熔劑性混合料 的英文怎麼說

中文拼音 [róngxìnghúnliào]
熔劑性混合料 英文
fluxed mixture
  • : 動詞(熔化) melt; fuse; smelt
  • : Ⅰ名詞1 (藥劑; 制劑) a pharmaceutical or other chemical preparation 2 (某些有化學作用的物品) a...
  • : Ⅰ名詞1 (性格) nature; character; disposition 2 (性能; 性質) property; quality 3 (性別) sex ...
  • : 混形容詞1. (渾濁) muddy; turbid2. (糊塗; 不明事理) foolish; stupid
  • : 合量詞(容量單位) ge, a unit of dry measure for grain (=1 decilitre)
  • : 名詞1 (材料; 原料) material; stuff 2 (喂牲口用的穀物) feed; fodder 3 (料器) glassware 4 (...
  • 混合 : (攙雜在一起) mix; blend; mingle; admix; mixture; mix up; interfusion; commixture; blending; cre...
  1. In this paper the formula, the technics, the dosage of the filler and the macromolecule coupling agent are studied which influence the technics condition, mechanical properties, structure configuration. also x - ray large angle diffraction, scan electron microscope, dta etc are used to analysis and test the properties of the pp / talc composites. conclusions as follows : 1

    本文系統地研究了復體系配方、工藝方法、填及偶聯用量對復體系工藝條件、力學能及結構形態的影響,同時利用廣角x射線衍射、掃描電鏡、 dta等對復體系的能進行了測試與分析,主要研究內容及結論如下: 1滑石粉的加入,雖然使pp的化時間增加,但是煉能耗下降,有利於pp的加工;偶聯的加入,使pp的化時間增加,能耗略有降低,總體而言,對加工無不利影響。
  2. The crystal is applied to the papermaking that can raise whiteness and non - transparency, remains - proportion of the crystal is higher than the usual light calcium carbonate. as for plastics, it can improve impact strength in the plastics, its inhibiting - burning capability is advancing bigger than the common inhibiting - burning material of magnesium hydroxide. concerning the thermo tropic adhesives, the physical property of compound - packing is higher than the one of single - packing, namely remover strength, softening point, hardness, climate tolerance and the speed of consolidation are high

    晶須作為造紙填,可使紙張的白度和不透明度提高,留著率比造紙常用填輕質碳酸鈣高;用作塑,可使塑的沖擊強度提高,阻燃能比常用阻燃材氫氧化鎂有較大的提高;添加到熱型膠粘中,與輕質碳酸鈣使用可明顯提高熱膠的剝離強度、軟化點、硬度、耐侯以及固化速度。
  3. In attempt to prepare and study the novel electrically conductive nanocomposites, with polyethylene ( pe ) served as the matrix, maleic anhydride grafted polyethylene ( gpe ) served as eg intercalates and expanded graphite ( eg ) served as a conductive filler, prepared gpe / eg, pe / gpe / eg electrically conductive composites via solution intercalation ( si ), direct melt mixing ( dmm ) and master batch melt mixing ( mmm ) methods. by means of testing conductivity and mechanical property, with the measures of tem, sem, om, xrd and dsc, studied the relationship between preparation method, material composition, and electrically conductive as well as mechanical property. the main outcomes never reported at home and abroad literature were obtained as follows : 1 the gpe / eg electrically conductive nanocomposites were prepared via si method

    本論文以制備和研究新型高分子導電納米復為目的,以聚乙烯( pe )為基體,馬來酸酐接枝聚乙烯( gpe )為插層,膨脹石墨( eg )為導電填,採用溶液插層( si )法、直接( dmm )法和兩者相結體母( mmm )法制備了gpe eg 、 pe gpe eg導電復,通過電導率和力學能測試,運用tem 、 sem 、 om 、 xrd和dsc等手段,研究了制備方法、材組成、形態結構和導電能及力學能之間的關系,得到以下未見國內外文獻報道的研究結果: 1採用si法成功制備了gpe eg導電納米復,其導電逾滲閥值( _ c )為1 . 59vol ,遠低於dmm法制得gpe eg常規復的_ c ( 3 . 13vol ) 。
  4. As to the crosslinking polyethylene, organic montmorillonite was further modified by attach the monomers on the surface and interlayer of montmorillonite in the way of mixing at a high speed. after the former procedure, the crosslinking polyethylene / montmorillonite nanocomposites had been easily obtained by melt mixing crosslinking polyethylene and the modified montmorillonite directly

    而對于交聯聚乙烯,則首先通過高速的方式將小分子單體和引發負載到有機蒙脫土的表面和層間,再將制得的二次改蒙脫土同交聯聚乙烯直接融復,成功的制備了交聯聚乙烯蒙脫土納米復
  5. In this paper, we make use of hexadesyltrimethyl, an approximate ammonium compounding ( 15 - ch2 - number 17 ), ocatadecylaminechloried as cation exchange agents. the montorillonite is treated with these agents, which results in marked increase in their organophilic properties. the orgnic - montmorillonite has been identified by x - ray diffraction, different thermal analysis and infrared adsorption spectra

    在本文中,我們分別用十六烷基三甲基溴化銨、一種銨鹽( 15主鏈- ch2 -數量17 )和十八烷基氯化銨作為陽離子交換,對蒙脫土進行了改,使之由親水變成親油,繼而採用融插層方法制備了聚乙烯/蒙脫土復
  6. The main producing methods of conductive paper are as follows : mix papermaking of conductive materials and pulp fibers ( wet process ), conductive fibers adhered by adhesives or fusing with meldable fibers ( dry process ), papers coated with conductive coaters, electroless plating, situ adsorption and polymerization of conductive polymers onto pulp fibers, etc

    導電紙的主要製造方法有:導電材與紙漿纖維抄(濕法) 、導電纖維用膠黏或與熱纖維(干法) 、紙基用導電塗塗布、化學鍍和導電聚物紙漿纖維現場吸附聚等。
分享友人