熱元件 的英文怎麼說

中文拼音 [rèyuánjiàn]
熱元件 英文
thermal element
  • 件 : Ⅰ量詞（用於個體事物） piece; article; item Ⅱ名詞1. （指可以一一計算的事物） 2. （文件） letter; correspondence; paper; document
  1. Wl - fa2000 double units laminator is the newest and highest intellective full automatic laminator, use intellective numbers meter control the temperature, you needn ' t do any other operations during it ' s working, import the hydraulic pressure mode, excellent calefaction 、 refrigeration elements, two - double designing, use water and air cooling mode, so that effective improve the working efficiency and better effect, it ' s diploid more quickly than wl - fa1000 laminator

    Fa2000型雙塔層壓機是最新研製出的高效率智能型全自動層壓機，溫度採用智能化數碼控制儀，工作時不需要進行任何操作，壓力採用用進口液壓加壓方式，優質的加熱、散熱元件。
  2. Heat element graphite ; molybdenum ; composite material cfc

    加熱元件：石墨金屬鉬復合材料
  3. Heat element graphite ; composite material cfc

    加熱元件：石墨棒石墨板
  4. Heat element molybdenum ; graphite ; composite material cfc

    加熱元件：金屬鉬鉭鎢石墨棒復合材料
  5. Heating element of lanthanum chromite in high temperature

    鉻酸鑭高溫電熱元件
  6. The heating units of electric kitchen ranges at 600℃ to 700℃ emit much more heat.

    廚房中溫度在600-700的電爐灶加熱元件能散發出更大的熱量。
  7. We adopt new production process of cold ends, so our sic heating elements have excellent specific rate of heat zone resistance and cold end resistance, saving energy, long life, avoiding over - temperature of cold ends to damage the furnace body. the commercial name of our sic heating elements is songshan silca heating elements

    我們的碳化硅電熱元件採用新的冷端部生產工藝，具有優良的熱冷端電阻比，節能、壽命長，同時避免了因冷端部溫度過高對爐體造成的損害。
  8. The water heater shall have a self - diagnostic control that monitors and indicates power on, no power or control failure, start - up failure, high - limit operation, sensor failure, defective upper element, or defective lower element

    這種熱水器應該配置自診斷控制裝置，能夠監控和顯示通電、停電、控制裝置故障、啟動故障、高溫運行、感應器故障、上部加熱元件或下部加熱元件故障等狀態。
  9. In the third, this paper makes a survey on components of the exhausted flue gas and waste heat resource, and discusses the possibility and methods of steam generation and air preheating with the waste heat. and then, the analysis on the advantages and disadvantages of heat recovery plants with conventional steel - water heat pipes and inorganic heat - transfer heat pipes is carried out. the paper also gives a valuation about the plan and features of the design of heat recovery

    對余熱源排煙的成分和余熱資源量進行標定，討論余熱回收產生蒸汽或加熱燃燒用空氣的可行性和方法，分析常規余熱回收技術設計、採用普通鋼-水熱管和無機傳熱熱管等傳熱元件的設計余熱回收裝置的優缺點，並對余熱回收設計方案及其特點進行總體評價。
  10. A new type thick - film circuit heatin g - element is introduced and the main technology is expounded, including the requireme nt and performance of substrate mate rial and electro - pastes. the process of heating - element is intro duced too. at last, the application a nd problem of the new type heating - element are put forward

    介紹了基於不銹鋼基板的大功率密度厚膜電熱元件的研究現狀，並對厚膜電路式電熱元件的關鍵技術進行闡述，包括大功率密度電熱元件所用基板材料和基於基板的電子漿料的使用要求，以及電熱元件的制備工藝;最後分析了該新型電熱元件的應用前景和所要解決的問題。
  11. Unscrew the retaining bolt ( see figure 7, # 1 ). hold the element with pliers and remove it using a semicircular motion

    旋下固定螺栓（參閱圖7 ， # 1 ） 。用鉗子握住加熱元件（加熱棒）旋轉半圈拆卸下加熱棒。
  12. Failure analysis of silicon carbide heating element

    碳化硅發熱元件失效分析
  13. The energy smart setting shall monitor element usage and adjust the tank temperature for usage pattern detected

    節能智能設置將監控加熱元件的使用情況，並根據監測到的用戶的使用習慣調節熱水水溫。
  14. 4supplied with strong support clips and suction cups, designed for extended use and completely safe

    4自動恆溫控制及高質量的發熱元件，高效節能經久耐用。
  15. We select ni / cr alloy resistor as element together with ceramic embedding hearth ; select small flat - and - disc heat - even hubby ceramic sample holder, select ni / cr & ni / si thermoelectric couple ( type k ) as thermoscope with threads 0. 5 mm in diameter which is installed in the middle of the holders symmetrically ; select aluminum silicate fire - retardant fiber as materials for heat preservation ; design some hardware, for example temperature controller & transporter, signal amplifier etc ; design controlling curve to heat stove ; and introduce the method of least squares nonlinear regression and subsection function to deal with data. in order to obtain the reasonable operation conditions and operation curve, we have also done many theory analysis and experiment discussions

    通過理論和試驗探討，選用鎳鉻合金電阻絲作為加熱元件，配以陶瓷質埋入式爐膛；選用陶瓷質小尺寸扁平?圓盤均熱塊體型樣品支持器；選用0 . 5mm絲徑鎳鉻?鎳硅熱電偶（ k ）作為測溫元件；熱電偶對稱安置在樣品支持器容器的中部；選用硅酸鋁耐火纖維作保溫材料；合理選用和設計了溫度控制器、溫度變送器、信號放大電路等硬體；採用升溫曲線來控制爐膛供熱過程；採用最小二乘法非線性回歸與分段函數相結合的曲線模擬方法，進行圖形處理。
  16. Using the opened thermosiphon of 38x3 as experimental element and water as working fluid, the characteristics of dynamic low load boiling, stable severe boiling heat transfer coefficient and critical heat flux are gotten for the opened thermosiphon at the pressure of 0. 02 - 0. 1mpa and 0. 1 - 0. 8mpa respectively, which makes up the drawback that the opened thermisiphon has not yet accurate boiling heat transfer relationship formulas. by means of experimental results, an opened thermisiphon waste heat recovery boiler is designed for the high temperature gases that the positi e electrode copper refining furnace exhaust, which overcomes effectively the drawback of short life, little capacity and unable to inspect that the closed steel - water thermosion has

    本文以工程上常用的38 3的開口封底為實驗元件，以水為工質，對開啟式熱管內的動態低負荷沸騰、穩態旺盛沸騰及臨界沸騰特性進行系統的可視化實驗研究，實驗壓力為0 . 02 0 . 8mpa ，實驗得出了38 3的開口封底管在工作壓力為0 . 02 0 . 8mpa和0 . 1 0 . 8mpa下的管內沸騰傳熱系數及臨界熱負荷計算關聯式，彌補了開口封底管? ?這一新型傳熱元件尚無準確的沸騰換熱關聯式的缺陷。
  17. Used as frame of vacuum tube, heating elements

    W1 w2 ：用於製造電子管柵極邊桿，加熱元件等。
  18. This causes increased cycling of the heater elements and can result in increased water temperatures at the hot water outlet

    這將增加加熱元件的周期性工作頻率，並可能導致熱水出水口處水溫升高。
  19. Make sure the replacement element has the correct voltage and wattage rating

    確保所要替換的新加熱元件具有正確的額定電壓和功率。
  20. They are not sized to a specific wattage output like metallic heating elements

    這種硅碳棒不同於金屬加熱元件，沒有固定的輸出功率。
分享友人
分享到 Line

分享到臉書