熔化膨脹 的英文怎麼說

中文拼音 [rónghuàpéngzhàng]
熔化膨脹 英文
melting dilation
  • 熔 : 動詞（熔化） melt; fuse; smelt
  • 膨 : 動詞（物體的長度或體積增加） expand; swell
  • 脹 : 動詞1. （膨脹） expand; dilate; inflate 2. （脹大） swell; distend; bloat
  • 熔化 : melt; smelt; meltdown; fusion; fusation; diatexis; eliquation; run; melting; smelting
  • 膨脹 : expand; swell; dilate; inflate; puff; bulge; inflation; expansion; dilatation; buckling; swelling...
  1. The imported transparent glaze fired at lower temperature was analysed semi - quantitatively by adopting emission spectroscope. the stripping of lead and cadmium from this transparent glaze fired at lower temperature in ceramic product was determined by atomic absorption spectroscope. the effect of chemical composition on the stripping of lead and cadmium was analysed. upon the author s opinion, the overproof lead stripping from the imported transparent glaze fired at lower temperature can only be settled by adopting lead - free glaze instead of adopting low - lead prescription. the author succeeded in developing an excellent lead - free transparent glaze fired at the lower temperature of 1000 1050. the success is based on an inquiry into the feasibility of using such new agents of fusion as li2o and sro in replacement of pbo ; and on a study of the effects of the contents of sio2 ， al2o3 ， b2o3and other metallic oxides on such performances of glaze as coefficient of linear expansion, fusion temperature and transparency. it is also based on an analysis of coefficient of linear expansion of blank and glaze on an analysis of coefficient of linear expansion of blank and glaze on their correlation ; and on a study of technology for preparing glaze

    採用發射光譜儀對進口低溫透明釉進行半定量分析，並用原子吸收光譜儀測定其陶瓷製品的鉛、鎘的溶出量，分析化學成分對鉛、鎘溶出量的影響.結果表明，進口低溫透明釉採用低鉛配方不能解決鉛溶出量的超標問題，只有採用無鉛釉才能解決.探討用氧化鋰和氧化鍶等新型熔劑完全代替氧化鉛的工藝，研究釉料中氧化硅、氧化鋁、氧化硼和各種金屬氧化物的含量，對釉的線膨脹系數、熔融溫度和透明度等性能的影響.分析坯料、釉料的線膨脹系數及其相互關系和釉料制備的工藝，研製出優質的1000 1050低溫無鉛透明釉
  2. Polybenzoxazine / vermiculite hybrid nanocomposites were prepared from two kinds of polybenzoxazine precursors and two kinds of organically modified - vermiculite minerals and expanded - vermiculite which were consisted of vermiculite, hydrobiotite and phlogopite. after treatment of vermiculite minerals by hexadecyl trimethylam monium bromide ( ctab ), the d001 of vermiculite layers of vermiculite mineral increased from 1. 43nm to 2. 67nm and developed a d002 = 1. 34nm

    本文分析了蛭石精礦和膨脹蛭石的組成和結構，用十六烷基三甲基溴化銨（ ctab ）進行了有機化處理，再通過熔融或溶液混合插層苯並嗯嗪樹脂（ ben ）制備了ben插層蛭石納米復合材料，並採用蒙脫土進行了對照實驗。
  3. The crystallization and melting behavior of mellocene - catalized branched and linear polyethylenes of low molecular weight was studied. it was found that the crystalline lattice of branched polyethylene is larger than that of linear polyethylene because of the existence of branched chains. the melting behavior of branched polyethylene is similar to that of linear polyethylene since the branched chains can not enter the lattice. however, the crystalline behavior of low molecular weight branched polyethylene is the same as that of high molecular weight linear polyethylene, but different with that of low molecular weigh linear polyethylene. kinetics theory analysis evidenced that the transition temperature of growth regime of the branched polyethylene is about 20 lower than that of linear polyethylene with the same molecular weight. it may be attributed to the existence of short branched chains

    研究了金屬茂催化的低分子量支化聚乙烯和線性聚乙烯的結晶及熔融行為，發現支化聚乙烯的結構與線性聚乙烯相同為正交結構，但晶格略有膨脹.支鏈的存在對熔融行為影響不大，兩種聚乙烯的熔點均隨結晶溫度的升高而非線性增加，表現出低分子量樣品的共同特徵.但支鏈的存在對結晶行為卻有很大的影響，主要是由於支鏈的存在降低了晶體的結晶速率從而影響結晶過程，使得低分子量的支化聚乙烯的結晶行為與高分子量線性聚乙烯的結晶行為相似而與低分子量的線性聚乙烯不同.動力學分析表明，低分子量的支化聚乙烯的結晶生長方式的轉變溫度比同等分子量的線性聚乙烯降低了約20
  4. For the crystalline polymer matrix, the ptc transition temperature is close to the melting point, while for the amorphous polymer matrix, the ptc transition temperature is close to the glass transition temperature

    Ptc轉變溫度與體積膨脹的轉變溫度非常一致，對于結晶聚合物基體體系， ptc轉變溫度在基體的熔點附近，而對于非晶聚合物基體體系， ptc轉變溫度在基體的玻璃化轉變溫度附近。
  5. 1. the splitting from the binding interface of cuw / crcu roots from the rich cr and the oxidation of the binding interface, which leads to the higher thermal resistance in binding interface than normal, and the thermal stress enhanced. the extruded cu is suggested to instead of casting cu

    （ 1 ）斷裂是由於原材料鑄態的crcu中c :質點大於熔滲的孔隙而沉積在界面上，同時在有氧源存在的條件下，結合面氧化，致使結合面結合不好，界面熱阻升高， cuw與crcu部分的膨脹不同，應力集中，燃弧后斷裂。
分享友人
分享到 Line

分享到臉書