有效的方法，極大的推動了有機-無機復合光功能材料的研究。
  12. Chapter 4 preparation of tio2 nano - films and its surface structural morphology tio2 nano - films were successfully fabricated by a sol - gel process on glass substrate. the morphology and microstructure of films were investigated via atomic force microscope ( afm ), x - ray diffractometer ( xrd ) and transmission electron microscopy ( tem )

    凝膠法制備了tio _ 2納米溶膠，在不同的處理方式下以刮片法制幾種無機納米材料的制備、表徵與應用備了兩種ti仇多孔納米薄膜，並利用afm ， tem ， xrd等測試方法對膜表面結構及物理化學特性進行了表徵。
分享友人
分享到 Line

分享到臉書