熱值測定器 的英文怎麼說

中文拼音 [rèzhícèdìngqì]
熱值測定器 英文
heating effect indicator
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 定 : Ⅰ形容詞1 （平靜; 穩定） calm; stable 2 （已經確定的; 不改變的） fixed; settled; established Ⅱ動詞...
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 測定 : determine; determination; setting-out; admeasurement; assignment; assay; finding
  1. Radiators and convectors. part 2 : test methods and rating

    散熱器和換流器.第2部分:測試方法和額定值
  2. Test method for gross calorific value of coal and coke by the isoperibol bomb calorimeter

    等溫彈式量熱器測定煤和焦炭總熱值的試驗方法
  3. In the paper, with system energy balance method and heat conductive equations ， on tne basis of short time heat transfer modeling established the long time modeling, considering heat interference in thermal well group. this paper used the finit element method for element division and computer analysis, and provided the operation temperature figure. acquired computation values agreed well with experimental results, the most difference between them was 5. 13 %

    本文採用系統能量平衡結合熱傳導方程，在淺埋套管式換熱器短期傳熱模型基礎上建立了長期傳熱模型，並考慮了管群熱干擾對模型的影響。並運用有限單元法軟體編程進行離散和計算機分析，得出模擬溫度場，其模擬值與實測的均值基本相符，兩者最大誤差小於5 . 13 % ，表明該模型具有一定的合理性和實用意義。
  4. Avoiding the difficulties of detecting the difficult parameters in furnace control and of building up the models, integrated with fuzzy control and conventional pid control, abb ’ s control it system is used to predict the bloom surface and center temperature directly based on the temperature of furnace wall easily to be detected so that the temperature settings in various furnace sections can be self - corrected, the furnace temperature of each section self - adjusted and on - line parameters of combustion control self - optimized. in addition, the heating parameters and the operating status of the field plant can be monitored with alarm

    採用abb公司的controlit控制系統，避開爐子控制中遇到的困難參數檢測及建模困難等因素，直接根據容易檢測的爐壁溫度來推知鋼坯表面溫度及鋼坯中心溫度，將模糊控制技術與常規pid控制相結合，實現各段溫爐設定值自修正、各段爐溫自協調、各參數在線自整定的自尋優最佳燃燒控制;對熱工參數、現場設備的運行情況進行監視、報警，實現爐膛壓力、管道壓力、換熱器的保護控制，並將重要參數送往廠級mis網路。
  5. Standard test method for calorific heating value of gases in natural gas range by continuous recording calorimeter

    用連續記錄量熱器測定天燃氣范圍中煤氣熱值的標準測試方法
  6. Testing of solid and liquid fuels - determination of gross calorific value by the bomb calorimeter and calculation of net calorific value - part 3 : method using adiabatic jacket

    固體和液體燃料試驗.用彈式量熱器測定總熱值以及凈熱
  7. Testing of solid and liquid fuels - determination of gross calorific value by the bomb calorimeter and calculation of net calorific value - part 1 : principles, apparatus, methods

    固體和液體燃料試驗.用單式量熱器測定總熱值並計算凈
  8. The speed can be adjusted incessantly at the required speed range. the motor also can be kept at the same speed even when the load is three times of the rated load. moreover, the universal of this controller is strong, and the heat dissipation is good

    永磁無刷直流電動機控制器樣機的測試結果表明：電機轉速可在要求范圍內連續調節，在幾乎三倍的額定轉矩范圍內，電機轉速在設定值下可保持高於指標精度的穩定工作，控制器之間通用性強、散熱可靠。
  9. The experimental results indicate that when the air flow rate is determined, the key problem for energy saving is how to keep the indoor thermal comfort at a suitable level and reduce the difference between the internal and external temperature of the room. a formula is gained for calculating the critical values of air exchange rate. when ventilating rate is greater than the value, radiating heating is the better way for energy saving, or else, convection method in heating is more suitable

    實測還指出，當通風量一定時，如何保證人體熱舒適度不變而減少室內外氣溫差將成為大通風量房間節約採暖能耗的關鍵，本文結合圍護結構傳熱機理，在對三種方式的能耗狀況進行理論分析的基礎上，提出了換氣次數的節能臨界值，若換氣次數高於此值，則輻射供暖是較好的選擇，否則，散熱器供暖是較好的方法。
  10. As composite material are widely used in navigation and physical education equipments for high comparing intensity and module, even it has the approxi - mate zero expanding coefficient, as the same time, configuration of composite has been aroused attention by scientific researchers, the goal of them is to find an integrated structure with high efficiency and intelligent and many function all along. grid structure is the right structure with the high efficiency, the researchers overseas have been studying the structure for many years, which manifests it has many excellent nature ; existing research indicate it has higher stiffness and intensity. the form can be detected in health easily for its open shape

    復合材料具有高的比強度和比模量，同時又具有近於零的熱膨脹系數和良好的尺寸穩定性等優良性能，已經廣泛應用於航天航空事業和體育器材生產工業，與此同時，尋求一種高效的、低成本的、並將智能化和功能化集於一體的結構形式，一直是航空航天追求的目標，具有點陣結構的復合材料格柵結構正是這種高效的結構形式，表現出多項優良性能;國外對其進行了大規模的理論分析和一些數值模擬研究，已有的研究表明該結構具有良好的可設計與自動化生產性能而無材料之間匹配問題，開放式的結構形式為結構的健康檢測提供了便利，具有廣闊的應用前景。
  11. To the concrete two - phase flow - crude oil, its temperature, speed and capacitance value are measured by flat capacitance sensors, fluke rlc instrument and other auxiliary appliance. assessing the characters of crude oil and predicting the solidifying point is the result of using fuzzy information arithmetic

    針對具體的兩相流? ?原油，用平板電容器、 fluke精密電橋和其它輔助傳感器分別測取了原油的熱處理溫度、降溫速率和電容值，利用模糊信息融合演算法對測量值進行處理和尋優，從而進行原油熱處理的綜合評定和凝點的在線預測。
  12. Heat - processed foods in hermetically sealed containers. determination of ph

    密封容器中的加熱食物. ph值的測定
  13. Analysis of the test results of the rear - installed cooling system revealed that the overheat problem resulted from the measured cooling air temperature being higher and the coolant flow and transmission oil flow being smaller than the correct design value, and that the wrong location of the hydraulic oil cooler cannot completely meet the need of the cooling system

    通過對測試數據進行分析，確定了系統過熱的原因，即系統中測試獲取的冷卻風的溫度比設計值高，冷卻水和傳動油的體積流量比設計值小，而且液壓油散熱器布置位置錯誤。
分享友人
分享到 Line

分享到臉書