熔渣保 的英文怎麼說

中文拼音 [róngzhābǎo]
熔渣保 英文
slackness covered electrode
  • 熔 : 動詞（熔化） melt; fuse; smelt
  • 渣 : 名詞1 （渣滓） dregs; residue; sediment:煤渣coal cinder; 殘渣 dregs; 豆腐渣 soya bean residue; 豬...
  • 保 : Ⅰ動詞1 （保衛; 保護） defend; protect 2 （保持） keep; preserve; maintain in good condition 3 （...
  1. A kind of stainless steel flux - cored wire has been successfully developed, based on acid slag type system, by adding a bit of oxides and trace of deoxidizer, adjusting the fluidity of melting slag to increase shielding of the back weld

    在酸性渣系的基礎上，通過添加少量氧化物，調整熔渣的流動性，並加入微量的強脫氧劑，以增強背面焊縫的保護，研製成功一種背面不充氬的不銹鋼打底單面焊雙面成形專用藥芯焊絲。
  2. The moderate supersonic carbon added to the mold flux for ultra - low carbon steel is used to stay the melting speed as skeleton. then the mold flux coils have the good adiabatic, insulation and even flow property. at the same time it cause the carbon increase in the steel slabs and the operation of the ultra - low carbon is affected at last

    超低碳鋼連鑄結晶器用保護渣中，外加中超碳黑作為骨架降低熔化速度，使保護渣具有良好的絕熱保溫性、均勻流動的潤滑性，但同時卻會引起鋼鑄坯的碳增量，最終影響超低碳鋼的成功操作。
  3. In order to keep the normal bath temperature and slag forming condition, the charge of pig iron should not be exceeded 10 % on middle and small converter

    中小型轉爐內生鐵塊的加入量不應超過10 % ，使轉爐吹煉過程中保持正常的熔池升溫和成渣狀況。
  4. Meanwhile it retains evenness on lift force to prevent leakage of residue that is caused by installation clearance error or changes in welding criteria, flow off molten iron as well as break - over welding, so that the ideal fosion depth and finishment have been fulfilled

    在需原動力的條件下，該機利用彈性夾角變化，隨著筒體轉動，使墊層焊劑始終緊貼筒體外側環向焊接區，並保持托力均勻防止因裝配間隙誤差或焊接規范變化而引起漏渣，鐵水下淌及焊穿現象，達到理想的熔深度和光潔度。
  5. On the other hand, under the force of mechanical, the carbon and cao & sio2 superfine powder are obtained ; the specific surface area of these particles is increased. the tem photos indicated that, the carbon particles are composites on the surface of the melting superfine particles uniformly

    另一方面，在機械力作用下，碳黑及cao sio _ 2的熔融顆粒被超細粉碎，比表面積增大，同時tem照片顯示，中超碳黑均勻地復合於超細熔融顆粒表面，並有逐步嵌入的趨勢，提高了碳的有效利用率，降低了保護渣的熔化速度。
  6. In doing so, the utilization rate of carbon is increased and the melting speed of protection slag is decreased. the application result indicated that : using superfine composite particles, only 0. 3 % of carbon is needed, while carbon in traditional particles would up to 2 %. hence, the adding of superfine composite powder can avoid the increasing of carbon in steel slag

    應用單位實驗表明：在不影響保護渣整體性能的前提下，使用超細復合粒子保護渣，降低熔速的外摘要博士學位論文加中超碳黑的量可大幅度減少，僅需0 . 3 % ，而使用傳統方法制備的保護渣外加中超碳黑量不低於2 % 。
  7. With engaged in person who cast crystallization device electroplate copper repair and new product make in succession, crystallization device always becomes and makes, overhaul of the equipments and reorganize and outfit, refractory material of casting etc. and person who melt hollow particle cast, spend, protect dreg production, storage transportation, etc

    是以從事連鑄機結晶器電鍍銅板修復及新品製作結晶器總成製造連鑄機設備檢修與整備耐火材料及預熔型空心顆粒連鑄用保護渣生產倉儲運輸等為主體的綜合性集體企業。
分享友人
分享到 Line

分享到臉書