無電刷的 的英文怎麼說

中文拼音 [diànshuāde]
無電刷的 英文
bürstenlos brushless
  • : 無Ⅰ動詞(沒有) not have; there is not; be without Ⅱ名詞1 (沒有) nothing; nil 2 (姓氏) a surn...
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : 刷構詞成分。
  • : 4次方是 The fourth power of 2 is direction
  1. This paper is based on " the remodeled item of the 122mm automatic barbette servo system ". it introduced the controlled project of brushless direct current motor realized by dsp at first. on the base of analyzing and studying the driving wave of the brushless direct current motor thoroughly and fully, it carried on the servo system ' s simulink and presented the concrete software and hardware ' s devise of the whole system in the end

    本論文撰寫是以「 122mm自行迫榴炮伺服控制系統改型項目」為基礎,首先介紹了dsp實現直流控制方案,在深入、系統分析和研究了直流機驅動波形基礎上,然後進行了伺服控制系統模擬,最後給出了伺服控制系統具體軟硬體設計。
  2. Adopted unique ventilation system and non - carbonate direct current motor stabilize the hot airflow

    採用獨特導風系統及直流機,恆定預熱風量。
  3. Some studies on control modes of the system, especially on a dc, pm, brushless and sensor - less motor driven systems. a method of rotor position identification without sensors has been developed. using a microchip to increate system efficiency, anti - disturbing ability and reliability of pwm modulation

    研究了適于直流、、永磁、位置傳感器機轉子位置檢測方法;採用單片機實現了該種運行控制,提高了系統在pwm調制時位置檢測換相控制過程抗干擾能力。
  4. Compared to the traditional converter, the new one can transform electric power from a static part to a rotary part without an electrocircuit connection, which makes the contactless power transform come true. one application of this converter is to supply a steady and regulable excitation circuit for synchronous generator by integrated its second winding with the motor while its primary winding is static. the thesis gives two methods of the rotating converter design paticullarly : flyback and fullbridge, and explains how the circuits are designed

    通過理論分析、模擬分析和實驗驗證,得出這兩種旋轉變換器都能進行感應能傳輸,但它們傳輸功率是不同,反激式旋轉換器最大隻能傳輸幾十瓦功率感應能,因此只能用在感應能傳輸較小場合,或者信號傳輸場合;而全橋式旋轉變換器能傳輸較大功率,可用於新型勵磁方案中。
  5. Theory of thulium no - brush dc motor will be research. 2

    了解稀土永磁直流工作原理。
  6. The simulation results prove that this control technique can effectively minimize the torque ripple for the bldcm drives whose back - emf waveform crest width is less than 120

    模擬結果表明這種控制策略能有效地抑制反動勢平頂寬度小於120直流動機換相轉矩脈動。
  7. For the bldcm which has a general crest width of the back - emf waveform, two kinds of torque ripple conditions when drived by sine - wave current as well as by square - wave current are deduced based on the mathematical models. in addition, a comparison is carried out between these two conditions, which indicates that sinusoidal current driving is more favorable to minimizing the torque ripple when the crest width of the back - emf waveform is less than a certain value

    闡述了抑制齒槽轉矩措施對反動勢波形影響,利用直流數學模型推導並比較了任意平頂寬度梯形波反動勢在正弦波和矩形波兩種流驅動下磁轉矩脈動情況,得出在梯形波平頂寬度減小到一定數值后採用正弦流驅動更有利於減小磁轉矩脈動。
  8. Digital signal processor ( dsp ) combined with repm bldcm, which build up a dc adjustable speed system, achieve to control multiple motor speed, positive and negative rotate, protect and fault exemine by a true single chip. design and present a electromagnetism scheme of repm bldcm used in electromotion chair drive system. select electronical components and chips in the drive board by contrast with variant drive mode. design the drive board principle picture, make a drive board pcb and debug it. design a principle picture with dsp core. workout the motor control code introduced popular programme modle. test the programme reliability and control performance by linking tms320lf2407 evm, pc, drive borad and the bldcm. the bldcm swatch is prepare experiment

    本論文闡述了方波驅動稀土永磁直流動機原理及數學模型;設計並給出了一種動座椅用稀土永磁直流動機磁設計方案;對機採用何種驅動方式進行了對比分析;對驅動路進行了元器件選型、原理圖設計、制板及調試;有針對性闡述了dsp在本系統應用中所涉及到功能模塊;設計了以dsp為核心控制路原理圖;以模塊化軟體編程思想編制了機控制軟體;通過tms320lf2407目標板、上位機、驅動板及聯調,證明了系統可行。
  9. The model and simulation of the brushless doubly - fed machine

    雙饋建模和模擬
  10. Made of compound refractory with high purification and binder free from phosphor. used for slag line and weak section of eaf, strong adhesion, high binding strength at high temperature, erosion resistant, long service life

    採用高純合成材料和磷結合劑生產高性能噴補料,適用於各種渣線及熱點部位噴補維護.具有附著率高,高溫結合強度好,抗沖性能優異,使用壽命長優點
  11. Design engineers now selecting pmbldc motors over conventional dc or induction motor drives for the following reasons : 1 ) the absence of brushes results in an essentially maintenance free operation and eliminates the undesirable effects of commutation such as sparks, brush - loss, radio - frequency interference, etc. 2 ) the low inertia of the rotor enhances the quality of the mechanical response of the motor, shortening the acceleration and deceleration time. 3 ) utilizing rare - earth permanent magnet materials with high coercive force results in substantially higher efficiency than their counterpart with brushes of the same size. 4 ) because of the absence of commutation segments, the stator construction is simple

    現在工程師們更為青睞永磁直流動機是因為以下幾點原因: ( 1 )去除了永磁直流動機徹底地免除了維護而且消除了我們不希望由於換向帶來火花、損耗以及干擾等等; ( 2 )低轉動慣量轉子提高了機機械響應質量,從而縮短了機加速和減速時間; ( 3 )高矯頑力稀土永磁材料使用使得同樣尺寸永磁直流動機比傳統直流動機效率高; ( 4 )由於沒有機械換向部分定子結構簡單了。
  12. A mathematic model of the motor is builded and emulated through matlab. the low - speed and constant - torque, high - speed and constant - power state is analyzed and researched, also the software approach of simulation to the driver has been done, a digital signal processor tms320lf2407 is developed successfully to control the perm square - wave bldcm driving airscrew of solar powered unmanned engine. it is useful to the further study

    在matlab下建立了數學模型,通過計算機模擬,驗證了數學模型正確性,同時在理論上對低速恆轉矩高速恆功率運行進行了分析與研究,提出了一種用模糊控制方法實現恆功率控制,並對驅動器進行了系統模擬,成功研製了以數字信號處理控制器tms320lf2407為控制核心驅動器,控制直流動機驅動太陽能人飛機螺旋槳,為後面繼續研究工作提供了參考。
  13. This paper describes principle and general design on rotating deflector of the laser scanner according to application. theory on brushless dc motor is studied and structures of the mechanics and control system have been designed according to special requirements of the rotating laser scanner. the scanning motor developed has been tested synthetically in performance

    本論文針對轉鏡式激光掃描器應用,實施了轉鏡式激光掃描器原理及總體方案設計,對直流動機理論進行了探討,並針對轉鏡式激光掃描器特殊要求進行了掃描器機械結構及其控制系統結構設計,對研製掃描性能進行了綜合實驗。
  14. Adaptive fuzzy control of brushless dc motor

    直流模糊自適應控制
  15. This paper gives the fundamental equation of electric circuit of switched reluctance generator ( srg ). the phase flux linkage, indutance and phase current of srg are discussed based on unsaturated magnetic circuit

    給出了開關磁阻路基本方程,分析了基於不飽和磁路條件相磁鏈、相感和相流。
  16. Abstract : a new current feedback control method of brushless dc motor ( bldcm ) is introduced in this paper, which combines the traditional overlap method with the fixed - frequency sampling current control method. it both stabilizes the work frequency of the inverter, and improves the commutative performance of bldcm. and it is verified by the result of the simulation

    文摘:提出一種永磁直流流反饋新控制方法,即採用常規重疊換相法與定頻采樣流控制相結合方法,既能穩定逆變器工作頻率,又改善了永磁直流換相性能,利用模擬對提出方法進行了驗證。
  17. Many paper is dealing with the brushless dc motor. some of them neglect the effect of the inductance, some of them take the inductance into accoutant, but do not analyze the effect of the commuting angle

    在國內外文獻中,在直流動機運行性能分析上,有忽略了作用,有雖然考慮了繞組感,但沒有分析切換角作用。
  18. In this chapter, the method of bldcm rotor position detection is first discussed. then the principle and algorithm of bemf zero crossing point detection is explained. in succession, the chapter dissertates the software realization of the bemf zero crossing point detection algorithm, the software disturbance filter and the modification of phase displacement, and the software realization of commutation point

    在這一章中,先簡述了直流轉子位置器檢測方法;然後論述了反動勢過零檢測原理和演算法以及該演算法軟體實現、軟體濾波和相移修正、換相點軟體實現;最後對軟體開環換相起動策略作了詳細論述。
  19. Main purpose : it is widely used in steady speed mix, high speed disperse and sand will lab process. it adopt mouse cage motor, so no sparkle phenomena when working

    主要用途:廣泛適用於穩速攪拌,高速分散,砂磨實驗過程。由於採用了籠式機,運轉時不會產生火花。與有機相比,磨損問題,噪聲小。
  20. Abstract : based on the classical theory, the harmonic winding potential of the tooth harmonic brushless exciting generator have been calculated and analysed. the results tally with the data of no - load test very well. it was demonstrated the designing thread of harmonic winding is correct

    文摘:從經典理論出發,對齒諧波勵磁發諧波繞組勢進行了分析計算,其結果與空載實驗得出數據完全吻合.說明諧波繞組設計思路是正確
分享友人