煅燒過程 的英文怎麼說

中文拼音 [shāoguòchéng]
煅燒過程 英文
calcination process
  • 煅 : 動詞1. （中藥製法: 放在火里燒） calcine2. （鍛造） forge
  • 燒 : Ⅰ動詞1 （使東西著火） burn 2 （加熱或接觸某些化學藥品、放射性物質等使物體起變化） cook; bake; hea...
  • 過 : 過Ⅰ動詞[口語] （超越） go beyond the limit; undue; excessiveⅡ名詞（姓氏） a surname
  • 程 : 名詞1 （規章; 法式） rule; regulation 2 （進度; 程序） order; procedure 3 （路途; 一段路） journe...
  • 過程 : process; procedure; transversion; plication; course
  1. Kiln simple structure, convenient and reliable control of the production process, the vulnerability of small, high rates of operation, the plant is calcined high - grade cement equipment, but also widely used in metallurgical, chemical, construction and other industries

    回轉窯結構簡單，生產過程式控制制方便可靠、易損件少、運轉率高，是水泥廠煅燒高標號水泥的設備，同時也廣泛用於冶金、化工、建築等行業。
  2. The liquid synthesis of nanocrystals titania at low temperature, due to avoiding the sintering process, brings superior physical and chemical properties

    低溫液相合成晶態納米二氧化鈦由於避免了高溫煅燒過程，可望賦予其更優越的特性。
  3. In this paper, co3o4 nano - particles were prepared by homogeneous precipitation method, technical conditions and kinetics were studied, the main contents and results are as follows : co ( no3 ) 2 6h2o was used as raw materials, and co ( nh2 ) 2 was used as precipitator, co3o4 nano - particles were prepared by homogeneous precipitation. the influences of concentration, molar ratio of reactants, reaction temperature and time, dryness temperature and time, and calcining temperature and time on particle size were investigated

    本文採用均勻沉澱法制備納米co _ 3o _ 4粉體材料，研究了制備工藝條件、沉澱反應和前驅體熱分解過程的動力學，主要研究內容及結果如下：以硝酸鈷為原料，尿素為沉澱劑，採用均勻沉澱法制備納米co _ 3o _ 4 ，考察了硝酸鈷濃度、反應物摩爾比、反應溫度和時間、乾燥溫度和時間、煅燒溫度和時間等條件對產物粒徑的影響。
  4. While this concept for calcination / carbonation processes sounds simple, in practice sorbents undergoing cyclic calcination and carbonation suffer from a serious loss of calcium utilization efficiency as the cycling proceeds

    雖然煅燒/碳化過程的原理聽起來似乎簡單，但實際上，在循環煅燒和碳化的過程中，吸附劑的鈣使用效率將嚴重下降。
  5. Abstract : some new technological measures, such as new reactors, gel method to remove silicon, direct dissolve acid to recrystallizate and direct calcine from zirconyl chloride, were used to reform zirconium dioxide production process. as a result, the materials consumption and energy consumption were reduced and the wastewater discharge was decreased. meanwhile the rubbish were recovered and utilized to prepare into a by - product as silica aerosol. the pollution prevention and control in production process were achieved

    文摘:採用新型反應器及膠凝除硅、直接酸溶重結晶、直接煅燒等技術對二氧化鋯的生產工藝進行了改革，降低了原材料消耗及能耗，減少了廢液排放量，並將回收的廢物加工成副產品白炭黑，在生產過程中防治污染。
  6. Some new technological measures, such as new reactors, gel method to remove silicon, direct dissolve acid to recrystallizate and direct calcine from zirconyl chloride, were used to reform zirconium dioxide production process. as a result, the materials consumption and energy consumption were reduced and the wastewater discharge was decreased. meanwhile the rubbish were recovered and utilized to prepare into a by - product as silica aerosol. the pollution prevention and control in production process were achieved

    採用新型反應器及膠凝除硅、直接酸溶重結晶、直接煅燒等技術對二氧化鋯的生產工藝進行了改革，降低了原材料消耗及能耗，減少了廢液排放量，並將回收的廢物加工成副產品白炭黑，在生產過程中防治污染。
  7. And the value drop to the lowest at ph = 0. 8. as the increase of heat treatment temperature, the pore size distribution peak of sio2 microspheres is very narrow, meanwhile the specific surface area is the smallest before 160 c. the polymer template is removed at 350 c, so the pore structure of sio2 particles has a big change which involve the increase of specific surface area and the broaden of pore size distribution peak. with the continuous raise of temperature the sio2 network will shrink little, as a result the average pore size will decrease, but the specific surface area has no obvious change

    結果發現：二氧化硅膠體顆粒均勻分佈於脲醛聚合物網路中，煅燒去除有機模板后微球表面變粗糙，而粒徑沒有明顯變化； ph值較小時，復合微球中聚合物含量較大，而ph值較大時，得到復合微球結構鬆散，因此熱處理后的二氧化硅微球孔容及平均孔徑都較大，而在ph = 0 . 8時，得到最小值；武漢理工大學碩士學位論文隨著熱處理溫度的變化，小於160時，空分佈較窄，而比表面積較小，在350時，由於有機模板的去除，微球孔結構發生突變，比表面積明顯增大，而孔徑分佈變寬，溫度繼續升高時，二氧化硅網路發生收縮，平均孔徑變小而比表面積由於有機炭化物的完全去除沒有太大變化;微球中的微孔在熱處理過程中處于平衡狀態，分佈沒有太大變化。
  8. In the process of wollastonite fining, we can forge and then cool it to protect its crystal structure which is short acicular fiber. mechanochemical modification by jet mill is super to speedily mixed modification by stirring mix

    硅灰石微粉碎過程中，為保護硅灰石的短纖維針狀結構，可在粉碎前對硅灰石進行煅燒空冷處理。
  9. Reaction of limestone calcination and sulfuration under o _ ( 2 ) / co _ ( 2 ) atmosphere were experimented on a bench scale fluidized bed facility and analyzed by thermodynamic analysis. limestone samples were analyzed by press mercury apparatus and scanning electron microscope. mechanism for limestone calcination and sulfuration under o _ ( 2 ) / co _ ( 2 ) atmosphere was raised and discussed

    熱力學角度和小型流化床試驗臺上研究了空氣和o _ 2 / co _ 2氣氛下的石灰石煅燒分解與硫化反應特性，並對煅燒過程和硫化反應過程中的石灰石樣品結合壓汞儀和掃描電鏡進行了微觀分析，得出了o _ 2 / co _ 2氣氛下石灰石煅燒與硫化反應特浙江大學博士學位論文點，探討了02 / co :氣氛下石灰石的硫化反應機理。
  10. The power prepared was examined by many kinds of analytic measures, like as xrd, xps, tem, sem and x rays fluorescence, etc. the sol - gel method was used to synthesize dy - doped titanium oxide, the impact of elements such as solvent ' s quantities, temperature, ph value, calcination temperature on the course of sol - gel is studied, and the quantities of mixed rare earth is also studied on the influence about the structure of phase, thus established the best technology parameter

    本文對摻雜稀土元素鏑的氧化鈦和氧化鋯超微陶瓷粉末的制備的工藝過程進行了研究，並用xps 、 xrd 、 tem 、 sem和x射線熒光等多種測試手段對制得的粉末進行了分析。用溶膠-凝膠法合成氧化鏑/氧化鈦的陶瓷粉末，研究了溶劑量，溫度， ph值，煅燒溫度等對溶膠-凝膠過程的影響，以及摻雜稀土量對相結構的影響，從而確立了最佳的工藝參數。
  11. Because the calcining of cement kiln has characteristics of more variables, non - linearity, pure lag, strong coupling etc., controlling cement kiln with traditional control ways is very difficult

    由於水泥回轉窯的煅燒過程具有多變量、非線性、純滯后和強耦合等特點，使得採用傳統的控制理論對水泥窯的控制變的十分困難。
  12. During charging from the conveyor belts or vibrating feeders. the circular shaft design facilitates uniform stone and fuel distribution during charging and calcination throughout the complete shaft cross section

    圓形窯的設計使在整個窯筒的橫截面上上料和煅燒過程中的石料和燃料的分配更加均勻。
  13. Traditionally, rces activities have been focused on the supply of process know - how, basic engineering and key equipment, especially for

    ， rce的業務已集中在提供工藝過程技術訣竅，基本工程和關鍵設備，特別是用於煅燒耐火材料原料的
分享友人
分享到 Line

分享到臉書