煉成渣 的英文怎麼說
中文拼音 [liànchéngzhā]
煉成渣
英文
clinker-
Multi - laboratory center of pangang is worked for production of steel - making factory. many producing processes, such as desulfurize 、 extracting - vanadium 、 steel - marking 、 refine out ladle ( lf 、 rh ) 、 caster etc, need directing and controlling by sampling and analysis, in order to get chemical composition information of molten iron 、 semisteel 、 molten steel 、 vanadium slag and slag and develop producing
攀鋼煉鋼綜合化驗中心是為煉鋼廠生產服務的，煉鋼廠各生產工序如脫硫、提釩、煉鋼、爐外精煉（ lf 、 rh ） 、連鑄等，都必須通過取樣、化驗分析來實時獲得鐵水、半鋼、鋼水以及提釩釩渣、爐渣等化學成分來指導、優化生產。In order to keep the normal bath temperature and slag forming condition, the charge of pig iron should not be exceeded 10 % on middle and small converter
中小型轉爐內生鐵塊的加入量不應超過10 % ，使轉爐吹煉過程中保持正常的熔池升溫和成渣狀況。During the process, the follwing task must be done : ( 1 ) desulphur ( 2 ) temperature control ( 3 ) the fine adjust of chemic analysis ( 4 ) making the steel more clear ( 5 ) slag making in order to implement the following main function, the lf process computer system should be designed : ( 1 ) to dynamic plan lf process according to recived heat schedule
Lf爐（ ladlefurnace ）即鋼包精煉爐，是鋼鐵生產中主要的爐外精煉設備。它的主要任務是：脫硫溫度調節精確的成分微調改善鋼水純凈度造渣在lf爐生產中建立過程式控制制計算機系統，主要用來解決以下問題：實時接收生產計劃，按照計劃動態組織生產。Bright stock refined, high viscosity lubricating oil usually made residual stocks by suitable treatment, such as a combination of acid treatment or solvent extraction with dewaxing or clay finishing
光亮油通常由渣油經加工處理而製成的精煉、高粘度潤滑油。加工處理的方式包括：酸處理（或溶劑萃取）脫蠟（或粘土精製）相結合。Bright stock refined ， high viscosity lubricating oil usually made from residual stocks by suitable treatment ， such asa combination of acid treatment or solvent extraction with dewaxing or clay finishing
光亮油通常由渣油經加工處理而製成的精煉、高粘度微個個潤滑油。加工處理的方式包括：酸處理（或溶劑萃取）與脫蠟（或粘土精製）相結合。Abstract : the slag splashing practice and obtained results were introduced under conditions of steelmaking from semi - steel at pzh steel. the problems present in slag splashing in converter at pzh steel were analyzed
文摘:介紹了攀鋼在半鋼煉鋼工藝條件下進行的濺渣護爐實踐和所取得的成效，對濺渣護爐存在的問題進行了分析。With this model the eaf steel - making process can be simulated, including of scrap melting procedure, the changes of temperature, slag quantity and compositions of steel, slag and off - gas
該模型可動態地模擬電弧爐冶煉過程中的廢鋼量、爐溫、渣量、鋼液成分、爐渣組成和爐氣成分的變化。This paper probes into the feasibility of taking the reduced slag after magnesium ' s smelting as the desulfurizer, makes the component analysis on the reduced slag after magnesium ' s smelting, and studies on the performances of the reduced slag being as the desulfurizer after magnesium ' s smelting under the conditions of different oxygen contents, grain sizes and reaction temperatures by using tga
探討了金屬鎂冶煉還原渣作為脫硫劑的可能性，對金屬鎂冶煉還原渣進行了成分分析，並利用tga研究了金屬鎂冶煉還原渣在不同氧氣含量、不同粒徑、不同反應溫度條件下作為脫硫劑的性能。Some tests for liangang sinter adding bos slag have be done in the laboratory and plant trial. the results show that in the range of bos slag percentage, from 0 % to 8 %, with the increase of bos slag percentage, the sinter speed has been lower, but the sinter strength and productivity of sinter product have been higher, the sinter productivity will be the maximum when bos slag percentage is 4 % ; the siner reducibility has been improved, the normal operation of bof will not be effected anymore because of the circulation of p form bos slag
對燒結礦配加轉爐鋼渣進行了實驗室研究和工業試驗，在鋼渣配比0 % 8 %的范圍內進行的研究表明：隨著鋼渣配比的增加，燒結速度稍有下降，燒結礦強度、燒結成品率均有所提高，利用系數在4 %左右時達到最大值；燒結礦還原性得到改善；鋼渣中帶入的p的循環富集不會影響煉鋼的現行操作。Abstract : by means of mineralogical study of earlier slag samples of the flash furnaceanalyze the mineralogical composition and its variation, so that expose oxidation atmosphere in furnace and required controlled parts in the later smelting
文摘:本文通過對閃速爐前期爐渣的礦物學研究，分析礦物的組成及變化情況，以揭示爐內氧化氣氛的強度及在後期冶煉中需注意控制的部分。分享友人