無量綱系數 的英文怎麼說

中文拼音 [liánggāngshǔ]
無量綱系數 英文
dimensionless coefficient
  • : 無Ⅰ動詞(沒有) not have; there is not; be without Ⅱ名詞1 (沒有) nothing; nil 2 (姓氏) a surn...
  • : 量動1. (度量) measure 2. (估量) estimate; size up
  • : Ⅰ名詞1 (提網的總繩 多用於比喻) the headrope of a fishing net 2 (比喻事物最主要的部分) key lin...
  • : 系動詞(打結; 扣) tie; fasten; do up; button up
  • : 數副詞(屢次) frequently; repeatedly
  • 無量 : measureless; immeasurable; boundless
  • 系數 : [數學] coefficient; ratio; modulus; quotient; factor
  1. By comparing the results with relative experiment data, it is shown that rng k - is more exactly than the other turbulent model. 2 ) the influences of axial inflow position, radial outflow size, rotating reynold number, non - dimensional mass flowrate and axial inflow angle on the flow and heat transfer characteristics were numerically investigated for a typical rotator - stator cavity with axial inflow, radial inflow and radial outflow. the correlations for average nusselt number vs rotating reynold number or non - dimensional mass flowrate were established

    ( 2 )針對一典型的徑向、軸向進氣,徑向出氣的轉-靜盤腔結構,統研究軸向進氣位置、徑向出口大小、旋轉雷諾和軸向垂直預旋進氣等對盤腔內流動和換熱的影響,整理出轉-靜盤腔內轉盤平均努謝爾與旋轉雷諾之間的準則關聯式。
  2. The existed material fatigue performance test curves are dealt with and analyzed, and the non - dimensional stress - strain curve, tangent modulus factor curve and fatigue life curve are drawn based on the experiment data, and these three non - dimensional parameter curves are used to find the inherent rules that the test curves can be replaced each other to some extent. it can be concluded that if the common character and system error of these materials are found, the test curve of a certain material can be used for reference by another material. this is a simple approach about fatigue life estimate and is engineering practical

    對已有的材料力學疲勞性能試驗曲線進行分析整理,利用試驗據繪制了相對應力應變曲線、切線模因子曲線和疲勞壽命曲線,利用這三種曲線發現了其中存在的規律性,即在某種程度上實驗曲線可以互相取代,並用試驗據對此進行了討論,並由此推斷,如果找出材料彼此的共性或彼此之間的統誤差就可以將一種材料的試驗曲線供其它材料參考使用,這是一種估算材料的疲勞壽命的簡便方法,對工程而言具有實用性。
  3. Based on the review, the fluid flow and heat transfer in the curved circular and rectangular pipes have been researched by employing perturbation method and numerical simulation with a physical model under the rotational orthogonal curvilinear coordinate in a rotating curvilinear pipe with multi - parameters. we firstly analyzed the fully developed fluid flow and heat transfer, mixed convection heat transfer, the development of flow and heat transfer in the inlet in different cross section ( circular, elliptical, annular and rectangular crossection ). the variations of the secondary flow, axial velocity, distribution of temperature, the friction force on the wall, the ratio of friction factor as well as the nusselt number with different dimensionless parameters had been examined in detailed

    本文在總結和分析了一個世紀以來有關曲線管道流動和換熱特性的研究成果的基礎上,以旋轉正交曲線坐標統下的多參旋轉螺旋管道中的對流傳熱為物理模型,通過攝動方法和有限體積法,首次對各種截面(圓截面、橢圓截面、環形截面、矩形截面)旋轉曲線管道內充分發展流動的流動結構和傳熱特性(包括耦合對流傳熱特性)以及旋轉曲線管道開口段發展流動的流動結構和換熱特性進行了統的值模擬和理論分析,詳細討論了各種對管道內軸向速度分佈、二次流結構、溫度分佈、壁面摩擦力、摩擦比以及管道nusselt的影響,獲得了若干創新性成果。
  4. Thirdly, the conclusions of the two aspect applications are given as follows : the exploration of the application of the evaporation duct prediction to the flux relationship research and evaporation duct predicting shows that based on this predicting method and with microwave refractometer, as sensor, ( 1 ) the dimensionless gradient function of temperature, humidity and refractivity in the flux relationships can be determined with higher precision, ( 2 ) the limitations of conventional observations on the predicting accuracy for evaporation duct can be avoided and the precise prediction for evaporation duct can be obtained with the accurate measurement of refractivity profile within a few meters. the radar performance under given evaporation

    三、對兩個應用問題的討論表明:基於本文發展的蒸發波導預測理論,使用微波折射率儀為傳感器: ( 1 )開展通研究時,可以用於邊界層溫度、濕度和折射率梯度函的精確測定和得到蒸發波導環境預測所需的偽折射率參化函; ( 2 )預測蒸蒸發波導環境特性和傳播特性及其應用研究發波導環境時可以避免使用傳統氣海界面要素測中存在的局限,並用折射率音d面不太高的精確測結果精確預測蒸發波導環境。
  5. The relationship between the air concentration and the scour depth can be expressed as an exponential function. aeration does not affect the shape of scour hole

    摻氣濃度c _對沖坑深度的影響,可表達為摻氣濃度與沖坑深度的冪函
  6. The results show that there exists such nonlinear dynamical phenomena as chaos ang quasi - period movement when the rotational speed, mass eccentric and a synthesizing parameter of the system change. from different point of view, the chaotical phenomenen induced by double period bifurcation is found. in this paper, the dynamical model of bearing - elastical rotor with a cross - section of crack is estabilished

    結果表明,在這一非穩態油膜力模型下,在轉速、偏心及一包含諸多因素的綜合參的變化過程中,在很大的范圍內,統運動都會出現由不斷倍周期分岔導致的混沌現象和概周期運動。
  7. By using the solution developed and the frequency - dependent stiffness coefficient and damp coefficient, the dynamic behavior, especially the one concerned with the variation of the dimensionless maximum response along the depth, for the pile with finite length or with infinite length was studied. it was shown that to simplify computation a pile of finite length can be taken as the one of infinite length if the ratio of pile length to its diameter ( i. e. lid ) is greater than 15

    利用所得解,採用與頻率相關的剛度和阻尼的近似表達式,對有限長樁和限長樁的動力特性特別是對最大響應沿深度的變化曲線進行了參研究,表明在常見樁土參下,當長徑比大於15時,可將有限長樁視為限長樁以簡化計算。
  8. If we change the aspect ratio ( a ) solely, an optimal reductive effectiveness of the mc can be gotten when a equals to 2. 0 we obtained the correlation between the inlet gas velocity and other non - dimenional factors, which will be helpful to the practical application

    利用模擬的結果,我們找出了使熔體內熱毛細對流得到最佳抑制所需的氣流沖刷速度和幾個的關式。這疑對將來實驗及工程上的適用有一定的指導意義。
  9. In chapter three, the momentum integral equations and their solutions of two - phase fluids in boundary layer are given and the no - disturbance solutions on the surface of vane are required. leading into the disturbance factor of no - dimension and thickness coefficient ks in boundary layer, the numerical method of finite approximation is used to calculate the boundary layer

    第三章給出了固液兩相流泵的邊界層動積分方程及其解的一般表達式,並得到葉片表面的擾動解;引入了擾動因子及邊界層厚度k _ ,給出了用於邊界層計算的有限次逼近的計算方法。
  10. The present results indicate that the quantitative description of the non - dimensional mean lateral streak spacing + differs from the results previously published. the spacing + is not a constant value of 100. it becomes larger as the reynolds number in terms of shear velocity increase

    試驗結果表明,低速帶間距的+並非為以往一致認為的100左右的常,而是隨摩阻雷諾的增大而逐漸增大,在水力光滑區與摩阻雷諾成二次方關,在過渡區則為線性關
  11. When impact applies on a discrete system in which one of constraints is a constant with coulomb friction, the phenomenon of slip - stick at the point can cause the change of friction and the integration for frictional force during infinitesimal impulsive interval becomes impossible according to traditional impulsive dynamics of discrete systems. by introducing a new dimensional time parameter, first - order momentum - impulse differential equations are obtained and the discussion over infinitesimal impulsive interval is transformed into a piece - wise study on the finite region of impulse

    在引入新的的時間參后,通過建立相應的動-沖的一階微分方程,在趨近於零的沖擊區間的討論變為在有限區間中來分段研究含滑動-黏滯的沖擊過程,得到了受到多點打擊的離散統考慮庫侖摩擦時的動力學的求解方法,即根據沖擊前的初始狀態需回到繁瑣的微分方程的求解便可以得到沖擊后統的動力學響應。
  12. By adopting the nondimensional functions of the profile - flux relationships summarized by dyer, the analytical solution of m - o length is derived for the stable surface layer, which is applicable to richardson number less than 0. 2

    求解過程中採用了dyer歸納的通廓線關形式,並給出解析解的適用范圍是richardson
  13. The physical and mathematical models are founded. numerical simulation of marangoni convection in the liquid bridge and gas channel was performed by employing the primitive variable method and using galerkin finite element method, which is applied for discretization of non - dimensional governing equations and boundary conditions. the relationship between the suppressing status of mc in the liquid bridge and the inlet gas velocity or the channel width is obtained, and the suppressing status of some kinds of marangoni numbers ( ma ) or size ratios of liquid bridge a is analyzed

    採用原始變法,用galerkin有限單元法對控制方程及邊界條件進行離散后,值模擬了微重力條件下半浮區硅熔體及氣體流道內的marangoni對流,得出了氣流沖刷速度及流道寬度變化和熔體內熱毛細對流抑製程度的關,進而分析了不同的ma和不同熔體幾何尺寸比a下熱毛細對流抑制情況。
  14. Therefore, the solution of the problem can be reduced to a seri es of algebraic equations and solved numerically by truncating the finite terms of the infinite algebraic equations. finally, given two kinds of incident wave and different dimensionless parameters, numerical examples are provided to show the influence of wave number, shear modulus, thickness and distance between the center of the cavity and ground surface upon the dynamic stress concentration by incident steady sh - wave

    最後作為算例,給出了第一類和第二類兩種不同的sh波入射方式對襯砌的散射,並選取了兩種值,得出了圓形襯砌對sh波散射的值結果,討論了不同的波比、彈性模比、厚度比以及不同的圓形襯砌中心到水平地面距離與襯砌內半徑的比值對動應力集中的影響。
  15. Methods : the experts consultation method based on information of investment and financing of public health in rural areas of hunan was used to establish the indexs which were then being dimensionless by pole - differential and then weighted average method was used to process the practical data of 14 regions in hunan province

    方法:本文在廣泛收集我省農村公共衛生投融資方面的資料據的基礎上,運用專家咨詢法確立符合本研究領域特徵的指標體和指標權重,並運用極差法對實際據進行化處理,採用加權平均法計算出我省14個地州市的區域分類標志值。
  16. The relationship between the non - dimensional drag coefficient of sma plate face and time is presented, and the pressure distribution on and around the sma plate surface as well as the karman vortex configuration in the wake at a certain time are given

    給出了形狀記憶合金薄板表面的流體阻力隨時間的變化關,同時給出了某一時刻薄板表面及其周邊的壓力分佈和薄板尾跡中的卡門渦街形態。
分享友人