熔解點 的英文怎麼說

中文拼音 [róngjiědiǎn]
熔解點 英文
melting point
  • 熔 : 動詞（熔化） melt; fuse; smelt
  • 解 : 解動詞（解送） send under guard
  • 點 : Ⅰ名詞1 （液體的小滴） drop （of liquid） 2 （細小的痕跡） spot; dot; speck 3 （漢字的筆畫「、」）...
  1. Dark red flake, melting point 197 ` c, easily deliquescent, soluble in water poisonous, corrosive and flammable with the organic

    呈紅色片狀物，熔點197 ` c ，極易溶解，易溶於水，有毒，腐蝕性強，與有機物接觸可引起燃燒。
  2. Synthetic cryolites is mainly used as the flux in the aluminium electrolysing and the fillers of rubber, grinding wheel, the milk whiter agent of enamel glass - shaded and the flux of the non - iron metal, etc. its merits are adjustable molecular ratio, lower cost and good fluidity

    人造冰晶石可作電解氧化鋁的助熔劑，橡膠，砂輪的填充劑，搪瓷玻璃罩的增白劑及非鐵金屬的助溶劑等，它具有可調整的克分子傳導率，成本低，流動性好等優點
  3. Through the research of crosslinking of matrix resin, heating treatment of composite and mixing of different polymer, we draw some conclusions : 1 、 percolation theory can explain the phenomenon of the jump of resistance when the content of cb reach a critical volume ; 2 、 based on ohm conduct theory, abounded to the percolation the wbibull statistical theory and other theory, an adapted theory was obtained to explain the jump of resistance and the other phenomenon ; 3 、 the ntc phenomenon was eliminated by crosslinking the matrix of conductive composite, at the same time the stability of composite was improved

    通過對基體樹脂的交聯、復合材料的熱處理、聚合物共混物的研究得出了如下的結論： 1 、滲濾理論能夠很好的解釋導電粒子含量達到某一值時電導率劇增的問題； 2 、在歐姆導電模型的基礎上，綜合應用了weibull統計理論模型，結合原來的體積膨脹等理論，成功的解釋了ptc復合材料在基體材料熔點附近的跳變問題、 ntc現象以及熱循環穩定性等問題； 3 、有機ptc導電復合材料經硅烷交聯以後能夠消除ntc現象，改善了導電復合材料的穩定性能。
  4. Water has higher melting point, boiling point, heat of vaporization, heat of fusion and surface tension than comparable hydrides such as hydrogen suiphide or ammonia or most liquids

    與氫硫化物、氨水或其他大多數的液體相比，水具有較高的熔點、沸點、蒸發比熱、熔解熱和表面張力。
  5. The physics model was established to deduce the relationship of different classifying gear speeds and melting point on the base of the broken theory and the broken process of pvc. it explained that the melting point of nanocrystalline pvc was low. therefore the effect of nanocrystal was proved in theory

    最後通過引入破碎理論針對pvc的破碎過程，建立物理模型推導出分級輪旋轉速度與晶體熔點的關系，解釋納米晶pvc熔點低的原因，從而從理論上探討了pvc的納米晶效應。
  6. The introduction of lateral rods firstly induced the decrease of crystallization ability, which resulted in the descent of melting points. further increasing the lateral rods centent resulted in the increase of polymers " melting points. but it was interesting that the solvability was enhanced all the time

    橫向液晶基元的引入首先導致聚合物結晶能力的下降，熔點降低；進一步增加橫向液晶基元的含量，聚合物的結晶能力又逐漸增加，熔點升高，但是，聚合物的溶解性始終變好。
  7. As each human begins to embody all elements including air, water, fire and earth along with the inverse elements of ether, vapor, smoke and lava, humanity will begin to thaw out as there will be enough fire to allow for an internal shift within each.

    當每個人融合入所有的元素包括氣，水，火和土，連同逆元素如以太，蒸汽，煙和熔巖時，人類將開始解凍，因為這將使每個人的內部被充分點燃（擁有足夠的能量）而允許一個內在轉換的發生。
  8. Abstract : according to characters of different research ways, the research development of thermodynamic models of metallic melts is systematically introduced, such as solution model method, geometrical model method, interaction coefficient method, analytical method and experienced model method

    文摘:根據不同研究方法的特點，綜述了溶液模型法、幾何模型法、相互作用系數法、解析計演算法以及經驗模型法等金屬熔體熱力學模型的研究進展，並對這些方法進行了簡要的評述。
  9. An equivalent flow length method was used to predict the filling pattern and transferred the tracing of melt front to computing weighted approximate shortest flow path on finite element mesh model

    該法將熔體前峰面的追蹤問題轉換為帶權曲面上任意兩點間近似最短路徑的求解。
  10. Through the gc analyses and the nuclear magnetic resonance analyses showed that the copolyesters obtained here were random copolymers of 3hb and 3hv units. hv fraction in the copolymers reached 38 %. through thermal analyses showed that the melting point was reduced and pyrolysis temperature was increased

    經氣相色譜、核磁共振分析，此共聚物為3hb與3hv所組成的不規則共聚物， hv組分在共聚物中約佔38 ；經熱分析，獲得的phbv共聚物的熔點有所降低，分解溫度有所升高，在性能上優于phb 。
  11. The mechanica1 performance is superior to p1ain pp. 0n the sem photographs of impact fracture surface, it was observed that the pu11out of si licate 1ayers hard1y was found and the compat ibi 1 ity of pp and montmori l 1oni te was improved great l y. xrd resu1 ts suggested that the basal spacing of silicate layer was about 4

    小角xrd結果顯示，復合材料中無機片層間距d _ （ 001 ）在4 . 0nm左右，為插層型材料，通過dsc測試發現復合材料的熔點和分解溫度均有一定的提高，蒙脫土的加入可提高材料的熱性能。
  12. White crystal ； insoluble in water ； soluble in methanol, ethanol, toluenc etc organic solvents. m. p. 49 52. decomposed at ordinary temperature. storage at below 10

    白色結晶，不溶於水，溶於甲醇、乙醇、甲苯等有機溶劑，熔點49 52 ，常溫下分解，存放在低於10的地方。
  13. The thermodynamic conditions of decomposition of the foaming agent tih2, homogeneous and heterogeneous nucleation in high - temperature solid and liquid, growth and movement were achieved to demonstrate the trend of pore evolvement in this paper. moreover, according to the characteristics of in - situ gas foaming, the equations of the height change of foaming samples with heating time were primarily established to study the behavior of foams and to guild the experiment processes

    另外，論文通過大量的熱力學分析，得出了發泡過程中發泡劑分解以及氣孔在固液態時的均勻形核和非均勻形核、氣孔的生長和運動等熱力學條件，揭示了氣孔演化的趨勢；論文還根據內生氣源發泡的特點，初步建立了高溫熔體中氣體發泡高度隨時間變化的方程，為進一步深入的研究發泡機理奠定了一定的基礎。
分享友人
分享到 Line

分享到臉書