無量綱速度 的英文怎麼說

中文拼音 [wúliánggāngsùdù]
無量綱速度 英文
dimensionless velocity
  • 無 : 無Ⅰ動詞（沒有） not have; there is not; be without Ⅱ名詞1 （沒有） nothing; nil 2 （姓氏） a surn...
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 綱 : Ⅰ名詞1 （提網的總繩 多用於比喻） the headrope of a fishing net 2 （比喻事物最主要的部分） key lin...
  • 速 : Ⅰ形容詞（迅速; 快） fast; rapid; quick; speedy Ⅱ名詞1 （速度） speed; velocity 2 （姓氏） a surna...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 無量 : measureless; immeasurable; boundless
  • 速度 : 1. [物理學] velocity; speed; blast; bat 2. [音樂] tempo3. （快慢的程度） speed; rate; pace; tempo
  1. In this dissertation, two particular cooperative behaviors of the molecular motors in muscle isotonic contraction are introduced : ( l ) no attached cross - bridges work at the same tempo, the working process is not affected by the environment ; ( 2 ) no attached cross - bridges work at the same tempo, and the working rate is proportional to the very velocity of thin filament in the contraction

    運用能量守恆定律，本文探討了分子馬達間的兩種特定的協作行為： （一） n _ 0個分子馬達同步的工作，並且其工作過程與外部的環境無關。 （二） n _ 0個分子馬達同步的工作，但其工作的時間t _ （ on ）與細纖絲的速度v成反比，即t _ （ on ） = a / v ，其中a是一個單位量綱因子。
  2. According to non - newtonian fluid mechanics theory and mathematical method, conbined with plunger moving property, the hypothesize fluid is imcompressive, hydraulic radius of flow of liquid in crevice is very little, and it is laminar flow, the flow is treated fixed continuous flow at every instant position of plunger, equation of motion and boundary condition were set up in condition of concentric and eccentric of pump barrel and plunger

    運用非牛頓流體力學理論和數理方法，結合抽油泵柱塞運動特點，假設液體為不可壓縮的，液體在縫隙中流動的水力半徑很小，呈層流流動，柱塞在每一位置的瞬間，流動做定常流處理，建立了泵筒與柱塞同心和偏心兩種情況下運動方程和邊界條件，引入無量綱坐標、無量綱速度和柱塞與泵筒偏心配合時的縫隙高度，並給出縫隙流流速、流量的解析解。
  3. Based on the review, the fluid flow and heat transfer in the curved circular and rectangular pipes have been researched by employing perturbation method and numerical simulation with a physical model under the rotational orthogonal curvilinear coordinate in a rotating curvilinear pipe with multi - parameters. we firstly analyzed the fully developed fluid flow and heat transfer, mixed convection heat transfer, the development of flow and heat transfer in the inlet in different cross section ( circular, elliptical, annular and rectangular crossection ). the variations of the secondary flow, axial velocity, distribution of temperature, the friction force on the wall, the ratio of friction factor as well as the nusselt number with different dimensionless parameters had been examined in detailed

    本文在總結和分析了一個世紀以來有關曲線管道流動和換熱特性的研究成果的基礎上，以旋轉正交曲線坐標系統下的多參數旋轉螺旋管道中的對流傳熱為物理模型，通過攝動方法和有限體積法，首次對各種截面（圓截面、橢圓截面、環形截面、矩形截面）旋轉曲線管道內充分發展流動的流動結構和傳熱特性（包括耦合對流傳熱特性）以及旋轉曲線管道開口段發展流動的流動結構和換熱特性進行了系統的數值模擬和理論分析，詳細討論了各種無量綱參數對管道內軸向速度分佈、二次流結構、溫度分佈、壁面摩擦力、摩擦系數比以及管道nusselt數的影響，獲得了若干創新性成果。
  4. This formula used inverse regression and data fusion technical and maximum likelihood theory, then this method enabled random sample value obtained in ultrasonic and rebound method of different detection population to mix together effectively, and reach estimation of concrete strength

    該公式利用逆回歸理論、數據融合技術和最大似然原理，將回彈值和聲速值分別看作被解釋變量，將來自超聲法和回彈法不同量綱的檢測數據進行有效融合，得出混凝土強度的推定值，該推定結果具有無偏性和方差最小性質。
  5. When in experiment, the air was heated by the film heater installed on the above and below surface of channel, adopting various air velocity of flow, test import ' s and export ' s temperature, wall temperature, fluid flux and the drop of pressure, and the other parameter. adopting nu and nu0 to analyze the baffle ' s situation of heat transfer and fluid flow, which baffle was holed various diameters

    實驗時，通過矩形通道上下壁面敷設的電加熱膜加熱通道空氣，改變空氣流速，測試不同工況時的進出口溫度、壁面溫度、流體流量和壓力損失等參數，並採用無量綱努謝爾特準則數nu 、 nu _ 0等分析了設置不同開孔折流板的換熱與流動情況。
  6. If we change the aspect ratio ( a ) solely, an optimal reductive effectiveness of the mc can be gotten when a equals to 2. 0 we obtained the correlation between the inlet gas velocity and other non - dimenional factors, which will be helpful to the practical application

    利用模擬的結果，我們找出了使熔體內熱毛細對流得到最佳抑制所需的氣流沖刷速度和幾個無量綱參數的關系式。這無疑對將來實驗及工程上的適用有一定的指導意義。
  7. Temperature process lines with tidal cycles of multi engineering conditions of characteristic sections are obtained, the relationship between temperature distribution and velocity field is established, the inner mechanism change of temperature process lines is investigated, the interrelation between water intake and outlet is analyzed, the relation between the ratio of dimensionless temperature rise span of the plant intake and the ratio of river discharge volume and plant cooling water intake volume is obtained

    得到了特徵斷面多種工況隨潮周期變化的溫度過程線，建立了溫度場與流速場的相關關系，研究了溫度過程線的變化機理，分析了取排水口對溫度場的相互影響關系，探討了無量綱溫升時長比與無量綱來取流量比的相關關系。
  8. There is no thoroughly rounded theory about displacement ventilation system in our country at present and our research begins recently. the study work of this paper will be useful for further optimization design of displacement ventilation system. this dissertation includes five parts. the first part introduces the development of the displacement ventilation and the background of research in domestic and oversea. in the second part, it gives working principle of displacement ventilation system and it ’ s advantages to the mixture ventilation. the study also gives a series of indexes to evaluate displacement ventilation system and specifies air supply terminal device and so on. it is needed to simulate and analyse the velocity field, temperature field and distribution of flow field. this is the third part. the forth part specifies the simulative method for thermal stratification of displacement ventilation system. it gives some factors affecting thermal stratification height such as inlet temperature, inlet velocity, heat transfer of wall body, distance of heat source and so on

    本文的研究工作主要包括以下幾個方面的內容: （ 1 ）綜述了國內外相關的研究現狀和研究背景; （ 2 ）簡介了置換通風的工作原理，並分析了它相對于混合通風的優良特性及評價指標、末端裝置等; （ 3 ）對採用置換通風方式房間的溫度場、速度場和氣流分佈進行了模擬計算與分析; （ 4 ）對採用置換通風方式房間的熱力分層高度進行了模擬計算，並分析其影響因素，如:送風溫度、送風速度、圍護結構傳熱和熱源分佈等; （ 5 ）擬合了無量綱熱力分層高度相應于送風溫度t 、送風速度v 、熱源間距離l和圍護結構傳熱q的經驗公式。
  9. The physical and mathematical models are founded. numerical simulation of marangoni convection in the liquid bridge and gas channel was performed by employing the primitive variable method and using galerkin finite element method, which is applied for discretization of non - dimensional governing equations and boundary conditions. the relationship between the suppressing status of mc in the liquid bridge and the inlet gas velocity or the channel width is obtained, and the suppressing status of some kinds of marangoni numbers ( ma ) or size ratios of liquid bridge a is analyzed

    採用原始變量法，用galerkin有限單元法對無量綱控制方程及邊界條件進行離散后，數值模擬了微重力條件下半浮區硅熔體及氣體流道內的marangoni對流，得出了無量綱氣流沖刷速度及流道寬度變化和熔體內熱毛細對流抑製程度的關系，進而分析了不同的無量綱參數ma數和不同熔體幾何尺寸比a下熱毛細對流抑制情況。
  10. By analysis of frequency spectrum based on matlab platform, wavelet method in the application of cutting out a section of inputting earthquake wave was presented. in the process of pseudo dynamic test results, the method of non - dimensional representation and analytic representation of hysteretic curve was provided. the above two methods will help to compare dissipation energy capacity of this structure at the different acceleration peak value stage of pseudo dynamic test more precisely and comparably

    通過基於matlab的地震波頻譜分析，說明了小波分析方法在擬動力試西安建築科技大學博士學位論文驗中地震波截取方面的應用；在擬動力分段試驗數據的處理方面，本文將試驗結果的無綱量表示方法以及曲線的多項式擬合法引入滯回曲線的數據處理，這將有助於擬動力試驗不同加速度峰值條件下，各階段結構耗能能力的客觀比較。
分享友人
分享到 Line

分享到臉書